Elemental and stable isotopic composition of some metalliferous and pelagic sediments at DSDP Leg 70 Holes

Nontronite, the main metalliferous phase of the Galapagos mounds, occurs at subsurface depths of about 2 to 20 meters; Mn-oxide material is limited to the upper 2 meters of the mounds. The nontronite forms intervals of up to a few meters' thickness, consisting essentially of 100% nontronite granules, which alternate with intervals of normal pelagic sediment. Electron microprobe analyses of nontronite granules from different core samples indicate that: (1) there is little difference in major element composition between nontronites from varying locations within the mounds, with adjacent granules from a given sample having very similar compositions; (2) individual granules show little internal variation in composition. This indicates that the granules are composed of a single mineral of essentially constant composition, consistent with relatively uniform conditions of Eh and composition during nontronite formation. Mn-oxide crusts have very low Fe contents, a feature characteristic of rapidly deposited Mn-oxide crusts formed under hydrothermal influences. The rare-earth element (REE) abundances of the nontronites are generally extremely low, totalling less than several ppm. Two samples have the negatively Ce anomaly typical of authigenic precipitates formed relatively rapidly from seawater. A Mn-oxide crust sample has low REE contents, typical of Mn-oxide crusts formed under hydrothermal influences, but no negative Ce anomaly. A sample of unusual Mn-Fe-oxide mud has relatively high REE concentrations and a seawater-type pattern; both of these features are also found for metalliferous sediments from the East Pacific Rise. The oxygen and hydrogen isotopic composition of the nontronites define a restricted field within a d18O-dD plot. In manganiferous sediments, d18O and dD appear to decrease with increase in the Mn-oxide content of the sediment. From the d18O values of the nontronites, formation temperatures in the range of about 20-30°C have been estimated. By comparison, temperatures of up to 11.5 °C at a 9-meter depth have been directly measured within the mounds (Corliss et al., 1979), and heat-flow data suggest present basement/sediment interface temperatures of 15-25°C. In a plot of Fe + Mn vs. d18O, the Mn-oxide crust and Mn-Fe-ooze plot near the tie-lines for authigenic Mn nodules and silicate phases, implying that they have formed in isotopic equilibrium with seawater at or close to bottom-water temperatures.

Geochemistry of clinopyroxene megacrysts, xenocrysts, and phenocrysts in diabase dikes from ODP Hole 140-504B

We report the major, rare earth, and other trace element compositions of clinopyroxenes from two Leg 140, Hole 504B diabase dikes. These pyroxenes reflect a complex history of crystal growth and magma evolution. The large ranges of composition found reflect incorporation of exotic phenocrysts into the melt, the early formation of crystal clots before dike intrusion during an undercooling event, and in-situ fractionation of melt during and following dike emplacement. Some of the pyroxenes occur in coarse two- and three-phase glomerocrysts, which may be ôprotogabbrosö representing early stages of melt crystallization in the lower crust. Large variations in trace element composition are found. These likely reflect heterogeneous nucleation and growth of plagioclase and pyroxene in the melt, as well as complex interface kinetics that may affect partition coefficients during rapid crystal growth expected during undercooling. This can explain the formation of irregular chemical sector zoning in some equant anhedral phenocrysts. Undercooling of magmas in the lower crust most likely reflects input of fresh hot melt into a stagnating melt-storage zone. Dikes intruded upward from an inflated melt-storage zone during such a cycle are likely to be larger than those intruded from the storage zone between such cycles, when it would be deflated, consistent with the greater overall thickness of the phyric dikes in the Leg 140 section of Hole 504B.

Chemistry of phyllosilicates of ODP Hole 140-504B

Replacement minerals in olivine record the evolution of hydrothermal alteration between 1600 and 2000 mbsf in the sheeted dike complex in Hole 504B. 1. Talc (+ magnetite) rim on olivine represents the earliest alteration. Talc probably crystallized during initial cooling of the dikes. 2. The partial breakdown of talc to "deweylite", a chaotic mixture of serpentine and Al-free stevensite, was facilitated by further cooling and a somewhat increased fluid:rock interaction in the dikes. 3. The presence of chlorite veins and the replacement of unaltered olivine cores, talc, and deweylite and of other silicates by chlorite suggest fracturing of the rocks during cooling (shrinkage cracks) and local influx of seawater into the dikes. 4. Late amphibole veins and locally extensive amphibole alteration indicate increasing temperature and the development of new sets of fractures, possibly due to the injection of fresh magma. Several generations of chlorite and amphibole veins are present in the dikes. Offset veins and the crack-seal texture within veins in the dikes suggest that the alteration cycle was probably repeated with the injection of each set of new dikes. Presently measured temperatures (195°C) at 2000 m depth in Hole 504B indicate that deweylite, which was previously considered a low-temperature mineral, can form well above its previously estimated crystallization temperature of 50°C.