P-wave velocities of samples from the Penninic of the western Alps along NFP20-west seismic-reflection profiles

Using the transit pulse method, we have determined compressional wave velocities of rocks from various geological units belonging to the Penninic zone along the NFP20-West profiles of the Swiss western Alps. The velocities have been measured at confining pressures up to 400 MPa, along three orthogonal axes defined by the macrostructure of the rocks. The samples analysed show a degree of metamorphism ranging from greenschist to eclogite facies. This collection includes schists, dolomites, gneisses and ophiolitic rocks. The mean velocities range from 5.9 km/s for a quartzitic calcschist to 7.9 km/s for an eclogitic metagabbro. The velocity anisotropy is as high as 20 %. The range of acoustic impedance is wide, from 15 to 27 10(6) kg/m2s. From these measurements, normal incident reflection coefficients for likely rock assemblages within and between geological units were estimated in order to interpret zone of the strong reflections recorded along the seismic profiles. Reflection coefficients as high as 0.17 could be determined.

Optical evidence for the proximity to a spin-density-wave metallic state in Na0.7CoO2

We present the optical properties of Na0.7CoO2 single crystals, measured over a broad spectral range as a function of temperature (T). The capability to cover the energy range from the far-infrared up to the ultraviolet allows us to perform reliable Kramers-Kronig transformation, in order to obtain the absorption spectrum (i.e., the complex optical conductivity). To the complex optical conductivity we apply the generalized Drude model, extracting the frequency dependence of the scattering rate (Gamma) and effective mass (m*) of the itinerant charge carriers. We find that Gamma(omega) at low temperatures and for similar to omega. This suggests that Na0.7CoO2 is at the verge of a spin-density-wave metallic phase.

The IST METRA Project

This article summarizes the main achievementsof the Multi-Element Transmit andReceive Antennas (METRA) Project, an ISTresearch and technological development project carried out between January 2000 and June 2001 by Universitat Politècnica de Catalunya, the Center for Personkommunikation of Aalborg University, Nokia Networks, Nokia Mobile Phones, and Vodafone Group Research and Development.The main objective of METRA was the performanceevaluation of multi-antenna terminals incombination with adaptive antennas at the basestation in UMTS communication systems. 1 AMIMO channel sounder was developed that providedrealistic multi-antenna channel measurements.Using these measured data, stochasticchannel models were developed and properly validated.These models were also evaluated inorder to estimate their corresponding channelcapacity. Different MIMO configurations andprocessing schemes were developed for both theFDD and TDD modes of UTRA, and their linkperformance was assessed. Performance evaluationwas completed by system simulations thatillustrated the benefits of MIMO configurationsto the network operator. Implementation cost vs.performance improvement was also covered bythe project, including the base station and terminalmanufacturer and network operator viewpoints.Finally, significant standards contributionswere generated by the project and presented to the pertinent 3GPP working groups.

T-wave alternans predicts mortality in a population undergoing a clinically indicated exercise test.

Eur Heart J. 2007 Oct;28(19):2332-7. Epub 2007 Jul 25.

Computational Approach to the Study of Thermal Spin Crossover Phenomena

The key parameters associated to the thermally induced spin crossover process have been calculated for a series of Fe(II) complexes with mono-, bi-, and tridentate ligands. Combination of density functional theory calculations for the geometries and for normal vibrational modes, and highly correlated wave function methods for the energies, allows us to accurately compute the entropy variation associated to the spin transition and the zero-point corrected energy difference between the low- and high-spin states. From these values, the transition temperature, T 1/2, is estimated for different compounds.

Isentropic Exergy and Pressure of the Shock Wave Caused by the Explosion of a Pressure Vessel

An accidental burst of a pressure vessel is an uncontrollable and explosion-like batch process. In this study it is called an explosion. The destructive effectof a pressure vessel explosion is relative to the amount of energy released in it. However, in the field of pressure vessel safety, a mutual understanding concerning the definition of explosion energy has not yet been achieved. In this study the definition of isentropic exergy is presented. Isentropic exergy is the greatest possible destructive energy which can be obtained from a pressure vessel explosion when its state changes in an isentropic way from the initial to the final state. Finally, after the change process, the gas has similar pressure and flow velocity as the environment. Isentropic exergy differs from common exergy inthat the process is assumed to be isentropic and the final gas temperature usually differs from the ambient temperature. The explosion process is so fast that there is no time for the significant heat exchange needed for the common exergy.Therefore an explosion is better characterized by isentropic exergy. Isentropicexergy is a characteristic of a pressure vessel and it is simple to calculate. Isentropic exergy can be defined also for any thermodynamic system, such as the shock wave system developing around an exploding pressure vessel. At the beginning of the explosion process the shock wave system has the same isentropic exergyas the pressure vessel. When the system expands to the environment, its isentropic exergy decreases because of the increase of entropy in the shock wave. The shock wave system contains the pressure vessel gas and a growing amount of ambient gas. The destructive effect of the shock wave on the ambient structures decreases when its distance from the starting point increases. This arises firstly from the fact that the shock wave system is distributed to a larger space. Secondly, the increase of entropy in the shock waves reduces the amount of isentropic exergy. Equations concerning the change of isentropic exergy in shock waves are derived. By means of isentropic exergy and the known flow theories, equations illustrating the pressure of the shock wave as a function of distance are derived. Amethod is proposed as an application of the equations. The method is applicablefor all shapes of pressure vessels in general use, such as spheres, cylinders and tubes. The results of this method are compared to measurements made by various researchers and to accident reports on pressure vessel explosions. The test measurements are found to be analogous with the proposed method and the findings in the accident reports are not controversial to it.

Power spectral changes of the superimposed M wave during isometric voluntary contractions of increasing strength.

INTRODUCTION: We examined the power spectral changes of the compound muscle action potential (M wave) evoked during isometric contractions of increasing strength. METHODS: Surface electromyography (sEMG) of the vastus lateralis and medialis was recorded from 20 volunteers who performed 4-s step-wise isometric contractions of different intensities. A maximal M wave was elicited by a single stimulus to the femoral nerve and superimposed on the voluntary contractions. The spectral characteristics (Fmean and Fmedian) of sEMG and M-wave signals were calculated. RESULTS: M-wave spectral indicators increased systematically with contraction intensity up to 60% MVC and then leveled off at higher forces. Over the 10-60% MVC range, the increase in spectral indicators was 3 times higher for M waves (36%) than for sEMG (12%). CONCLUSIONS: The consistent increase in M-wave spectral characteristics with force is due to the fact that the number of motor units recruited by the superimposed supramaximal stimulus is approximately stable.

Impacts des technologies de l'information sur les modes de coordination à travers quatre études en systèmes d'information

L'évolution de l'environnement économique, des chaînes de valeur et des modèles d'affaires des organisations augmentent l'importance de la coordination, qui peut être définie comme la gestion des interdépendances entre des tâches réalisées par des acteurs différents et concourants à un objectif commun. De nombreux moyens sont mis en oeuvre au sein des organisations pour gérer ces interdépendances. A cet égard, les activités de coordination bénéficient massivement de l'appui des technologies de l'information et de communication (TIC) qui sont désormais disséminées, intégrées et connectées sous de multiples formes tant dans l'environnement privé que professionnel. Dans ce travail, nous avons investigué la question de recherche suivante : comment l'ubiquité et l'interconnec- tivité des TIC modifient-elles les modes de coordination ? A travers quatre études en systèmes d'information conduites selon une méthodologie design science, nous avons traité cette question à deux niveaux : celui de l'alignement stratégique entre les affaires et les systèmes d'information, où la coordination porte sur les interdépendances entre les activités ; et celui de la réalisation des activités, où la coordination porte sur les interdépendances des interactions individuelles. Au niveau stratégique, nous observons que l'ubiquité et l'interconnectivité permettent de transposer des mécanismes de coordination d'un domaine à un autre. En facilitant différentes formes de coprésence et de visibilité, elles augmentent aussi la proximité dans les situations de coordination asynchrone ou distante. Au niveau des activités, les TIC présentent un très fort potentiel de participation et de proximité pour les acteurs. De telles technologies leur donnent la possibilité d'établir les responsabilités, d'améliorer leur compréhension commune et de prévoir le déroulement et l'intégration des tâches. La contribution principale qui émerge de ces quatre études est que les praticiens peuvent utiliser l'ubiquité et l'interconnectivité des TIC pour permettre aux individus de communi-quer et d'ajuster leurs actions pour définir, atteindre et redéfinir les objectifs du travail commun. -- The evolution of the economic environment and of the value chains and business models of organizations increases the importance of coordination, which can be defined as the management of interdependences between tasks carried out by different actors and con-tributing to a common goal. In organizations, a considerable number of means are put into action in order to manage such interdependencies. In this regard, information and communication technologies (ICT), whose various forms are nowadays disseminated, integrated and connected in both private and professional environments, offer important support to coordination activities. In this work, we have investigated the following research question: how do the ubiquity and the interconnectivity of ICT modify coordination mechanisms? Throughout four information systems studies conducted according to a design science methodology, we have looked into this question at two different levels: the one of strategic alignment between business and information systems strategy, where coordination is about interdependencies between activities; and the one of tasks, where coordination is about interdependencies between individual interactions. At the strategic level, we observe that ubiquity and interconnectivity allow for transposing coordination mechanisms from one field to another. By facilitating various forms of copresence and visibility, they also increase proximity in asynchronous or distant coordination situations. At the tasks level, ICTs offer the actors a very high potential for participation and proximity. Such technologies make it possible to establish accountability, improve common understanding and anticipate the unfolding and integration of tasks. The main contribution emerging from these four studies is that practitioners can use the ubiquity and interconnectivity of ICT in order to allow individuals to communicate and adjust their actions to define, reach and redefine the goals of common work.

Properties of amorphous silicon thin films grown in square wave modulated silane rf discharges.

Hydrogenated amorphous silicon (a‐Si:H) thin films have been obtained from pure SiH4 rf discharges by using the square wave modulation (SQWM) method. Film properties have been studied by means of spectroellipsometry, thermal desorption spectrometry, photothermal deflection spectroscopy and electrical conductivity measurements, as a function of the modulation frequency of the rf power amplitude (0.2-4000 Hz). The films deposited at frequencies about 1 kHz show the best structural and optoelectronic characteristics. Based upon the experimental results, a qualitative model is presented, which points up the importance of plasma negative ions in the deposition of a‐Si:H from SQWM rf discharges through their influence on powder particle formation.