Optimisation of environmental gas cleaning routes for solid wastes cogeneration systems. Part II - Analysis of waste incineration combined gas/steam cycle

In the first paper of this paper (Part I), conditions were presented for the gas cleaning technological route for environomic optimisation of a cogeneration system based in a thermal cycle with municipal solid waste incineration. In this second part, an environomic analysis is presented of a cogeneration system comprising a combined cycle composed of a gas cycle burning natural gas with a heat recovery steam generator with no supplementary burning and a steam cycle burning municipal solid wastes (MSW) to which will be added a pure back pressure steam turbine (another one) of pure condensation. This analysis aims to select, concerning some scenarios, the best atmospheric pollutant emission control routes (rc) according to the investment cost minimisation, operation and social damage criteria. In this study, a comparison is also performed with the results obtained in the Case Study presented in Part I. (c) 2007 Elsevier Ltd. All rights reserved.

Optimisation of environmental gas cleaning routes for solid wastes cogeneration systems - Part I - Analysis of waste incineration steam cycle

Research of advanced technologies for energy generation contemplates a series of alternatives that are introduced both in the investigation of new energy sources and in the improvement and/or development of new components and systems. Even though significant reductions are observed in the amount of emissions, the proposed alternatives require the use of exhaust gases cleaning systems. The results of environmental analyses based on two configurations proposed for urban waste incineration are presented in this paper; the annexation of integer (Boolean) variables to the environomic model makes it possible to define the best gas cleaning routes based on exergetic cost minimisation criteria. In this first part, the results for steam cogeneration system analysis associated with the incineration of municipal solid wastes (MSW) is presented. (c) 2007 Elsevier Ltd. All rights reserved.

Structural characterization of wild rubbers, microstructure of the rubber extracted from ficus elastica by C-13-NMR

Low molecular weight fractions of polyisoprene extracted from Ficus elastica Herb. ex Hornem. were studied by C-13-NMR. The identification of 2-3 trans terminal units at the end of the polymer chain needed the acquisition of more than 17 000 transients. (C) 2000 Elsevier B.V. Ltd. All rights reserved.

Banana Peel Applied to the Solid Phase Extraction of Copper and Lead from River Water: Preconcentration of Metal Ions with a Fruit Waste

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Study of charge transport in blends of natural rubber and poly(o-methoxyaniline) based on a resistor network statistical model

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

A comparative study of the non-isothermal degradation of natural rubber from Mangabeira (Hancornia speciosa Gomes) and Seringueira (Hevea brasiliensis)

Due to the increasing search for alternative sources of natural rubber (NR) whose properties are similar to Hevea brasiliesis, several sources have been studied in the past few years. Among them, Mangabeira (Hancornia speciosa Gomes), which is native to Amazon rainforest and other regions of Brazil, has a potential as another viable rubber source. As a continuation of a series of comparative studies between Hancornia and Hevea (clone RRIM 600) these two species by our research team, their thermal behavior was analyzed by thermogravimetry (TG) using Flynn-Wall-Ozawa's approach in order to obtain kinetic parameters (reaction order, pre-exponential factor and activation energy) of the decomposition process. Results indicated that the thermal behavior of NR from Hancornia was comparable to Hevea with some differences observed as follows: reaction order for Hancornia was higher than for Hevea at the beginning of degradation and very close for temperatures over 350 A degrees C; activation energy and pre-exponential factor had the same trend, i.e., increased with increasing degree of conversion remaining almost constant between 20 and 70% and then increasing for higher degrees, although Hevea was slightly more thermally stable than Hancornia. These major influences in the degradation process in the early stage are attributed to differences in non-rubber constituents present in these two species.

Comparative Study on the Technological Properties of Latex and Natural Rubber from Hancornia speciosa Gomes and Hevea brasiliensis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Type C botulism in swine fed on restaurant waste

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Studies on productivity and characterization of polygalacturonase from Aspergillus giganteus submerged culture using citrus pectin and orange waste

Polygalacturonases are part of the group of enzymes involved in pectin degradation. The aim of this work was to investigate some of the factors affecting polygalacturonase production by an Aspergillus giganteus strain and to characterize this pectinolytic activity. Several carbon sources, both pure substances and natural substrates, were tested in standing cultures, and the best results were obtained with orange bagasse and purified citrus pectin. on citrus pectin as sole carbon source, the highest extracellular activity (9.5 U/ml and 40.6 U/mg protein) was obtained in 4.5-day-old cultures shaken at 120 rpm, pH 3.5 and 30 degrees C, while on orange bagasse, the highest extracellular activity (48.5 U/ml and 78.3 U/mg protein) was obtained in 3.5-day-old cultures shaken at 120 rpm, pH 6.0 and 30 degrees C. Optimal polygalacturonase activity was observed in assays conducted at pH 5.5-6.5 and 55-60 degrees C. The activity showed good thermal stability, with half-lives of 90 and 30 min when incubated at 55 and 60 degrees C, respectively. High stability was observed from pH 4.5 to 8.5; more than 90% of the activity remained after 24 h in this pH range.

Structure and Applications of a Rhamnolipid Surfactant Produced in Soybean Oil Waste

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Biological cycle of Lorryia formosa (Acari, Tydeidae) on rubber tree leaves: A case of thelytoky

Lorryia formosa Cooreman has been collected on many different host plants around the world. The biological cycle of this species was studied at 28 degrees C with mites collected from a rubber tree crop. The life table was constructed based on sixty individuals. The average lifetime was 37.43 +/- 20.23 (SE) days, and the r(m) was 0.08. The sex ratio was totally female biased, and unfertilized eggs developed into females. This is the first record of thelytoky in Tydeoidea proved by rearing.

Properties of a biosurfactant produced by Bacillus pumilus using vinasse and waste frying oil as alternative carbon sources

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Changes in leaf physiology caused by Calacarus heveae (Acari, Eriophyidae) on rubber tree

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Seasonal suitability of three rubber tree clones to Calacarus heveae (Acari, Eriophyidae)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Biological cycle of Tenuipalpus heveae Baker (Acari, Tenuipalpidae) on leaflets of three rubber tree clones

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)