Method to Improve the Conversion Gain Flatness of Transformer-Coupled Mixers

A 4-10 GHz, on-chip balun based current commutating mixer is proposed. Tunable resistive feedback is used at the transconductance stage for wideband response, and interlaced stacked transformer is adopted for good balance of the balun. Measurement results show that a conversion gain of 13.5 dB, an IIP3 of 4 dBm and a noise figure of 14 dB are achieved with 5.6 mW power consumption under 1.2 V supply. The simulated amplitude and phase imbalance is within 0.9 dB and ±2◦ over the band.

Detector for imaging and dosimetry of laser-driven epithermal neutrons by alpha conversion

An epithermal neutron imager based on detecting alpha particles created via boron neutron capture mechanism is discussed. The diagnostic mainly consists of a mm thick Boron Nitride (BN) sheet (as an alpha converter) in contact with a non-borated cellulose nitride film (LR115 type-II) detector. While the BN absorbs the neutrons in the thermal and epithermal ranges, the fast neutrons register insignificantly on the detector due to their low neutron capture and recoil cross-sections. The use of solid-state nuclear track detectors (SSNTD), unlike image plates, micro-channel plates and scintillators, provide safeguard from the x-rays, gamma-rays and electrons. The diagnostic was tested on a proof-of-principle basis, in front of a laser driven source of moderated neutrons, which suggests the potential of using this diagnostic (BN+SSNTD) for dosimetry and imaging applications.

An Empirical Analysis of Performance Impacts Resulting From Conversion to Franchise Operations

Franchising is an important form of organizational control. Possible benefits of franchising include its ability to reduce agency costs that increase with costly monitoring, and provide incentives for the use of local information by onsite managers. However, these benefits may come at a cost, as franchisees may reduce quality by choosing to free ride. While many studies have investigated the reasons for franchising, few studies have documented the impacts of franchising on unit level operating performance. Using time-series data from a number of lodging properties that were converted to franchisee control from company control, this study documents the performance impacts of franchising. The analysis reveals that conversion results in a modest decline in financial performance and an immediate sharp decline in quality.

Adsorption Calorimetry for Energy Conversion Technologies: Applications in Organic Photovoltaics, Catalysis, and Atomic Layer Deposition

Thesis (Ph.D.)--University of Washington, 2016-07

How much theory should be covered in an MSc conversion Course?

Abstract not available

Analyse comparée de l'efficacité des programmes de conversion de titres de dette en prise de participation en Argentine, au Chili et au Mexique comme solution partielle à leur niveau d'endettement critique

Cet ouvrage comporte d'abords une mise en situation décrivant le contexte économique qui mena à la crise du début des années 1980 et à la mise sur pieds de nouveaux mécanismes financiers visant le ré-équilibre des économies en difficulté. Parmi l'ensemble des nouveaux types de transactions, les conversions de titres de dette en prise de participation (Debt for Equity Swaps: DES) sont étudiées en particulier à cause des nombreux avantages qu'elles comportent. Dans un contexte de déséquilibres interne et externe graves tel ceux vécus par certains pays d'Amérique latine, ces conversions semblent en effet très appropriées grâce à leur contribution à réduire l'encours de la dette extérieure et à augmenter le niveau des investissements, tout en limitant les pertes des banques prêteuses. L'analyse des programmes DES de l'Argentine, du Chili et du Mexique est faite à trois niveaux: le comportement des principaux indicateurs économiques est observé avant et après la mise en application des programmes, les avantages que les investisseurs et les pays débiteurs ont pu tirer des transactions sont ensuite mesurés en termes monétaires, et finalement, une étude des clauses particulières à chaque programme permet de terminer l'étude de l'efficacité des démarches de chaque pays pour retrouver un certain équilibre économique. Chacun des trois pays étudiés a démontré une certaine force en particulier. L'Argentine est le pays qui a le mieux profité de la décote de sa dette sur le marché secondaire et ainsi réussit à réduire son encours avec des escomptes considérables. Le volume des transactions fut cependant minime. C'est le Chili qui a pu radier la plus forte proportion de sa dette totale grâce aux transactions DES. Finalement, le Mexique s'est démarqué par l'importance des avantages qu'il a offerts aux investisseurs lors de la conversion des titres. L'étude permet de conclure que les transactions DES ont en effet un potentiel très intéressant comme outil de redressement pour un pays ne pouvant plus assumer le niveau de sa dette, mais ce, à condition que la mise sur pieds des programmes coïncide avec une prise en charge globale des économies. Le succès d'un programme dépend en grande partie de la confiance des investisseurs internationaux et des banques en la volonté de chaque état à adopter les mesures d'ajustement qu'impose leur situation critique.

Algol 68 Dialect Conversion -- a Syntactic Approach

A syntax directed package for converting Revised Algol 68 programs into Algol 68-R form, (where possible) is being developed at Nottingham. The package makes use of J.M. Foster's Syntax Improving Device (SID) [1]. The experience gained has underlined the value of a syntactic approach to problems of this sort. A far wider range of constructs can be translated than would ever be possible by using ad hoc methods. In many respects the difficulties encountered are those of conventional compiler writing, but some intriguing new problems arise when, as in this case, the source language and target language differ relatively little in philosophy and appearance.

A Framework for Assessing the Reliability of Wind Energy Conversion Systems

During the last decade, wind power generation has seen rapid development. According to the U.S. Department of Energy, achieving 20\% wind power penetration in the U.S. by 2030 will require: (i) enhancement of the transmission infrastructure, (ii) improvement of reliability and operability of wind systems and (iii) increased U.S. manufacturing capacity of wind generation equipment. This research will concentrate on improvement of reliability and operability of wind energy conversion systems (WECSs). The increased penetration of wind energy into the grid imposes new operating conditions on power systems. This change requires development of an adequate reliability framework. This thesis proposes a framework for assessing WECS reliability in the face of external disturbances, e.g., grid faults and internal component faults. The framework is illustrated using a detailed model of type C WECS - doubly fed induction generator with corresponding deterministic and random variables in a simplified grid model. Fault parameters and performance requirements essential to reliability measurements are included in the simulation. The proposed framework allows a quantitative analysis of WECS designs; analysis of WECS control schemes, e.g., fault ride-through mechanisms; discovery of key parameters that influence overall WECS reliability; and computation of WECS reliability with respect to different grid codes/performance requirements.

Conversion of sub-tropical native vegetation to introduced conifer forest: Impacts on below-ground and above-ground carbon pools

Land-use change can have a major influence on soil organic carbon (SOC) and above-ground C pools. We assessed a change from native vegetation to introduced Pinus species plantations on C pools using eight paired sites. At each site we determined the impacts on 0–50 cm below-ground (SOC, charcoal C, organic matter C, particulate organic C, humic organic C, resistant organic C) and above-ground (litter, coarse woody debris, standing trees and woody understorey plants) C pools. In an analysis across the different study sites there was no significant difference (P > 0.05) in SOC or above-ground tree C stocks between paired native vegetation and pine plantations, although significant differences did exist at specific sites. SOC (calculated based on an equivalent soil mass basis) was higher in the pine plantations at two sites, higher in the native vegetation at two sites and did not differ for the other four sites. The site to site variation in SOC across the landscape was far greater than the variation observed with a change from native vegetation to introduced Pinus plantation. Differences between sites were not explained by soil type, although tree basal area was positively correlated with 0–50 cm SOC. In fact, in the native vegetation there was a significant linear relationship between above-ground biomass and SOC that explained 88.8% of the variation in the data. Fine litter C (0–25 mm diameter) tended to be higher in the pine forest than in the adjacent native vegetation and was significantly higher in the pine forest at five of the eight paired sites. Total litter C (0–100 mm diameter) increased significantly with plantation age (R2 = 0.64). Carbon stored in understorey woody plants (2.5–10 cm DBH) was higher in the native vegetation than in the adjacent pine forest. Total site C varied greatly across the study area from 58.8 Mg ha−1 at a native heathland site to 497.8 Mg ha−1 at a native eucalypt forest site. Our findings suggest that the effects of change from native vegetation to introduced Pinus sp. forest are highly site-specific and may be positive, negative, or have no influence on various C pools, depending on local site characteristics (e.g. plantation age and type of native vegetation).

Catherine Tekakwitha et la peinture missionnaire : stratégies de conversion en Nouvelle-France au 17e siècle

Pour respecter les droits d’auteur, la version électronique de ce mémoire a été dépouillée de certains documents visuels et audio-visuels. La version intégrale du mémoire a été déposée au Service de la gestion des documents et des archives de l'Université de Montréal

Solar Energy Conversion by Nanostructured TiO2

Research in solar energy conversion and the associated photoactive materials has attracted continuous interest. Due to its proper electronic band structure, high quantum efficiency, and photonic and chemical innerness, TiO2 has been demonstrated as a versatile oxide semiconductor capable of efficiently utilizing sunlight to produce electrical and chemical energy. Its outstanding physicochemical performances have led to an array of advanced photocatalytic and photoelectrochemical applications including environmental photocatalysis, dye/semiconductor-sensitized solar cell, and solar fuel productions.

Design and construction of a two dimensional duct equipped with a wave generator and a variable coastal slope and an ocean wave energy conversion system (OWC)

The aims of this thesis were evaluation the type of wave channel, wave current, and effect of some parameters on them and identification and comparison between types of wave maker in laboratory situations. In this study, designing and making of two dimension channels (flume) and wave maker for experiment son the marine buoy, marine building and energy conversion systems were also investigated. In current research, the physical relation between pump and pumpage and the designing of current making in flume were evaluated. The related calculation for steel building, channels beside glasses and also equations of wave maker plate movement, power of motor and absorb wave(co astal slope) were calculated. In continue of this study, the servo motor was designed and applied for moving of wave maker’s plate. One Ball Screw Leaner was used for having better movement mechanisms of equipment and convert of the around movement to linear movement. The Programmable Logic Controller (PLC) was also used for control of wave maker system. The studies were explained type of ocean energies and energy conversion systems. In another part of this research, the systems of energy resistance in special way of Oscillating Water Column (OWC) were explained and one sample model was designed and applied in hydrolic channel at the Sheikh Bahaii building in Azad University, Science and Research Branch. The dimensions of designed flume was considered at 16 1.98 0. 57 m which had ability to provide regular waves as well as irregular waves with little changing on the control system. The ability of making waves was evaluated in our designed channel and the results were showed that all of the calculation in designed flume was correct. The mean of error between our results and theory calculation was conducted 7%, which was showed the well result in this situation. With evaluating of designed OWC model and considering of changes in the some part of system, one bigger sample of this model can be used for designing the energy conversion system model. The obtained results showed that the best form for chamber in exit position of system, were zero degree (0) in angle for moving below part, forty and five (45) degree in front wall of system and the moving forward of front wall keep in two times of height of wave.