ADUBAÇÃO N-K NO ABACAXIZEIRO ‘BRS IMPERIAL’ – II EFEITO NO SOLO, NA NUTRIÇÃO DA PLANTA E NA PRODUÇÃO

RESUMO O abacaxizeiro ‘BRS Imperial’ é uma cultivar resistente à fusariose, apresenta frutos saborosos, mas ainda é pouco conhecido dos fruticultores. Este trabalho teve como objetivo avaliar o efeito de diferentes doses de N e K nas características químicas do solo, nos teores foliares de nutrientes e nas variáveis de produção de um cultivo de ‘BRS Imperial’. O experimento foi instalado no espaçamento 0,90 x 0,40 x 0,40 m, com quatro doses de N (0; 160; 320 e 550 kg ha-1) e quatro de K2O (0; 240; 480 e 600 kg ha-1), em blocos ao acaso, com cinco repetições, em fatorial completo 4 x 4. Foram realizadas análises químicas das folhas e do solo, e mensuradas as variáveis de produção. O cultivo do abacaxizeiro sem N e K ou apenas com adubação nitrogenada resultaram em menores índices de pH, K+, Ca e 2+Mg2+ no solo, no final do ciclo de cultivo, em relação aos teores iniciais. Mesmo na maior dose de K aplicada, o teor deste nutriente no solo ficou baixo. Os teores foliares de N e K estimados, nas doses máximas testadas, foram 12,8 e 31,8 g kg-1, respectivamente. As variáveis de colheita mostraram significância para as doses de N em todas as avaliações, enquanto as doses de K2O influenciaram apenas na relação comprimento/diâmetro do fruto. Pela análise de regressão, as doses de N mostraram efeito quadrático na massa dos frutos com coroa, a qual se apresentou com 1.086 g na dose máxima física de 365 kg ha-1 e produtividade estimada de 42 t ha-1.

Combinación de sistemas de flujo de baja y alta presion para la determinacion de Mg, Ca y Sr en salmueras por espectrofotometria de absorcion atomica con llama

This article describes the combination of low- and high-pressure flow systems for the determination of Magnesium, Calcium and Strontium by flame atomic absorption spectrometry (FAAS). In the low-pressure system a short C-18 RP column (length 0,5 cm) was utilized for the preconcentration/matrix separation step, xylenol orange was used as chelating agent and tetrabutylamonium acetate for ion pair formation. The hydraulic high pressure nebulization (HHPN) was used for sample transport and sample introduction in the high pressure system. The repeatabilities and detection limits for Mg, Ca and Sr were determined and compared with those obtained by pneumatic nebulization (PN). The results show that the detection limits obtained using the HHPN for Mg, Ca and Sr are between 1.5 to 2 times better than those obtained by PN when the signal transient was measured in area. The system presented a sampling frequency of 130 h-1 for direct determination of Mg, Ca or Sr in samples of saturated sodium chloride used in the production of chlorine and sodium hydroxide.

Reaction Kinetics and Viscosity Modelling in the Fusion Syntheses of Ca- and Ca/Mg-resinates

Rosin is a natural product from pine forests and it is used as a raw material in resinate syntheses. Resinates are polyvalent metal salts of rosin acids and especially Ca- and Ca/Mg- resinates find wide application in the printing ink industry. In this thesis, analytical methods were applied to increase general knowledge of resinate chemistry and the reaction kinetics was studied in order to model the non linear solution viscosity increase during resinate syntheses by the fusion method. Solution viscosity in toluene is an important quality factor for resinates to be used in printing inks. The concept of critical resinate concentration, c crit, was introduced to define an abrupt change in viscosity dependence on resinate concentration in the solution. The concept was then used to explain the non-inear solution viscosity increase during resinate syntheses. A semi empirical model with two estimated parameters was derived for the viscosity increase on the basis of apparent reaction kinetics. The model was used to control the viscosity and to predict the total reaction time of the resinate process. The kinetic data from the complex reaction media was obtained by acid value titration and by FTIR spectroscopic analyses using a conventional calibration method to measure the resinate concentration and the concentration of free rosin acids. A multivariate calibration method was successfully applied to make partial least square (PLS) models for monitoring acid value and solution viscosity in both mid-infrared (MIR) and near infrared (NIR) regions during the syntheses. The calibration models can be used for on line resinate process monitoring. In kinetic studies, two main reaction steps were observed during the syntheses. First a fast irreversible resination reaction occurs at 235 °C and then a slow thermal decarboxylation of rosin acids starts to take place at 265 °C. Rosin oil is formed during the decarboxylation reaction step causing significant mass loss as the rosin oil evaporates from the system while the viscosity increases to the target level. The mass balance of the syntheses was determined based on the resinate concentration increase during the decarboxylation reaction step. A mechanistic study of the decarboxylation reaction was based on the observation that resinate molecules are partly solvated by rosin acids during the syntheses. Different decarboxylation mechanisms were proposed for the free and solvating rosin acids. The deduced kinetic model supported the analytical data of the syntheses in a wide resinate concentration region, over a wide range of viscosity values and at different reaction temperatures. In addition, the application of the kinetic model to the modified resinate syntheses gave a good fit. A novel synthesis method with the addition of decarboxylated rosin (i.e. rosin oil) to the reaction mixture was introduced. The conversion of rosin acid to resinate was increased to the level necessary to obtain the target viscosity for the product at 235 °C. Due to a lower reaction temperature than in traditional fusion synthesis at 265 °C, thermal decarboxylation is avoided. As a consequence, the mass yield of the resinate syntheses can be increased from ca. 70% to almost 100% by recycling the added rosin oil.

Óxidos de ferro e monazita de areias de praias do Espírito Santo

Sand samples collected from two sampling sites on Guarapari and Iriri beaches, state of Espírito Santo, Brazil, were studied in an attempt to better describe their chemical and mineralogical compositions and radioactive behaviors. The sands were found to contain about 6 (Guarapari) and 2 dag kg-1 (Iriri) of rare earth and thorium that, if allocated to the monazite-(Ce) structure, lead to the averaged formulae Ce3+0,494Gd3+0,012La3+0,209Nd3+0,177Pr3+0,040Sm3+0,024Th4+0,033 (PO4) and Ce3+0,474La3+0,227Nd3+0,190Pr3+0,044Sm3+0,032Th4+0,024 (PO4). From Mössbauer spectroscopy data, the magnetic fractions of these sands were found to contain stoichiometric hematite (47.4 dag kg-1, from Guarapari, and 25.1 dag kg-1, from Iriri) and magnetite (44.1 and 58.8 dag kg-1). The specific alpha and beta radiation activities were also measured for both samples.

epiCentre!: rehabilitació de Ca n'Oliver com a centre d'art

Award-winning

Magnetic Perovskites Sr2FeMoO6 and La(1-x)Ca(x)MnO3: Synthesis, Fabrication and Characterization of Nanosized Powders and Thin Films

Due to font problem on the tilte field the titlte of the thesis is corrected here. The title of the thesis is: Magnetic Perovskites Sr₂FeMoO₆ and La_(1-x)Ca<sub>(x)MnO₃: Synthesis, Fabrication and Characterization of Nanosized Powders and Thin Films

Nutrientes (K, P, Ca, Na, Mg e Fe) em sedimentos (solos aluviais) e cultivares (feijão e milho) de praias e barrancos de rios de água branca: a bacia do purus no estado do Acre, Brasil

The present research highlights the macronutrient abundance in the sediments of beaches and cliffs and cultivates in the river Purus and flowing, southwest of Amazon. The concentrations found in leaves and bean seeds and corn leaves reflect the mineralogical and chemical nature of those rich sediments in K2O and Na2O, which are formed by smectite, illite and K-feldspar. The factors of transfer of the elements in the corn leaves and bean (Ca>K>Na) and bean seeds (Na>K>Ca) demonstrate that the nutrient needs of the cultivate were found appropriately in the sediments (soils) of the beaches and cliffs.

Avaliação da qualidade de sedimentos - estudo de caso: sub-bacia do Ribeirão Espírito Santo, afluente do Rio São Francisco

This study evaluated the environmental impact resulting from surface water and sediment contamination by metals in a watershed affected by a tailing basin that controls effluents coming from a zinc-ore beneficiation plant. The studies combined assessments of sediment chemistry (exceedances of sediment quality guidelines), benthic assemblage structure and acute and chronic ecotoxicity. The results showed that the levels of metal contamination in sediments are not yet enough to cause deleterious effects to the biota. However, the ecotoxicity tests indicated the occurrence of chronic effects, demonstrating that other factors, as the use of fertilizers, could also be a source of contamination.

Determinação direta de Ca, Mg, Mn e Zn em amostras de leite de búfala da Ilha de Marajó por espectrometria de absorção atômica com chama (FAAS)

This work proposes an analytical procedure for direct determination of calcium, magnesium, manganese and zinc in buffalo milk by flame atomic absorption spectrometry (FAAS). Samples were diluted with a solution containing 10% (v/v) of water-soluble tertiary amines (CFA-C) at pH 8. For comparison, buffalo milk samples were digested with HNO3 and H2O2. According to a paired t-test, the results obtained in the determination of Ca, Mg, Mn and Zn in digested samples and in 10% (v/v) CFA-C medium were in agreement at a 95% confidence level. The developed procedure is simple, rapid, decrease the possibility of contamination and can be applied for the routine determination of Ca, Mg, Mn and Zn in buffalo milk samples without any difficulty caused by matrix constituents, such as fat content, and particle size distribution in the milk emulsion.

Aplicação de métodos quimiométricos na otimização da extração de Ca, Mg, K, Fe, Zn, Cu e Mn em folhas de braquiária

This work applied a 2² factorial design to the optimization of the extraction of seven elements (calcium, magnesium, potassium, iron, zinc, copper and manganese) in brachiaria leaves, determined by flame atomic absorption spectrometry. The factors sample mass and digestion type were evaluated at two levels: 200/500 mg, and dry/wet, respectively. Principal component analysis allowed simultaneous discrimination of all the significant effects in one biplot. Wet digestion and mass of 200 mg were considered the best conditions. The decrease of 60% in sample mass allowed to save costs and reagents. The method was validated through the estimation of figures of merit.

Chumbo e cádmio detectados em alimentos vegetais e gramíneas no município de Santo Amaro-Bahia

This study evaluated the level of the metals Pb mg kg-1 and Cd mg kg-1 found in plant species and the contribution of the levels detected in contaminated soils located in the urban area of the city of Santo Amaro, Bahia. Levels were determined by graphite furnace and flame atomic absorption spectrometry. The results showed the presence of Pb and Cd in plant species at levels ranging from 0.18 to 118.2 mg kg-1 and 0.04 to 7.29 mg kg-1, respectively. The concentration values obtained varied according to the plant species and were not strongly influenced by the concentration values detected in the soil.