A linearly tunable low-voltage CMOS transconductor with improved common-mode stability and its application to (gm)-C filters

A linearly tunable low-voltage CMOS transconductor featuring a new adaptative-bias mechanism that considerably improves the stability of the processed-signal common,mode voltage over the tuning range, critical for very-low voltage applications, is introduced. It embeds a feedback loop that holds input devices on triode region while boosting the output resistance. Analysis of the integrator frequency response gives an insight into the location of secondary poles and zeros as function of design parameters. A third-order low-pass Cauer filter employing the proposed transconductor was designed and integrated on a 0.8-mum n-well CMOS standard process. For a 1.8-V supply, filter characterization revealed f(p) = 0.93 MHz, f(s) = 1.82 MHz, A(min) = 44.08, dB, and A(max) = 0.64 dB at nominal tuning. Mined by a de voltage V-TUNE, the filter bandwidth was linearly adjusted at a rate of 11.48 kHz/mV over nearly one frequency decade. A maximum 13-mV deviation on the common-mode voltage at the filter output was measured over the interval 25 mV less than or equal to V-TUNE less than or equal to 200 mV. For V-out = 300 mV(pp) and V-TUNE = 100 mV, THD was -55.4 dB. Noise spectral density was 0.84 muV/Hz(1/2) @1 kHz and S/N = 41 dB @ V-out = 300 mV(pp) and 1-MHz bandwidth. Idle power consumption was 1.73 mW @V-TUNE = 100 mV. A tradeoff between dynamic range, bandwidth, power consumption, and chip area has then been achieved.

A stochastic shift model for economically designed charts constrained by the process stage configuration

An economic model including the labor resource and the process stage configuration is proposed to design g charts allowing for all the design parameters to be varied in an adaptive way. A random shift size is considered during the economic design selection. The results obtained for a benchmark of 64 process stage scenarios show that the activities configuration and some process operating parameters influence the selection of the best control chart strategy: to model the random shift size, its exact distribution can be approximately fitted by a discrete distribution obtained from a relatively small sample of historical data. However, an accurate estimation of the inspection costs associated to the SPC activities is far from being achieved. An illustrative example shows the implementation of the proposed economic model in a real industrial case. (C) 2011 Elsevier B.V. All rights reserved.

Chemical process to separate iron oxides particles in pottery sample for EPR dating

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Stable colloidal suspensions of nanostructured zirconium oxide synthesized by hydrothermal process

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

On designing OTA-C graphic-equalizers with MOSFET-triode transconductors

A CMOS audio-equalizer based on a parallel-array of 2nd-order bandpass-sections is presented and realized with triode transconductors. It has a programmable 12db-boost/cut on each of its three decade-bands, easily achieved through the linear dependence of gm on VDS. In accordance with a 0.8μm n-well double-metal fabrication process, a range of simulations supports theoretical analysis and circuit performance at different boost/cut scenarios. For VDD=3.3V, fullboosting stand-by prover consumption is 1.05mW. THD=-42.61dB@1Vpp and may be improved by balanced structures. Thermal- and I/f-noise spectral densities are 3.2μV/Hz12 and 18.2μV/Hz12@20Hz, respectively, for a dynamic range of 52.3dB@1Vpp. The equalizer effective area is 2.4mm2. The drawback of the existing transmission-zero due to the feedthrough-capacitance of a triode input-device is also addressed. The proposed topology can be extended to the design of more complex graphic-equalizers and hearing-aids.

Biomass fire consumption and carbon release rates of rainforest-clearing experiments conducted in northern Mato Grosso, Brazil

Biomass consumption and carbon release rates during the process of forest clearing by fire in five test plots are presented and discussed. The experiments were conducted at the Caiabi Farm near the town of Alta Floresta, state of Mato Grosso, Brazil, in five square plots of 1 ha each designated A, B, C, D, and E, with different locations and timing of fire. Plot A was located in the interface with a pasture, with three edges bordering on the forest, and was cut and burned in 1997. Plots B,C, D, and E were located inside the forest. Plot B was cut and burned in 1997. Plot C was inside a deforested 9-ha area, which was cut and burned in 1998. Plot D was inside a deforested 4-ha area, which was cut in 1998 and burned in 1999. Plot E was inside a deforested 4-ha area which was cut and burned in 1999. Biomass consumption was 22.7%, 19.5%, 47.5%, 61.5% and 41.8%, for A, B, C, D, and E, respectively. The effects of an extended curing period and of increasing the deforested area surrounding the plots could be clearly observed. The consumption for areas cut and burned during the same year, tended toward a value of nearly 50% when presented as a function of the total area burned. The aboveground biomass of the test site and the amount of carbon before the fire were 496 Mg ha-1 and 138 Mg ha-1, respectively. Considering that the biomass that remains unburned keeps about the same average carbon content of fresh biomass, which is supported by the fact that the unburned material consists mainly of large logs and considering the value of 50% for consumption, the amount of carbon released to the atmosphere as gases was 69 Mg ha-1. The amounts of CO2 and CO released to the atmosphere by the burning process were then estimated as 228 Mg ha-1 and 15.9 Mg ha-1, respectively. Observations on fire propagation and general features of the slash burnings in the test areas complete the paper. Copyright 2001 by the American Geophysical Union.

Structural and electrical properties of strontium barium niobate thin films crystallized by conventional furnace and rapid-thermal annealing process

Strontium barium niobate (SBN) thin films were crystallized by conventional electric furnace annealing and by rapid-thermal annealing (RTA) at different temperatures. The average grain size of films was 70 nm and thickness around 500 nm. Using x-ray diffraction, we identified the presence of polycrystalline SBN phase for films annealed from 500 to 700 °C in both cases. Phases such as SrNb2O6 and BaNb2O6 were predominantly crystallized in films annealed at 500 °C, disappearing at higher temperatures. Dielectric and ferroelectric parameters obtained from films crystallized by conventional furnace and RTA presented essentially the same values.

A tobacco cDNA reveals two different transcription patterns in vegetative and reproductive organs

In order to identify genes expressed in the pistil that may have a role in the reproduction process, we have established an expressed sequence tags project to randomly sequence clones from a Nicotiana tabacum stigma/style cDNA library. A cDNA clone (MTL-8) showing high sequence similarity to genes encoding glycine-rich RNA-binding proteins was chosen for further characterization. Based on the extensive identity of MTL-8 to the RGP-1a sequence of N. sylvestris, a primer was defined to extend the 5′ sequence of MTL-8 by RT-PCR from stigma/style RNAs. The amplification product was sequenced and it was confirmed that MTL-8 corresponds to an mRNA encoding a glycine-rich RNA-binding protein. Two transcripts of different sizes and expression patterns were identified when the MTL-8 cDNA insert was used as a probe in RNA blots. The largest is 1,100 nucleotides (nt) long and markedly predominant in ovaries. The smaller transcript, with 600 nt, is ubiquitous to the vegetative and reproductive organs analyzed (roots, stems, leaves, sepals, petals, stamens, stigmas/styles and ovaries). Plants submitted to stress (wounding, virus infection and ethylene treatment) presented an increased level of the 600-nt transcript in leaves, especially after tobacco necrosis virus infection. In contrast, the level of the 1,100-nt transcript seems to be unaffected by the stress conditions tested. Results of Southern blot experiments have suggested that MTL-8 is present in one or two copies in the tobacco genome. Our results suggest that the shorter transcript is related to stress while the larger one is a flower predominant and nonstress-inducible messenger.

In-process grinding monitoring through acoustic emission

This work aims to investigate the efficiency of digital signal processing tools of acoustic emission signals in order to detect thermal damages in grinding processes. To accomplish such a goal, an experimental work was carried out for 15 runs in a surface grinding machine operating with an aluminum oxide grinding wheel and ABNT 1045 Steel as work material. The acoustic emission signals were acquired from a fixed sensor placed on the workpiece holder. A high sampling rate data acquisition system working at 2.5 MHz was used to collect the raw acoustic emission instead of the root mean square value usually employed. Many statistical analyses have shown to be effective to detect burn, such as the root mean square (RMS), correlation of the AE, constant false alarm rate (CFAR), ratio of power (ROP) and mean-value deviance (MVD). However, the CFAR, ROP, Kurtosis and correlation of the AE have been presented more sensitive than the RMS. Copyright © 2006 by ABCM.

Barbados: public-private sector partnership

Includes bibliography

Environmental value, valuation methods, and natural disaster damage assessment

Includes bibliography

An Educational international partnership responding to local needs: Process evaluation of the Brazil FAIMER Regional Institute

The Brazilian public health system requires competent professionals sensitive to the needs of the population. The Foundation for Advancement of International Medical Education and Research (FAIMER) provides a two-year faculty development programme for health professions educators, aiming to build leadership in education to improve health. A partnership with governmental initiatives and FAIMER was established for meeting these needs. This paper describes the initial process evaluation results of the Brazilian FAIMER Institute Fellowship (FAIMER BR). Methods: Data were analysed for the classes 2007-2010 regarding: application processes; innovation project themes; retrospective post-pre self-ratings of knowledge acquisition; and professional development portfolios. Results: Seventeen of 26 Brazilian states were represented among 98 Fellows, predominantly from public medical schools (75.5%) and schools awarded Ministry of Health grants to align education with public health services (89.8%). One-third (n = 32) of Fellows' innovation projects were related to these grants. Significant increases occurred in all topic subscales on self-report of knowledge acquisition (eff ect sizes, 1.21-2.77). In the follow up questionnaire, 63% of Fellows reported that their projects were incorporated into the curriculum or institutional policies. The majority reported that the programme deepened their knowledge (98%), provided new ideas about medical education (90%) and provided skills for conflict management (63%). One-half of the Fellows reported sustained benefits from the programme listserv and other communications, including breadth of expertise, establishment of research collaboration and receiving emotional support. Conclusion: Contributors to initial programme success included alignment of curriculum with governmental initiatives, curriculum design merging educational technology, leadership and management skills and central role of an innovation educational project responding to local needs.

Alignment of operations strategy: Exploring the marketing interface

Purpose - The purpose of this paper is to identify factors that can help managers to overcome barriers to alignment of operations strategy at the interface with marketing. Design/methodology/approach - This objective required the application of a procedure based on strategic consensus and a deeper analysis, such that the delimitation of the study in a single case was mandatory. The strategic processes of interfacing involve managerial attributes that are subject to the influence of human aspects and, therefore, the research method used a qualitative approach. The protocol design included the following data sources: interviews, document reviews and researcher observations. The categorisation was made based on the theoretical references, the frequency of observations, common responses and information from documents. Findings - The balance between intra-functional trade-offs, joint research on the competitive context, reflections on the understanding of customer needs and operational performance, and understanding of inter-functional trade-offs were the main factors verified. They effectively support decisions associated with interface processes and promotes the integration of these processes. They can generate inputs that enable managers to achieve an appropriate balance among alternatives in light of various trade-offs. Practical implications - These factors make possible new connections between strategic processes in the context of operations and marketing functions. The formations of these strategies are aligned through a better understanding of both threats and opportunities by means of a joint analysis of the competitive context. The presented findings can be used to develop a clear definition of strategic objectives of operations and a more appropriate treatment of market needs. Originality/value - The findings from the research can be considered as new elements for promoting alignment in the formation process of the operations strategy. Little research to date has examined the operations-marketing strategic interface of companies in the context of strategic consensus. © Emerald Group Publishing Limited.

Istmo Centroamericano: estadísticas del subsector eléctrico (datos actualizados a 2001)

Incluye Bibliografía

Relação C/N e proporção de fontes nitrogenadas na produtividade de Agaricus blazei Murrill e poder calorífico do composto

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)