Equilibrium of the simultaneous etherification ofisobutene and isoamylenes with ethanol inliquid-phase

The simultaneous etherification of isobutene and isoamylenes with ethanol has been studied using macroreticu-lar acid ion-exchange resins as catalyst. Most of the experiments were carried out over Amberlyst-35. In addition,Amberlyst-15 and Purolite CT-275 were also tested. Chemical equilibrium of four chemical reactions was studied:ethyl tert-butyl ether formation, tert-amyl ethyl ether formation from isoamylenes (2-methyl-1-butene and 2-methyl-2-butene) and isomerization reaction between both isoamylenes. Equilibrium data were obtained in a batchwisestirred tank reactor operated at 2.0 MPa and within the temperature range from 323 to 353 K. Experimental molarstandard enthalpy and entropy changes of reaction were determined for each reaction. From these data, the molarenthalpy change of formation of ethyl tert-butyl ether and tert-amyl ethyl ether were estimated. Besides, the chemical equilibrium between both diisobutene dimers, 2,4,4-trimethyl-1-pentene and 2,4,4-trimethyl-2-pentene, wasevaluated. A good agreement between thermodynamic results for the simultaneous etherification carried out in thiswork and those obtained for the isolated ethyl tert-butyl ether and tert-amyl ethyl ether systems was obtained.

Chemical and isotopic equilibrium between CO2 and CH4 in fumarolic gas discharges: Generation of CH4 in arc magmatic-hydrothermal systems

The chemical and isotopic composition of fumarolic gases emitted from Nisyros Volcano, Greece, and of a single gas sample from Vesuvio, Italy, was investigated in order to determine the origin of methane (CH,) within two subduction-related magmatic-hydrothermal environments. Apparent temperatures derived from carbon isotope partitioning between CH4 and CO2 of around 340degreesC for Nisyros and 470degreesC for Vesuvio correlate well with aquifer temperatures as measured directly and/or inferred from compositional data using the H2O-H-2-CO2-CO-CH4 geothermometer. Thermodynamic modeling reveals chemical equilibrium between CH4, CO2 and H2O implying that carbon isotope partitioning between CO2 and CH, in both systems is controlled by aquifer temperature. N-2/(3) He and CH4/(3) He ratios of Nisyros fumarolic gases are unusually low for subduction zone gases and correspond to those of midoceanic ridge environments. Accordingly, CH4 may have been primarily generated through the reduction of CO, by H, in the absence of any organic matter following a Fischer-Tropsch-type reaction. However, primary occurrence of minor amounts of thermogenic CH4 and subsequent re-equilibration with co-existing CO2 cannot be ruled out entirely- CO2/He-3 ratios and delta(13)C(CO2) values imply that the evolved CO2 either derives from a metasomatized mantle or is a mixture between two components, one outgassing from an unaltered mantle and the other released by thermal breakdown of marine carbonates. The latter may contain traces of organic matter possibly decomposing to CH4 during thermometamorphism. Copyright (C) 2004 Elsevier Ltd.

Epidote in hydrous mafic magmas : near solidus phase relations in the lower crust

Crystallisation of hydrous mafic magmas at high pressure is a subject of numerous petrologic and experimental studies since the last century and is mainly related to the process of continental crust formation and the possible link between mantle derived melts and low pressure granitoids. Albeit the sequence of crystallization is well constrained by experimental studies, the origin of exposed lower crustal rocks exposed on the earth surface is controversial. Ones line of argument is favouring high pressure crystallization of dry or wet mafic magmas, whereas others invoke partial melting of pre-existing crust. Therefore studies involving field, textural and chemical observations of exposed lower crust such as in Kohistan (Pakistan) or Talkeetna (Alaska) are crucial to understand the continental crust formation processes via arc magmatism. Epidote-bearing gabbros are very sparse and always associated with the deep part of continental crust (>30 km) as in the Kohistan Arc Complex (Pakistan) or in the Chelan Complex (western U.S.). Magmatic epidote is restricted to a small temperature interval above the water-saturated solidus of MORB and represent the last crystallizing liquids in lower crustal regions. However, epidote and melt stability at lower crustal pressures are not clearly established.¦The Chelan complex (western U.S.) at the base of the Cascadian Arc is composed mainly by peraluminous tonalité associated with gabbroic and ultramafic rocks and was traditionally interpreted as a migmatitic terrain. However field, chemical and mineralogical observations rather suggest a magmatic origin and point to a protracted crystallization at intermediate to high pressure ~ 1.0 GPa dominated by amphibole fractionation and followed by isobaric cooling down to 650°C. Crystal fractionation modelling using whole rock composition and field constraints is able to generate peraluminous tonalité. The modelled crystallisation sequence and the volume proportions are in agreement with experimental studies performed at these pressures. The Chelan complex was thus not formed during a partial melting event, but represent the sequence of crystallisation occurring at the base of the crust. Massive fractionation of hornblende is able to generate peraluminous tonalité without significant assimilation of crustal rock.¦Similarly to the Chelan complex, the base of the Kohistan arc is composed of cumulates derived by high pressure crystallization of hydrous magma. In garnet gabbros, epidote occurs as magmatic phase, crystallising from hydrous interstitial melt trapped between grain boundaries at lower crustal pressures (Ρ ~ 1.2 GPa) for temperature of (650-700 °C). Trace and REE signature in epidote indicate that epidote was formed through peritectic reaction involving garnet, clinopyroxene and plagioclase. At the beginning of the crystallisation epidote signature is dominated by REE content in the melt, whereas at the end the signature is dominated by reacting phases. Melt in equilibrium with epidote inferred from the partition coefficients available is similar to intrusive tonalité up the section indicating that hydrous melt was extracted from the garnet gabbros. In some gabbros epidote shows single homogeneous compositions, while in others coexisting epidote have different compositions indicating the presence of solvi along the Al-Fe3+ join. The overgowths are only observed in presence of paragonite in the assemblage, suggesting high water content. At high water content, the hydrous solidus is shift to lower temperature and probably intersects the solvi observed along the Al-Fe3+ join. Therefore, several compositions of epidote is stable at high water content.¦-¦La composition chimique de la croûte continentale est considérée comme similaire à celle du magmatisme calco-alcalin de marge continentale active (enrichissement en éléments mobiles dans les fluides, anomalies négatives en Nb, Ta et éléments à haut potentiel électronique, etc...). Cependant la nature andésitique de la croûte continentale (Si02 > 60 wt%), résultant des nombreuses intrusions de granitoïdes dans la croûte supérieure, est sujette à polémique et le lien entre les magmas dérivés du manteau et les roches évoluées de faible profondeur n'est pas clairement établi (fusion partielle de croûte basaltique, cristallisation fractionnée à haute pression, etc...).¦Les affleurements de croûte profonde sont rares mais précieux, car ils permettent d'observer les phénomènes se passant à grande profondeur. Le complexe de Chelan (Washington Cascades) en est un exemple. Formé à environ 30 km de profondeur, il est composé de roches gabbroïques et ultramafiques, ainsi que de tonalités, qui furent souvent interprétés comme le produit de la fusion partielle de la croûte. Cependant, les relations de terrain, la chimie des éléments majeurs et des éléments traces sont cohérentes avec l'évolution d'un complexe magmatique mafique dans la croûte profonde ou moyenne ( 1.0 GPa), dominée par le fractionnement de l'amphibole. Après son emplacement, le complexe a subi un refroidissement isobare jusqu'à des températures de l'ordre de 650 °C, déduit de la composition chimique des minéraux. Un bilan de masse contraint pax les observations de terrain permet de calculer la séquence et les volumes de fractionnement. Les faciès évolués légèrement hyperalumineux observés sur le terrain peuvent être générés par la cristallisation de 3 % de websterite à olivine, 12 % d'hornblendite à pyroxène 33 % d'hornblendite, 19 % de gabbros, 15 % de diorite et 2 % de tonalité. Nous montrons ainsi qu'une série de fractionnement contrôlée par l'amphibole permet de générer des tonalités sans assimilation de matériel crustal et l'exemple de Chelan illustre la viabilité de ce processus dans la formation de croûte continentale.¦Les réactions proches du solidus saturé en H20 dans les systèmes basaltiques à des pressions élevées restent énigmatiques. Diverses expériences tendent à montrer que l'épidote est stable dans ces conditions, mais rarement observée (décrite ?) comme phase primaire dans les systèmes naturels. Les épidotes trouvées dans les gabbros de Jijal (nord-Pakistan) montrent des textures de type .magmatique telles qu'observées dans les roches évoluées. Le contenu en terres rares de ces épidotes est très variable allant de signatures enrichies en terres rares légères impliquant la présence de liquide interstitiel à des signatures complètement déprimées en ces mêmes éléments, évoquant une cristallisation en coexistence avec du grenat. Ces diverses signatures reflètent un chemin de cristallisation en présence de liquide interstitiel et enregistrent des réactions péritectiques impliquant grenat, clinopyroxene et plagioclase à des pressions de ~ 1.2 GPa pour des températures de 650-700 °C. Cependant dans quelques échantillons deux ou trois compositions d'épidotes coexistent démontrant la présence de lacunes d'immiscibilité le long de la solution solide épidote-clinozoïsite. La forte teneur en H20 du liquide magmatique est certainement à l'origine de la coexistence de deux compositions distinctes.

Contact force transitions in regrasp tasks of planar objects

This paper presents a simple and fast solution to the problem of finding the time variations of the forces that keep the object equilibrium when a finger is removed from a three contact point grasp or a finger is added to a two contact point grasp, assuming the existence of an external perturbation force (that can be the object weight itself). The procedure returns force set points for the control system of a manipulator device in a regrasping action. The approach was implemented and a numerical example is included in the paper to illustrate how it works.