Análise comparativa de métodos de avaliação da composição corporal em homens sadios e em pacientes com doença pulmonar obstrutiva crônica: antropometria, impedância bioelétrica e absortiometria de raios-X de dupla energia

The aim of this study was to examine the agreement between the results of body fat (BF and BF%), fat-free mass (FFM) and FFM index (FFMI= FFM/height2) as estimated by skinfold anthropometry (ANT), bioelectrical impedance (BIA) and dual-energy X-ray absorptiometry (DXA) in two groups of men (> or = 50 y), one comprising healthy individuals (n=23) and the other, patients with chronic obstructive pulmonary disease (COPD) (n=24). Comparisons between body composition techniques were done by repeated measures ANOVA; the Bland & Altman procedure was used to analyse agreement. RESULTS AND CONCLUSIONS: 1) comparison between healthy and COPD groups showed significant differences between all studied variables; 2) in the healthy group, values for BF, BF%, FFM and FFMI were not significantly different when BIA or ANT was compared to DXA; however, in COPD, values for BF and BF% were significantly higher and for FFM and FFMI significantly lower when BIA was compared to DXA; in contrast, no differences were shown between values for these variables when ANT was compared with DXA; 3) Bland & Altman test, in both groups, showed no agreement between BIA and DXA and between ANT and DXA; it was also shown that body fat was overestimated and fat free mass underestimated by BIA in relation to DXA.

Utilization of shells of the snail Achatina fúlica Bowdich, 1822 (Mollusca, Gastropoda) by the hermit crab Clibanarius vittatus (Bosc, 1802) (Decapoda, Anomura) in the São Vicente Estuary, São Paulo, Brazil

Hermit crabs depend on mollusc shells for housing. In this study, an unusual resource is reported for a hermit crab that usually inhabits marine gastropod shells. During a field study conducted from May 2001 to April 2003 in an estuarine area in São Vicente, state of São Paulo, Brazil, 21 individuals of Clibanarius vittatus (Bosc, 1802) were found inhabiting the shells of the terrestrial gastropod Achatina fullea Bowdich, 1822. A. fúlica occurs in nearshore grass patches, where occasional contact with sea water kills them, and their shells then become available to the hermit crabs.

β-Carotene supplementation results in adverse ventricular remodeling after acute myocardial infarction

Objective: We studied the effects of β-carotene (BC) on ventricular remodeling after myocardial infarction. Methods: Myocardial infarction was induced in Wistar rats that were then treated with a BC diet (500 mg/kg of diet per day; MI-BC; n = 27) or a regular diet (MI; n = 27). Hearts were analyzed in vivo and in vitro after 6 mo. Results: BC caused decreased left ventricular wall thickness (MI = 1.49 ± 0.3 mm, MI-BC = 1.23 ± 0.2 mm, P = 0.027) and increased diastolic (MI = 0.83 ± 0.15 cm2, MI-BC = 0.98 ± 0.14 cm2, P = 0.020) and systolic (MI = 0.56 ± 0.12 cm2, MI-BC = 0.75 ± 0.13 cm2, P = 0.002) left ventricular chamber areas. With respect to systolic function, the BC group presented less change in fractional area than did controls (MI = 32.35 ± 6.67, MI-BC = 23.77 ± 6.06, P = 0.004). There was no difference in transmitral diastolic flow velocities between groups. In vitro results showed decreased maximal isovolumetric systolic pressure (MI = 125.5 ± 24.1 mmHg, MI-BC = 95.2 ± 28.4 mmHg, P = 0.019) and increased interstitial myocardial collagen concentration (MI = 3.3 ± 1.2%, MI-BC = 5.8 ± 1.7%, P = 0.004) in BC-treated animals. Infarct sizes were similar between groups (MI = 45.0 ± 6.6%, MI-BC = 48.0 ± 5.8%, P = 0.246). Conclusion: Taken together, these data suggest that BC has adverse effects on ventricular remodeling after myocardial infarction. © 2006 Elsevier Inc. All rights reserved.

Quantum propagator for some classes of three-dimensional three-body systems

In this work we solve exactly a class of three-body propagators for the most general quadratic interactions in the coordinates, for arbitrary masses and couplings. This is done both for the constant as the time-dependent couplings and masses, by using the Feynman path integral formalism. Finally, the energy spectrum and the eigenfunctions are recovered from the propagators. © 2005 Elsevier Inc. All rights reserved.

Intervalo hídrico ótimo e produtividade de cultivares de soja

The objective of this study was to determine the optimal water interval and its relationship with soybean yield. For this study, an experiment was carried out in Jaboticabal, São Paulo State, Brazil, in a Haplustox medium textured soil. The experimental design consisted of a completely randomized with subdivided plots (six compaction levels and four soybean cultivars), with four replications. The soil compaction levels were: T 0 = 0, T 1* = 1, T 1 = 1, T 2 = 2, T 4 = 4 and T 6 = 6 strides of a 11 ton tractor, on the same place, side by side on soil surface. In T 1* the compaction occurred when the soil was dry. In December, 2003 the soybean (Glycine max), cultivars IAC Foscarin 31, MG/BR 46 (Conquista), BRS/MG 68 (Vencedora) and IAC 8 - 2 were sown. After sowing, indeformed soil samples were collected in layers of 0.03-0.06, 0.08-0.11, 0.15-0.18 and 0.22-0.25 m for determination of soil water content and resistance to penetration curve and the optimal water content. According to model, the critical soil bulk density (Dsc) for soybean yield varied between cultivars from 1.56 to 1.64 Mg m -3. The soil bulk density at which the yield of soybean cultivars decreased was greater than the Dsc.

Bond strength of a resin cement to high-alumina and zirconia-reinforced ceramics: The effect of surface conditioning

Purpose: The aim of this study was to evaluate the effect of two surface conditioning methods on the microtensile bond strength of a resin cement to three high-strength core ceramics: high alumina-based (In-Ceram Alumina, Procera AllCeram) and zirconia-reinforced alumina-based (In-Ceram Zirconia) ceramics. Materials and Methods: Ten blocks (5 ×6 × 8 mm) of In-Ceram Alumina (AL), In-Ceram Zirconia (ZR), and Procera (PR) ceramics were fabricated according to each manufacturer's instructions and duplicated in composite. The specimens were assigned to one of the two following treatment conditions: (1) airborne particle abrasion with 110-μm Al2O3 particles + silanization, (2) silica coating with 30 μm SiOx particles (CoJet, 3M ESPE) + silanization. Each ceramic block was duplicated in composite resin (W3D-Master, Wilcos, Petrópolis, RJ, Brazil) using a mold made out of silicon impression material. Composite resin layers were incrementally condensed into the mold to fill up the mold and each layer was light polymerized for 40 s. The composite blocks were bonded to the surface-conditioned ceramic blocks using a resin cement system (Panavia F, Kuraray, Okayama, Japan). One composite resin block was fabricated for each ceramic block. The ceramic-composite was stored at 37°C in distilled water for 7 days prior to bond tests. The blocks were cut under water cooling to produce bar specimens (n = 30) with a bonding area of approximately 0.6 mm2. The bond strength tests were performed in a universal testing machine (crosshead speed: 1 mm/min). Bond strength values were statistically analyzed using two-way ANOVA and Tukey's test (≤ 0.05). Results: Silica coating with silanization increased the bond strength significantly for all three high-strength ceramics (18.5 to 31.2 MPa) compared to that of airborne particle abrasion with 110-μm Al2O3 (12.7-17.3 MPa) (ANOVA, p < 0.05). PR exhibited the lowest bond strengths after both Al2O3 and silica coating (12.7 and 18.5 MPa, respectively). Conclusion: Conditioning the high-strength ceramic surfaces with silica coating and silanization provided higher bond strengths of the resin cement than with airborne particle abrasion with 110-μm Al2O3 and silanization.

Cursos de geologia: expansão, interiorização e consolidação do ensino de geologia no brasil

A short time after the creation of the first Geology courses in Brazil (in 1957 with the pioneers in the University of São Paulo and in the Federal Universities of Ouro Preto, Pernambuco and Rio Grande do Sul, and then in the following year in the Federal Universities of Bahia and Rio de Janeiro), there arose other initiatives that spread almost twenty Geology courses throughout Brazil. In addition to expanding the Geology teaching in the South, Southeast and Northeast regions, these initiatives succeeded in allowing access to geological education for the population in the North and Central-west of Brazil. In the 1960s, the courses in the Federal University of Para in Belém (1964), University of Brasilia (1965) and São Paulo State University in Rio Claro (1969) were implanted. In the following decade, the courses in the Federal Rural University of Rio de Janeiro in Seropédica (1970), the Federal University of Ceará in Fortaleza (1970), the University of Rio dos Sinos in São Leopoldo (1973), the Federal University of Paraná in Curitiba (1973), the Federal University of Minas Gerais in Belo Horizonte (1973), the Federal University of Amazonas in Manaus (1976), the Federal University of Mato Grosso in Cuiabá (1976), the Federal University of Rio Grande do Norte in Natal (1976), and the State University of Rio de Janeiro in Rio de Janeiro (1977) were all created. At the close of the twentieth century, the course was implanted in the State University of Campinas (1998). Now, at the beginning of the twenty-first century, new Geology courses are being implanted, accentuating the movement inland of Geology teaching in Brazil. The Federal University of Pará began a new course in its campus in Marabá in the south-east of Pará and the Federal University of Bahia implanted a new course in its campus in Barreiras in the west of Bahia. Finally, the Federal Universities of Sergipe, Espírito Santo and Roraima commenced Geology courses in Aracaju, Alegre and Boa Vista, respectively. This chapter will present the synthesis of the Geology courses which, over the last decades of the twentieth century, contributed to the expansion of Geology teaching in the country, taking it to every region and giving opportunities to a large number of Brazilian citizens to realize their dreams and tread the paths of their professional vocation.

Influence of lower cutoff values for 100-g oral glucose tolerance test and glycemic profile for identification of pregnant women at excessive fetal growth risk

Objective: To evaluate data from patients with normal oral glucose tolerance test (OGTT) results and a normal or impaired glycemic profile (GP) to determine whether lower cutoff values for the OGTT and GP (alone or combined) could identify pregnant women at risk for excessive fetal growth. Methods: We classified 701 pregnant women with positive screening for gestational diabetes mellitus (GDM) into 2 categories - (1) normal 100-g OGTT and normal GP and (2) normal 100-g OGTT and impaired GP - to evaluate the influence of lower cutoff points in a 100-g OGTT and GP (alone or in combination) for identification of pregnant women at excessive fetal growth risk. The OGTT is considered impaired if 2 or more values are above the normal range, and the GP is impaired if the fasting glucose level or at least 1 postprandial glucose value is above the normal range. To establish the criteria for the OGTT (for fasting and 1, 2, and 3 hours after an oral glucose load, respectively), we considered the mean (75 mg/dL, 120 mg/dL, 113 mg/dL, and 97 mg/dL), mean plus 1 SD (85 mg/dL, 151 mg/dL, 133 mg/dL, and 118 mg/dL), and mean plus 2 SD (95 mg/dL, 182 mg/dL, 153 mg/dL, and 139 mg/dL); and for the GP, we considered the mean and mean plus 1 SD (78 mg/dL and 92 mg/dL for fasting glucose levels and 90 mg/dL and 130 mg/dL for 1- or 2-hour postprandial glucose levels, respectively). Results: Subsequently, the women were reclassified according to the new cutoff points for both tests (OGTT and GP). Consideration of values, in isolation or combination, yielded 6 new diagnostic criteria. Excessive fetal growth was the response variable for analysis of the new cutoff points. Odds ratios and their respective confidence intervals were estimated, as were the sensitivity and specificity related to diagnosis of excessive fetal growth for each criterion. The new cutoff points for the tests, when used independently rather than collectively, did not help to predict excessive fetal growth in the presence of mild hyperglycemia. Conclusion: Decreasing the cutoff point for the 100-g OGTT (for fasting and 1, 2, and 3 hours) to the mean (75 mg/dL, 120 mg/dL, 113 mg/dL, and 97 mg/dL) in association with the GP (mean or mean plus 1 SD-78 mg/dL and 92 mg/dL for the fasting state and 90 mg/dL and 130 mg/dL for 1- or 2-hour postprandial values-increased the sensitivity and specificity, and both criteria had statistically significant predictive power for detection of excessive fetal growth. © 2008 AACE.

La Inversión Extranjera en América Latina y el Caribe 1998

Documento en inglés ingresado en Biblioteca (88498)

Foreign Investment in Latin America and the Caribbean 1998

Includes bibliography

Buenos gobiernos corporativos para los negocios: el caso de Chile

Incluye Bibliografía

La dimensión ambiental en los estilos de desarrollo de América Latina

Incluye Bibliografía

Colombia: lecciones de la reforma agraria

Incluye Bibliografía

Etnicidad y ciudadanía en América Latina: la acción colectiva de los pueblos indígenas

Incluye Bibliografía

Evaluación de la aplicación de los beneficios tributarios para la gestión e inversión ambientales en Colombia

Incluye Bibliografía