Cynodon dactylon, Green Couch Grass, Bermuda Grass 'Winter Gem'

‘Winter Gem’ is a selection from a cross between ‘Wintergreen’ and Couch 5 (also designated C5). Couch 5 was a selection from an earlier series of crosses by the breeder between ‘Wintergreen’ and a number of Cynodon dactylon accessions, which were collected by the breeder from the Mornington Peninsula area of Victoria between 1986 and 1990. C5 was an experimental breeding line, and was not subsequently reserved as vegetative germplasm. Living material of C5 is no longer in existence. Following the crossing of Couch 5 and ‘Wintergreen’ in 1998, the resultant seed was germinated on moist blotting paper. Individual seedlings, a total of 150 in number, were planted into 150mm pots and these plants observed during 1998 and 1999. During the summer of 1999-2000, the majority of the seedling plants were culled on the basis of their shoot density, leaf texture, internode length, and colour. In the spring of 2000, the remaining 20 potted seedlings were planted individually into 4m2 plots at the Evergreen Turf farm at Pakenham (Victoria), and allowed to expand fully across these plots. The final selection of Seedling 9 (later designated DN9) in late 2002 was based on shoot density, leaf texture, and retention of winter colour as expressed in these plots. Propagation: The original plant had been multiplied through four (4) vegetative expansions prior to PBR application without showing any discernible off types. Breeder: David Nickson, Frankston, VIC. PBR Certificate Number 3132, Application Number 2005/290, granted 11 September 2006.

Cynodon transvaalensis x Cynodon dactylon, Hybrid Green Couch Grass, Hybrid Bermuda Grass 'P18'

‘P18’ was first produced in 1992 and is a mutant genotype obtained from a hybrid Bermudagrass line believed to be ‘Tifdwarf’, which was grown in a greenhouse owned by H&H Seed Company in Yuma, Arizona. ‘P18’ was selected for its extremely fine leaf texture, its high shoot density under close mowing, its rapid growth rate, and its uniform dark green colour, and was subsequently evaluated for these traits and characteristics. Propagation: vegetative. Breeder: Howard E. Kaewer, Eden Prairie, MN, USA. PBR Application Number 2007/179, Certificate Number 3567, granted 13 August 2007.

Paspalum vaginatum Swartz, Seashore Paspalum 'SDX-1'

‘SDX-1’ originated as an open-pollinated chance seeding in an old green of ‘Adalayd’ seashore paspalum (US Plant Patent 3939) surrounded by an undefined local ecotype of the same species. ‘SDX-1’ was finer textured and had a denser, more prostrate growth habit than its putative parents which are ‘Adalayd’ (maternal) and an undefined parental genotype growing among the surrounding local ecotype. ‘SDX-1’ was compared with other promising seedlings discovered similarly at the same time, and was selected on the basis of its dwarf growth habit, tolerance of low cutting height, turf density, fine-textured growth, and apparent salt tolerance under field conditions. Breeder: Stewart T Bennett, Paul H Tillman, Michael DePew, Enviro Turf LC, Terkonsha, MI, USA. PBR Certificate Number 3660, Application Number 2006/160, granted 16 December 2008.

Zoysia matrella, Manila Grass 'A-1'

‘A-1’ was selected from a breeding population of 40 seedling Zoysia matrella plants from various parts of Southeast Asia (Japan, Philippines, China, Korea, Vietnam and Thailand). The original plants were vegetatively propagated and evaluated first in pots. A shortlist of selected genotypes was expanded to field plantings at Sheldon, QLD and evaluated against existing Z. matrella and Z. matrella x Z. japonica hybrid cultivars under mowing heights from 10 to 25mm and under shade levels ranging from 0 to 80%. ‘A-1’ showed higher tiller density and a more prostrate growth habit than the parent ecotype, and was selected from the subsequent breeding population on the basis of its superior turf colour and quality under mowing for 6 years and its shade tolerance as shown by its ability to maintain density of the mown sward under greatly reduced light levels (70-80% shade). Additional observations regarding climatic adaptation were made in Cairns, QLD, and Melbourne, VIC, respectively. Breeder: Donald S Loch, Alexandra Hills, QLD. PBR Certificate Number 3649, Application Number 2008/091, granted 16 December 2008.

Enhancement of Tunneling Density of States at a Junction of Three Luttinger Liquid Wires

We study the tunneling density of states (TDOS) for a junction of three Tomonaga-Luttinger liquid wires. We show that there are fixed points which allow for the enhancement of the TDOS, which is unusual for Luttinger liquids. The distance from the junction over which this enhancement occurs is of the order of x=v/(2 omega), where v is the plasmon velocity and omega is the bias frequency. Beyond this distance, the TDOS crosses over to the standard bulk value independent of the fixed point describing the junction. This finite range of distances opens up the possibility of experimentally probing the enhancement in each wire individually.

Design of a Near Optimum Regulator for a Power Plant

For systems which can be decomposed into slow and fast subsystems, a near optimum linear state regulator consisting of two subsystem regulators can be developed. Depending upon the desired criteria, either a short term (fast controller) or a long term controller (slow controller) can be easily designed with minimum computational costs. Using this approach an example of a power system supplying a cyclic load is studied and the performance of the different controllers are compared.

Factors contributing to wear tolerance of Bermudagrass (Cynodon dactylon (L.) Pers., C. dactylon x C. transvaalensis Burtt-Davey) on a sand-based profile under simulated sports field conditions

Wear resistance and recovery of 8 Bermudagrass (Cynodon dactylon (L.) Pers.) and hybrid Bermudagrass (C. Dactylon x C. transvaalensis Burtt-Davey) cultivars grown on a sandbased soil profile near Brisbane, Australia, were assessed in 4 wear trials conducted over a two year period. Wear was applied on a 7-day or a 14-day schedule by a modified Brinkman Traffic Simulator for 6-14 weeks at a time, either during winter-early spring or during summer-early autumn. The more frequent wear under the 7-day treatment was more damaging to the turf than the 14-day wear treatment, particularly during winter when its capacity for recovery from wear was severely restricted. There were substantial differences in wear tolerance among the 8 cultivars investigated, and the wear tolerance rankings of some cultivars changed between years. Wear tolerance was associated with high shoot density, a dense stolon mat strongly rooted to the ground surface, high cell wall strength as indicated by high total cell wall content, and high levels of lignin and neutral detergent fiber. Wear tolerance was also affected by turf age, planting sod quality, and wet weather. Resistance to wear and recovery from wear are both important components of wear tolerance, but the relative importance of their contributions to overall wear tolerance varies seasonally with turf growth rate.

WHIPPET: a novel tool for prioritizing invasive plant populations for regional eradication

Large geographic areas can have numerous incipient invasive plant populations that necessitate eradication. However, resources are often deficient to address every infestation. Within the United States, weed lists (either state-level or smaller unit) generally guide the prioritization of eradication of each listed species uniformly across the focus region. This strategy has several limitations that can compromise overall effectiveness, which include spending limited resources on 1) low impact populations, 2) difficult to access populations, or 3) missing high impact populations of low priority species. Therefore, we developed a novel science-based, transparent, analytical ranking tool to prioritize weed populations, instead of species, for eradication and tested it on a group of noxious weeds in California. For outreach purposes, we named the tool WHIPPET (Weed Heuristics: Invasive Population Prioritization for Eradication Tool). Using the Analytic Hierarchy Process that included expert opinion, we developed three major criteria, four sub-criteria, and four sub-sub-criteria, taking into account both species and population characteristics. Subject matter experts weighted and scored these criteria to assess the relative impact, potential spread, and feasibility of eradication (major criteria) for 100 total populations of 19 species. Species-wide population scores indicated that conspecific populations do not necessarily group together in the final ranked output. Thus, priority lists based solely on species-level characteristics are less effective compared to a blended prioritization based on both species attributes and individual population and site parameters. WHIPPET should facilitate a more efficacious decision-making process allocating limited resources to target invasive plant infestations with the greatest predicted impacts to the region under consideration.

Refining the process of agent selection through understanding plant demography and plant response to herbivory

Understanding plant demography and plant response to herbivory is critical to the selection of effective weed biological control agents. We adopt the metaphor of 'filters' to suggest how agent prioritisation may be improved to narrow our choices down to those likely to be most effective in achieving the desired weed management outcome. Models can serve to capture our level of knowledge (or ignorance) about our study system and we illustrate how one type of modelling approach (matrix models) may be useful in identifying the weak link in a plant life cycle by using a hypothetical and an actual weed example (Parkinsonia aculeata). Once the vulnerable stage has been identified we propose that studying plant response to herbivory (simulated and/or actual) can help identify the guilds of herbivores to which a plant is most likely to succumb. Taking only potentially effective agents through the filter of host specificity may improve the chances of releasing safe and effective agents. The methods we outline may not always lead us definitively to the successful agent(s), but such an empirical, data-driven approach will make the basis for agent selection explicit and serve as testable hypotheses once agents are released.

Technical highlights: Invasive plant and animal research 2009-10

Technical highlights 2009–10, with detailed progress reports on the latest invasive plant and animal research undertaken by Biosecurity Queensland, a service unit of the Department of Employment, Economic Development and Innovation.

Technical highlights: Invasive plant and animal research 2008-09

Technical highlights 2008–09, with detailed progress reports on the latest invasive plant and animal research undertaken by Biosecurity Queensland, a service unit of the Department of Employment, Economic Development and Innovation.

Technical highlights: Invasive plant and animal research 2007-08

Technical highlights 2007–08, with detailed progress reports on the latest invasive plant and animal research undertaken by Biosecurity Queensland, a service unit of the Department of Primary Industries and Fisheries.

Adventures in plant anatomy – not just a pigment of my imagination

An overview of teaching and research activities in the area of plant anatomy at QUT is provided. The current status of teaching of technical skills in plant anatomy is discussed briefly. Examples of applications of plant anatomy to a diverse range of fields are provided, including the crossover between art and science.

Effects of stage of defoliation on seed production and growth of Stylosanthes humilis.

Stylosanthes humilis swards grown at Brisbane in irrigated boxes were defoliated (about 60 per cent removal of tops) at floral initiation, first flower appearance, or advanced flowering stages ; seed yield was 45, 16, and 14 per cent respectively of seed yield in undefoliated swards. Decreased yields were primarily due to poor seed set of florets, were also associated with reduced inflorescence density and floret number per inflorescence, and occurred despite increases (in some defoliation treatments) in seed size, leaf growth rate, and differentiation of leaves and branches. Total seasonal plant growth was independent of defoliation treatment.