Comparison of the nanoparticles performance in the photocatalytic degradation of a styrene-butadiene rubber nanocomposite

Much has been talking about the advantages of polymeric nanocomposites, but little is known about the influence of nanoparticles on the stability of these materials. In this sense, we studied the influence of both oxides of zirconium and titanium, known to have photocatalytic properties, as well as the influence of synthetic clay Laponite on the photodegradation of styrene-butadiene rubber (SBR). SBR nanocomposites were prepared by the colloidal route by mixing commercial polymer lattices and nanometric anatase TiO2, monoclinic ZrO2 or exfoliated Laponite clays colloidal suspensions. To better understand the degradation mechanisms that occur in these nanocomposites, the efficiency of different photocatalysts under ultraviolet radiation was monitored by FT-IR and UV-vis spectroscopies and by differential scanning calorimetric. It was observed that TiO2 and ZrO2 nanoparticles undoubtedly acted as catalysts during the photodegradation process with different efficiencies and rates. However, when compared to pure SBR samples, the polymer degradation mechanism was unaffected. Unlike studies with nanocomposites montmorillonite, exfoliated laponite clay effectively acts as a photostabilizer of polymer UV photodegradation. Copyright © 2012 Wiley Periodicals, Inc.

Deposition and photo-induced electrical resistivity of dip-coated NiO thin films from a precipitation process

Thin films of the semiconductor NiO are deposited using a straightforward combination of simple and versatile techniques: the co-precipitation in aqueous media along with the dip- coating process. The obtained material is characterized by gravimetric/differential thermal analysis (TG-DTA) and X-ray diffraction technique. TG curve shows 30 % of total mass loss, whereas DTA indicates the formation of the NiO phase about 578 K (305 C). X-ray diffraction (XRD) data confirms the FCC crystalline phase of NiO, whose crystallinity increases with thermal annealing temperature. UV-Vis optical absorption measurements are carried out for films deposited on quartz substrate in order to avoid the masking of bandgap evaluation by substrate spectra overlapping. The evaluated bandgap is about 3.0 eV. Current-voltage (I-V) curves measured for different temperatures as well as the temperature-dependent resistivity data show typical semiconductor behavior with the resistivity increasing with the decreasing of temperature. The Arrhenius plot reveals a level 233 meV above the conduction band top, which was attributed to Ni2+ vacancy level, responsible for the p-type electrical nature of NiO, even in undoped samples. Light irradiation on the films leads to a remarkable behavior, because above bandgap light induced a resistivity increase, despite the electron-hole generation. This performance was associated with excitation of the Ni 2+ vacancy level, due to the proximity between energy levels. © 2012 Springer Science+Business Media New York.

Synthesis of PTSH-modified CeO2 nanoparticles: Effect of the modifier on structure, optical properties, and dispersibility

CeO2 nanoparticles were synthesized by the precipitation method and modified with para-toluene sulfonic acid (PTSH), either in situ or post-synthesis. The presence of PTSH in the samples was confirmed by FTIR. PXRD and FTIR analyses showed that the post-synthesis PTSH modification altered the CeO2 structure, whereas the in situ modification maintained intact the crystalline structure and UV-vis absorbance properties. For both in situ and post-synthesis modifications, TEM images revealed the presence of nanoparticles that were 5nm in size. The dispersibility of the in situ PTSH-modified material in a hydrophilic ureasil-poly(ethylene oxide) matrix was investigated using SAXS measurements, which indicated that CeO2 nanoparticles modified with PTSH in situ were less aggregated within the matrix, compared to unmodified CeO2 nanoparticles. © 2013 Elsevier B.V.

New isoniazid complexes, promising agents against mycobacterium tuberculosis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Synthesis, characterization, x-ray structure, DNA cleavage, and cytotoxic activities of palladium(ii) complexes of 4-phenyl-3-thiosemicarbazide and triphenylphosphane

Complexes of the type [PdX(PPh3)(1)]X [1 = 4-phenyl-3- thiosemicarbazide; X = Cl- (2), Br- (3), I- (4), and SCN- (5)] have been synthesized and characterized by elemental analyses and IR, UV/Vis, and 1H and 13C NMR spectroscopy. The molecular structure of complex 4 was determined by single-crystal X-ray diffraction. The binding of the complexes with a purine base (guanosine) was investigated by 1H NMR spectroscopy and mass spectrometry, which showed the complexes to coordinate to guanosine through N7. A gel electrophoresis assay demonstrated the ability of 2-5 to cleave DNA plasmid. All the complexes were tested in vitro by means of the MTT assay for their cytotoxicity against two murine cell lines, LM3 (mammary adenocarcinoma) and LP07 (lung adenocarcinoma), and compared with cisplatin. Complexes 2-5 exhibited good cytotoxicity that surpasses that of cisplatin in the case of LM3. A series of thiosemicarbazide/phosphane palladium(II) complexes have been synthesized and fully characterized. These complexes are able to cleave DNA plasmid and show cytotoxicity against adenocarcinoma (mammary LM3 and lung LP07), surpassing the cytotoxicity of cisplatin in the case of LM3. Copyright © 2013 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

Local order of Pb1-xLaxZr0.40Ti 0.60O3 ferroelectric ceramic materials probed by X-ray absorption and Raman spectroscopies

This paper reports on the structural characterization of Pb 1-xLaxZr0.40Ti0.60O3 (PLZT) ferroelectric ceramic compositions prepared by the conventional solid state reaction method. X-ray absorption spectroscopy (XAS) and Raman spectroscopy were used to probe the local structure of PLZT samples that exhibits a normal and relaxor ferroelectric behavior. From the Zr K-edge and Pb LIII-edge EXAFS spectra, a considerable dissymmetry of Zr and Pb sites was observed in all samples, including those showing a long-range order cubic symmetry and a relaxor behavior. The Raman spectroscopy results confirmed the existence of a local disorder in all PLZT samples through the observation of Raman active vibrational modes. The variation in the intensity of the E(TO 3) mode in the PLZT relaxor samples indicates that the process of correlation between nanodomains stabilizes at temperatures lower than T m. © 2013 Elsevier B.V. All rights reserved.

'Ti''O IND.2'/'Sn''O IND. 2 modificado com 'Ag IND. 2''O', para obtenção de fotocatalisadores

Pós-graduação em Química - IQ

Investigação de propriedades de filmes finos de Sn'O IND. 2' e 'Al IND. 2''O IND. 3' para aplicação em dispositivos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Fabricação e caracterização de filmes finos e ultrafinos de coroas de éter com azobenzeno incorporado e estudo da birrefringência fotoinduzida

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Ácido fólico: validação do método espectrofotométrico

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Micropartículas biodegradáveis para liberação prolongada intraocular de cetorolaco de trometamina obtidas po Spray Drying

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Efeito fotocrômico em Ormosil's dopados com molibdênio preparados por síntese de Sol-Gel

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Obtenção e caracterização de compósitos de borracha natural e polianilina com ferrita de bário

Pós-graduação em Ciência dos Materiais - FEIS

Preparação e caracterização de resina epóxi transparente dopada com nanoestruturas semicondutoras de CdS

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Caracterização de propriedades de vidros polarizados do sistema P2O5 – B2O3 – CaO – TiO2

Pós-graduação em Ciência dos Materiais - FEIS