Unsuccessful attacks dominate a drone-preying wasp's hunting performance near stingless bee nests

Bee males (drones) of stingless bees tend to congregate near entrances of conspecific nests, where they wait for virgin queens that initiate their nuptial flight. We observed that the Neotropical solitary wasp Trachypus boharti (Hymenoptera, Cabronidae) specifically preys on males of the stingless bee Scaptotrigona postica (Hymenoptera, Apidae); these wasps captured up to 50 males per day near the entrance of a single hive. Over 90% of the wasp attacks were unsuccessful; such erroneous attacks often involved conspecific wasps and worker bees. After the capture of non-male prey, wasps almost immediately released these individuals unharmed and continued hunting. A simple behavioral experiment showed that at short distances wasps were not specifically attracted to S. postica males nor were they repelled by workers of the same species. Likely, short-range prey detection near the bees' nest is achieved mainly by vision whereas close-range prey recognition is based principally on chemical and/or mechanical cues. We argue that the dependence on the wasp's visual perception during attack and the crowded and dynamic hunting conditions caused wasps to make many preying attempts that failed. Two wasp-density-related factors, wasp-prey distance and wasp-wasp encounters, may account for the fact that the highest male capture and unsuccessful wasp bee encounter rates occurred at intermediate wasp numbers.

Performance of body fat and body mass index cutoffs in elevated blood pressure screening among male children and adolescents

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

RESPONSES of HEMATOLOGICAL PARAMETERS and AEROBIC PERFORMANCE of ELITE MEN and WOMEN SWIMMERS DURING A 14-WEEK TRAINING PROGRAM

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

THE INFLUENCE of RESTING PERIOD LENGTH on JUMPING PERFORMANCE

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Thermal performance of multipass parallel and counter-cross-flow heat exchangers

A thorough study of the thermal performance of multipass parallel cross-flow and counter-cross-flow heat exchangers has been carried out by applying a new numerical procedure. According to this procedure, the heat exchanger is discretized into small elements following the tube-side fluid circuits. Each element is itself a one-pass mixed-unmixed cross-flow heat exchanger. Simulated results have been validated through comparisons to results from analytical solutions for one- to four-pass, parallel cross-flow and counter-cross-flow arrangements. Very accurate results have been obtained over wide ranges of NTU (number of transfer units) and C* (heat capacity rate ratio) values. New effectiveness data for the aforementioned configurations and a higher number of tube passes is presented along with data for a complex flow configuration proposed elsewhere. The proposed procedure constitutes a useful research tool both for theoretical and experimental studies of cross-flow heat exchangers thermal performance.

Processing of high performance composites based on peek by aqueous suspension prepregging

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Performance, carcass traits, meat quality and economic analysis of feedlot of young bulls fed oilseeds with and without supplementation of vitamin E

The objective of this research was to evaluate average daily gain (ADG), carcass traits, meat tenderness and profitability of keeping cattle fed different oilseeds and vitamin E in feedlot. A total of 40 Red Norte young bulls with initial average body weight of 339±15 kg were utilized. The experimental design was completely randomized in a 2 × 2 factorial arrangement. The experiment lasted 84 days and experimental diets presented soybeans or cottonseeds as lipid sources associated or not to daily supplementation of 2,500 UI vitamin E per animal. The concentrate:roughage ratio was 60:40. Diets had the same amount of nitrogen (13% CP) and ether extract (6.5%). The data were analyzed by means of statistical software SAS 9.1. Neither vitamin supplementation nor lipid source affected ADG. There was no interaction between lipid source and vitamin supplementation for the variables studied. The inclusion of cottonseed reduced the carcass yield. There was no effect of diets on hot and cold carcass weights or prime cuts. The inclusion of cottonseed reduced the backfat thickness. No effect of experimental diets on the rib-eye area was observed. There was no effect of lipid source or vitamin supplementation on meat tenderness, which was affected, however, by ageing time. Diets with soybeans presented higher cost per animal. The utilization of soybean implied reduction of the gross margin (R$ 59.17 and R$ 60.51 for diets based on soy with and without supplemental vitamin, respectively, vs. R$ 176.42 and R$ 131.79 for diets based on cottonseed). The utilization of cottonseed enables improvement of profitability of feedlot fattening, in spite of negatively affecting some carcass characteristics.

Diurnal variation in oral temperature, sleepiness and performance of high school girls

Evaluation of rhythmic fluctuations cf physical and mental variables should be of special significance for the understanding of students' performance and setting the schedules of school activities. The present study investigated the pattern of diurnal variation in oral temperature, sleepiness and performance of a group of adolescents undergoing a daytime school schedule. Eighteen girls (mean age 16 years-old), who attended the same class from 0715h to 1645h, were tested on seven days. They measured their oral temperature, quantified their sleepiness level by means of a visual analogue scale, and completed the following tests: letter cancellation test, addition test, and a simple motor task. One-way ANOVA statistics for repeated measures was used in order to verify the effect of test time on oral temperature,sleepiness and performance. Possible correlations between the level of sleepiness and performance were investigated by means of Spearman rank correlation. The results revealed significant time of day effect cn all variables, except for the number of addition errors. Oral temperature values showed an increase from morning to afternoon. Letter cancellation, motor task and addition scores increased from early morning to late afternoon, showing rapid fluctuations throughout the day. Sleepiness level was negatively correlated with letter cancellation scores during the first three tests of the day. In agreement with other work, the diurnal variation of oral temperature, letter cancellation and addition test showed an improvement as the day progressed. Sleepiness, on the other hand, decreased throughout the day, with the highest level associated with the first test of the day, suggesting a circadian pattern of variation rather than a cumulative effect due to school activities.

Coating residual stress effects on fatigue performance of 7050-T7451 aluminum alloy

The tendency of the aircraft industry is to enhance customer value by improving performance and reducing environmental impact. In view of availability, aluminum alloys have a historically tendency to faster insertion due to their lower manufacturing and operated production infrastructure. In landing gear components, wear and corrosion control of many components is accomplished by surface treatments of chrome electroplating on steel or anodizing of aluminum. One of the most interesting environmentally safer and cleaner alternatives for the replacement of hard chrome plating or anodizing is tungsten carbide thermal spray coating, applied by the high velocity oxy fuel (HVOF) process. However, it was observed that residual stresses originating from these coatings reduce the fatigue strength of a component.An effective process as shot peening treatment, considered to improve the fatigue strength, pushes the crack sources beneath the surface in most of medium and high cycle cases, due to the compressive residual stress field induced. The objective of this research is to evaluate a tungsten carbide cobalt (WC-Co) coating applied by the high velocity oxy fuel (HVOF) process, used to replace anodizing. Anodic films were grown on 7050-T7451 aluminum alloy by sulfuric acid anodizing, chromic acid anodizing and hard anodizing. The influence on axial fatigue strength of anodic films grown on the aluminum alloy surface is to degrade the stress-life performance of the base material. Three groups of specimens were prepared and tested in axial fatigue to obtain S-N curves: base material, base material coated by HVOF and base material shot peened and coated.Experimental results revealed increase in the fatigue strength of Al 7050-T7451 alloy associated with the WC 17% Co coating. on the other hand, a reduction in fatigue life occurred in the shot peened and coated condition. Scanning electron microscopy technique and optical microscopy were used to observe crack origin sites, thickness and coating/substrate adhesion. (c) 2007 Elsevier B.V. All rights reserved.

Adhesive performance of dentin bonding agents applied in vivo and in vitro. Effect of intrapulpal pressure and dentin depth

The purpose of this study was to evaluate the influence of intrapulpal pressure and dentin depth on bond strengths of an etch-and-rinse and a self-etching bonding agent to dentin in vitro and in vivo. Twenty-four pairs of premolars were randomly divided into four groups (n = 6) according to the dentin bonding agent, Single Bond and Clearfil SE Bond, and intrapulpal pressure, null or positive. Each tooth of the pair was further designated to be treated in vivo or in vitro. The intrapulpal pressure was controlled in vivo by the delivery of local anesthetics containing or not a vasoconstrictor, while in vitro, it was achieved by keeping the teeth under hydrostatic pressure. Class I cavities were prepared and the dentin bonding agents were applied followed by incremental resin restoration. For the teeth treated in vitro, the same restorative procedures were performed after a 6 month-storage period. Beams with I mm 2 cross-sectional area were prepared and, microtensile tested. Clearfil SE Bond was not influenced by any of the variables of the study, while bond strengths produced in vitro were significatly higher for Single Bond. Overall, lower bond strengths were produced in deep dentin, which reached statistical significance when Single Bond was applied under physiological or simulated intrapulpal pressure. In conclusion, in vitro bonding may overestimate the immediate adhesive performance of more technique-sensitive dentin bonding systems. The impact of intrapulpal pressure on bond strength seems to be more adhesive dependent than dentin morphological characteristics related to depth. (C) 2007 Wiley Periodicals, Inc.

Evaluation of the performance of pharmacists in terms of providing health assistance at a university hospital

OBJETIVE: This study aimed to assess the practices of pharmacists in Hospital Care. Method - we interviewed 20 pharmacists from the Pharmacy Division by applying a structured instrument, in September 2005. This instrument addressed aspects related to the main activities at the Hospital Pharmacy, which were assessed according to indicators organized into five areas: sector management, hospital pharmacotechniques, committee activities, information and pharmacotherapeutic follow-up, as well as teaching and research activities.RESULTS: the Pharmacy Division considered all structural aspects under analysis as essential for the good development and application of its services. We found that some essential services, such as the Medication Information Service and Pharmacotherapeutic Follow-up, were absent. Pharmacist professionals were dissatisfied about human resource and physical structure dimensioning, and they presented as not very active in terms of Pharmaceutical Care.CONCLUSION: Results indicate that care is still centered on the drug, with few clinical activities. We suggest reformulations in service management, particularly in the management of pharmacists.

Dietary vitamin or mineral mix removal during the finisher period on broiler chicken performance

The effect of dietary vitamin (VS) and mineral (MS) mix withdrawal between 42 and 49 d of age on broiler chicken performance was evaluated. The diets were formulated based on corn and soybean meal, and the experiments were conducted in floor pens using wood shavings as litter. Trial I evaluated withdrawal of VS and MS mix at 42, 45, and 49 d. The results of this trial showed that VS and MS mix withdrawal at 42 d of age did not impair feed intake (FI) or weight gain (WG), but feed conversion (FC) was improved (P = 0.043) when both mixes were maintained in the diets until 49 d of age. Trial 2 assessed the withdrawal of VS or MS mix at 42 d of age. FI and WG were not affected by withdrawal, but FC was poorer (P = 0.035) for the broilers fed the diet without VS. The relative liver weight was reduced by VS or MS mix withdrawal (P = 0.014 and P = 0.001, respectively). Carcass, breast, and leg yields were not affected by VS or MS mix withdrawals in either trial. The findings of the study suggested that VS mix withdrawal during the final period of broiler chicken growth was more deleterious than the withdrawal of MS mix, because it affected FC ratio. VS or MS withdrawal during this period did not affect carcass yield.

Use of Yucca schidigera extract in broiler diets and its effects on performance results obtained with different coccidiosis control methods

A trial was conducted to assess the effects of the dietary supplement Yucca schidigera extract on the performance of broilers subjected to different coccidiosis control methods. Six hundred male broiler chicks were randomly allocated to 1 of 5 treatments with 4 replicates each. The treatments were as follows: T1, vaccinated against coccidiosis; T2, nonvaccinated, a dietary coccidiostat; T3, vaccinated against coccidiosis, diet supplemented with Y. schidigera extract (0.01%); T4, coccidiostat plus Y. schidigera extract added to feed (0.01%); and T5, nonvaccinated, nonsupplemented control. The parameters analyzed were bird performance and morphology of the intestinal mucosal surface. The intestinal villi were higher at 6 d of age in broilers treated with coccidiostats or vaccinated against coccidiosis and supplemented with Y. schidigera extract compared with groups receiving the vaccine only or no treatment. Addition of the Y. schidigera extract to the diet of vaccinated birds improved average daily gain and feed conversion rate at 42 d of age compared with the other treatments, suggesting there might be a beneficial, synergistic effect between the coccidiosis vaccine and the Y. schidigera extract.