909 resultados para MG ALLOYS
Resumo:
Ion - molecule complexes of magnesium cation with ethyl isocyanate were produced in a laser- ablation supersonic expansion nozzle source. Photo- induced reactions in the 1: 1 complexes have been studied in the spectral range of 230 - 410 nm. Photodissociation mass spectrometry revealed the persistent product Mg+ from nonreactive quenching throughout the entire wavelength range. As for the reactive channels, the photoproducts, Mg+OCN and C2H5+, were produced only in the blue absorption band of the complex with low yields. The action spectrum of Mg+(OCNC2H5) consists of two pronounced peaks on the red and blue sides of the Mg+ 3(2)P <-- 3(2)S atomic transition. The ground state geometry of Mg+ - OCNC2H5 was fully optimized at B3LYP/6- 31 - G** level by using GAUSSIAN 98 package. The calculated absorption spectrum of the complex using the optimized structure of its ground state agrees well with the observed action spectrum. Photofragment branching fractions of the products are almost independent of the photolysis photon energy for the 3P(x,y,z) excitations. The very low branching ratio of reactive products to nonreactive fragment suggests that evaporation is the main relaxation pathway in the photo- induced reactions of Mg+ (OCNC2H5). (C) 2003 American Institute of Physics.
Resumo:
[目的]揭示过量Mg2+对玉米和大豆萌发特性的影响。[方法]设0、40、80、120、160、200、240、280、320、360、400 mmol/L11个Mg2+浓度处理,研究不同处理对玉米和大豆发芽势、发芽率、鲜重、干重、根长、株高、茎粗等指标的影响。[结果]随着Mg2+浓度的升高,玉米的发芽被延缓,而大豆发芽率降低明显,达到0.05水平的显著性差异。随着Mg2+浓度升高,玉米和大豆的鲜重和干重降低,但均表现出一定的适应性。玉米和大豆幼根和幼苗生长受Mg2+抑制明显,普遍表现出萎缩、发育不良现象。[结论]过量Mg2+胁迫对不同农作物的发芽势、发芽率影响不同,对农作物的根、茎器官生长毒害作用明显。
Resumo:
[Objective] The research aimed to reveal the effects of excessive Mg2+ on the germination characteristics of maize and soybean. [Method] Eleven concentration gradients of Mg2+ including 0,40,80,120,160,200,240,280,320,360 and 400 mmol/L were set up to study the effects of different treatments on such indices as the germination potential,germination rate,fresh weight,dry weight,root length,plant height and stem diameter of maize and soybean. [Result] With the increasing of Mg2+ concentration,the germination of maize delayed and the germination rate of soybean obviously decreased,reaching the significant difference at 0.05 level. When Mg2+ concentration increased,the fresh weight and dry weight of maize and soybean decreased,but maize and soybean showed some adaptability. The growth of radicles and seedlings in maize and soybean were obviously inhibited by Mg2+,and atrophy and dysplasia phenomena appeared. [Conclusion] Excessive Mg2+ stress has different effects on the germination potential and germination rate of different crops and has obvious poisoning effects on the root and stem growth of crops.
Resumo:
目的研究过量Mg2+对土壤中脲酶、磷酸酶和过氧化氢酶活性的影响.方法通过在清洁土壤中投加不同质量浓度的MgC l2试剂,经过28 d的培养,期间在第1、3、7、14、28 d取样,测定土壤中的脲酶、磷酸酶和过氧化氢酶的活性.结果数据分析表明Mg2+对脲酶有激活作用,当Mg2+的质量分数为0.6%时,土壤脲酶活性提高最多,为91.6%,脲酶活性增加的程度为:0.6%>0.8%>0.4%>0.2%>1.0%>0,并且第1 d是观测脲酶变化的最佳时间.Mg2+对磷酸酶活性有先激活再抑制的作用,其活性在第3 d有大幅度增加,而从第14 d开始到第28 d,5个含不同质量分数Mg2+的土样,其磷酸酶活性全都低于空白试验。过氧化氢酶活性在试验的所有土样中均受到长效抑制.结论脲酶、磷酸酶和过氧化氢酶对Mg2+反映敏感,在Mg2+质量分数为0.6%时可以短期提高土壤肥力,但是长期大量的Mg2+介入土壤会严重影响土壤肥力,因此,可以考虑以Mg2+作为镁污染土壤的生态毒理指标.
Resumo:
Mg-6Zn-5Al-4RE (RE = Mischmetal, mass%) alloy was prepared by metal mould casting method. The microstructure and mechanical properties of the as-cast and heat-treated alloys were investigated
Resumo:
Ti45Zr30Ni25Yx (x = 1, 3, 5 and 7) alloys were prepared by melt-spinning at wheel velocity of 20 m s(-1). The effect of additive Y on phase structure and electrochemical performance of melt-spun alloys was investigated. Ti45Zr30Ni25Yx melt-spun alloys were composed of I-phase and amorphous phase. T
Resumo:
Mg-20Zn-8Al-xCe(x=0-2 wt.%) alloys were prepared by metal mould casting method, the effects of Ce on the microstructure and mechanical properties of the alloys were investigated. The results showed that the dendrite as well as gram size were refined by the addition of Ce, and the best refinement was obtained in 1.39% Ce containing alloy.
Resumo:
Ti-based icosahedral quasicrystalline phase (I-phase) exhibited excellent hydrogen storage property for special structure. Unfortunately, the application as the negative electrode material of the nickel-metal hydride batteries was limited due to the poor electrochemical kinetics. Meanwhile, rare-earth element was beneficial to the electrochemical properties of Ti, Zr-based alloy.
Resumo:
通过气体保护制备了Mg-RE-Zn-Zr[RE=Ce-40La(wt%)的富铈稀土]合金,并对合金进行了热处理,测试了不同状态下合金的硬度、抗拉强度及伸长率等力学性能,采用光学显微镜、X射线衍射仪及扫描电镜对合金显微组织、拉伸断口进行了分析。结果发现,采用T6热处理工艺后,合金的晶粒尺寸明显细化,硬度、抗拉强度、屈服强度和伸长率显著提高,分别提高了11%,24%,7.3%和102%
Resumo:
以EZ33A镁合金为基体材料,制备了Mg-3Zn-3Y-Zr合金,研究了稀土元素Y对其显微组织及力学性能的影响。结果表明:由于添加Y和Zr,使铸造Mg-3Zn-3Y-Zr合金的枝晶组织得到细化,等轴趋势明显;由于Y在镁中的溶解度较大,经过固溶时效处理后,使弥散强化相增多,起到强化晶界的作用,从而提高合金的硬度,同时使其室温及高温力学性能均明显提高。
Resumo:
The structure and electrochemical characteristics of melted composite Ti0.10Zr0.15V0.35Cr0.10Ni0.30+x% LaNi5 (x=0, 1, 5 and 10) hydrogen storage alloys have been investigated systematically. XRD shows that the matrix phase structure of V-based solid solution phase with a BCC structure and C14 Laves phase with hexagonal structure is not changed after adding LaNi5 alloy. However, the amount of the secondary phase increases with increasing LaNi5 content. Field emission scanning electron microscopy-energy dispersive spectroscopy (FESEM-EDS) shows that the C14 Laves phase contains more Zr and the white lard phase has a composition close to (Zr, Ti)(V, Cr, Ni, La)(2).
Resumo:
Microstructures and electrochemical properties of Ti0.26Zr0.07V0.21Mn0.1Ni0.33Mox (x=0,0.025,0.05,0.075, 0.10) electrode alloys have been investigated. The results of XRD analysis show that the alloys are mainly composed of V-based solid solution phase with body centered cubic (bcc) structure and C14 Laves phase with hexagonal structure. The addition of Mo element can imp ove the activation characteristics, maximum discharge capacity and cyclic durability for the electrode alloys
Resumo:
A refined version of the edge-to-edge matching model is described here. In the original model, the matching directions were obtained from the planes with all the atomic centers that were exactly in the plane, or the distance from the atomic center to the plane which was less than the atomic radius. The direction-matching pairs were the match of straight rows-straight rows and zigzag rows-zigzag rows. In the refined model, the matching directions were obtained from the planes with all the atomic centers that were exactly in the plane.
Resumo:
For (Ti1-xVx)(2)Ni (x = 0.05,0.1,0.15,0.2 and 0.3) ribbons, synthesized by arc-melting and subsequent melt-spinning techniques, an icosahedral quasicrystalline phase was present, either in the amorphous matrix or together with the stable Ti2Ni-type phase. With increasing x values, the maximum discharge capacity of the alloy electrodes increased until reached 271.3 mAh/g when x = 0.3. The cycling capacity retention rates for these electrodes were approximately 80% after a preliminary test of 30 consecutive cycles of charging and discharging.
Resumo:
Mg-4Al-4Nd-0.5Zn-0.3Mn alloy was prepared by metal mould casting method. Microstructure, aging behavior, mechanical properties and fracture morphology of the alloy were investigated. The results showed that alpha-Mg, Al-11 Nd-3, Al2Nd and Mg-32(Al,Zn)(49) phases were the main phases of the as-cast alloy. And the long rod-like Al-11 Nd-3 phase was decomposed to granular Al2Nd through T6 heat treatment. The tensile strength was also enhanced by T6 treatment. The yield strength was increased by 17% and 21% at RT and 150 degrees C, respectively. It was mainly because that the precipitates were refined through T6 treatment and this became more benefit to hinder dislocations slipping.