Modeling of multiple cracks in reinforced concrete members using solid finite elements with high aspect ratio

This paper presents a new technique to model interfaces by means of degenerated solid finite elements, i.e., elements with a very high aspect ratio, with the smallest dimension corresponding to the thickness of the interfaces. It is shown that, as the aspect ratio increases, the element strains also increase, approaching the kinematics of the strong discontinuity. A tensile damage constitutive relation between strains and stresses is proposed to describe the nonlinear behavior of the interfaces associated with crack opening. To represent crack propagation, couples of triangular interface elements are introduced in between all regular (bulk) elements of the original mesh. With this technique the analyses can be performed integrally in the context of the continuum mechanics and complex crack patterns involving multiple cracks can be simulated without the need of tracking algorithms. Numerical tests are performed to show the applicability of the proposed technique, studding also aspects related to mesh objectivity.

Análise experimental da conexão entre blocos segmentais e geogrelha de PVA

The test system connection segmental blocks and geogrids at the Department of Civil Engineering, UNESP - Guaratinguetá order to verify the strength of the connection system when subjected to different confining stresses. The present work aims to demonstrate the procedures for carrying out the test as well as the placement of concrete blocks. Were analyzed two ways of placing the blocks in the press. An entire block and two halves in the first layer, named position 12, compared to a different format, two entire blocks in the first layer, named position 21; also geogrids: single and double layer. From the data obtained for the peak strength of 20 tests it was possible to obtain the envelopes break in the connection for single and double layer. In 2011, the size of the concrete block used in the test was lower when compared with previous years. What resulted in significant decreases in the loss of connection in single layer and it was noted that there was no decrease in the strength of connection in the double-layer tests, despite the smaller area of contact between the block and geogrid. It is concluded that, through the analysis of geogrids after running the test, the concrete block is responsible for theforce that allows the movement of the geogrid due to the force from the ground

Potencial de aproveitamento de agregados reciclados de resíduos da construção e demolição

CONAMA Resolution 307 / 02, in Article 4, states that the primary goal of those involved in the reuse process of construction and demolition waste is not the generation of such wastes, secondarily is the reduce, reuse, recycling and proper disposal of such material. The disposal problem of large volumes of waste generated coupled with the scarcity of natural resources and environmental degradation involved in the extraction process of such materials resulted in several studies, that after many analyzes proposed various forms of reuse and recycling . The NBR 15.116/04 provides requirements for the use of recycled aggregates in paving and concrete without structural function. This work aims to show the usage potential of recycled aggregates from waste generated in construction and demolition sampled Group AB Areias, Pindamonhangaba (SP) in order to meet the standards in Brazil, as well as the environmental contribution by reducing the use of raw materials extracted from nature. After stabilization and particle size analysis of the California Bearing Ratio and Proctor, obtained mixtures of recycled aggregates showed higher values submitted by the minimum standards related, with excellent potential for use in paving

Aplicação de sistema de gestão da qualidade na execução de obras de pavimentação asfáltica, baseado nas diretrizes da ABNT NBR ISO 9001:2008

This work brings to its content proposed deployment of a system of quality management in paving asphalt based on the elaboration of a basic training to meet those entering this area of civil engineering at a technical manual for the implementation of major services running on paving of roads. The training was designed to serve both those entering the field of asphalt paving, synthesizing the complex processes involved in paving services and providing an overview of the steps in implementation thereof, as well as entrants must meet the enterprise user of this system, providing them an idea of the method used by the company designing the paving of roads. The technical manual presented in turn, has 8 (eight) of the main services components of a work of paving, which are: Mobilization and Maintenance of construction site, Regularization and subfloor preparation, execution or sub-base BGS base (graded gravel plain), Execution of sub-base or base BGTC (graded gravel treated with cement), Implementation of subbase or base Macadam hydraulic Priming bituminous waterproofing, asphalt binder Priming and finally the execution flexible pavement - HMA (hot milled asphalt concrete). These services are presented in the form of IT-Education work, this seven items are presented that guide the performance of services, thus providing overall guidelines to perform the services described in it. The development of IT's was based on experiences in day-to-day paving near the theoretical precepts presented in the literature, so the conditions specified in these documents aim to always guide the implementation of services in general, giving the process a versatility major operation, as this work takes into account the dynamics of such services, as well as the variety of their execution according to local conditions and specified in the project. So in general we can say that this ... (Complete abstract click electronic access below)

Análise de blocos de concreto com resíduo de borracha de pneu e metacaulim

Pós-graduação em Engenharia Civil - FEIS

Electropolymerization using binuclear nickel(II) Schiff base complexes bearing N4O4 donors as supramolecular building blocks

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Failure behavior modeling of slender reinforced concrete columns subjected to eccentric load

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influence of time evolution in the modulus of elasticity of concrete reinforced by carbon fibers

The modulus of elasticity is an important property for the behavior analysis of concrete structures. This research evaluated the strain difference between concrete specimens with and without the application of laminate carbon fiber composites as well as the variation time, in months, of the axial strength compression and modulus of elasticity. Through the experimental results, it is concluded that increases in compressive strength and modulus of elasticity are more significant in the specimens without reinforcement.

Concreto permeável para pavimentação urbana com uso de resíduos de construção e demolição produzidos na usina de reciclagem de são josé do Rio Preto

Pós-graduação em Engenharia Civil - FEIS

Viabilidade técnica e econômica do superadobe na construção de casas populares

The need for affordable housing and the high cost of today's building materials make necessary to look for useful and affordable technologies for these house buildings. In this context, this study aimed to evaluate the technical and economic feasibility of construction technology called Earthbag for use in public housing. Technical assessments were based on Kiffmeyer and Hunter's book (2004), academics dissertations and construction standards for the technology. The result allowed a positive evaluation towards the feasibility proposal and showing the possibility of replace the use of structural concrete blocks in public housing. The economic viability was performed an economical compared to a project Housing Project Bom Retiro 2 with one of Earthbag which have been shown considerable savings between the techniques. For the construction of masonry, build with purchased sand, 13% lower budget was found in comparison of a concrete masonry block. With the use of sand from the work site itself, there is a saving of 18%. Although earthbag has proven to be a technically and economically feasible for application in the construction of affordable housing, the shortage of technical and scientific studies and Brazilian regulations on this technology has limited its large-scale use

Impact of Bottom Flange Confinement Reinforcement on Performance of Prestressed Concrete Bridge Girders

For many years AASHTO provided no recommendation to state DOT’s on bottom flange confinement reinforcement for their bridge superstructures. The 1996 edition of AASHTO Standard Specification for Highway Bridges stated that nominal reinforcement be placed to enclose the prestressing steel from the end of the girder for at least a distance equal to the girder’s height. A few years later the 2004 AASHTO LRFD Bridge Design Specification changed the distance over which the confinement was to be distributed from 1.0h to 1.5h, and gave minimum requirements for the amount of steel to be used, No.3 bars, and their maximum spacing, not to exceed 6”. Research was undertaken to study what impact, if any, confinement reinforcement has on the performance of prestressed concrete bridge girders. Of particular interest was the effect confinement had on the transfer length, development length, and vertical shear capacity of the fore mentioned members. First, an analytical investigation was performed on the subject, and then an experimental investigation followed which consisted of designing, fabricating, and testing eight tee-girders and three NU1100 girders with particular attention paid to the amount and distribution of confinement reinforcement placed at the end of each girder. The results of the study show: 1) neither the amount or distribution of confinement reinforcement had a significant effect on the initial or final transfer length of the prestress strands; 2) at the AASHTO calculated development length, no significant impact from confinement was found on either the nominal flexural capacity of bridge girders or bond capacity of the prestressing steel; 3) the effects from varied confinement reinforcement on the shear resistance of girders tested was negligible, however, distribution of confinement did show to have an impact on the prestressed strands’ bond capacity; 4) confinement distribution across the entire girder did increase ductility and reduced cracking under extreme loading conditions.

Water Quality Variability in a Bioswell and Concrete Drainage Pipe, Southwest Lincoln, Nebraska

Abstract The goal of this project is to evaluate the effectiveness of bioswells in protecting water quality from urban runoff. The hypothesis tested in this project is that water in bioswells improves water quality. Water quality in both a bioswell and an underground concrete lined ditch, both containing ground and surface water, were tested for certain water quality parameters. These parameters consisted of: Dissolved Oxygen, pH, water temperature, weather temperature, Total Dissolved Solids, Specific Conductivity, Alkalinity, Total Dissolved Carbon, Chemical Oxygen Demand, and depth and width of the sampling site. An additional contaminant that was looked at was motor oil. This was measured by comparing Total Organic Carbon with Chemical Oxygen Demand. A variety of different methods to measure the water quality parameters were utilized. The concrete site had more stable readings, but much higher water temperatures. However, the bioswell water is mainly from surface water runoff, and the underground concrete lined pipe is from underground water, so the two cannot be directly compared. The bioswell had high readings, especially pertaining to Oxygen Demand, Total Organic Carbon, and Specific Conductivity in early test dates. But, these readings improved as they were filtered though the bioswell. As plant activity increased and the weather began to warm up there were more stable readings. It is concluded that bioswells are an effective way to reduce problems associated with urban runoff pertaining to certain water quality parameters.

Viabilidade técnica e econômica do superadobe na construção de casas populares

The need for affordable housing and the high cost of today's building materials make necessary to look for useful and affordable technologies for these house buildings. In this context, this study aimed to evaluate the technical and economic feasibility of construction technology called Earthbag for use in public housing. Technical assessments were based on Kiffmeyer and Hunter's book (2004), academics dissertations and construction standards for the technology. The result allowed a positive evaluation towards the feasibility proposal and showing the possibility of replace the use of structural concrete blocks in public housing. The economic viability was performed an economical compared to a project Housing Project Bom Retiro 2 with one of Earthbag which have been shown considerable savings between the techniques. For the construction of masonry, build with purchased sand, 13% lower budget was found in comparison of a concrete masonry block. With the use of sand from the work site itself, there is a saving of 18%. Although earthbag has proven to be a technically and economically feasible for application in the construction of affordable housing, the shortage of technical and scientific studies and Brazilian regulations on this technology has limited its large-scale use

Lufaxin, a Novel Factor Xa Inhibitor From the Salivary Gland of the Sand Fly Lutzomyia longipalpis Blocks Protease-Activated Receptor 2 Activation and Inhibits Inflammation and Thrombosis In Vivo

Objective-Blood-sucking arthropods' salivary glands contain a remarkable diversity of antihemostatics. The aim of the present study was to identify the unique salivary anticoagulant of the sand fly Lutzomyia longipalpis, which remained elusive for decades. Methods and Results-Several L. longipalpis salivary proteins were expressed in human embryonic kidney 293 cells and screened for inhibition of blood coagulation. A novel 32.4-kDa molecule, named Lufaxin, was identified as a slow, tight, noncompetitive, and reversible inhibitor of factor Xa (FXa). Notably, Lufaxin's primary sequence does not share similarity to any physiological or salivary inhibitors of coagulation reported to date. Lufaxin is specific for FXa and does not interact with FX, Dansyl-Glu-Gly-Arg-FXa, or 15 other enzymes. In addition, Lufaxin blocks prothrombinase and increases both prothrombin time and activated partial thromboplastin time. Surface plasmon resonance experiments revealed that FXa binds Lufaxin with an equilibrium constant approximate to 3 nM, and isothermal titration calorimetry determined a stoichiometry of 1:1. Lufaxin also prevents protease-activated receptor 2 activation by FXa in the MDA-MB-231 cell line and abrogates edema formation triggered by injection of FXa in the paw of mice. Moreover, Lufaxin prevents FeCl3-induced carotid artery thrombus formation and prolongs activated partial thromboplastin time ex vivo, implying that it works as an anticoagulant in vivo. Finally, salivary gland of sand flies was found to inhibit FXa and to interact with the enzyme. Conclusion-Lufaxin belongs to a novel family of slow-tight FXa inhibitors, which display antithrombotic and anti-inflammatory activities. It is a useful tool to understand FXa structural features and its role in prohemostatic and proinflammatory events. (Arterioscler Thromb Vasc Biol. 2012;32:2185-2196.)

Attenuation of foot pressure during running on four different surfaces: asphalt, concrete, rubber, and natural grass

The practice of running has consistently increased worldwide, and with it, related lower limb injuries. The type of running surface has been associated with running injury etiology, in addition other factors, such as the relationship between the amount and intensity of training. There is still controversy in the literature regarding the biomechanical effects of different types of running surfaces on foot-floor interaction. The aim of this study was to investigate the influence of running on asphalt, concrete, natural grass, and rubber on in-shoe pressure patterns in adult recreational runners. Forty-seven adult recreational runners ran twice for 40 m on all four different surfaces at 12 +/- 5% km . h(-1). Peak pressure, pressure-time integral, and contact time were recorded by Pedar X insoles. Asphalt and concrete were similar for all plantar variables and pressure zones. Running on grass produced peak pressures 9.3% to 16.6% lower (P < 0.001) than the other surfaces in the rearfoot and 4.7% to 12.3% (P < 0.05) lower in the forefoot. The contact time on rubber was greater than on concrete for the rearfoot and midfoot. The behaviour of rubber was similar to that obtained for the rigid surfaces - concrete and asphalt - possibly because of its time of usage (five years). Running on natural grass attenuates in-shoe plantar pressures in recreational runners. If a runner controls the amount and intensity of practice, running on grass may reduce the total stress on the musculoskeletal system compared with the total musculoskeletal stress when running on more rigid surfaces, such as asphalt and concrete.