Analysis and design of sinusoidal quadrature RC-oscillators

Modern telecommunication equipment requires components that operate in many different frequency bands and support multiple communication standards, to cope with the growing demand for higher data rate. Also, a growing number of standards are adopting the use of spectrum efficient digital modulations, such as quadrature amplitude modulation (QAM) and orthogonal frequency division multiplexing (OFDM). These modulation schemes require accurate quadrature oscillators, which makes the quadrature oscillator a key block in modern radio frequency (RF) transceivers. The wide tuning range characteristics of inductorless quadrature oscillators make them natural candidates, despite their higher phase noise, in comparison with LC-oscillators. This thesis presents a detailed study of inductorless sinusoidal quadrature oscillators. Three quadrature oscillators are investigated: the active coupling RC-oscillator, the novel capacitive coupling RCoscillator, and the two-integrator oscillator. The thesis includes a detailed analysis of the Van der Pol oscillator (VDPO). This is used as a base model oscillator for the analysis of the coupled oscillators. Hence, the three oscillators are approximated by the VDPO. From the nonlinear Van der Pol equations, the oscillators’ key parameters are obtained. It is analysed first the case without component mismatches and then the case with mismatches. The research is focused on determining the impact of the components’ mismatches on the oscillator key parameters: frequency, amplitude-, and quadrature-errors. Furthermore, the minimization of the errors by adjusting the circuit parameters is addressed. A novel quadrature RC-oscillator using capacitive coupling is proposed. The advantages of using the capacitive coupling are that it is noiseless, requires a small area, and has low power dissipation. The equations of the oscillation amplitude, frequency, quadrature-error, and amplitude mismatch are derived. The theoretical results are confirmed by simulation and by measurement of two prototypes fabricated in 130 nm standard complementary metal-oxide-semiconductor (CMOS) technology. The measurements reveal that the power increase due to the coupling is marginal, leading to a figure-of-merit of -154.8 dBc/Hz. These results are consistent with the noiseless feature of this coupling and are comparable to those of the best state-of-the-art RC-oscillators, in the GHz range, but with the lowest power consumption (about 9 mW). The results for the three oscillators show that the amplitude- and the quadrature-errors are proportional to the component mismatches and inversely proportional to the coupling strength. Thus, increasing the coupling strength decreases both the amplitude- and quadrature-errors. With proper coupling strength, a quadrature error below 1° and amplitude imbalance below 1% are obtained. Furthermore, the simulations show that increasing the coupling strength reduces the phase noise. Hence, there is no trade-off between phase noise and quadrature error. In the twointegrator oscillator study, it was found that the quadrature error can be eliminated by adjusting the transconductances to compensate the capacitance mismatch. However, to obtain outputs in perfect quadrature one must allow some amplitude error.

Measuring the effects of price movements on private consumption

This paper studies how shocks in the prices of Food, Energy and Financial Assets affect private consumption using a VAR Model. Then, the total effects are broken into direct and indirect effects, using the coefficients taken from the previous model. We use quarterly data for the Portuguese economy from the last 20 years. We found that energy prices and financial assets have a strong connection with consumption, suggesting that the economy may be too exposed to shocks in these markets.

The effect of energy and traffic light labeling on parents purchasing decisions of cereals for their children

Objective: Nutritional labeling systems are considered a tool to fight obesity since they aim to contribute for more informed food choices as well as assist consumers to make healthier nutrition options and in this manner, contribute to a decrease in the obesity rate. This study intends to analyze the effect of different types of labeling systems on parents’ purchasing decisions for their children on a specific product: breakfast cereals. More precisely, how labels affect parents’ perception of healthiness regarding cereals and if the nutritional information has an effect on intended purchases for their children. Participants and methods: We conducted a study with 135 Portuguese parents of children aged 4 to12 years. Parents answered a questionnaire with one of three hypothetical cereals menus. Menus only differed in their nutritional labeling technique: no labels (control group), reference intake labels or traffic light labels. In addition, we conducted 20 face-to-face interviews to a different group of parents in order to perform a recall task. Findings: This paper provides no evidence to suggest that energy labeling or traffic light labeling systems alone were successful in helping parents making healthy purchases of cereals for their children. Therefore, there is the need to promote supplementary policies to encourage the consumption of healthier food and help fight obesity.

Exchange rate pressure in Angola

The objective of this work is to develop an operational tool to analyze exchange rate pressure in the context of Angola. The Angolan economy exhibits a number of relevant characteristics: a closed financial account, a partially controlled current account, a highly dollarized economy and exports (oil) price determined in World markets. These features have a direct effect on the demand of foreign currency and motivate their inclusion in the specification of a model for Angola. The model provides the rational for a measure of an exchange market rate pressure (EMP) index that contains exports changes, imports changes, the foreign interest rate and inflation and the change in foreign reserves corrected for a measure dollarization. The empirical performance new measure is comparable (slightly better) to the performance of the EMP indexes obtained in Eichengreen Rose and Wyplosz (1994) and Klassen and Jager (2011).

The consumption of beauty products on famale young adults in Portugal. Recommenrations for the brand Lancôme to improve its store trafic

This project aims to explore the Portuguese Beauty and Cosmetics market, and to discuss the usage and purchase behaviour of young female adults, between 18 and 26 years old. After a market analysis based on secondary data, it evaluates the results of qualitative and quantitative research based on 9 interviews and 126 online questionnaires to explore the consumers’ reasoning when choosing products from this category – fragrances, skin care or make-up – as well as their attitude towards brands, with a special focus on the premium cosmetics brand Lancôme. Contrary to our expectations there was no statistically significant positive influence of the online touchpoints within this age segment’s purchase intention. However, results indicate that Lancôme is already being perceived by some as young and modern, but is still suffering the threat of Mass Market brands that are valued by this target, mainly due to a price sensitivity towards premium beauty brands.

Community indentification in peer-t-peer collaborative consumption services

Even though collaborative consumption (CC) is gaining economic importance, research in CC is still in its infancy. Consumers’ reasons for participating have already been investigated but little research on consequences of participation has been conducted. This article examines whether interactions between customers in peer-to-peer CC services influence the willingness to coproduce service outcomes. Drawing on social exchange theory, it is proposed that this effect is mediated by consumers’ identification with the brand community. Furthermore, continuance intention in CC is introduced as a second stage moderator. In a cross-sectional study, customers of peer-to-peer accommodation sharing are surveyed. While customer-to-customer interactions were found to have a positive effect on brand community identification, brand community identification did not positively affect co-production intention. Surprisingly, the effect of brand community identification on co-production intention was negative. Moreover, continuance intention of customers did not moderate this relationship. Bearing in mind current challenges for researchers and companies, theoretical and managerial implications are discussed.

Forest biomass and wood consumption In the lower course of the Amazon: a case study of rhe Urubueua Island

Várzea and terra-firme forests in the lower course of the Amazon were compared in terms of forest structure, wood volume increments and forest biomass. The wood volume of várzea forests was smaller than that of terra-firme forests, particularly when severe human intervention such as the cultivation of açaí palm occurred. The difference was even greater in the forest weight comparison because of the lower wood density of várzea trees. These trees are not directly influenced by water stress during the dry season, while late wood with a high density is formed in the terra-firme trees. The annual forest disappearance area due to firewood for tile factories was estimated to be about 276 ha on the island investigated, which had an area of 36,200 ha. Assuming that the forests are rotatively cultivated every 25 to 30 years, the total deforestation area is 6,870-6,948 ha in 25 years and 8,244~8,337 ha in 30 years. This result means that the balance between forest biomass and utilization is not in crisis, however, this balance might be lost as long as substitutive energy such as electricity is not supplied.

Characterization of pesticide consumption in the county of Santarém, Pará, Brazil

Many potentially harmful pesticides for both human health and the environment are used in Brazilian Amazon. However, no scientific datum on pesticide usage is presently available for this region. Consequently, it is difficult to assess which substances arc used and in which quantities. As an important premise for future work on pesticide contamination in the county of Santarém (State of Pará, Brazil), a survey was conducted in order to qualify and quantify the use of some pesticides in this region. This investigation was made between January and March 1997 and August and October 1998 and revealed use of several organophosphates, synthetic pyrethroids and carbamates insecticides. Furthermore, many herbicides and fungicides were listed. These pesticides are used for agriculture, domestic, and sanitary programs. This paper also provides a first estimation of quantities of some insecticides commonly used in agriculture (chlorpyrifos, malathion, metamidophos and methyl-parathion). The annual consumption for these four compounds is estimated at ca. 1 910 kg. Organophosphate insecticide consumption in the county of Santarém seems to be lower than the Brazilian average in terms of «per capita» and «per agricultural area» consumptions. Nevertheless, this county uses toxic substances on sensitive environments such as floodplains (várzeas), making relevant a thorough study on the potential contamination of this environment and its biota.

Monitoring energy consumption in android applications

Dissertação de Mestrado em Engenharia Informática

Growth rate of a terra firme rain forest in Brazilian Amazonia over an eight-year period in response to logging

This paper deals with growth rates of trees > 5cm dbh over an eight-year period from 257 species at the Tapajós National Forest. The discussion is centred on the behaviour of the forest after logging. Permanent sample plots were established in 1981 and measured at the first time. The area was logged in 1982. Measurements after logging occurred in 1983, 1987 and 1989. Considering all species together, diameter increment was similar for both intensities of logging until five years after logging. Light-demanding species showed significantly higher growth rates than shade-tolerant species in the logged forest, with greater increment in the heavier treatment intensity. Commercial species also had higher growth rates in the heavier logged area, although those were significantly different only in the period from one to five years after logging. In the undisturbed forest, growth rates increased with increasing dbh size. At species level, growth rate varied between and within treatments, as well as between trees within species, depending mainly on degree of canopy opening. The logging favoured the growth of commercial species, chiefly the light-demanders. Therefore, if the same growth conditions continue being given, for example by silvicultural treatments, to those species of commercial interest, the forest would reach a stock available for harvesting around year 30 after logging. However, the high variation in increment rates indicates that an eight-year period is not sufficient to allow predictions on cutting cycles or polycyclic management systems for the study forest.

Producing LFT composite parts for large consumption markets from thermoplastic powder-coated towpregs

Thermoplastic matrix composites are receiving increasing interest in last years. This is due to several advantageous properties and speed of processing of these materials as compared to their thermoset counterparts. Among thermoplastic composites, Long Fibre Thermoplastics (LFTs) have seen the fastest growth, mainly due to developments in the automotive sector. LFTs combine the (semi-)structural material properties of long (>1 cm) fibres, with the ease and speed of thermoplastic processing. This paper reports a study of a novel low-cost LFT technology and resulting composites. A patented powder-coating machine able to produce continuously pre-impregnated materials directly from fibre rovings and polymer powders was used to process glass-fibre reinforced polypropylene (GF/PP) towpregs. Such pre-impregnated materials were then chopped and used to make LFTs in a patented low-cost piston-blender developed by the Centre of Lightweight Structures, TUD-TNO, the Netherlands. The work allowed studying the most relevant towpreg production parameters and establishing the processing window needed to obtain a good quality GF/PP powder coated material. Finally, the processing window that allows producing LFTs of good quality in the piston-blender and the mechanical properties of final stamped GF/PP composite parts were also determined.

High strain rate constitutive modeling forhistorical structures subjected to blast loading

Doctoral Thesis Civil Engineering

Empathy and heart rate variability: a need and a mechanism of emotion regulation

Dissertação de mestrado integrado em Psicologia

End-of-day dryness, corneal sensitivity and blink rate in contact lens wearers

Purpose: To study the relationship among the variables intensity ofthe end-of-day (EOD) dryness, corneal sensitivity and blink rate in soft contact lens (CL) wearers. Methods: Thirty-eight soft CL wearers (25 women and 13 men; mean age 27.1 ± 7.2 years) were enrolled. EOD dryness was assessed using a scale of 0–5 (0, none to 5, very intense). Mechanical and thermal (heat and cold) sensitivity were measured using a Belmonte’s gas esthesiometer. The blink rate was recorded using a video camera while subjects were wearing a hydrogel CL and watching a film for 90 min in a controlled environmental chamber. Results: A significant inverse correlation was found between EOD dryness and mechanical sensitivity (r: −0.39; p = 0.02); however, there were no significant correlations between EOD dryness and thermal sensitivity. A significant (r: 0.56; p < 0.001) correlation also was observed between EOD dryness and blink rate, but no correlations were found between blink rate and mechanical or thermal sensitivity. Conclusions: CL wearers with higher corneal sensitivity to mechanical stimulation reported more EOD dryness with habitual CL wear. Moreover, subjects reporting more EOD dryness had an increased blink rates during wear of a standard CL type. The increased blink rate could act to improve the ocular surface environment and relieve symptoms

Outcrossing rate of Couratari multiflora (J.Smith) Eyma (Lecythidaceae), a low-density tropical tree species from a central Amazonian rainforest

A multilocus mixed-mating model was used to evaluate the mating system of a population of Couratari multiflora, an emergent tree species found in low densities (1 individual/10 ha) in lowland forests of central Amazonia. We surveyed and observed phenologically 41 trees in an area of 400 ha. From these, only four mother trees were analyzed here because few of them set fruits, which also suffered high predation. No difference was observed between the population multilocus outcrossing rate (t mp = 0.953 ± 0.040) and the average single locus rate (t sp = 0.968 ± 0.132). The four mother trees were highly outcrossed (t m ~ 1). Two out of five loci showed departures from the Hardy-Weinberg Equilibrium (HWE) expectations, and the same results occurred with the mixed-mating model. Besides the low number of trees analyzed, the proportion of loci in HWE suggests random mating in the population. However, the pollen pool was heterogeneous among families, probably due to both the small sample number and the flowering of trees at different times of the flowering season. Reproductive phenology of the population and the results presented here suggest, at least for part of the population, a long-distance pollen movement, around 1,000 m.