Electronic charge transfer between ceria surfaces and gold adatoms: a GGA+U investigation

We use density functional theory calculations with Hubbard corrections (DFT+U) to investigate electronic aspects of the interaction between ceria surfaces and gold atoms. Our results show that Au adatoms at the (111) surface of ceria can adopt Au0, Au+ or Au� electronic configurations depending on the adsorption site. The strongest adsorption sites are on top of the surface oxygen and in a bridge position between two surface oxygen atoms, and in both cases charge transfer from the gold atom to one of the Ce cations at the surface is involved. Adsorption at other sites, including the hollow sites of the surface, and an O–Ce bridging site, is weaker and does not involve charge transfer. Adsorption at an oxygen vacancy site is very strong and involves the formation of an Au� anion. We argue that the ability of gold atoms to stabilise oxygen vacancies at the ceria surface by moving into the vacancy site and attracting the excess electrons of the defect could be responsible for the enhanced reducibility of ceria surfaces in the presence of gold. Finally, we rationalise the differences in charge transfer behaviour from site to site in terms of the electrostatic potential at the surface and the coordination of the species.

A self-calibrating electrometer for atmospheric charge measurements from a balloon platform

Charged aerosol particles and water droplets are abundant throughout the lower atmosphere, and may influence interactions between small cloud droplets. This note describes a small, disposable sensor for the measurement of charge in non-thunderstorm cloud, which is an improvement of an earlier sensor [K. A. Nicoll and R. G. Harrison, Rev. Sci. Instrum. 80, 014501 (2009)]. The sensor utilizes a self-calibrating current measurement method. It is designed for use on a free balloon platform alongside a standard meteorological radiosonde, measuring currents from 2 fA to 15 pA and is stable to within 5 fA over a temperature range of 5 °C to −60 °C. During a balloon flight with the charge sensor through a stratocumulus cloud, charge layers up to 40 pC m−3 were detected on the cloud edges.

RuII(α-diimine) or RuIII(α-diimine·–)? Structural, spectroscopic, and theoretical evidence for the stabilization of a prominent metal-to-Ligand charge- transfer excited-state configuration in the ground state

The new compounds [Ru(R-DAB)(acac)2] (R-DAB = 1,4-diorganyl- 1,4-diazabuta-1,3-diene; R = tert-butyl, 4-methoxyphenyl, 2,6-dimethylphenyl; acac– = 2,4-pentanedionate) exhibit intrachelate ring bond lengths 1.297charge-transfer absorption band in the visible region and by DFT calculations. Oxidation of the compounds occurs mainly at the R-DAB·– radical ligand to produce UV/Vis/NIR and electron paramagnetic resonance (EPR) spectroelectrochemically detectable RuIII species, whereas the reduction proceeds less reversibly and yields predominantly (R-DAB)-ligand-based spin for the 4-methoxyphenyl derivative, measured at low temperature. The results are discussed with respect to metal-to-ligand chargetransfer (MLCT) excited states of conventional (α-diimine)- ruthenium(II) complexes and in view of other (α-diimine)- metal complexes with ambiguous oxidation-state assignments.

Electronic structure of Pd multi-layers on Re(0001): the role of charge transfer

Understanding the origin of the properties of metal-supported metal thin films is important for the rational design of bimetallic catalysts and other applications, but it is generally difficult to separate effects related to strain from those arising from interface interactions. Here we use density functional (DFT) theory to examine the structure and electronic behavior of few-layer palladium films on the rhenium (0001) surface, where there is negligible interfacial strain and therefore other effects can be isolated. Our DFT calculations predict stacking sequences and interlayer separations in excellent agreement with quantitative low-energy electron diffraction experiments. By theoretically simulating the Pd core-level X-ray photoemission spectra (XPS) of the films, we are able to interpret and assign the basic features of both low-resolution and high-resolution XPS measurements. The core levels at the interface shift to more negative energies, rigidly following the shifts in the same direction of the valence d-band center. We demonstrate that the valence band shift at the interface is caused by charge transfer from Re to Pd, which occurs mainly to valence states of hybridized s-p character rather than to the Pd d-band. Since the d-band filling is roughly constant, there is a correlation between the d-band center shift and its bandwidth. The resulting effect of this charge transfer on the valence d-band is thus analogous to the application of a lateral compressive strain on the adlayers. Our analysis suggests that charge transfer should be considered when describing the origin of core and valence band shifts in other metal / metal adlayer systems.

Reverse knowledge transfer: evidence from General Motors in the UK and Poland

This paper explores the concept of a reverse diffusion of knowledge, that is, the transfer flowing from a company’s subsidiary to its home plant. The article presents the empirical evidence gathered in General Motors UK and Poland, where the reverse diffusion of a concept of the built-in quality took place. Lastly, the implications of our findings for future research are discussed.

Reverse transfers of innovation and national development: evidence from Brazilian subsidiaries

The search for innovation has become an important motivation for the internationalization of companies in emerging countries. In that context, this study tests the impact that a nation’s development has on whether subsidiaries transfer innovation of products or that of processes. Survey data collected from 73 subsidiaries of Brazilian companies indicate that companies located in developed markets tend to transfer more product-oriented innovations than do those based in emerging countries. Furthermore, the size and age of a subsidiary has an impact on the transfer process. The larger and younger the subsidiary, the more likely a company is to favor the flow of product innovation into its headquarters. The level of national development was not identified as an influence on the flow of process innovation.

Reverse correlation reveals how observers sample visual information when estimating three-dimensional shape

Human observers exhibit large systematic distance-dependent biases when estimating the three-dimensional (3D) shape of objects defined by binocular image disparities. This has led some to question the utility of disparity as a cue to 3D shape and whether accurate estimation of 3D shape is at all possible. Others have argued that accurate perception is possible, but only with large continuous perspective transformations of an object. Using a stimulus that is known to elicit large distance-dependent perceptual bias (random dot stereograms of elliptical cylinders) we show that contrary to these findings the simple adoption of a more naturalistic viewing angle completely eliminates this bias. Using behavioural psychophysics, coupled with a novel surface-based reverse correlation methodology, we show that it is binocular edge and contour information that allows for accurate and precise perception and that observers actively exploit and sample this information when it is available.

The impact of charge transfer and structural disorder on the thermoelectric properties of cobalt intercalated TiS2

A family of phases, CoxTiS2 (0 ≤ x ≤ 0.75) has been prepared and characterised by powder X-ray and neutron diffraction, electrical and thermal transport property measurements, thermal analysis and SQUID magnetometry. With increasing cobalt content, the structure evolves from a disordered arrangement of cobalt ions in octahedral sites located in the van der Waals’ gap (x ≤ 0.2), through three different ordered vacancy phases, to a second disordered phase at x ≥ 0.67. Powder neutron diffraction reveals that both octahedral and tetrahedral inter-layer sites are occupied in Co0.67TiS2. Charge transfer from the cobalt guest to the TiS2 host affords a systematic tuning of the electrical and thermal transport properties. At low levels of cobalt intercalation (x < 0.1), the charge transfer increases the electrical conductivity sufficiently to offset the concomitant reduction in |S|. This, together with a reduction in the overall thermal conductivity leads to thermoelectric figures of merit that are 25 % higher than that of TiS2, ZT reaching 0.30 at 573 K for CoxTiS2 with 0.04 ≤ x ≤ 0.08. Whilst the electrical conductivity is further increased at higher cobalt contents, the reduction in |S| is more marked due to the higher charge carrier concentration. Furthermore both the charge carrier and lattice contributions to the thermal conductivity are increased in the electrically conductive ordered-vacancy phases, with the result that the thermoelectric performance is significantly degraded. These results illustrate the competition between the effects of charge transfer from guest to host and the disorder generated when cobalt cations are incorporated in the inter-layer space.

Towards conceptualizing reverse service supply chains

Purpose – Recognizing the heterogeneity of services, this paper aims to clarify the characteristics of forward and the corresponding reverse supply chains of different services. Design/methodology/approach – The paper develops a two-dimensional typology matrix, representing four main clusters of services according to the degree of input standardization and the degree of output tangibility. Based on this matrix, this paper develops a typology and parsimonious conceptual models illustrating the characteristics of forward and the corresponding reverse supply chains of each cluster of services. Findings – The four main clusters of service supply chains have different characteristics. This provides the basis for the identification, presentation and explanation of the different characteristics of their corresponding reverse service supply chains. Research limitations/implications – The findings of this research can help future researchers to analyse, map and model forward and reverse service supply chains, and to identify potential research gaps in the area. Practical/implications – The findings of the research can help managers of service firms to gain better visibility of their forward and reverse supply chains, and refine their business models to help extend their reverse/closed-loop activities. Furthermore, the findings can help managers to better optimize their service operations to reduce service gaps and potentially secure new value-adding opportunities. Originality/value – This paper is the first, to the authors ' knowledge, to conceptualize the basic structure of the forward and reverse service supply chains while dealing with the high level of heterogeneity of services.

Second-life retailing: a reverse supply chain perspective

Purpose – The authors examine the role of entrepreneurial business models in the reverse supply chain of apparel/fashion retailers. The purpose of this paper is to offer an alternative approach to the “return to the point of origin” prevalent in the reverse chain of manufacturers but less technically and economically feasible in the case of apparel/fashion retailers. This approach, second-life retailing, not only reduces waste but also democratises consumption. Design/methodology/approach – The paper is based on an extensive literature review, semi-structured interviews with managers of two second-life retailers in Malaysia and observations of a number of stores. Findings – Using the Business Model Canvas, the authors demonstrate the essential characteristics of second-life retailers. Retailers in this study, unlike retailers in the developed world, combine traditional business models with off-price retailing. There is no clear demarcation between the forward and reverse supply chain used to manage first- and second-hand retailing. Practical implications – The paper demonstrates the potential of innovative business models in the reverse supply chain. It encourages managers to look beyond the “return to the point of origin” and seek imaginative alternatives. Such alternatives potentially could result in additional revenue, enhanced sustainability and democratisation of consumption meeting triple bottom line objectives. Originality/value – This paper highlights the importance and relevance of entrepreneurial business models in addressing the reverse supply chain, demonstrating this with the aid of two Malaysian off-price retailers. It also contributes to our nascent knowledge by focusing on emerging markets.

One-step reverse transcriptase polymerase chain reaction for the diagnosis of respiratory syncytial virus in children

Human respiratory syncytial virus (HRSV) is the main cause of acute lower respiratory tract infections in infants and children. Rapid diagnosis is required to permit appropriate care and treatment and to avoid unnecessary antibiotic use. Reverse transcriptase (RT-PCR) and indirect immunofluorescence assay (IFA) methods have been considered important tools for virus detection due to their high sensitivity and specificity. In order to maximize use-simplicity and minimize the risk of sample cross-contamination inherent in two-step techniques, a RT-PCR method using only a single tube to detect HRSV in clinical samples was developed. Nasopharyngeal aspirates from 226 patients with acute respiratory illness, ranging from infants to 5 years old, were collected at the University Hospital of the University of Sao Paulo (HU-USP), and tested using IFA, one-step RT-PCR, and semi-nested RT-PCR. One hundred and two (45.1%) samples were positive by at least one of the three methods, and 75 (33.2%) were positive by all methods: 92 (40.7%) were positive by one-step RT-PCR, 84 (37.2%) by IFA, and 96 (42.5%) by the semi-nested RT-PCR technique. One-step RT-PCR was shown to be fast, sensitive, and specific for RSV diagnosis, without the added inconvenience and risk of false positive results associated with semi-nested PCR. The combined use of these two methods enhances HRSV detection. (C) 2007 Elsevier B.V. All rights reserved.

Effects of the cationic antimicrobial peptide eumenitin from the venom of solitary wasp Eumenes rubronotatus in planar lipid bilayers: Surface charge and pore formation activity

Eumenitin, a novel cationic antimicrobial peptide from the venom of solitary wasp Eumenes rubronotatus, was characterized by its effects on black lipid membranes of negatively charged (azolectin) and zwitterionic (1,2-diphytanoyl-sn-glycero-3-phosphocholine (DPhPC) or DPhPC-cholesterol) phospholipids: surface potential changes, single-channel activity, ion selectivity, and pore size were studied. We found that eumenitin binds preferentially to charged lipid membranes as compared with zwitterionic ones. Eumenitin is able to form pores in azolectin (G(1) = 118.00 +/- 3.67 pS or G(2) = 160.00 +/- 7.07 pS) and DPhPC membranes (G = 61.13 +/- 7.57 pS). Moreover, cholesterol addition to zwitterionic DPhPC membranes inhibits pore formation activity but does not interfere with the binding of peptide. Open pores presented higher cation (K (+)) over anion (Cl-) selectivity. The pore diameter was estimated at between 8.5and 9.8 angstrom in azolectin membranes and about 4.3 angstrom in DPhPC membranes. The results are discussed based on the toroidal pore model for membrane pore-forming activity and ion selectivity. (c) 2007 Elsevier Ltd. All rights reserved.