Grain yield components of pearl millet under optimum conditions can be used to identify germplasm with adaptation to and zones

There is evidence that high-tillering, small-panicled pearl millet landraces are better adapted to the severe, unpredictable drought stress of the and zones of NW India than are low-tillering, large-panicled modern varieties, which significantly outyield the landraces under favourable conditions. In this paper, we analyse the relationship of and zone adaptation with the expression, under optimum conditions, of yield components that determine either the potential sink size or the ability to realise this potential. The objective is to test whether selection under optimal conditions for yield components can identify germplasm with adaptation to and zones in NW India, as this could potentially improve the efficiency of pearl millet improvement programs targeting and zones. We use data from an evaluation of over 100 landraces from NW India, conducted for two seasons under both severely drought-stressed and favourable conditions in northwest and south India. Trial average grain yields ranged from 14 g m(-2) to 182 g m(-2). The landraces were grouped into clusters, based on their phenology and yield components as measured under well-watered conditions in south India. In environments without pre-flowering drought stress, tillering type had no effect on potential sink size, but low-tillering, large-panicled landraces yielded significantly more grain, as they were better able to realise their potential sink size. By contrast, in two low-yielding and zone environments which experienced pre-anthesis drought stress, low-fillering, large-panicled landraces yielded significantly less grain than high-tillering ones with comparable phenology, because of both a reduced potential sink size and a reduced ability to realise this potential. The results indicate that the high grain yield of low-tillering, large-panicled landraces under favourable conditions is due to improved partitioning, rather than resource capture. However, under severe stress with restricted assimilate supply, high-tillering, small-panicled landraces are better able to produce a reproductive sink than are large-panicled ones. Selection under optimum conditions for yield components representing a resource allocation pattern favouring high yield under severe drought stress, combined with a capability to increase grain yield if assimilates are available, was more effective than direct selection for grain yield in identifying germplasm adapted to and zones. Incorporating such selection in early generations of variety testing could reduce the reliance on random stress environments. This should improve the efficiency of millet breeding programs targeting and zones. (c) 2005 Elsevier B.V. All rights reserved.

Breeding Rice for Drought-Prone Environments

A large portion of the world’s poor farm in rainfed systems where the water supply is unpredictable and droughts are common. In Asia, about 50% of all the rice land is rainfed and, although rice yields in irrigated systems have doubled and tripled over the past 30 years, only modest gains have occurred in rainfed rice systems. In part, this is because of the difficulty in improving rice varieties for environments that are heterogeneous and variable, and in part because there has been little effort to breed rice for drought tolerance. Information available for other cereals (for example, maize, Bänziger et al 2000) and for wheat and the limited or circumstantial evidence available for rice indicate that we can now breed varieties that have improved yield under drought and produce high yields in the good seasons. This manual aims to help plant breeders develop such varieties. While the manual focuses on drought tolerance, this must be integrated with the mainstream breeding program that also deals with agronomic adaptation, grain quality, and pest and disease resistance. Mackill et al (1996) have written a guide to the overall improvement of rice for rainfed conditions. This manual should be seen as an amplification of and updating of the section on drought tolerance in that book. Because final proof of many approaches for breeding drought-tolerant rice is not yet available, and because some aspects may not work in all environments and germplasm, we recommend that you use this manual with caution. Test the suggested approaches and only implement them on a large scale if they are effective and realistic for your own situation

Trait physiology and crop modelling to link phenotypic complexity to underlying genetic systems

New tools derived from advances in molecular biology have not been widely adopted in plant breeding because of the inability to connect information at gene level to the phenotype in a manner that is useful for selection. We explore whether a crop growth and development modelling framework can link phenotype complexity to underlying genetic systems in a way that strengthens molecular breeding strategies. We use gene-to-phenotype simulation studies on sorghum to consider the value to marker-assisted selection of intrinsically stable QTLs that might be generated by physiological dissection of complex traits. The consequences on grain yield of genetic variation in four key adaptive traits – phenology, osmotic adjustment, transpiration efficiency, and staygreen – were simulated for a diverse set of environments by placing the known extent of genetic variation in the context of the physiological determinants framework of a crop growth and development model. It was assumed that the three to five genes associated with each trait, had two alleles per locus acting in an additive manner. The effects on average simulated yield, generated by differing combinations of positive alleles for the traits incorporated, varied with environment type. The full matrix of simulated phenotypes, which consisted of 547 location-season combinations and 4235 genotypic expression states, was analysed for genetic and environmental effects. The analysis was conducted in stages with gradually increased understanding of gene-to-phenotype relationships, which would arise from physiological dissection and modelling. It was found that environmental characterisation and physiological knowledge helped to explain and unravel gene and environment context dependencies. We simulated a marker-assisted selection (MAS) breeding strategy based on the analyses of gene effects. When marker scores were allocated based on the contribution of gene effects to yield in a single environment, there was a wide divergence in rate of yield gain over all environments with breeding cycle depending on the environment chosen for the QTL analysis. It was suggested that knowledge resulting from trait physiology and modelling would overcome this dependency by identifying stable QTLs. The improved predictive power would increase the utility of the QTLs in MAS. Developing and implementing this gene-to-phenotype capability in crop improvement requires enhanced attention to phenotyping, ecophysiological modelling, and validation studies to test the stability of candidate QTLs.

Developing high yielding wheat for water limited environments in northern Australia

A novel strategy linking physiology with plant breeding, molecular biology and computer simulation modelling is outlined here which aims to enhance selection of high yielding wheats with superior performance under conditions of water scarcity for the northern, subtropical, winter cereals region of Australia. In previous research, a source of high yield and performance under dry conditions for the target region was identified in a drought resistant parent. A large population of fixed lines for molecular genetic studies has been developed using the drought resistant line and widely grown current Australian variety. A preliminary study comparing the parent varieties was conducted in the winter of 2003. The two varieties were similar in many aspects of phenology, morphology and physiology. However, several important traits were identified that likely contribute to higher grain mass and yield of the drought resistant parent, including differences in the number and dry mass of tillers and spikes during development and the ability of drought resistant line to retain green leaves longer during grain filling.

Molecular breeding for rainfed lowland rice in the Mekong Region

In the past 20 years, the rice-breeding program in Thailand had little success in developing new cultivars to replace Kao Dawk Mali 105 (KDML105) and Kao Khor 6 (RD6). Main reason is a poor adoption of new cultivars by farmers due to poor adaptation of new cultivars to the rainfed environments, susceptibility to diseases and insect pests and unacceptable grain qualities. The conventional breeding program also takes at least 15 years for releasing new cultivars. New breeding strategy can be established to shorten period for cultivar improvement by using marker-assisted selection (MAS), rapid generations advance (RGA), early generation testing in multi-locations for grain yield and qualities. Four generation of MAS backcross breeding were conducted to transfer gene and QTL for bacterial blight resistance (BLB), submergence tolerance (SUB), brown planthopper resistance (BPH) and blast resistance (BL) into KDML105. Selected backcross lines, introgressed with target gene/QTL, were tolerant to SUB and resistant to BLB, BPH and BL. The agronomic performance and grain quality of these lines were as good as or better than KDML105.

Improving drought tolerance in rainfed lowland rice: an example from Thailand

A large portion of the world’s poor farm in rainfed systems where the water supply is unpredictable and droughts are common. In Thailand there are approximately 6.2 million ha of rain fed lowland rice which account for 67% of the country’s total rice-growing area. This rice system is often characterised by too much and too little water in the same season. Farmers’ estimates of their annual losses to drought are as high as 45% in the upper parts of the toposequence. In contrast to irrigated rice systems, gains from crop improvement of rainfed rice have been modest, in part because there has been little effort to breed and select for drought tolerance for the target rainfed environments. The crop improvement strategy being used in Thailand considers three mechanisms that influence yield in the drought prone targets: yield potential as an important mechanism for mild drought (where yield loss is less than 50%), drought escape (appropriate phenology) and drought tolerance traits of leaf water potential, sterility, flower delay and drought response index for more severe drought conditions. Genotypes are exposed to managed drought environments for selection of drought tolerant genotypes. A marker assisted selection (MAS) scheme has been developed and applied for selection of progenies in the backcrossing program. The plant breeding program uses rapid generation advance techniques that enable early yield testing in the target population of environments (TPE) through inter-station (multi-location yield testing) and on-farm trials. A farmer participatory approach has been used to identify the TPE for the breeding program. Four terrace paddy levels have been identified, upper (drought), middle (drought prone to favorable) and lower (flooded). This paper reports the change in the breeding program for the drought prone rainfed lowland rice environments of North and Northeast Thailand by incorporating our knowledge on adaptation and on response of rice to drought.