Highly linear reconfigurable UWB filters with independently controlled dual bandnotch

This letter proposes a high-linearity reconfigurable lower ultra-wideband (3.1–5.25 GHz) filter with independently controlled dual bandnotch at WiMAX 3.5 GHz band and satellite communication systems 4.2 GHz band. Reconfigurability has been achieved by the implementation of Graphene based switches (simulation only) and PIN diodes (measurements). The simulation and measurement results in OFF state show an entire bandpass response from 3.1 GHz to 5.25 GHz and with a very low insertion loss. In ON state, the results show that sharp rejections at 3.5 GHz and 4.2 GHz are achieved, with a low passband insertion loss. The two bandnotch operate independently of each other; thus allowing to control the behaviour of the required bandnotch. The third order intermodulation products were also measured in OFF and ON states and the linearity results have been presented. The filter is able to achieve a high performance with good linearity and no significant loss.

Two-Path All-pass Based Half-Band Infinite Impulse Response Decimation Filters and the Effects of Their Non-Linear Phase Response on ECG Signal Acquisition

This paper is based on the novel use of a very high fidelity decimation filter chain for Electrocardiogram (ECG) signal acquisition and data conversion. The multiplier-free and multi-stage structure of the proposed filters lower the power dissipation while minimizing the circuit area which are crucial design constraints to the wireless noninvasive wearable health monitoring products due to the scarce operational resources in their electronic implementation. The decimation ratio of the presented filter is 128, working in tandem with a 1-bit 3rd order Sigma Delta (ΣΔ) modulator which achieves 0.04 dB passband ripples and -74 dB stopband attenuation. The work reported here investigates the non-linear phase effects of the proposed decimation filters on the ECG signal by carrying out a comparative study after phase correction. It concludes that the enhanced phase linearity is not crucial for ECG acquisition and data conversion applications since the signal distortion of the acquired signal, due to phase non-linearity, is insignificant for both original and phase compensated filters. To the best of the authors’ knowledge, being free of signal distortion is essential as this might lead to misdiagnosis as stated in the state of the art. This article demonstrates that with their minimal power consumption and minimal signal distortion features, the proposed decimation filters can effectively be employed in biosignal data processing units.

Low Pass Filters

Resources created at the University of Southampton for the module Remote Sensing for Earth Observation

High Pass Filters

Resources created at the University of Southampton for the module Remote Sensing for Earth Observation

Specific Filters Applied in Nuclear Medicine Services

In Nuclear Medicine, radioiodine, in various chemical forms, is a key tracer used in diagnostic practices and/or therapy. Due to its high volatility, medical professionals may incorporate radioactive iodine during the preparation of the dose to be administered to the patient. In radioactive iodine therapy doses ranging from 3.7 to 7.4GBq per patient are employed. Thus, aiming at reducing the risk of occupational contamination, we developed a low cost filter to be installed at the exit of the exhaust system where doses of radioactive iodine are fractionated, using domestic technology. The effectiveness of radioactive iodine retention by silver impregnated silica [10%] crystals and natural activated carbon was verified using radiotracer techniques. The results showed that natural activated carbon is effective for I2 capture for a large or small amount of substrate but its use is restricted due to its low flash point (150º C). Besides, when poisoned by organic solvents, this flash point may become lower, causing explosions if absorbing large amounts of nitrates. To hold the CH3I gas, it was necessary to increase the volume of natural activated carbon since it was not absorbed by SiO2 + Ag crystals. We concluded that, for an exhaust flow range of (306 4) m3/h, a double stage filter using SiO2 + Ag in the first stage and natural activated carbon in the second is sufficient to meet radiological safety requirements.

Employment of the Technique of Radiotracers for Analysis of Industrial Filters

The main aim of this work is to develop a methodology to evaluate the characteristics of porous media in filter using the radio-tracing technique. To do this, an experimental prototype filter made up of an acrylic cylinder, vertically mounted and supported on the lower side by a controlled leaking valve was developed. Two filters (spheres of acrylic and silica crystals) were used to check the movement of the water through the porous media using 123I in its MIBG (iodine-123-meta-iodo benzyl-guanidine) form. Further up the filter an instantaneous injection of the substance makes it possible to see the passage of radioactive clouds through the two scintillatory detectors NaI (2x2)” positioned before and immediately after the cylinder with the filtering element (porous media). The are caused by the detectors on the passage of the radioactive cloud are analyzed through statistical functions using the weighted moment method which makes it possible to calculate the Residence-Time (the amount of time the tracer takes to thoroughly pass through the filter) per the equation of dispersion in tubular flow and the one-directional flow of the radiotracer in the porous media.

Inter-industry differences in local banks' effect on new firm formation : A regional study of entrepreneurship in Sweden

Formation of new firms is important, since new firms create jobs and economic growth. When entrepreneurs lack the financial resources which are needed to start a firm, they often turn to banks to borrow money. Previous research has shown that relationships between banks and new business borrowers most often are local and that the dependence on banks differs across industries. In light of this, the purpose of this paper is to investigate if local access to banks has a stronger relationship with the rate of new firm formation in some industries than in others. Based on cross-sectional data on all Swedish municipalities in 2009, a series of OLS regressions are estimated to test if variables used to describe the bank market in a municipality are related with the new firm formation rate, both in total and in different industry categories. The results show that the number of bank branches per capita is positively related with the total new firm formation rate. In regards to the inter-industry differences, the findings indicate that local access to banks is more important for new firm formation in some industries than in others. 

THE COSTS OF RAISING EQUITY RATIO FOR BANKS Evidence from publicly listed banks operating in Finland

The solvency rate of banks differs from the other corporations. The equity rate of a bank is lower than it is in corporations of other field of business. However, functional banking industry has huge impact on the whole society. The equity rate of a bank needs to be higher because that makes the banking industry more stable as the probability of the banks going under will decrease. If a bank goes belly up, the government will be compensating the deposits since it has granted the bank’s depositors a deposit insurance. This means that the payment comes from the tax payers in the last resort. Economic conversation has long concentrated on the costs of raising equity ratio. It has been a common belief that raising equity ratio also increases the banks’ funding costs in the same phase and these costs will be redistributed to the banks customers as higher service charges. Regardless of the common belief, the actual reaction of the funding costs to the higher equity ratio has been studied only a little in Europe and no study has been constructed in Finland. Before it can be calculated whether the higher stability of the banking industry that is caused by the raise in equity levels compensates the extra costs in funding costs, it must be calculated how much the actual increase in the funding costs is. Currently the banking industry is controlled by complex and heavy regulation. To maintain such a complex system inflicts major costs in itself. This research leans on the Modigliani and Miller theory, which shows that the finance structure of a firm is irrelevant to their funding costs. In addition, this research follows the calculations of Miller, Yang ja Marcheggianon (2012) and Vale (2011) where they calculate the funding costs after the doubling of specific banks’ equity ratios. The Finnish banks studied in this research are Nordea and Danske Bank because they are the two largest banks operating in Finland and they both also have the right company form to able the calculations. To calculate the costs of halving their leverages this study used the Capital Asset Pricing Model. The halving of the leverage of Danske Bank raised its funding costs for 16—257 basis points depending on the method of assessment. For Nordea the increase in funding costs was 11—186 basis points when its leverage was halved. On the behalf of the results found in this study it can be said that the doubling of an equity ratio does not increase the funding costs of a bank one by one. Actually the increase is quite modest. More solvent banks would increase the stability of the banking industry enormously while the increase in funding costs is low. If the costs of bank regulation exceeds the increase in funding costs after the higher equity ratio, it can be thought that this is the better way of stabilizing the banking industry rather than heavy regulation.

A Study of Privacy Preserving Queries with Bloom Filters

This thesis focuses on the private membership test (PMT) problem and presents three single server protocols to resolve this problem. In the presented solutions, a client can perform an inclusion test for some record x in a server's database, without revealing his record. Moreover after executing the protocols, the contents of server's database remain secret. In each of these solutions, a different cryptographic protocol is utilized to construct a privacy preserving variant of Bloom filter. The three suggested solutions are slightly different from each other, from privacy perspective and also from complexity point of view. Therefore, their use cases are different and it is impossible to choose one that is clearly the best between all three. We present the software developments of the three protocols by utilizing various pseudocodes. The performance of our implementation is measured based on a real case scenario. This thesis is a spin-off from the Academy of Finland research project "Cloud Security Services".

Loan quality, ownership and efficiency of Indian banks : A bootstrap truncated regression approach

Senate Documents vol 24 Evolution of Credit and Banks in France

From the Founding of the Bank of France to the Present Time

Productos botánicos para el manejo del ácaro blanco (Polyphagotarsonemus latus, Banks.) (Acarina; Tarsonemidae, en chiltoma (Capsicum annuum L.), en Masaya, Nicaragua

Con el objetivo de evaluar cinco productos botánicos para el manejo del ácaro blanco de la chiltoma, se realizó un estudio en el Municipio de Tisma, Masaya en el período comprendido de Septiembre a Noviembre del año 2014. Las alternativas evaluadas fueron: Eucalipto, Neem, Crisantemo, Madero Negro y Chile+Ajo+Jabon en comparación con el testigo que fue solamente aplicación de agua. Las variables evaluadas fueron: Número de ácaro blanco por planta, porcentaje de severidad del daño de ácaro blanco por planta, además de algunas variables económicas como el rendimiento en kg/ha por tratamiento evaluado, análisis de presupuesto parcial, análisis de dominancia y tasa de retorno marginal. Los resultados obtenidos en el estudio determinan que los tratamientos Madero Negro y chile+ajo+jabon fueron los que presentaron el mejor efecto de control del ácaro blanco, los mejores rendimientos comerciales lo obtuvieron los tratamientos madero negro y chile+ajo+jabon, las mejores tasas de retorno marginal fueron obtenidas en los tratamientos madero negro seguido del chile+ajo+jabon.