Are alternative livelihood projects alleviating poverty in mining communities? Experiences from Ghana

This paper critiques the approach being taken in Ghana to implement Alternative Livelihood (AL) projects in mining communities. The rapid insurgence of illegal artisanal gold mining has forced policymakers to think more creatively about ways in which to deal with mounting unemployment in the country's rural areas. Most of the economic activities being promoted, however, have proved highly unpopular with target groups. The adopted policy approaches reflect how little in tune the organisations championing AL activities are with the mindsets and ambitions of rural populations.

Fitting models for the joint action of two drugs using SAS(R)

Combinations of drugs are increasingly being used for a wide variety of diseases and conditions. A pre-clinical study may allow the investigation of the response at a large number of dose combinations. In determining the response to a drug combination, interest may lie in seeking evidence of synergism, in which the joint action is greater than the actions of the individual drugs, or of antagonism, in which it is less. Two well-known response surface models representing no interaction are Loewe additivity and Bliss independence, and Loewe or Bliss synergism or antagonism is defined relative to these. We illustrate an approach to fitting these models for the case in which the marginal single drug dose-response relationships are represented by four-parameter logistic curves with common upper and lower limits, and where the response variable is normally distributed with a common variance about the dose-response curve. When the dose-response curves are not parallel, the relative potency of the two drugs varies according to the magnitude of the desired effect and the models for Loewe additivity and synergism/antagonism cannot be explicitly expressed. We present an iterative approach to fitting these models without the assumption of parallel dose-response curves. A goodness-of-fit test based on residuals is also described. Implementation using the SAS NLIN procedure is illustrated using data from a pre-clinical study. Copyright © 2007 John Wiley & Sons, Ltd.

Joint effects of density and a growth inhibitor on the life history and population growth rate of the midge Chironomus riparius

Results of previous laboratory studies suggest that high population density often buffers the effects of chemical stressors that predominately increase mortality. Mortality stressors act to release more resources for the survivors and, therefore, produce less-than-additive effects. By contrast, growth stressors are expected to have opposite results or more-than-additive effects. We investigated the effects of a growth inhibitor (lufenuron) on larval growth and survival of Chironomus riparius and examined its joint effects with density on population growth rate (PGR). Exposure to 60 mu g/kg sediment or greater inhibited larval growth, and exposure to 88 mu g/kg or greater often resulted in mortality before reaching emergence. The effects of lufenuron, however, differed with population density. At 88 mu g/kg, mortalities and, to a lesser extent, reduced fecundity resulted in a reduction in PGR at low density. Conversely, when populations were initiated at high density, PGR was similar to that of controls, because the few survivors reached maturity sooner and started producing offspring earlier. The effect of density as a growth stressor therefore was stronger than the effect of lufenuron, which had effects similar to those of a mortality stressor and produced less-than-additive effects. Longterm studies under field conditions, however, are needed before less-than-additive effects are considered to be the norm.

Joint effects of population density and toxicant exposure on population dynamics of Capitella sp I

Very few studies have analyzed the dependence of population growth rate on population density, and even fewer have considered interaction effects of density and other stresses, such as exposure to toxic chemicals. Yet without such studies we cannot know whether chemicals harmful at low density have effects on carrying capacity or, conversely, whether chemicals reducing carrying capacity are also harmful at low density, impeding a population's capacity to recover from disturbance. This study examines the combined effects of population density and a toxicant (fluoranthene) on population growth rate (pgr) and carrying capacity using the deposit-feeding polychaete Capitella sp. I as a test organism. Populations were initiated with a stable age distribution, and population density and age/size distribution were followed during a period of 28 wk. Fluoranthene (FLU), population density, and their interaction influenced population growth rate. Population growth rate declined linearly with the logarithm of population biomass, but the slope of the relationship was steeper for the control populations than for populations exposed to 50 mug FLU/(g sediment dry mass). Populations exposed to 150 mug FLU/(g sediment dry mass) went extinct after 8 wk of exposure. Despite concerns that toxicant effects would be exacerbated at high density, we found the reverse to be the case, and effects of fluoranthene on population growth rate were much reduced in the region of carrying capacity. Fluoranthene did. reduce carrying capacity by 46%, and this could haven important implications for interacting species and/or sediment biogeochemical processes.

The joint effects of larval density and C-14-cypermethrin on the life history and population growth rate of the midge Chironomus riparius

1. Chemical effects on organisms are typically assessed using individual-level endpoints or sometimes population growth rate (PGR), but such measurements are generally made at low population densities. In contrast most natural populations are subject to density dependence and fluctuate around the environmental carrying capacity as a result of individual competition for resources. As ecotoxicology aims to make reliable population projections of chemical impacts in the field, an understanding of how high-density or resource-limited populations respond to environmental chemicals is essential. 2. Our objective was to determine the joint effects of population density and chemical stress on the life history and PGR of an important ecotoxicological indicator species, Chironomus riparius, under controlled laboratory conditions. Populations were fed the same ration but initiated at different densities and exposed to a solvent control and three concentrations of C-14-cypermethrin in a sediment-water test system for 67 days at 20 +/- 1 degreesC. 3. Density had a negative effect on all the measured life-history traits, and PGR declined with increasing density in the controls. Exposure to C-14-cypermethrin had a direct negative effect on juvenile survival, presumably within the first 24 h because the chemical rapidly dissipated from the water column. Reductions in the initial larval densities resulted in an increase in the available resources for the survivors. Subsequently, exposed populations emerged sooner and started producing offspring earlier than the controls. C-14-cypermethrin had no effect on estimated fecundity and adult body weight but interacted with density to reduce the time to first emergence and first reproduction. As a result, PGR increased with cypermethrin concentration when populations were initiated at high densities. 4. Synthesis and applications. The results showed that the effects of C-14-cypermethrin were buffered at high density, so that the joint effects of density and chemical stress on PGR were less than additive. Low levels of chemical stressors may increase carrying capacity by reducing juvenile competition for resources. More and perhaps fitter adults may be produced, similar to the effects of predators and culling; however, toxicant exposure may result in survivors that are less tolerant to changing conditions. If less than additive effects are typical in the field, standard regulatory tests carried out at low density may overestimate the effects of environmental chemicals. Further studies over a wide range of chemical stressors and organisms with contrasting life histories are needed to make general recommendations.

A review of the use of demonstration projects to achieve widespread adoption of innovative practices

The UK construction industry has embarked on one of the largest experiments in the implementation of innovative technologies and practices in its history. Following Rethinking Construction[1], generally known as the Egan Report, the Movement for Innovation was established with the aim of using demonstration projects as practical examples of innovation in order to encourage others to follow the example. The number of demonstration projects has exceeded the original plans and more are being added. This paper reviews the approach in terms of the practice of using demonstration projects to achieve widespread take up of innovation, the modifications to the programme and its management and considers future developments to improve its, effectiveness.

Comparative costs of the commercial process in different construction procurement methods

The commercial process in construction projects is an expensive and highly variable overhead. Collaborative working practices carry many benefits, which are widely disseminated, but little information is available about their costs. Transaction Cost Economics is a theoretical framework that seeks explanations for why there are firms and how the boundaries of firms are defined through the “make-or-buy” decision. However, it is not a framework that offers explanations for the relative costs of procuring construction projects in different ways. The idea that different methods of procurement will have characteristically different costs is tested by way of a survey. The relevance of transaction cost economics to the study of commercial costs in procurement is doubtful. The survey shows that collaborative working methods cost neither more nor less than traditional methods. But the benefits of collaboration mean that there is a great deal of enthusiasm for collaboration rather than competition.

Informal communication networks and the diffusion of innovations in UK construction projects: A research design

The UK industry has been criticised for being slow to adopt construction process innovations. Research shows that the idiosyncrasies of participants, their roles in the system and the contextual differences between sections of the industry make this a highly complex problem. There is considerable evidence that informal social networks play a key role in diffusion of innovations. The aim is to identify informal communication networks of project participants and the role these play in the diffusion of construction innovations. The characteristics of this network will be analysed in order to understand how they can be used to accelerate innovation diffusion within and between projects. Social Network Analysis is used to determine informal communication routes. Control and experiment case study projects are used within two different organizations. This allows informal communication routes concerning innovations to be mapped, whilst testing if the informal routes can facilitate diffusion. Analysis will focus upon understanding the combination of informal strong and weak ties, and how these impede or facilitate the diffusion of the innovation. Initial work suggests the presence of an informal communication network. Actors within this informal network, and the organization's management are unaware of its' existence and their informal roles within it. Thus, the network remains an untapped medium regarding innovation diffusion. It is proposed that successful innovation diffusion is dependent upon understanding informal strong and weak ties, at project, organization and industry level.