938 resultados para Effect of the pasture supplementation strategy in the growing period on performance
Resumo:
TiO2 films have been deposited on ITO substrates by dc reactive magnetron sputtering technique. It has been found that the sputtering pressure is a very important parameter for the structure of the deposited TiO2 films. When the pressure is lower than 1 Pa, the deposited has a dense structure and shows a preferred orientation along the [101] direction. However, the nanorod structure has been obtained as the sputtering pressure is higher than 1 Pa. These nanorods structure TiO2 film shows a preferred orientation along the [110] direction. The x-ray diffraction and the Raman scattering measurements show both the dense and the nanostructure TiO2 films have only an anatase phase, no other phase has been obtained. The results of the SEM show that these TiO2 nanorods are perpendicular to the ITO substrate. The TEM measurement shows that the nanorods have a very rough surface. The dye-sensitized solar cells (DSSCs) have been assembled using these TiO2 nanorod films prepared at different sputtering pressures as photoelectrode. And the effect of the sputtering pressure on the properties of the photoelectric conversion of the DSSCs has been studied.
Resumo:
The prediction of asymmetric equilibria with Stackelberg outcomes is clearly the most frequent result in the endogenous timing literature. Several experiments have tried to validate this prediction empirically, but failed to find support for it. By contrast, the experiments find that simultaneous-move outcomes are modal and that behavior in endogenous timing games is quite heterogeneous. This paper generalizes Saloner’s (1987) and Hamilton and Slutsky’s (1990) endogenous timing games by assuming that players are averse to inequality in payoffs. We explore the theoretical implications of inequity aversion and compare them to the empirical evidence. We find that this explanation is able to organize most of the experimental evidence on endogenous timing games. However, inequity aversion is not able to explain delay in Hamilton and Slutsky’s endogenous timing games.
Resumo:
INTRODUCTION: Study of the temporal activity of malaria vectors during the implantation of a hydroelectric power station on the River Paraná, intended to generate electrical energy. The river separates the States of São Paulo and Mato Grosso do Sul, in Brazil. The objective was to verify whether alterations occurred in the wealth and diversity indices of Anopheles, following two successive floods, extended to the temporal activity and nycthemeral rhythm followed over a five year period. METHODS: Mosquito capture was performed monthly using the Human Attraction Technique and Shannon Traps. The first, executed for 24h, provided the nycthemeral rhythm and the second, lasting 15h, permitted the tracking of Anopheles during the two floods. RESULTS: The bimodal pattern of Anopheles darlingi defined before these floods was modified throughout the environment interventions. The same effect had repercussions on the populations of An albitarsis s.l., An triannulatus and An galvaoi. Activity prior to twilight was less affected by the environment alterations. CONCLUSIONS: The dam construction provoked changes in Anopheles temporal activity patterns, permitting classification of the area as an ecologically steady and unstable situation. Differences observed in Anopheles behavior due to the capture methods revealed the influence of solo and multiple attractiveness inside the populations studied.
Resumo:
INTRODUCTION: Angiostrongylus vasorum is a nematode that parasitizes molluscs, dogs, and even man. METHODS: The objective was to evaluate the predatory activity of the conidia of two fungal isolates of Duddingtonia flagrans (AC001 and CG722) on first-stage larvae (L1) of A. vasorum in laboratory conditions. RESULTS: At the end of the experiment, there were significant reductions (p<0.01) of 74.5% and 63.2%, on average, in the A. vasorum L1 recovered in the AC001 and CG722 treatment conditions, respectively. CONCLUSIONS: The two isolates of fungi were efficient in the capture and destruction of A. vasorum L1.
Resumo:
The increasing environmental concern about waste materials and the necessity of improving the performance of asphalt mixtures prompted the study of incorporating different waste materials in conventional bitumen. The reuse of waste materials can present benefits at an environmental and economic level, and some wastes can be used to improve the pavement performance. Thus, the purpose of this study is to evaluate the incorporation of different waste materials in bitumen, namely waste motor oil and different polymers. In order to accomplish this goal, 10% of waste motor oil and 5% of polymers (high density polyethylene, crumb rubber and styrene-butadiene-styrene) were added to a conventional bitumen and the resulting modified bitumens were characterized through basic and rheological tests. From this work, it can be concluded that the incorporation of different waste materials improve some important properties of the conventional bitumen. Such improvements might indicate a good behaviour at medium/high temperatures and an increase of fatigue and rutting resistance. Therefore, these modified bitumens with waste materials can contribute to a sustainable development of road paving industry due to their performance and environmental advantages.
Resumo:
Poly(vinylidene fluoride), PVDF, films and membranes were prepared by solvent casting from dimethylformamide, DMF, by systematically varying polymer/solvent ratio and solvent evaporation temperature. The effect of the processing conditions on the morphology, degree of porosity, mechanical and thermal properties and crystalline phase of the polymer were evaluated. The obtained microstructure is explained by the Flory-Huggins theory. For the binary system, the porous membrane formation is attributed to a spinodal decomposition of the liquid-liquid phase separation. The morphological features were simulated through the correlation between the Gibbs total free energy and the Flory-Huggins theory. This correlation allowed the calculation of the PVDF/DMF phase diagram and the evolution of the microstructure in different regions of the phase diagram. Varying preparation conditions allow tailoring polymer 2 microstructure while maintaining a high degree of crystallinity and a large β crystalline phase content. Further, the membranes show adequate mechanical properties for applications in filtration or battery separator membranes.
Resumo:
Gold nanoparticles were dispersed in two different dielectric matrices, TiO2 and Al2O3, using magnetron sputtering and a post-deposition annealing treatment. The main goal of the present work was to study how the two different host dielectric matrices, and the resulting microstructure evolution (including both the nanoparticles and the host matrix itself) promoted by thermal annealing, influenced the physical properties of the films. In particular, the structure and morphology of the nanocomposites were correlated with the optical response of the thin films, namely their localized surface plasmon resonance (LSPR) characteristics. Furthermore, and in order to scan the future application of the two thin film system in different types of sensors (namely biological ones), their functional behaviour (hardness and Young's modulus change) was also evaluated. Despite the similar Au concentrations in both matrices (~ 11 at.%), very different microstructural features were observed, which were found to depend strongly on the annealing temperature. The main structural differences included: (i) the early crystallization of the TiO2 host matrix, while the Al2O3 one remained amorphous up to 800 °C; (ii) different grain size evolution behaviours with the annealing temperature, namely an almost linear increase for the Au:TiO2 system (from 3 to 11 nm), and the approximately constant values observed in the Au:Al2O3 system (4–5 nm). The results from the nanoparticle size distributions were also found to be quite sensitive to the surrounding matrix, suggesting different mechanisms for the nanoparticle growth (particle migration and coalescence dominating in TiO2 and Ostwald ripening in Al2O3). These different clustering behaviours induced different transmittance-LSPR responses and a good mechanical stability, which opens the possibility for future use of these nanocomposite thin film systems in some envisaged applications (e.g. LSPR-biosensors).
Resumo:
Magdeburg, Univ., Fak. für Geistes-, Sozial- und Erziehungswiss., Diss., 2009
Resumo:
The unique ability of angiotensin converting enzyme (ACE) inhibitors to inhibit the generation of angiotensin II has made them very useful agents for treating patients with renovascular hypertension. Their efficacy in lowering blood pressure in this type of secondary hypertension is now well established. However, episodes of acute renal failure may occur during ACE inhibition, particularly when renal perfusion is compromised. This is often the case in patients with renal artery stenosis and a single kidney or with bilateral renal artery stenosis. In recent years, investigators have shown concern at the long-term fate of the stenotic kidney in patients with unilateral renal artery stenosis who are treated with ACE inhibitors. Although overall renal function remained stable, a decrease in glomerular filtration was demonstrated in the stenotic kidney under ACE inhibition. The long-term implications of this observation merit further investigations.
Resumo:
The National Health Strategy “Quality and Fairness, Health System for You” states“ a key objective of the human resource framework is to develop and explicitly value staff at all levels of the health system. This in turn benefits service users.” The strategy explicitly states that one of its initiatives was “to introduce the grade of Health Care Assistant (HCA) as a member of healthcare teams to assist and support nurses and midwives. A national six month training programme for Health Care Assistants to commence at the end of November 2001. Seventeen pilot programmes to be delivered by the health services in conjunction with the Further Education Training Awards Council (FETAC)”.