Numerical modeling of marine radiocarbon reservoir ages during the last deglaciation

A critical problem in radiocarbon dating is the spatial and temporal variability of marine reservoir ages (MRAs). We assessed the MRA evolution during the last deglaciation by numerical modeling, applying a self-consistent iteration scheme in which an existing radiocarbon chronology (derived by Hughen et al., Quat. Sci. Rev., 25, pp. 3216-3227, 2006) was readjusted by transient, 3-D simulations of marine and atmospheric Delta14C. To estimate the uncertainties regarding the ocean ventilation during the last deglaciation, we considered various ocean overturning scenarios which are based on different climatic background states (PD: modern climate, GS: LGM climate conditions). Minimum and maximum MRAs are included in file 'MRAminmax_21-14kaBP.nc'. Three further files include MRAs according to equilibrium simulations of the preindustrial ocean (file 'C14age_preindustrial.nc'; this is an update of our results published in 2005) and of the glacial ocean (files 'C14age_spinupLGM_GS.nc' and 'C14age_spinupLGM_PD.nc').

A laboratory-scale experiment and a numerical simulation of unusual spiral plumes in a High-Prandtl-number fluid, links supplementary material

We experimentally and numerically investigated the generation of plumes from a local heat source (LHS) and studied the interaction of these plumes with cellular convective motion (CCM) in a rectangular cavity filled with silicon oil at a Prandtl number (Pr) of approximately two thousand. The LHS is generated using a 0.2-W green laser beam. A roll-type CCM is generated by vertically heating one side of the cavity. The CCM may lead to the formation of an unusual spiral convective plume that resembles a vertical Archimedes spiral. A similar plume is obtained in a direct numerical simulation. We discuss the physical mechanism for the formation of a spiral plume and the application of the results to mantle convection problems. We also estimate the Reynolds (Re) and Rayleigh (Ra) numbers and apply self-similarity theory to convection in the Earth's mantle. Spiral plumes can be used to interpret mantle tomography results over the last decade.

A numerical discrete element study on the influence of an embedded viscoelastic-plastic layer at different viscosity values

The major aim of this study was to examine the influence of an embedded viscoelastic-plastic layer at different viscosity values on accretionary wedges at subduction zones. To quantify the effects of the layer viscosity, we analysed the wedge geometry, accretion mode, thrust systems and mass transport pattern. Therefore, we developed a numerical 2D 'sandbox' model utilising the Discrete Element Method. Starting with a simple pure Mohr Coulomb sequence, we added an embedded viscoelastic-plastic layer within the brittle, undeformed 'sediment' package. This layer followed Burger's rheology, which simulates the creep behaviour of natural rocks, such as evaporites. This layer got thrusted and folded during the subduction process. The testing of different bulk viscosity values, from 1 × 10**13 to 1 × 10**14 (Pa s), revealed a certain range where an active detachment evolved within the viscoelastic-plastic layer that decoupled the over- and the underlying brittle strata. This mid-level detachment caused the evolution of a frontally accreted wedge above it and a long underthrusted and subsequently basally accreted sequence beneath it. Both sequences were characterised by specific mass transport patterns depending on the used viscosity value. With decreasing bulk viscosities, thrust systems above this weak mid-level detachment became increasingly symmetrical and the particle uplift was reduced, as would be expected for a salt controlled forearc in nature. Simultaneously, antiformal stacking was favoured over hinterland dipping in the lower brittle layer and overturning of the uplifted material increased. Hence, we validated that the viscosity of an embedded detachment strongly influences the whole wedge mechanics, both the respective lower slope and the upper slope duplex, shown by e.g. the mass transport pattern.

An environmental magnetic study, sedimentological and numerical methods around Tauranga Harbour, New Zealand

Magnetic iron minerals are widespread and indicative sediment constituents in estuarine, coastal and shelf systems. We combine environmental magnetic, sedimentological and numerical methods to identify magnetite-enriched placer-like zones in a complex coastal system and delineate their formation mechanisms. Magnetic susceptibility and remanence measurements on 245 surficial sediment samples collected in and around Tauranga Harbour, the largest barrier-enclosed tidal estuary of New Zealand, reveal several discrete enrichment zones controlled by local hydrodynamic conditions. Active magnetite enrichment takes place in tidal channels, which feed into two coast-parallel nearshore magnetite-enriched belts centered at water depths of 6-10 m and 10-20 m. A close correlation between magnetite content and magnetic grain size was found, where higher susceptibility values are associated within coarser magnetic crystal sizes. Two key mechanisms for magnetite enrichment are identified. First, tide-induced residual currents primarily enable magnetite enrichment within the estuarine channel network. A coast-parallel, fine sand magnetite enrichment belt in water depths of less than 10 m along the barrier island has a strong decrease in magnetite content away from the southern tidal inlet and is apparently related to active coast-parallel transport combined with mobilizing surf zone processes. A second, less pronounced, but more uniform magnetite enrichment belt at 10-20 m water depth is composed of non-mobile, medium-coarse-grained relict sands, which have been reworked during post-glacial sea level transgression. We demonstrate the potential of magnetic methods to reveal and differentiate coastal magnetite enrichment patterns and investigate their formative mechanisms.

Numerical ages of magnetostratigraphically calibrated biostratigraphic zones at DSDP Leg 73 Holes

Most Cenozoic nannofossil and many foraminiferal zonal boundaries have been accurately determined and magnetostratigraphically calibrated at five Leg 73 boreholes. The numerical ages of the boundaries were computed by assuming a linear seafloor spreading rate and a radiometric age of 66.5 m.y. for the Cretaceous/Tertiary boundary. Alternative magnetostratigraphic ages (given below in parentheses) were obtained by adopting a 63.5 m.y. age for the Cenozoic. Our data confirm previous determinations of the Pleistocene/Pliocene boundary at 1.8 (1.7) m.y. and of the Pliocene/ Miocene boundary at 5.1 (5.0) m.y. The Miocene/Oligocene boundary is placed within Chron C-6C and has a magnetostratigraphic age of 23.8 to 24.0 (22.7 to 22.9) m.y. The Oligocene/Eocene boundary is also very precisely located within Chron C-13-R, with a magnetostratigraphic age of 37.1 to 37.2 (35.5 to 35.6) m.y. The Eocene/Paleocene boundary should be located within an uncored interval of Chron C-24 and have a magnetostratigraphic age of 59.0 (55.4) +/- 0.2 m.y. The general accord of the magnetostratigraphic and radiometric ages supports the hypothesis that the seafloor spreading rate was linear during the Cenozoic. Two possible exceptions are noted: the middle Miocene radiometric ages are a few million years older, and the early Eocene radiometric ages are several million years younger, than the corresponding magnetostratigraphic ages.