936 resultados para Laboratory
Resumo:
Os estágios iniciais da lagosta tropical Enoplometopus antillensis Lütken, 1865 foram descritos e ilustrados a partir de espécimes cultivados em laboratório. Fêmeas ovígeras foram capturadas em seu habitat, na profundidade cerca de 15 metros e transportadas para o laboratório. As larvas foram cultivadas em tanques de água recirculante por aproximadamente 15 dias e, então transferidas para quatro aquários (capacidade 10 litros). As larvas foram alimentadas com náuplios de Artemia sp. recém eclodidos. A microalga Dunaliella viridis AUTOR foi diariamente adicionada no cultivo. As larvas mudaram sete vezes alcançando o zoea VIII. O estágio megalopa não foi obtido. O período de intermuda de cada estágio variou de cerca de oito a 12 dias. Comparações morfológicas com trabalhos anteriores são brevemente discutidas.
Resumo:
O desenvolvimento completo de Lepidophthalmus siriboia Felder & Rodrigues, 1993 foi descrito e ilustrado em detalhes a partir de espécimens cultivados em laboratório. Fêmeas ovígeras foram coletadas na ilha de Canela nordeste do Estado do Pará. As larvas eclodem como prezoea e o desenvolvimento larval consiste de 3 estágios de zoea e 1 de megalopa. O desenvolvimento dos 3 estágios de zoea durou em média de 69 a 111 horas. A duração de megalopa foi cerca de 185 horas (cerca de 8 dias). O primeiro juvenil foi alcançado em 254 horas (cerca de 10 dias) após a eclosão. Comparações morfológicas com espécies do mesmo gênero são discutidas.
Resumo:
ABSTRACT: Analytical procedures for U-Pb isotope dilution analyses at the Pará-Iso isotope geology laboratory of the Federal University of Pará (UFPA) are described in detail. The procedures are applied to zircon, titanite, rutile, apatite, columbite-tantalite and whole rock. Reagent preparation and chemical processing are done in clean-room conditions. Samples are dissolved using Teflon™ microcapsules in steel jacket Teflon™ Parr Instrument™ bomb or Teflon™ screw cap containers. U and Pb are separated using anion exchange AG 1x8 resin columns. Typical blanks for mineral sample amounts of 0.01 to 1.0 mg are less than 1 pg U and 20-30 pg Pb. Isotope analysis of the U and Pb from the same filament are carried out using a Finnigan MAT 262 mass-spectrometer in static and dynamic modes. The current analytical level is demonstrated on analyses of international standard zircon 91500 with three different 235U-205Pb and 235U-208Pb isotope tracers and whole rock standards. Results of analyses of two zircon samples are also presented.
Resumo:
Leprosy is a chronic infectious condition caused by Mycobacterium leprae(M. leprae). It is endemic in many regions of the world and a public health problem in Brazil. Additionally, it presents a wide spectrum of clinical manifestations, which are dependent on the interaction between M. leprae and host, and are related to the degree of immunity to the bacillus. The diagnosis of this disease is a clinical one. However, in some situations laboratory exams are necessary to confirm the diagnosis of leprosy or classify its clinical form. This article aims to update dermatologists on leprosy, through a review of complementary laboratory techniques that can be employed for the diagnosis of leprosy, including Mitsuda intradermal reaction, skin smear microscopy, histopathology, serology, immunohistochemistry, polymerase chain reaction, imaging tests, electromyography, and blood tests. It also aims to explain standard multidrug therapy regimens, the treatment of reactions and resistant cases, immunotherapy with bacillus Calmette-Guérin (BCG) vaccine and chemoprophylaxis.
Resumo:
Purpose. - The purposes of this study were: i) to compare the physiological responses measured during a specific table tennis incremental test with the physiological responses measured during cycling, arm cranking, and treadmill running tests; and ii) to verify the accuracy of table tennis performance prediction based on the physiological responses from these tests.Methods. - Eleven national level male table tennis players participated in the study and undertook incremental tests using ergometers. Table tennis performance was defined as the ranking obtained during a simulated tournament between the participants.Results. - In general, peak values for physiological variables (e.g., (V) over dotO(2PEAK) and [La]PEAK) were significantly lower (P < 0.05) in the specific test (e.g., (V) over dotO(2PEAK) = 39.9 +/- 1.5 ml.kg(-1) per minute and [La]PEAK = 6.4 +/- 0.5 mmol.L-1) than during cycling (e.g., (V) over dotO(2PEAK) = 41.3 +/- 1.4 ml.kg(-1) per minute and [La]PEAK = 10.2 +/- 0.7 mmol.L-1) or running (e.g., (V) over dotO(2PEAK) = 43.9 +/- 1.5 ml.kg(-1) per minute and [La]PEAK = 10.0 +/- 0.7 mmol.L-1), but higher than during arm cranking (e.g., (V) over dotO(2PEAK) = 26.6 +/- 1.6 ml.kg(-1) per minute and [La]PEAK = 8.9 +/- 0.6 mmol.L-1). At respiratory compensation point intensity (RCP), only the variables measured on arm cranking were lower (P < 0.05) than on the other ergometers. Stepwise multiple regression analysis showed significant correlation between table tennis performance and lactate concentration ([La]) and also rate of perceived effort (RPE) at RCP during cycling (r = 0.89; P < 0.05).Conclusion. - In conclusion, the significant differences obtained between the specific and laboratory ergometers demonstrate the need to use a specific test to measure physiological parameters in table tennis and the physiological parameters measured, independent of the ergometer used, are unable to predict table tennis performance. (C) 2013 Elsevier Masson SAS. All rights reserved.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
The juvenile development of the freshwater crab Dilocarcinus pagei Stimpson, 1861 was studied under laboratory conditions, focusing on setae morphology. The ovigerous females were collected manually associated with water hyacinth at the Municipal Dam of Sao Jose do Rio Preto (Sao Paulo, Brazil). The specimens were raised in the laboratory under constant aeration, photoperiod (12: 12 h) and temperature (27 +/- 1 degrees C). Twelve juvenile stages were obtained with descriptions of the main morphological characters that allow their identification are presented. Fourteen types of setae were discovered: dentate, denticulate, serrulate, papposerrate, cuspidate, plumose, plumodenticulate, plumoserrulate, simple, pappose, brush, curved, nail and setules. The greatest diversity of setae was found on the mouth appendages, especially the maxillule. The gill ontogeny and sexual dimorphism becomes apparent from the second juvenile stage onwards. At the third juvenile stage, the carapace begins to exhibit a wider shape, becoming similar to that of the adults.
Resumo:
Background: The potential attraction from 1-octen-3-ol for sandflies has been documented; however, studies using other primary alcohols are limited.Findings: We used a wind tunnel to compare the activation and attractive behaviors in male and female Lutzomyia longipalpis using 1-octen-3-ol and three additional alcohols, 1-octanol, 1-heptanol and 1-nonanol at three different concentrations: neat (100%) and diluted in hexane (10% and 50%). The compounds 1-octen-3-ol and 1-nonanol induced a clear concentration-dependent activation and attraction response in females. In males, 1-octen-3-ol, 1-nonanol and 1-heptanol yielded the same results.Conclusions: L. longipalpis is attracted to 1-octen-3-ol, 1-nonanol and 1-heptanol, which are found in many plant volatiles.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
In this work we compute the one-nucleon-induced nonmesonic hypernuclear decay rates of He-5(Lambda), C-12(Lambda) and C-13(Lambda) using a formalism based on the independent particle shell model in terms of laboratory coordinates. To ascertain the correctness and precision of the method, these results are compared with those obtained using a formalism in terms of center-of-mass coordinates, which has been previously reported in the literature. The formalism in terms of laboratory coordinates will be useful in the shell-model approach to two-nucleon-induced transitions.
Resumo:
The universities have realized the importance of extending their knowledge to the population through the provision of services. Thus, this paper presents the data obtained in an agreement between UNESP/Laboratory of Paternity and Public Defender Service in São Paulo State to make DNA paternity tests.
Resumo:
In laboratory tests, just following the manufacturer’s instructions of materials or equipments may not be enough to obtain reliable data. Thus, intra and inter-examiners studies may be required. The aim of this study was to illustrate the application of the Intraclass Correlation Coefficient (r) in a study related to the color changing and hardness of composite resin conducted by two examiners. The color and hardness of 10 specimens of composite resin were evaluated by a colorimetric spectrophotometer and hardness tester, respectively, at two different times. Two trained examiners performed two measurements with an interval of one week. Specimens were stored in artificial saliva at 37±1ºC for 7 days. The Intraclass Correlation was used for analysis of intra and inter-examiner reproducibility. The intra-examiner reproducibility was 0.79, 0.44 and 0.76 for L, a and b color coordinates for the examiner 1 and 0.84, 0.23, 0.21 for examiner 2. For hardness, r-values were 0.00 and 0.23 for the examiner 1 and 2, respectively, showing unsatisfactory agreement on color and hardness evaluation for both examiners. It was noted that only the observation of protocol for use of equipment and examiners training were not sufficient to collect reliable information. Thus, adjustments in the experimental protocol were made and devices were produced to standardize the measurements. The reproducibility study was performed again. For examiner 1, values as 0.90, 0.59 and 0.79 were verified for L, a and b coordinates and, for examiner 2 were obtained values of 0.90, 0.75, 0.95. In relation to hardness, r-values of 0.75 and 0.71 were obtained for examiners 1 and 2, respectively. The inter-examiner reproducibility was 0.86, 0.87, 0.91 for L, a and b coordinates and 0.79 for hardness. It was concluded that intra and inter-examiner calibration is essential for obtaining quality measurements in laboratory tests.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)