Using Geophysical Tools to Resolve Areas of Seismic Ambiguity

The flanks of an oil-bearing structure were investigated to determine the most likely reservoir geometry in an area where the seismic path forks in preparation for a field equity redetermination. Two alternate hypotheses were evaluated: a “high fork model” where the reservoir top follows the higher of the two paths and a “low fork model” in which the reservoir follows the lower path. I took four approaches to evaluate the hypotheses: 1) Depth conversion by multiple velocity models to evaluate the fidelity of the picked horizon on models that did not contain a fork; 2) hand interpretation around the areas of high uncertainty to eliminate their influence; 3) path choice effects on the plausibility of the environment of deposition; and subsurface geometry modeling with synthetics to compare calculated 1D seismic responses with current data. Investigation established that both fork interpretations cannot follow a continuous seismic reflector but are otherwise equally plausible. Interval modeling revealed several structure scenarios, supporting both high and low fork, which fit the seismic data. To augment the lower fork argument, a scenario with an additional sand interval off-structure is recommended, for simplicity and reasonability.

Seismic Evaluation and Retrofit of Concentrically Braced Frames

Thesis (Master's)--University of Washington, 2016-06

Bandwidth requirements for shallow, high-resolution seismic reflection

The optimum bandwidth for shallow, high-resolution seismic reflection differs from that required for conventional petroleum reflection. An understanding of this issue is essential for correct choice of acquisition instrumentation. Numerical modelling of simple Bowen Basin coal structures illustrates that, for high-resolution imaging, it is important to accurately record all frequencies up to the limit imposed by earth scattering. On the contrary, the seismic image is much less dependent on frequencies at the lower end of the spectrum. These quantitative observations support the use of specialised high-frequency geophones for high-resolution seismic imaging. Synthetic seismic inversion trials demonstrate that, irrespective of the bandwidth of the seismic data, additional low-frequency impedance control is essential for accurate inversion. Inversion provides no compelling argument for the use of conventional petroleum geophones in the high-resolution arena.