Compositional influence on the electrical performance of zinc indium tin oxide transparent thin-film transistors

In this work, zinc indium tin oxide layers with different compositions are used as the active layer of thin film transistors. This multicomponent transparent conductive oxide is gaining great interest due to its reduced content of the scarce indium element. Experimental data indicate that the incorporation of zinc promotes the creation of oxygen vacancies. In thin-film transistors this effect leads to a higher threshold voltage values. The field-effect mobility is also strongly degraded, probably due to coulomb scattering by ionized defects. A post deposition annealing in air reduces the density of oxygen vacancies and improves the fieldeffect mobility by orders of magnitude. Finally, the electrical characteristics of the fabricated thin-film transistors have been analyzed to estimate the density of states in the gap of the active layers. These measurements reveal a clear peak located at 0.3 eV from the conduction band edge that could be attributed to oxygen vacancies.

Eye lens monitoring for interventional radiology personnel: dosemeters, calibration and practical aspects of H p (3) monitoring. A 2015 review.

A thorough literature review about the current situation on the implementation of eye lens monitoring has been performed in order to provide recommendations regarding dosemeter types, calibration procedures and practical aspects of eye lens monitoring for interventional radiology personnel. Most relevant data and recommendations from about 100 papers have been analysed and classified in the following topics: challenges of today in eye lens monitoring; conversion coefficients, phantoms and calibration procedures for eye lens dose evaluation; correction factors and dosemeters for eye lens dose measurements; dosemeter position and influence of protective devices. The major findings of the review can be summarised as follows: the recommended operational quantity for the eye lens monitoring is H p (3). At present, several dosemeters are available for eye lens monitoring and calibration procedures are being developed. However, in practice, very often, alternative methods are used to assess the dose to the eye lens. A summary of correction factors found in the literature for the assessment of the eye lens dose is provided. These factors can give an estimation of the eye lens dose when alternative methods, such as the use of a whole body dosemeter, are used. A wide range of values is found, thus indicating the large uncertainty associated with these simplified methods. Reduction factors from most common protective devices obtained experimentally and using Monte Carlo calculations are presented. The paper concludes that the use of a dosemeter placed at collar level outside the lead apron can provide a useful first estimate of the eye lens exposure. However, for workplaces with estimated annual equivalent dose to the eye lens close to the dose limit, specific eye lens monitoring should be performed. Finally, training of the involved medical staff on the risks of ionising radiation for the eye lens and on the correct use of protective systems is strongly recommended.

Electrical characteristics of eddy current position sensor

In the thesis the principle of work of eddy current position sensors and the main cautions that must be taken into account while sensor design process are explained. A way of automated eddy current position sensor electrical characteristics measurement is suggested. A prototype of the eddy current position sensor and its electrical characteristics are investigated. The results obtained by means of the automated measuring system are explained.

Formação e caracterização óptica de filmes automontados de POMA/PPV

A study is presented of the formation and optical properties of polymeric heterostructures from poly(p-phenylene vinylene) (PPV) and poly(o-methoxyaniline) (POMA) produced via the self-assembly technique. POMA layers were obtained in a non self-limiting process from its emeraldine salt, semiconducting form in HCl solution. Thermal conversion of PPV was performed at low temperatures with the substitution of the counter-ion Cl in the PPV precursor by a long sulfonic chain, the dodecylbenzenesulfonate (DBS) ion. The optical properties of PPV films converted in this way are not affected by POMA, which can be used as transparent electrode of PPV luminescent devices.

Synthesis and NMR characterization of aliphatic-aromatic copolyesters by reaction of poly(ethylene terephthalate) post-consumer and poly(ethylene adipate)

An aliphatic-aromatic copolyester of poly(ethylene terephthalate), PET, and poly(ethylene adipate), PEA, PET-co-PEA, was synthesized by the high temperature melt reaction of post-consumer PET and PEA. As observed by NMR spectroscopy, the reaction yielded random copolyesters in a few minutes through ester-interchange reactions, even without added catalyst. The copolyesters obtained in the presence of a catalyst presented higher intrinsic viscosity than that obtained without the addition of catalyst, due to simultaneous polycondensation and ester-interchange reactions. The structure of the aliphatic-aromatic copolyesters obtained in different PET/PEA ratio is random as observed by NMR analysis.

Micro- and nanostructuring of poly(ethylene-2,6-naphthalate) surfaces, for biomedical applications, using polymer replication techniques

Here we investigate the formation of superficial micro- and nanostructures in poly(ethylene-2,6-naphthalate) (PEN), with a view to their use in biomedical device applications, and compare its performance with a polymer commonly used for the fabrication of these devices, poly(methyl methacrylate) (PMMA). The PEN is found to replicate both micro- and nanostructures in its surface, albeit requiring more forceful replication conditions than PMMA, producing a slight increase in surface hydrophilicity. This ability to form micro/nanostructures, allied to biocompatibility and good optical transparency, suggests that PEN could be a useful material for production of, or for incorporation into, transparent devices for biomedical applications. Such devices will be able to be autoclaved, due to the polymer's high temperature stability, and will be useful for applications where forceful experimental conditions are required, due to a superior chemical resistance over PMMA.

Is it possible to utilize VIX for a profitable trading strategy of S&P 500 Index?

The goal of this research was to make an overall sight to VIX® and how it can be used as a stock market indicator. Volatility index often referred as the fear index, measures how much it costs for investor to protect his/her S&P 500 position from fluctuations with options. Over the relatively short history of VIX it has been a successful timing coordinator and it has given incremental information about the market state adding its own psychological view of the amount of fear and greed. Correctly utilized VIX information gives a considerable advantage in timing market actions. In this paper we test how VIX works as a leading indicator of broad stock market index such as S&P 500 (SPX). The purpose of this paper is to find a working way to interpret VIX. The various tests are made on time series data ranging from the year 1990 to the year 2010. The 10-day simple moving average strategy gave significant profits from the whole time when VIX data is available. Strategy was able to utilize the increases of SPX in example portfolio value and was able to step aside when SPX was declining. At the times when portfolio was aside of S it was on safety fund like on treasury bills getting an annual yield of 3 percent. On the other side just a static number’s of VIX did not work as indicators in a profit making way.

Influence of vinasse application in hydraulic conductivity of three soils

The potassium ion, present in great amount in the vinasse because it is a monovalent cation, has the characteristic of promoting the dispersion of clay particles, in the same way as the sodium, causing a reduction in the pore space of the soil and, in its turn, reducing its permeability. To evaluate this effect of reduction by application of vinasse to the soil, an experiment was conducted for three different soils, with the objective of evaluating the effect of the application of different doses of vinasse on hydraulic conductivity of saturated soil and verifying its possible chemical changes of these soils. For that, it was used PVC columns (in a scheme of constant head permeameter to obtain the values of hydraulic conductivity of saturated soil), filled with three soils - Dark Red Latosol (DRL), Purple Latosol (PL) and Eutrophic Red Nitossol (ERN) - , in which were applied four doses of vinasse (0, 150, 300 and 450m³ ha-1), distributed in a completely randomized design with a 3x4 factorial scheme with three replications. The results evidenced that only the Dark Red Latosol (DRL) showed a reduction in the values of hydraulic conductivity of saturated soil, and in front of the application of vinasse, up to 300m³ ha-1, it was observed an increase in the concentrations of potassium, calcium and cation exchange capacity (CEC) ions.

Concentration of injetion solution and its effects on soil and on yield of fertirrigated banana cv. Terra Maranhão

The Fertigation is the combined application of water and nutrients to a crop. It can be adapted to all types of agricultural crops. The objective of this study was to evaluate the effect of urea concentration in irrigation water on electrical conductivity of the soil solution and saturation extract along the first cycle of banana cv. Terra Maranhão. The experiment followed a completely randomized design with six treatments and ten replications. Treatments regarded for using three urea concentrations (1.0; 2.5 and 4.0 g L-1) in irrigation water applied by two micro irrigation systems (microsprinkler and drip). Results showed that there was a linear elevation of electrical conductivity of saturation extract and soil solution with the increase on concentration of urea in the injection solution. Urea should be used under concentrations up to 2.5 g L-1 in irrigation water without causing increase on electric conductivity of soil solution and saturation extract, considering 1.1 dS m-1 as the tolerated value for the crop. Nitrate in the soil solution increased significantly with the increase of urea concentration in the injection solution. The maximum concentration of nitrate in the soil occurred for 4,0 g L-1 concentration of the injection solution.

Cellular immune response of Curraleiro Pé-duro and Nellore calves following Mycobacterium bovis-BCG vaccination

The present study aimed to assess the CD4, CD8 and γδ blood levels for Curraleiro Pé-duro, as well as the specific IFN-γ response after BCG vaccination using flow cytometry. The specific immune response against BCG was also evaluated by tuberculin skin test, performed before and 45 days after the vaccination. For comparison purposes, the same parameters were investigated on Nellore calves, an exotic bovine with resistance previously demonstrated. Naturally, Curraleiro Pé-duro animals had greater levels of CD4, CD8 and γδ lymphocytes (p<0.05). In response to vaccine, Curraleiro Pé-duro showed greater ability to respond specifically to BCG, generating resistance profile (Th1), evidenced by greater number of antigen specific CD4+ cells producing IFN-γ (p<0.05) and also higher tuberculin skin test reaction (p<0.05). Additionally, vaccinated Curraleiro Pé-duro calves had higher CD4 cells numbers than both Nellore control (p<0.05) and vaccinated groups (p<0.05). Curraleiro Pé-duro calves' higher basal lymphocytes blood level and stronger response in both IFN-γ and tuberculin skin test parameters probably play a positive role on protection/resistance to Mycobacterium bovis.

Long-lasting mnemotropic effect of substance P and its N-terminal fragment (SP1-7) on avoidance learning

We investigated the long-lasting effect of peripheral injection of the neuropeptide substance P (SP) and of some N- or C-terminal SP fragments (SPN and SPC, respectively) on retention test performance of avoidance learning. Male Wistar rats (220 to 280 g) were trained in an inhibitory step-down avoidance task and tested 24 h or 21 days later. Immediately after the training trial rats received an intraperitoneal injection of SP (50 µg/kg), SPN 1-7 (167 µg/kg) or SPC 7-11 (134 µg/kg). Control groups were injected with vehicle or SP 5 h after the training trial. The immediate post-training administration of SP and SPN, but not SPC, facilitated avoidance behavior in rats tested 24 h or 21 days later, i.e., the retention test latencies of the SP and SPN groups were significantly longer (P<0.05, Mann-Whitney U-test) during both training-test intervals. These observations suggest that the memory-enhancing effect of SP is long-lasting and that the amino acid sequence responsible for this effect is encoded by its N-terminal part

Bradykinin enhances membrane electrical activity of pancreatic beta cells in the presence of low glucose concentrations

In most of cells bradykinin (BK) induces intracellular calcium mobilization. In pancreatic beta cells intracellular calcium is a major signal for insulin secretion. In these cells, glucose metabolism yields intracellular ATP which blocks membrane potassium channels. The membrane depolarizes, voltage-dependent Ca2+ channels are activated and the intracellular calcium load allows insulin secretion. Repolarization occurs due to activation of the Ca2+-dependent K+ channel. The insulin secretion depends on the integrity of this oscillatory process (bursts). Therefore, we decided to determine whether BK (100 nM) induces bursts in the presence of a non-stimulatory glucose concentration (5.6 mM). During continuous membrane voltage recording, our results showed that bursts were obtained with 11 mM glucose, blocked with 5.6 mM glucose and recovered with 5.6 mM glucose plus 100 nM BK. Thus, the stimulatory process obtained in the presence of BK and of a non-stimulatory concentration of glucose in the present study suggests that BK may facilitate the action of glucose on beta cell secretion.

Comparative sequence analysis of the P-, M- and L-coding region of the measles virus CAM-70 live attenuated vaccine strain

Measles virus is a highly contagious agent which causes a major health problem in developing countries. The viral genomic RNA is single-stranded, nonsegmented and of negative polarity. Many live attenuated vaccines for measles virus have been developed using either the prototype Edmonston strain or other locally isolated measles strains. Despite the diverse geographic origins of the vaccine viruses and the different attenuation methods used, there was remarkable sequence similarity of H, F and N genes among all vaccine strains. CAM-70 is a Japanese measles attenuated vaccine strain widely used in Brazilian children and produced by Bio-Manguinhos since 1982. Previous studies have characterized this vaccine biologically and genomically. Nevertheless, only the F, H and N genes have been sequenced. In the present study we have sequenced the remaining P, M and L genes (approximately 1.6, 1.4 and 6.5 kb, respectively) to complete the genomic characterization of CAM-70 and to assess the extent of genetic relationship between CAM-70 and other current vaccines. These genes were amplified using long-range or standard RT-PCR techniques, and the cDNA was cloned and automatically sequenced using the dideoxy chain-termination method. The sequence analysis comparing previously sequenced genotype A strains with the CAM-70 Bio-Manguinhos strain showed a low divergence among them. However, the CAM-70 strains (CAM-70 Bio-Manguinhos and a recently sequenced CAM-70 submaster seed strain) were assigned to a specific group by phylogenetic analysis using the neighbor-joining method. Information about our product at the genomic level is important for monitoring vaccination campaigns and for future studies of measles virus attenuation.