Combining ability of maize grain yield under different levels of environmental stress

The objectives of this work were to caracterize the tropical maize germplasm and to compare the combining abilities of maize grain yield under different levels of environmental stress. A diallel was performed among tropical maize cultivars with wide adaptability, whose hybrid combinations were evaluated in two sowing dates, in two years. The significance of the environmental effect emphasized the environmental contrasts. Based on grain yield, the environments were classified as favorable (8,331 kg ha-1), low stress (6,637 kg ha-1), high stress (5,495 kg ha-1), and intense stress (2,443 kg ha-1). None of the genetic effects were significant in favorable and intense stress environments, indicating that there was low germplasm variability under these conditions. In low and high stresses, the specific combining ability effects (SCA) were significant, showing that the nonadditive genetic effects were the most important, and that it is possible to select parent pairs with breeding potential. SCA and grain yield showed significant correlations only between the closer environment pairs like favorable/low stress and high/intense stress. The genetic control of grain yield differed under contrasting stress environments for which maize cultivars with wide adaptability are not adequate.

Environmental and genetic variation of isoflavone content of soybean seeds grown in Brazil

The objective of this work was to evaluate isoflavone concentrations in seeds of different Brazilian soybean cultivars grown in a range of locations and environmental conditions in Brazil. Seeds of 233 cultivars grown in Ponta Grossa, PR, Brazil, during the 2001/2002 soybean season, and of 22 cultivars sown in different locations of Brazilian Northeast, Southeast on South regions were analyzed for total isoflavones, including daidzin, glycitin, genistin and acetylgenistin. The total isoflavones ranged from 12 mg 100 g-1 (cv. Embrapa 48) to 461 mg 100 g-1 (cv. CS 305) among the 233 cultivars grown in Ponta Grossa, and the differences among them are due to genetic effects since all cultivars were grown and collected at the same locatation and year. This is an indication of the possibility of breeding for isoflavone content. Differences in isoflavone content observed in the cultivars grown in different locations permit the selection of locations for optimum isoflavone content (low or high), depending on the uses of soybean. In the Northeast region (5-8°S), higher concentrations of total isoflavones were observed at São Raimundo das Mangabeiras (232 mg 100 g-1) and Tasso Fragoso (284 mg 100 g-1) municipalities, and in the South (23-30°S), isoflavones were higher in Guarapuava, Canoinhas, Vacaria and Campos Novos municipalities, ranging from 130 to 409 mg 100 g-1.

Knowledge Licensing in a Model of R&D-driven Endogenous Growth

In this paper I present an endogenous growth model where the engine of growth is in-house R&D performed by high-tech firms. I model knowledge (patent) licensing among high-tech firms. I show that if there is knowledge licensing, high-tech firms innovate more and economic growth is higher than in cases when there are knowledge spillovers or there is no exchange of knowledge among high-tech firms. However, in case when there is knowledge licensing the number of high-tech firms is lower than in cases when there are knowledge spillovers or there is no exchange of knowledge.

Knowledge Licensing in a Model of R&D-driven Endogenous Growth

In this paper I present an endogenous growth model where the engine of growth is in-house R&D performed by high-tech firms. I model knowledge (patent) licensing among high-tech firms. I show that if there is knowledge licensing, high-tech firms innovate more and economic growth is higher than in cases when there are knowledge spillovers or there is no exchange of knowledge among high-tech firms. However, in case when there is knowledge licensing the number of high-tech firms is lower than in cases when there are knowledge spillovers or there is no exchange of knowledge.

SFY 2014 Budget Report from the Plumbers, Mechanical Professionals, and Contractor Licensing Board, November 1, 2014

Iowa Plumber, Mechanical Professional, and Contractor Licensing Board (PMB) submits the following annual budget report to the Iowa State Legislature. Iowa Code 105.9 requires the board to demonstrate that revenues remain within 10% of expenditures over a period of at least three years

SFY 2014 Budget Report from the Plumbers, Mechanical Professionals, and Contractor Licensing Board, December 10, 2015

Iowa Plumber, Mechanical Professional, and Contractor Licensing Board (PMB) submits the following annual budget report to the Iowa State Legislature. Iowa Code 105.9 requires the board to demonstrate that revenues remain within 10% of expenditures over a period of at least three years

Blue-Green Algae, Iowa Department of Public Health - Division of Environmental Health, September 15, 2011

The Iowa Department of Public Health (IDPH), Division of Environmental Health, Health Assessment Program gives people information about harmful chemicals and organisms in their environment. Blue-green algae are microscopic organisms that are naturally present in lakes and streams. Some blue-green algae produce toxins that could pose a health risk to people and animals when they are exposed to them in large enough quantities. This fact sheet answers questions about blue-green algae.

Annual Report: Division of Acute Disease Prevention, Emergency Response, and Environmental Health 2015 April 25, 2016

This report is a result of the ADPER & EH division management team retreat that was held on July 30 and 31, 2015 where a gap was identified in our communication with customers, especially when it came to sharing information about planning efforts. The purpose of this report is to provide a comprehensive look at what ADPER & EH has accomplished in the past year as well as what we are working on for the future. It also serves as an annual informational resource for stakeholders, local partners, policy makers and the general public.

Environmental Conditions Manual, January 2014

Infectious diseases are a continuing threat to all people, regardless of age, gender, lifestyle, ethnic background, or socioeconomic status. They cause illness, suffering and even death, and place an enormous financial burden on society. Although modern advances have controlled some infectious diseases, new ones are constantly emerging. State public health officials rely on local public health agencies, healthcare providers, laboratories and other public health personnel to report the occurrence of notifiable diseases. Without such data, trends cannot be accurately monitored, unusual occurrences of diseases (such as outbreaks) might not be detected or appropriately responded to, and the effectiveness of control and prevention activities cannot be evaluated.

Integrating life cycle costs and environmental impacts of composite rail car-bodies for a Korean train

Background, aim, and scope A coupled Life Cycle Costing and life cycle assessment has been performed for car-bodies of the Korean Tilting Train eXpress (TTX) project using European and Korean databases, with the objective of assessing environmental and cost performance to aid materials and process selection. More specifically, the potential of polymer composite car-body structures for the Korean Tilting Train eXpress (TTX) has been investigated. Materials and methods This assessment includes the cost of both carriage manufacturing and use phases, coupled with the life cycle environmental impacts of all stages from raw material production, through carriage manufacture and use, to end-of-life scenarios. Metallic carriages were compared with two composite options: hybrid steel-composite and full-composite carriages. The total planned production for this regional Korean train was 440 cars, with an annual production volume of 80 cars. Results and discussion The coupled analyses were used to generate plots of cost versus energy consumption and environmental impacts. The results show that the raw material and manufacturing phase costs are approximately half of the total life cycle costs, whilst their environmental impact is relatively insignificant (3-8%). The use phase of the car-body has the largest environmental impact for all scenarios, with near negligible contributions from the other phases. Since steel rail carriages weigh more (27-51%), the use phase cost is correspondingly higher, resulting in both the greatest environmental impact and the highest life cycle cost. Compared to the steel scenario, the hybrid composite variant has a lower life cycle cost (16%) and a lower environmental impact (26%). Though the full composite rail carriage may have the highest manufacturing cost, it results in the lowest total life cycle costs and lowest environmental impacts. Conclusions and recommendations This coupled cost and life cycle assessment showed that the full composite variant was the optimum solution. This case study showed that coupling of technical cost models with life cycle assessment offers an efficient route to accurately evaluate economic and environmental performance in a consistent way.

Is sustainability certification for biochar the answer to environmental risks?

Biochar has the potential to make a major contribution to the mitigation of climate change, and enhancement of plant production. However, in order for biochar to fulfill this promise, the industry and regulating bodies must take steps to manage potential environmental threats and address negative perceptions. The potential threats to the sustainability of biochar systems, at each stage of the biochar life cycle, were reviewed. We propose that a sustainability framework for biochar could be adapted from existing frameworks developed for bioenergy. Sustainable land use policies, combined with effective regulation of biochar production facilities and incentives for efficient utilization of energy, and improved knowledge of biochar impacts on ecosystem health and productivity could provide a strong framework for the development of a robust sustainable biochar industry. Sustainability certification could be introduced to provide confidence to consumers that sustainable practices have been employed along the production chain, particularly where biochar is traded internationally.

Geochemical compositions of Neogene phosphatic brachiopods: Implications for ancient environmental and marine conditions

Isotopic and trace element compositions of Miocene and Pliocene phosphatic brachiopods (Lingulidae and Discinidae) from southern North Sea, the Central Paratethys and the Atlantic coast of Europe were investigated in order to trace past environmental conditions and marine connections between the northern boreal and the southern subtropical-tropical marine basins. The North Sea genus Glottidia yielded low epsilon(Nd) and high delta O-18(PO4) values through the Mio-Pliocene indicating cold habitat temperature where the local seawater was dominated by the Atlantic Ocean. In contrast, the Middle Miocene Lingulidae and Discinidae of the Paratethys inhabited warm subtropical seawater with the possible influence of the Indian Ocean via the Mediterranean, as supported by their average epsilon(Nd) value of -8.3. The combined geochemical data support a thermal and marine separation of the Paratethys from the North Sea with no direct connection or major exchange of water from the Miocene onwards. The temperature in the Paratethys was very similar to that inferred from brachiopods from the Middle Miocene of western France, but the seawater epsilon(Nd) value here is identical to that of contemporaneous Atlantic Ocean. A Late Miocene lingulid brachiopod from southern Portugal has a high delta O-18(PO4), similar to the specimens investigated from the North Sea, reflecting either a deep water habitat or formation after the onset of major global cooling that resulted in an increased delta O-18 value of seawater. The epsilon(Nd) value of -8.4 for this site is compatible with an influence of Mediterranean outflow. (C) 2012 Elsevier B.V. All rights reserved.

Unexpected genomic variability in clinical and environmental strains of the pathogenic yeast Candida parapsilosis

Invasive candidiasis is the most commonly reported invasive fungal infection worldwide. Although Candida albicans remains the main cause, the incidence of emerging Candida species, such as C. parapsilosis is increasing. It has been postulated that C. parapsilosis clinical isolates result from a recent global expansion of a virulent clone. However, the availability of a single genome for this species has so far prevented testing this hypothesis at genomic scales. We present here the sequence of three additional strains from clinical and environmental samples. Our analyses reveal unexpected patterns of genomic variation, shared among distant strains, that argue against the clonal expansion hypothesis. All strains carry independent expansions involving an arsenite transporter homolog, pointing to the existence of directional selection in the environment, and independent origins of the two clinical isolates. Furthermore, we report the first evidence for the existence of recombination in this species. Altogether, our results shed new light onto the dynamics of genome evolution in C. parapsilosis.

Towards a dynamic model of e-commerce: environmental, technological and organisational drivers of B2C along time

Despite the important benefits for firms of commercial initiatives on the Internet, e-commerce is still an emerging distribution channel, even in developed countries. Thus, more needs to be known about the mechanisms affecting its development. A large number of works have studied firms¿ e-commerce adoption from technological, intraorganizational, institutional, or other specific perspectives, but there is a need for adequately tested integrative frameworks. Hence, this work proposes and tests a model of firms¿ business-to-consumer (called B2C) e-commerce adoption that is founded on a holistic vision of the phenomenon. With this integrative approach, the authors analyze the joint influence of environmental, technological, and organizational factors; moreover, they evaluate this effect over time. Using various representative Spanish data sets covering the period 1996-2005, the findings demonstrate the suitability of the holistic framework. Likewise, some lessons are learned from the analysis of the key building blocks. In particular, the current study provides evidence for the debate about the effect of competitive pressure, since the findings show that competitive pressure disincentivizes e-commerce adoption in the long term. The results also show that the development or enrichment of the consumers¿ consumption patterns, the technological readiness of the market forces, the firm¿s global scope, and its competences in innovation continuously favor e-commerce adoption.