A block coprocessor for user data rate improvements to GPRS coding scheme 4

The general packet radio service (GPRS) has been developed to allow packet data to be transported efficiently over an existing circuit-switched radio network, such as GSM. The main application of GPRS are in transporting Internet protocol (IP) datagrams from web servers (for telemetry or for mobile Internet browsers). Four GPRS baseband coding schemes are defined to offer a trade-off in requested data rates versus propagation channel conditions. However, data rates in the order of > 100 kbits/s are only achievable if the simplest coding scheme is used (CS-4) which offers little error detection and correction (EDC) (requiring excellent SNR) and the receiver hardware is capable of full duplex which is not currently available in the consumer market. A simple EDC scheme to improve the GPRS block error rate (BLER) performance is presented, particularly for CS-4, however gains in other coding schemes are seen. For every GPRS radio block that is corrected by the EDC scheme, the block does not need to be retransmitted releasing bandwidth in the channel and improving the user's application data rate. As GPRS requires intensive processing in the baseband, a viable field programmable gate array (FPGA) solution is presented in this paper.

Improving CS-4 user data rate in GPRS enabled devices by using a BLER co-processor

The General Packet Radio Service (GPRS) was developed to allow packet data to be transported efficiently over an existing circuit switched radio network. The main applications for GPRS are in transporting IP datagram’s from the user’s mobile Internet browser to and from the Internet, or in telemetry equipment. A simple Error Detection and Correction (EDC) scheme to improve the GPRS Block Error Rate (BLER) performance is presented, particularly for coding scheme 4 (CS-4), however gains in other coding schemes are seen. For every GPRS radio block that is corrected by the EDC scheme, the block does not need to be retransmitted releasing bandwidth in the channel, improving throughput and the user’s application data rate. As GPRS requires intensive processing in the baseband, a viable hardware solution for a GPRS BLER co-processor is discussed that has been currently implemented in a Field Programmable Gate Array (FPGA) and presented in this paper.

An ontological modelling of user requirements for personalised information provision

The knowledge economy offers opportunity to a broad and diverse community of information systems users to efficiently gain information and know-how for improving qualifications and enhancing productivity in the work place. Such demand will continue and users will frequently require optimised and personalised information content. The advancement of information technology and the wide dissemination of information endorse individual users when constructing new knowledge from their experience in the real-world context. However, a design of personalised information provision is challenging because users’ requirements and information provision specifications are complex in their representation. The existing methods are not able to effectively support this analysis process. This paper presents a mechanism which can holistically facilitate customisation of information provision based on individual users’ goals, level of knowledge and cognitive styles preferences. An ontology model with embedded norms represents the domain knowledge of information provision in a specific context where users’ needs can be articulated and represented in a user profile. These formal requirements can then be transformed onto information provision specifications which are used to discover suitable information content from repositories and pedagogically organise the selected content to meet the users’ needs. The method is provided with adaptability which enables an appropriate response to changes in users’ requirements during the process of acquiring knowledge and skills.

iTrench: a study of user reactions to the use of information technology in field archaeology

This article describes work undertaken by the VERA project to investigate how archaeologists work with information technology (IT) on excavation sites. We used a diary study to research the usual patterns of behaviour of archaeologists digging the Silchester Roman town site during the summer of 2007. Although recording had previously been undertaken using pen and paper, during the 2007 season a part of the dig was dedicated to trials of IT and archaeologists used digital pens and paper and Nokia N800 handheld PDAs to record their work. The goal of the trial was to see whether it was possible to record data from the dig whilst still on site, rather than waiting until after the excavation to enter it into the Integrated Archaeological Database (IADB) and to determine whether the archaeologists found the new technology helpful. The digital pens were a success, however, the N800s were not successful given the extreme conditions on site. Our findings confirmed that it was important that technology should fit in well with the work being undertaken rather than being used for its own sake, and should respect established work flows. We also found that the quality of data being entered was a recurrent concern as was the reliability of the infrastructure and equipment.

Prosthetics: a user guide for posthumans

Book review of 'The prosthetic impulse: from a posthuman present to a biocultural future', edited by M. Smith and J. Morra.

Suprathermal electron flux peaks at stream interfaces: Signature of solar wind dynamics or tracer for open magnetic flux transport on the Sun?

The high variability of the intensity of suprathermal electron flux in the solar wind is usually ascribed to the high variability of sources on the Sun. Here we demonstrate that a substantial amount of the variability arises from peaks in stream interaction regions, where fast wind runs into slow wind and creates a pressure ridge at the interface. Superposed epoch analysis centered on stream interfaces in 26 interaction regions previously identified in Wind data reveal a twofold increase in 250 eV flux (integrated over pitch angle). Whether the peaks result from the compression there or are solar signatures of the coronal hole boundary, to which interfaces may map, is an open question. Suggestive of the latter, some cases show a displacement between the electron and magnetic field peaks at the interface. Since solar information is transmitted to 1 AU much more quickly by suprathermal electrons compared to convected plasma signatures, the displacement may imply a shift in the coronal hole boundary through transport of open magnetic flux via interchange reconnection. If so, however, the fact that displacements occur in both directions and that the electron and field peaks in the superposed epoch analysis are nearly coincident indicate that any systematic transport expected from differential solar rotation is overwhelmed by a random pattern, possibly owing to transport across a ragged coronal hole boundary.

Non-stoichiometric oxide and metal interfaces and reactions

We have employed a combination of experimental surface science techniques and density functional calculations to study the reduction of TiO2(110) surfaces through the doping with submonolayer transition metals. We concentrate on the role of Ti adatoms in self doping of rutile and contrast the behaviour to that of Cr. DFT+U calculations enable identification of probable adsorption structures and their spectroscopic characteristics. Adsorption of both metals leads to a broken symmetry and an asymmetric charge transfer localised around the defect site of a mixed localised/delocalised character. Charge transfer creates defect states with Ti 3d character in the band gap at similar to 1-eV binding energy. Cr adsorption, however, leads to a very large shift in the valence-band edge to higher binding energy and the creation of Cr 3d states at 2.8-eV binding energy. Low-temperature oxidation lifts the Ti-derived band-gap states and modifies the intensity of the Cr features, indicative of a change of oxidation state from Cr3+ to Cr4+. Higher temperature processing leads to a loss of Cr from the surface region, indicative of its substitution into the bulk.

Queue-based agent architecture for multimodal interfaces

This paper presents a queue-based agent architecture for multimodal interfaces. Using a novel approach to intelligently organise both agents and input data, this system has the potential to outperform current state-of-the-art multimodal systems, while at the same time allowing greater levels of interaction and flexibility. This assertion is supported by simulation test results showing that significant improvements can be obtained over normal sequential agent scheduling architectures. For real usage, this translates into faster, more comprehensive systems, without the limited application domain that restricts current implementations.

An agent based approach to distributed task modeling for co-operative task support

This paper describes the design and implementation of an agent based network for the support of collaborative switching tasks within the control room environment of the National Grid Company plc. This work includes aspects from several research disciplines, including operational analysis, human computer interaction, finite state modelling techniques, intelligent agents and computer supported co-operative work. Aspects of these procedures have been used in the analysis of collaborative tasks to produce distributed local models for all involved users. These models have been used as the basis for the production of local finite state automata. These automata have then been embedded within an agent network together with behavioural information extracted from the task and user analysis phase. The resulting support system is capable of task and communication management within the transmission despatch environment.

Minimising the latency induced by consistency control, within a large scale multi-user distributed virtual reality system

Where users are interacting in a distributed virtual environment, the actions of each user must be observed by peers with sufficient consistency and within a limited delay so as not to be detrimental to the interaction. The consistency control issue may be split into three parts: update control; consistent enactment and evolution of events; and causal consistency. The delay in the presentation of events, termed latency, is primarily dependent on the network propagation delay and the consistency control algorithms. The latency induced by the consistency control algorithm, in particular causal ordering, is proportional to the number of participants. This paper describes how the effect of network delays may be reduced and introduces a scalable solution that provides sufficient consistency control while minimising its effect on latency. The principles described have been developed at Reading over the past five years. Similar principles are now emerging in the simulation community through the HLA standard. This paper attempts to validate the suggested principles within the schema of distributed simulation and virtual environments and to compare and contrast with those described by the HLA definition documents.