Self-defence against terrorism in the post 9/11 world

In 1986 the then United States Secretary of State George Shultz asserted that: It is absurd to argue that international law prohibits us from capturing terrorists in international waters or airspace; from attacking them on the soil of other nations, even for the purpose of rescuing hostages; or from using force against states that support, train and harbor terrorists or guerrillas. At that time the United States’ claim of a right to use military force in self-defence against terrorism2 received little support from other states.3 The predominant view then was that terrorist attacks committed by private or non-state actors were a form of criminal activity to be combated through domestic and international criminal justice mechanisms. The notion that such terrorist acts should be treated as ‘armed attacks’ triggering a victim state’s right of self-defence was not accepted by the majority of states. To suggest, as Shultz had done, that a state not directly responsible for terrorist acts could have its territorial integrity violated by military action targeting terrorists located within that state, was a controversial proposition in 1986. However, some fifteen years later, when the United States and a coalition of allies launched a military campaign in Afghanistan following the 11 September 2001 (hereafter ‘9/11’) terrorist attacks, there was virtually unanimous international support for the use of force.

Check-in processing : simulation of passengers with advanced traits

In order to tackle the growth of air travelers in airports worldwide, it is important to simulate and understand passenger flows to predict future capacity constraints and levels of service. We discuss the ability of agent-based models to understand complicated pedestrian movement in built environments. In this paper we propose advanced passenger traits to enable more detailed modelling of behaviors in terminal buildings, particularly in the departure hall around the check-in facilities. To demonstrate the concepts, we perform a series of passenger agent simulations in a virtual airport terminal. In doing so, we generate a spatial distribution of passengers within the departure hall to ancillary facilities such as cafes, information kiosks and phone booths as well as common check-in facilities, and observe the effects this has on passenger check-in and departure hall dwell times, and facility utilization.

Bringing protection home : healing the schism between international obligations and national safeguards created by extraterritorial processing

Extraterritorial processing schemes are designed to prevent and deter access to statutory and judicial safeguards in the country responsible for the interception and transfer of asylum seekers to a third country. In line with this objective, they incorporate interdiction, transfer and processing practices and standards that are deliberately isolated from the national legal and institutional protections within either the intercepting state or the third country where processing occurs. Australia's recent disbandment of its extraterritorial processing centres in third countries highlights the fact that extraterritorial processing schemes have proven unworkable as a matter of international law, as they negate the national safeguards fundamental to the satisfaction of a state's protection obligations.

The last post? Tracking the Australasian to Aussie Post, 1864-2002

Aussie Post, the flagship of ocker Australiana, folded in January 2002. Post began life as the Australasian, a middlebrow magazine steeped in a nineteenth century civics of stable citizenship with a modicum of diversionary leisure. The transformation began when the Australasian became Australasian Post in 1946 under George Johnston's brief 15-week editorship. Johnston's idealistic vision of Post as a voice of post-war Australian modernity was soon overtaken by commercial imperatives as Post's identity wavered between its civic antecedents and a new low-brow populism, a niche it had finally settled into by the mid-1950s. This tension between staid civics and risqué populism shaped the magazine's long evolution into its final realisation of the pictorial general interest genre. This paper, based on a close examination of the magazines themselves, tracks Post's generic evolution and focuses on the struggle to redefine the magazine’s identity during the post-war period when the axis of Australian identity was reluctantly shifting from the staid traditions of Rule Britannia to the flashy modernity of Pax Americana.

Legal ethics in a post-Westphalian world : building the international rule of law and otehr tasks

The emergence of strong sovereign states after the Treaty of Westphalia turned two of the most cosmopolitan professions (law and arms) into two of the least cosmopolitan. Sovereign states determined the content of the law within their borders – including which, if any, ecclesiastical law was to be applied; what form of economic regulation was adopted; and what, if any, international law applied. Similarly, states sought to ensure that all military force was at their disposal in national armies. The erosion of sovereignty in a post-Westphalian world may significantly reverse these processes. The erosion of sovereignty is likely to have profound consequences for the legal profession and the ethics of how, and for what ends, it is practised. Lawyers have played a major role in the civilization of sovereign states through the articulation and institutionalisation of key governance values – starting with the rule of law. An increasingly global profession must take on similar tasks. The same could be said of the military. This essay will review the concept of an international rule of law and its relationship to domestic conceptions and outline the task of building the international rule of law and the role that lawyers can and should play in it.

Realisation of ternary sigma-delta modulated arithmetic processing modules

Sigma-delta modulated systems have a number of very appealing properties and are, therefore, heavily used in analog to digital converters, amplifiers, and modulators. This paper presents new results which indicate that they may also have significant potential for general purpose arithmetic processing.

Digital signal processing

Signal Processing (SP) is a subject of central importance in engineering and the applied sciences. Signals are information-bearing functions, and SP deals with the analysis and processing of signals (by dedicated systems) to extract or modify information. Signal processing is necessary because signals normally contain information that is not readily usable or understandable, or which might be disturbed by unwanted sources such as noise. Although many signals are non-electrical, it is common to convert them into electrical signals for processing. Most natural signals (such as acoustic and biomedical signals) are continuous functions of time, with these signals being referred to as analog signals. Prior to the onset of digital computers, Analog Signal Processing (ASP) and analog systems were the only tool to deal with analog signals. Although ASP and analog systems are still widely used, Digital Signal Processing (DSP) and digital systems are attracting more attention, due in large part to the significant advantages of digital systems over the analog counterparts. These advantages include superiority in performance,s peed, reliability, efficiency of storage, size and cost. In addition, DSP can solve problems that cannot be solved using ASP, like the spectral analysis of multicomonent signals, adaptive filtering, and operations at very low frequencies. Following the recent developments in engineering which occurred in the 1980's and 1990's, DSP became one of the world's fastest growing industries. Since that time DSP has not only impacted on traditional areas of electrical engineering, but has had far reaching effects on other domains that deal with information such as economics, meteorology, seismology, bioengineering, oceanology, communications, astronomy, radar engineering, control engineering and various other applications. This book is based on the Lecture Notes of Associate Professor Zahir M. Hussain at RMIT University (Melbourne, 2001-2009), the research of Dr. Amin Z. Sadik (at QUT & RMIT, 2005-2008), and the Note of Professor Peter O'Shea at Queensland University of Technology. Part I of the book addresses the representation of analog and digital signals and systems in the time domain and in the frequency domain. The core topics covered are convolution, transforms (Fourier, Laplace, Z. Discrete-time Fourier, and Discrete Fourier), filters, and random signal analysis. There is also a treatment of some important applications of DSP, including signal detection in noise, radar range estimation, banking and financial applications, and audio effects production. Design and implementation of digital systems (such as integrators, differentiators, resonators and oscillators are also considered, along with the design of conventional digital filters. Part I is suitable for an elementary course in DSP. Part II (which is suitable for an advanced signal processing course), considers selected signal processing systems and techniques. Core topics covered are the Hilbert transformer, binary signal transmission, phase-locked loops, sigma-delta modulation, noise shaping, quantization, adaptive filters, and non-stationary signal analysis. Part III presents some selected advanced DSP topics. We hope that this book will contribute to the advancement of engineering education and that it will serve as a general reference book on digital signal processing.

Assessment of pre- and post-flood groundwater recharge via 3D visualisation, Lockyer Valley, southeast Queensland

The Lockyer Valley in southeast Queensland supports important and intensive irrigation which is dependant on the quality and availability of groundwater. Prolonged drought conditions from ~1997 resulted in a depletion of the alluvial aquifers, and concern for the long-term sustainability of this resource. By 2008, many areas of the valley were at < 20% of storage. Some relief occurred with rain events in early 2009, then in December 2010 - January 2011, most of southeast Queensland experienced unprecedented flooding. These storm-based events have caused a shift in research focus from investigations of drought conditions and mitigation to flood response analysis. For the alluvial aquifer system of the valley, a preliminary assessment of groundwater observation bore data, prior to and during the flood, indicates that there is a spatially variable aquifer response. While water levels in some bores screened in unconfined shallow aquifers have recovered by more than 10 m within a short period of time (months), others show only a small or moderate response. Measurements of pre- and post-flood groundwater levels and high-resolution time-series records from data loggers are considered within the framework of a 3D geological model of the Lockyer Valley using Groundwater Visualisation System(GVS). Groundwater level fluctuations covering both drought and flood periods are used to estimate groundwater recharge using the water table fluctuation method (WTF), supplemented by estimates derived using chloride mass balance. The presentation of hydraulic and recharge information in a 3D format has considerable advantages over the traditional 2D presentation of data. The 3D approach allows the distillation of multiple types of information(topography, geological, hydraulic and spatial) into one representation that provides valuable insights into the major controls of groundwater flow and recharge. The influence of aquifer lithology on the spatial variability of groundwater recharge is also demonstrated.