武汉东湖铜锈环棱螺的种群动态及次级生产力

1999年6月至2000年5月对武汉东湖铜锈环棱螺的种群生态学进行了周年研究.铜锈环棱螺年均密度和生物量分别为92.2ind./m2和142.83g/m2,密度和生物量的高峰分别出现在6月(157ind./m2)和11月(205.78g/m2);东湖铜锈环棱螺为一年一代,其一年中种群含有5个年龄组,其中1998年龄组占绝对优势.利用瞬时增长率法计算东湖铜锈环棱螺的周年生产量带壳湿重为91.56g/m2,去壳干重为5.32g/m2,P/B系数为0.64.同时研究了铜锈环棱螺的生产力动态变化,其生产量累积多数

Spintronics with graphene

Because of its fascinating electronic properties, graphene is expected to produce breakthroughs in many areas of nanoelectronics. For spintronics, its key advantage is the expected long spin lifetime, combined with its large electron velocity. In this article, we review recent theoretical and experimental results showing that graphene could be the long-awaited platform for spintronics. A critical parameter for both characterization and devices is the resistance of the contact between the electrodes and the graphene, which must be large enough to prevent quenching of the induced spin polarization but small enough to allow for the detection of this polarization. Spin diffusion lengths in the 100-μm range, much longer than those in conventional metals and semiconductors, have been observed. This could be a unique advantage for several concepts of spintronic devices, particularly for the implementation of complex architectures or logic circuits in which information is coded by pure spin currents. © Copyright 2012 Materials Research Society.

湖北钉螺在不同温度下的发育速率及形态变化

从野外采回的钉螺在室内各实验温度条件下均能正常产卵,其产卵量的高低与室温无关;在15-30℃的温度范围内,随着温度的升高钉螺的孵化期逐渐缩短;利用有效积温公式得知钉螺卵孵化的有效积温为193.55日度,发育起点温度为10.86℃;在各温度下初孵幼螺随着生长发育,螺壳的长宽比也随之加大.

甘草粗提物对鲫的免疫调节作用

本研究对中药甘草(Glycyrrhiza uralensis Fiseh)进行了粗提,将粗提物按0.5%和2%的质量分数制成药饵投喂鲫鱼(Carassius auratus)后,于第14天、28天、35天、42天5、6天采样检测其免疫指标。结果显示,低剂量组试验鱼血清溶菌酶活性逐渐升高,高剂量组在35d达到最大值(205.5±28.8)U/mL,之后略有下降。低剂量组和高剂量组试验鱼血清杀菌活性均有所波动,波动范围分别为62.0%—73.1%和75.0%—83.3%,就各期而言,对照组、低剂量组和高剂量组

滇池试验围隔内不同形态铁浓度的变化与物化因子的关系

在蓝藻水华形成以后,通过围隔实验,从2003年6月份到10月份定期采样测定水体中的pH、溶解氧(DO)、水温、总铁、亚铁、过滤性铁(<0.45μm)和可溶性磷的浓度,研究物化因子对不同形态铁浓度变化的影响。实验结果表明,蓝藻水华优势种微囊藻在pH 7—9和水温17.5—20.5℃的条件下,生长旺盛,消耗了大量的亚铁,使亚铁浓度大幅度下降;溶解氧和磷酸盐对亚铁浓度没有显著影响;在水华蓝藻严重发生的条件下,水体中的总铁和过滤性铁浓度没有显著意义的变化,而亚铁浓度的变化与水华蓝藻的种群密度成显著负相关(r=-0

快速建立鲢、鳙纯系的初步研究

运用随机扩增多态性DNA(RAPD)方法对雌核发育和人工转性鲢、鳙进行了遗传多样性的研究,并用长江天然鲢、鳙群体作为对照分析.在雌核发育鲢中,共得到187条带,其中19条为多态带,占10.16％,而对照组鲢共扩增205条带,有32个多态座位,占总带数的15.61％.在雌核发育鳙中共产生232条带,其中11条为多态带,比例为4.74％,而在对照组中共产生241条带,25条为多态带,比例为10.37％.遗传距离分析表明,雌核发育鲢和鳙的平均值分别为0.102和0.023.而对照组鲢和鳙遗传距离平均值分别为0.

铜锈微囊藻两种表型的生长生理特性及毒素组成比较分析

从滇池蓝藻水华中分离得到的铜锈微囊藻群体在实验室无机营养中解聚成单细胞 ,结果表明 ,群体微囊藻的生长速度明显低于单细胞微囊藻 ;前者具明显可见的胞外酸性多糖胶鞘 ,而单细胞则几乎没有 ;按常规方法分析比较两种细胞形态的毒性大小和毒素组成 ,发现群体微囊藻主要含有三种微囊藻毒素的异构体 ,而单细胞以MC LR为主 ;且单细胞微囊藻的毒性约为群体的 1 0倍。二者的LDH和PGM同工酶酶谱也有差异。本研究为解释毒素的合成和调控机理提供了新的证据

Complex chemistry DNS of n-heptane spray autoignition at high pressure and intermediate temperature conditions

Direct Numerical Simulations (DNS) of turbulent n-heptane sprays autoigniting at high pressure (P=24bar) and intermediate air temperature (Tair=1000K) have been performed to investigate the physical mechanisms present under conditions where low-temperature chemistry is expected to be important. The initial turbulence in the carrier gas, the global equivalence ratio in the spray region, and the initial droplet size distribution of the spray were varied. Results show that spray ignition exhibits a spotty nature, with several kernels developing independently in those regions where the mixture fraction is close to its most reactive value ξMR (as determined from homogeneous reactor calculations) and the scalar dissipation rate is low. Turbulence reduces the ignition delay time as it promotes mixing between air and the fuel vapor, eventually resulting in lower values of scalar dissipation. High values of the global equivalence ratio are responsible for a larger number of ignition kernels, due to the higher probability of finding regions where ξ=ξMR. Spray polydispersity results in the occurrence of ignition over a wider range of mixture fraction values. This is a consequence of the inhomogeneities in the mixing field that characterize these sprays, where poorly mixed rich spots are seen to alternate with leaner ones which are well-mixed. The DNS simulations presented in this work have also been used to assess the applicability of the Conditional Moment Closure (CMC) method to the simulation of spray combustion. CMC is found to be a valid method for capturing spray autoignition, although care should be taken in the modelling of the unclosed terms appearing in the CMC equations. © 2013 The Combustion Institute.

念珠藻葛仙米叶绿素荧光与水分胁迫的关系

在渗透系统中 ,念珠藻葛仙米因轻微失水而叶绿素的Fv/Fm 上升 ;水势继续降低时Fv/Fm快速下降。衬质系统和自然失水的影响相似 ,藻体在失去总水分的 94 %以后Fv/Fm 开始下降 ,此前水分的丢失对Fv/Fm 比值的上升稍有促进作用。干燥藻体吸水后Fv/Fm 的恢复速率随着贮藏时间的延长而下降 ,并且Fv/Fm 的恢复对光和蛋白质的重新合成有依赖性。DCMU虽然也抑制Fv/Fm 的恢复 ,但可逆转

Control of bimanual rhythmic movements: Trading efficiency for robustness depending on the context

This paper investigates how the efficiency and robustness of a skilled rhythmic task compete against each other in the control of a bimanual movement. Human subjects juggled a puck in 2D through impacts with two metallic arms, requiring rhythmic bimanual actuation. The arms kinematics were only constrained by the position, velocity and time of impacts while the rest of the trajectory did not influence the movement of the puck. In order to expose the task robustness, we manipulated the task context in two distinct manners: the task tempo was assigned at four different values (hence manipulating the time available to plan and execute each impact movement individually); and vision was withdrawn during half of the trials (hence reducing the sensory inflows). We show that when the tempo was fast, the actuation was rhythmic (no pause in the trajectory) while at slow tempo, the actuation was discrete (with pause intervals between individual movements). Moreover, the withdrawal of visual information encouraged the rhythmic behavior at the four tested tempi. The discrete versus rhythmic behavior give different answers to the efficiency/robustness trade-off: discrete movements result in energy efficient movements, while rhythmic movements impact the puck with negative acceleration, a property preserving robustness. Moreover, we report that in all conditions the impact velocity of the arms was negatively correlated with the energy of the puck. This correlation tended to stabilize the task and was influenced by vision, revealing again different control strategies. In conclusion, this task involves different modes of control that balance efficiency and robustness, depending on the context. © 2008 Springer-Verlag.

Core design options for high conversion BWRs operating in Th- 233U fuel cycle

Several options of fuel assembly design are investigated for a BWR core operating in a closed self-sustainable Th-233U fuel cycle. The designs rely on an axially heterogeneous fuel assembly structure consisting of a single axial fissile zone "sandwiched" between two fertile blanket zones, in order to improve fertile to fissile conversion ratio. The main objective of the study was to identify the most promising assembly design parameters, dimensions of fissile and fertile zones, for achieving net breeding of 233U. The design challenge, in this respect, is that the fuel breeding potential is at odds with axial power peaking and the core minimum critical power ratio (CPR), hence limiting the maximum achievable core power rating. Calculations were performed with the BGCore system, which consists of the MCNP code coupled with fuel depletion and thermo-hydraulic feedback modules. A single 3-dimensional fuel assembly having reflective radial boundaries was modeled applying simplified restrictions on the maximum centerline fuel temperature and the CPR. It was found that axially heterogeneous fuel assembly design with a single fissile zone can potentially achieve net breeding, while matching conventional BWR core power rating under certain restrictions to the core loading pattern design. © 2013 Elsevier B.V. All rights reserved.