Composition of matrix glasses and melt inclusions of fallout tephra from ODP Hole 125-782A

We studied the systematics of Cl, F and H2O in Izu arc front volcanic rocks using basaltic through rhyolitic glass shards and melt inclusions (Izu glasses) from Oligocene to Quaternary distal fallout tephra. These glasses are low-K basalts to rhyolites that are equivalent to the Quaternary lavas of the Izu arc front (Izu VF). Most of the Izu glasses have Cl ~400-4000 ppm and F ~70-400 ppm (normal-group glasses). Rare andesitic melt inclusions (halogen-rich andesites; HRA) have very high abundances of Cl (~6600-8600 ppm) and F (~780-910 ppm), but their contents of incompatible large ion lithophile elements (LILE) are similar to the normal-group glasses. The preeruptive H2O of basalt to andesite melt inclusions in plagioclase is estimated to range from ~2 to ~10 wt% H2O. The Izu magmas should be undersaturated in H2O and the halogens at their preferred levels of crystallization in the middle to lower crust (~3 to ~11 kbar, ~820° to ~1200°C). A substantial portion of the original H2O is lost due to degassing during the final ascent to surface. By contrast, halogen loss is minor, except for loss of Cl from siliceous dacitic and rhyolitic compositions. The behavior of Cl, F and H2O in undegassed melts resembles the fluid mobile LILE (e.g.; K, Rb, Cs, Ba, U, Pb, Li). Most of the Cl (>99%), H2O (>95%) and F (>53%) in the Izu VF melts appear to originate from the subducting slab. At arc front depths, the slab fluid contains Cl = 0.94+/-0.25 wt%, F = 990+/-270 ppm and H2O = 25+/-7 wt%. If the subducting sediment and the altered basaltic crust were the only slab sources, then the subducted Cl appears to be almost entirely recycled at the Izu arc (~77-129%). Conversely, H2O (~13-22% recycled at arc) and F (~4-6% recycled) must be either lost during shallow subduction or retained in the slab to greater depths. If a seawater-impregnated serpentinite layer below the basaltic crust were an additional source of Cl and H2O, the calculated percentage of Cl and H2O recycled at arc would be lower. Extrapolating the Izu data to the total length of global arcs (~37000 km), the global arc outflux of fluid-recycled Cl and H2O at subduction zones amounts to Cl ~2.9-3.8 mln ton/yr and H2O ~70-100 mln ton/yr, respectively - comparable to previous estimates. Further, we obtain a first estimate of global arc outflux of fluid-recycled F of ~0.3-0.4 mln ton/yr. Despite the inherent uncertainties, our results support models suggesting that the slab becomes strongly depleted in Cl and H2O in subduction zones. In contrast, much of the subducted F appears to be returned to the deep mantle, implying efficient fractionation of Cl and H2O from F during the subduction process. However, if slab devolatilization produces slab fluids with high Cl/F (~9.5), slab melting will still produce components with low Cl/F ratios (~0.9), similar to those characteristic of the upper continental crust (Cl/F ~0.3-0.9).

Lead 210 concentrations in sediments of the Arabian Sea

In order to evaluate bioturbation in abyssal Arabian-Sea sediments of the Indus fan profiles of 210Pb (half-life: 22.3 yr) and 234Th (half-life: 24.1 d) were measured in cores collected during September and October 1995 and April 1997, respectively. The density and composition of epibenthic megafauna and lebensspuren were determined in vertical seafloor photographs during April 1997. Mean eddy-diffusive mixing coefficients according to the distribution of excess 210Pb ( 210Pb-DB) were 0.072±0.028, 0.068±0.055, 0.373±0.119, 0.037±0.009 and 0.079±0.119 cm**2 yr**-1 in the northern, western, central, eastern and southern abyssal Arabian sea, respectively. Mean eddy-diffusive mixing coefficients according to the distribution of excess 234Th (234Th-DB) were 0.53, 1.64 and 0.47 cm**2 yr**-1 in the northern, western and central abyssal Arabian Sea, respectively. Mobile epibenthic megafauna at the western, northern, central and southern study sites were dominated by ophiuroids, holothurians, ophiuroids and natant decapods (the respective densities were 100, 82, 29 and 6 individuals 1000 m**-2). The northern study site was characterized by a high abundance of spoke traces and fecal casts. The central site showed spoke traces and many tracks. The southern site displayed the highest abundance of spoke traces, whereas at the western site hardly any lebensspuren were observed. There is evidence for at least two functional endmember communities in the Arabian Sea. In the northwestern Arabian Sea (WAST) vertical particle displacement seems to be dominated by macrofauna and primarily eddy-diffusive. In the southern Arabian Sea (SAST) non-local and 'incidental' mixing due to spoke-trace producers might become more important and superimpose reduced eddy-diffusive mixing. With respect to biological data CAST is an intermediate location. Given the biological data, average 210Pb-DB is higher and decimeter-scale variability of 210Pb-DB smaller at CAST than expected. These findings indicate that in a mixture of both endmember communities the organisms may interact in way that increases values of biodiffusivity, as reflected by 210Pb-DB, and reduces decimeter-scale 210Pb-DB heterogeneity in comparison to the simple sum of the isolated effects of the endmembers. For time scales <100 years there was no evidence for a relationship between food supply (POC flux) and bioturbation intensity, as reflected by 210Pb-DB and 234Th-DB. Bioturbation intensity should be controlled primarily by the composition of the benthic fauna, its specific adaptation to the environmental setting, and the abundance of each species of the benthic community. Food supply can have only an indirect influence on bioturbation intensity. In certain parts of the ocean the a priori overall positive relationship between POC flux and biodiffusivity might include restricted intervals displaying no or even negative relations.

(Table 1) Lead isotopic compositions of basalts from DSDP Hole 81-553

The passive continental margin south-west of Rockall Plateau is characterized by a thick sequence of oceanward-dipping seismic reflectors. During Leg 81 of the Deep Sea Drilling Project, these reflectors were sampled at Site 553 and proved to consist almost exclusively of basalt. Here we present lead isotope data which indicate that these basalts may have been contaminated by ancient uranium-depleted continental crust, or alternatively, derived from a sub-continental lithospheric mantle source. In either case, the implications are that the basalts of the south-west Rockall Plateau formed by eruption through and onto continental basement, not by 'subaerial seafloor spreading'. This conclusion is in accord with gravity models of the area, which predict stretched continental crust beneath the dipping reflector sequence.

Lead and cadmium in the Weser Estuary and the German Bight: Correlations between bacteria populations, heavy metals and organic carbon

Organic carbon, lead and cadmium contents of 20 sediments were determined and compared with the colony counts of anaerobic heterotrophic, anaerobic nitrogen fixing, chitinoclastic and cellulolytic bacteria. Organic carbon content, which is dependent on the sediment type, was positively correlated with lead and cadmium as well as with colony counts of all 4 physiological groups of bacteria. Even the sediments with the highest concentrations of 251.7 ppm Pb and 3.1 ppm Cd showed no reduction in their colony counts. From 2 different sediment sampIes with lead contents of 140 ppm and 21 ppm lead tolerance of the aerobic heterotrophic bacteria was investigated. However, no significant difference in lead tolerance of the 2 heterotrophic populations was found. Water from 6 stations was analysed for dissolved and particulate organic carbon, lead and cadmium. Dissolved lead concentrations were in the range of 0.2-0.5 µg/l and the particulate lead contents were between 0.05 and 4.3 µg/l. The concentrations of total lead for the stations off-shore were only one order of magnitude from the concentrations of the near-shore stations. The same phenomenon was observed for dissolved cadmium (0.02 - 0.25 µg/l) and particulate cadmium (0.003 - 0.15 µg/I) concentrations. Correlations between dissolved (1.6 - 10.8 mg/I) and particulate organic carbon (0.25 - 1.53 mg/I) with dissolved and particulate lead or cadmium were not found.

Lead and strontium isotope composition, mass accumulation rates and rare earth elements of selected samples from DSDP Sites 92-597 to 92-601

Most of the Pb isotope data for the Leg 92 metalliferous sediments (carbonate-free fraction) form approximately linear arrays in the conventional isotopic plots, extending from the middle of the field for mid-ocean ridge basalts (MORB) toward the field for Mn nodules. These arrays are directed closely to the average values of Mn nodules, the composition of which reflects the Pb isotope composition of seawater (Reynolds and Dasch, 1971). Since the Leg 92 samples are almost devoid of continentally derived detritus, it can be inferred that the more radiogenic end-member is seawater. The less radiogenic end-member lies in the very middle of the MORB field, and hence can be considered to reflect the Pb isotope composition of typical ocean-ridge basalt. The array of data lying between these two end-members is most readily interpreted in terms of simple linear mixing of Pb from the two different end-member sources. According to this model, eight samples from Sites 599 to 601 contain 50 to 100% basaltic Pb. Five of these samples have compositions that are identical within the uncertainty of the analyses. We use the average of these five values to define our unradiogenic end-member in the linear mixing model. The ratios used for this average are 206Pb/204Pb = 18.425 ± 0.010; 207Pb/204Pb = 15.495 ± 0.018; 208Pb/204Pb = 37.879 ± 0.068. These values should approximate the average Pb isotope composition of discharging hydrothermal solutions, and therefore also that of the basaltic crust, over the period of time represented by these samples ( 4 m.y., from 4 to 8 Ma). Sr isotope ratios show a significant range of values, from 0.7082 to 0.7091. The lower ratios are well outside the value of 0.70910 ± 6 for modern-day seawater (Burke et al., 1982). However, most values correspond very closely to the curve of 87Sr/86Sr versus age for seawater, with older samples having progressively lower 87Sr/86Sr ratios. The simplest explanation for this progressive reduction is that recrystallization of the abundant biogenic carbonate in the sediments released older seawater Sr which was incorporated into ferromanganiferous phases during diagenesis. Leg 92 metalliferous sediments have total rare earth element (REE) contents that range on a carbonate-free basis from 131 to 301 ppm, with a clustering between 167 and 222 ppm. The patterns have strong negative Ce anomalies. Samples from Sites 599 to 601 display a slight but distinct enrichment in the heavy REE relative to the light REE, whereas those from Sites 597 to 598 show almost no heavy REE enrichment. The former patterns (those for Sites 599 to 601) are interpreted as indicating moderate diagenetic alteration of metalliferous sediments originating at the EPR axis; the latter reflect more complete diagenetic modification.

Geochemistry of sediments beneath the Tonga-Kermadec arc

The fate of subducted sediment and the extent to which it is dehydrated and/or melted before incorporation into arc lavas has profound implications for the thermo-mechanical nature of the mantle wedge and models for crustal evolution. In order to address these issues, we have undertaken the first measurements of 10Be and light elements in lavas from the Tonga-Kermadec arc and the sediment profile at DSDP site 204 outboard of the trench. The 10Be/9Be ratios in the Tonga lavas are lower than predicted from flux models but can be explained if (a) previously estimated sediment contributions are too high by a factor of 2-10, (b) the top 1-22 m of the incoming sediment is accreted, (c) large amounts of sediment erosion are proposed, or (d) the sediment component takes several Myr longer than the subducting plate to reach the magma source region beneath Tonga. The lavas form negative Th/Be-Li/Be arrays that extend from a depleted mantle source composition to lower Th/Be and Li/Be ratios than that of the bulk sediment. Thus, these arrays are not easily explained by bulk sediment addition and, using partition coefficients derived from experiments on the in-coming sediment, we show that they are also unlikely to result from fluid released during dehydration of the sediment (or altered oceanic crust). However, partial melts of the dehydrated sediment residue formed at ~800 °C during the breakdown of amphibole +/- plagioclase and in the absence of cordierite have significantly lowered Th/Be ratios. The lava arrays can be successfully modelled as 10-15% partial melts of depleted mantle after it has been enriched by the addition of 0.2-2% of these partial melts. Phase relations suggest that this requires that the top of the subducting crust reaches temperatures of ~800 °C by the time it attains ~ 80 km depth which is in excellent agreement with the results of recent numerical models incorporating a temperature-dependent mantle viscosity. Under these conditions the wet basalt solidus is also crossed yet there is no recognisable eclogitic signal in the lavas suggesting that on-going dehydration or strong thermal gradients in the upper part of the subducting plate inhibit partialmelting of the altered oceanic crust.

Lead in bottom sediments, nodules, and sulfides from the Black Sea

A study of lead distribution in recent, ancient Black Sea and Neweuxinian bottom sediment shows similar vertical distributions of the element in the oxygen and hydrogen sulfide zones of the sea; i.e. hydrogen sulfide contamination does not affect lead contents in bottom sediments of the sea. Lead distribution in sediment mass of the Black Sea reflects dependence of accumulation of the element on the hydrodynamic regime of the sea and forms of its migration. It is noted that absence of lead accumulation in Black Sea nodules results from specific nodule formation and from geochemical activity of the element. A large role of diagenetic sulfide formation in lead geochemistry is shown. Degree of lead accumulation in iron sulfides depends on conditions of sedimentation and on physical and chemical parameters in the sea.