Potential hydroponics systems for seed potato production in tropical conditions

In tropical conditions such as Brazil, depending on the local altitude, potatoes can be planted and harvested in every month of the year successively, which favors pest and disease incidence, especially aphids transmission viruses. Therefore, obtaining good yield depends on constant pest and disease control and quality potato seed acquisition. One of the main strategies to increase a healthier seed potato multiplication rate and production is the use of hydroponic systems, with or without substrates, in channels, pots or boxes. In 2005 and 2008, researches investigated several hydroponic systems with and without the use of substrates. In the hydroponic systems without substrate, the aeroponic system resulted in the highest multiplication rate, with 47 tubers plant-1 compared to NFT and DFT, 35 and 37 tubers plant-1, respectively. With the use of substrates, the pot system obtained better results, reaching 12 tubers plant-1, followed by the capillary system and boxes, with 8 and 7 tubers plant-1, respectively. Potato seed production was influenced by hydroponics systems. Among hydroponic systems with substrate, the pots were shown as the best option. However, higher yields were obtained in the hydroponics systems without substrate, with the aeroponic system that provided the best results.

J/ψ and ψ (2S) production in pp collisions at √s = 7 TeV

A measurement of the J/ ψ and ψ (2S) production cross sections in pp collisions at √s = 7TeV with the CMS experiment at the LHC is presented. The data sample corresponds to an integrated luminosity of 37 pb -1. Using a fit to the invariant mass and decay length distributions, production cross sections have been measured separately for prompt and non-prompt charmonium states, as a function of the meson transverse momentum in several rapidity ranges and integrated in the kinematical regions considered in this study. In addition, cross sections restricted to the acceptance of the CMS detector are given, which are not affected by the polarization of the charmonium states. The ratio of the differential production cross sections of the two states, where systematic uncertainties largely cancel, is also determined. The branching fraction of the inclusive B → ψ (2S)X decay is extracted from the ratio of the non-prompt cross sections to be: B(B → ψ (2S)X) = (3:08 ± 0:12 (stat.+syst.) ± 0:13 (theor.) ± 0:42 (BPDG)) × 10 -3: B(B → ψ(2S)X) = (3.08 ± 0.12 (stat.+syst.) ± 0.13 (theor.) ± 0.42 (B PDG)) × 10 -3.

Selecting the most adequate bedding material for broiler production in Brazil

Broiler chicken production is widely dispersed across the globe, and one important issue for growers is the selection of adequate bedding material, as the availability and price of substrates varies among countries and regions within a same country. This study aimed at applying a multiple criteria analysis approach for the selection of the most appropriate bedding material for broiler production. Based on field research data and growers' experience, the most desirable characteristics of a litter material were chosen as the main criteria. The selected materials were wood shavings, rice husks, chopped Napier grass (Pennisetum pupureum), 50% sugar cane bagasse (Saccharum L.) plus 50% wood shavings, 50% sugar cane bagasse (Saccharum L.) plus 50% rice husks, and pure sugar cane bagasse (Saccharum L.). The analytical hierarchy process (AHP) was applied for selecting the most suitable bedding material. Validation was performed using data from previous studies carried out in central-western Brazil on the effects of different types of bedding material on broiler carcass quality. Considering the selected criteria, several bedding materials were tested and ranked, and the results showed that wood-shavings litter was the best option (weight = 0.28), followed by rice husks (weight = 0.24). All other tested alternatives presented lower scores and were, therefore, not considered for use. The AHP approach was found to be an efficient tool to select the most appropriate litter material under specific scenarios.

Search for WH associated production in pp̄ collisions at √s=1.96TeV

This report describes a search for associated production of W and Higgs bosons based on data corresponding to an integrated luminosity of L≈5.3fb -1 collected with the D0 detector at the Fermilab Tevatron pp̄ Collider. Events containing a W→ν candidate (with corresponding to e or μ) are selected in association with two or three reconstructed jets. One or two of the jets are required to be consistent with having evolved from a b quark. A multivariate discriminant technique is used to improve the separation of signal and backgrounds. Expected and observed upper limits are obtained for the product of the WH production cross section and branching ratios and reported in terms of ratios relative to the prediction of the standard model as a function of the mass of the Higgs boson (M H). The observed and expected 95% C.L. upper limits obtained for an assumed M H=115GeV are, respectively, factors of 4.5 and 4.8 larger than the value predicted by the standard model. © 2012 American Physical Society.

Search for Higgs boson production in oppositely charged dilepton and missing energy events in pp̄ collisions at √s=1.96TeV

We present a search for the standard model Higgs boson using events with two oppositely charged leptons and large missing transverse energy as expected in H→WW decays. The events are selected from data corresponding to 8.6fb -1 of integrated luminosity in pp̄ collisions at √s=1.96TeV collected with the D0 detector at the Fermilab Tevatron Collider. No significant excess above the standard model background expectation in the Higgs boson mass range this search is sensitive to is observed, and upper limits on the Higgs boson production cross section are derived. © 2012 American Physical Society.

Search for the standard model Higgs boson in associated WH production in 9.7fb -1 of pp̄ collisions with the D0 detector

We present a search for the standard model Higgs boson in final states with a charged lepton (electron or muon), missing transverse energy, and two or three jets, at least one of which is identified as a b-quark jet. The search is primarily sensitive to WH→ νbb̄ production and uses data corresponding to 9.7fb -1 of integrated luminosity collected with the D0 detector at the Fermilab Tevatron pp̄ Collider at √s=1.96TeV. We observe agreement between the data and the expected background. For a Higgs boson mass of 125 GeV, we set a 95% C.L. upper limit on the production of a standard model Higgs boson of 5.2×σ SM, where σ SM is the standard model Higgs boson production cross section, while the expected limit is 4.7×σ SM. © 2012 American Physical Society.

Search for resonant t̄t production in lepton+jets events in pp collisions at √s=7 TeV

A model-independent search for the production of heavy resonances decaying into top-antitop quark pairs is presented. The search is based on events containing one lepton (muon or electron) and at least two jets selected from data samples corresponding to an integrated luminosity of 4.4-5.0 fb -1 collected in pp collisions at √s =7 TeV. Results are presented from the combination of two dedicated searches optimized for boosted production and production at threshold. No excess of events is observed over the expected yield from the standard model processes. Topcolor Z′ bosons with narrow (wide) width are excluded at 95% confidence level for masses below 1.49 (2.04) TeV and an upper limit of 0.3 (1.3) pb or lower is set on the production cross section times branching fraction for resonance masses above 1 TeV. Kaluza-Klein excitations of a gluon with masses below 1.82 TeV (at 95% confidence level) in the Randall-Sundrum model are also excluded, and an upper limit of 0.7 pb or lower is set on the production cross section times branching fraction for resonance masses above 1 TeV.[Figure not available: See fulltext.] © 2012 CERN for the benefit of the CMS collaboration.

Posibilidades de expansión de la producción triguera en el Brasil = Possibilities for the expansion of wheat production in Brazil

Incluye Bibliografía

Transnationalization and integration of production in Latin America

Includes bibliography

Observation of a diffractive contribution to dijet production in proton-proton collisions at √s=7 TeV

The cross section for dijet production in proton-proton collisions at √s=7 TeV is presented as a function of a variable that approximates the fractional momentum loss of the scattered proton in single-diffractive events. The analysis is based on an integrated luminosity of 2.7 nb-1 collected with the CMS detector at the LHC at low instantaneous luminosities, and uses events with jet transverse momentum of at least 20 GeV. The dijet cross section results are compared to the predictions of diffractive and nondiffractive models. The low- data show a significant contribution from diffractive dijet production, observed for the first time at the LHC. The associated rapidity gap survival probability is estimated. © 2013 CERN. Published by the American Physical Society.

Comparison of random regression models to estimate genetic parameters for milk production in Guzerat (Bos indicus) cows

Random regression models have been widely used to estimate genetic parameters that influence milk production in Bos taurus breeds, and more recently in B. indicus breeds. With the aim of finding appropriate random regression model to analyze milk yield, different parametric functions were compared, applied to 20,524 test-day milk yield records of 2816 first-lactation Guzerat (B. indicus) cows in Brazilian herds. The records were analyzed by random regression models whose random effects were additive genetic, permanent environmental and residual, and whose fixed effects were contemporary group, the covariable cow age at calving (linear and quadratic effects), and the herd lactation curve. The additive genetic and permanent environmental effects were modeled by the Wilmink function, a modified Wilmink function (with the second term divided by 100), a function that combined third-order Legendre polynomials with the last term of the Wilmink function, and the Ali and Schaeffer function. The residual variances were modeled by means of 1, 4, 6, or 10 heterogeneous classes, with the exception of the last term of the Wilmink function, for which there were 1, from 0.20 to 0.33. Genetic correlations between adjacent records were high values (0.83-0.99), but they declined when the interval between the test-day records increased, and were negative between the first and last records. The model employing the Ali and Schaeffer function with six residual variance classes was the most suitable for fitting the data. © FUNPEC-RP.

Photoprotective and antioxidant effects of Rhubarb: Inhibitory action on tyrosinase and tyrosine kinase activities and TNF-α, IL-1α and α-MSH production in human melanocytes

Background: Exposure to ultraviolet (UV) radiation causes various forms of acute and chronic skin damage, including immunosuppression, inflammation, premature aging and photodamage. Furthermore, it induces the generation of reactive oxygen species, produces proinflammatory cytokines and melanocyte-stimulating hormone (MSH) and increases tyrosinase activity. The aim of this study was to evaluate the potential photoprotective effects of Rheum rhaponticum L. rhizome extract on human UV-stimulated melanocytes.Methods: The effects of Rheum rhaponticum rhizome extract on tyrosine kinase activity, and on interleukin-1α (IL-1α), tumour necrosis factor α (TNF-α), and α-MSH production in human epidermal melanocytes were evaluated under UV-stimulated and non-stimulated conditions. Antioxidant activity was evaluated by lipid peroxidation and 1,1-dyphenyl-2-picryl-hydrazyl (DPPH) assays, while anti-tyrosinase activity was evaluated by the mushroom tyrosinase method.Results: Rheum rhaponticum L. rhizome extract showed in vitro antioxidant properties against lipid peroxidation, free radical scavenging and anti-tyrosinase activities, and inhibited the production of IL-1α, TNF-α, α-MSH, and tyrosine kinase activity in melanocytes subjected to UV radiation.Conclusions: These results support the inclusion of Rheum rhaponticum L. rhizome extract into cosmetic, sunscreen and skin care products for the prevention or reduction of photodamage. © 2013 Silveira et al; licensee BioMed Central Ltd.

CCL3 and CXCL12 production in vitro by dental pulp fibroblasts from permanent and deciduous teeth stimulated by Porphyromonas gingivalis LPS

Objective: The aim of this study was to compare the production of the chemokines CCL3 and CXCL12 by cultured dental pulp fibroblasts from permanent (PDPF) and deciduous (DDPF) teeth under stimulation by Porphyromonas gingivalis LPS (PgLPS). Material and Methods: Primary culture of fibroblasts from permanent (n=3) and deciduous (n=2) teeth were established using an explant technique. After the fourth passage, fibroblasts were stimulated by increasing concentrations of PgLPS (0 - 10 pg/mL) at 1, 6 and 24 h. The cells were tested for viability through MTT assay, and production of the chemokines CCL3 and CXCL12 was determined through ELISA. Comparisons among samples were performed using One-way ANOVA for MTT assay and Two-way ANOVA for ELISA results. Results: Cell viability was not affected by the antigen after 24 h of stimulation. PgLPS induced the production of CCL3 by dental pulp fibroblasts at similar levels for both permanent and deciduous pulp fibroblasts. Production of CXCL12, however, was significantly higher for PDPF than DDPF at 1 and 6 h. PgLPS, in turn, downregulated the production of CXCL12 by PDPF but not by DDPF. Conclusion: These data suggest that dental pulp fibroblasts from permanent and deciduous teeth may present a differential behavior under PgLPS stimulation.