Micromechanics analysis of particulate-reinforced composites and their failure mechanisms

Stress fields and failure mechanisms have been investigated in composites with particles either surface treated or untreated under uniaxial tension. Previous experimental observation of failure mechanisms in a composite with untreated particles showed that tensile cracks occurred mostly at the polar region of the particle and grew into interfacial debonding. In a composite with surface-treated particles, however, shear yielding and shear cracking proceeded along the interphase-matrix interface at the polar area of the matrix and thus may improve the mechanical behaviour of the material. The finite element calculations showed that octahedral shear stress at the polar and longitudinal areas of the particle treated by coupling agents is much larger than that of materials with untreated particles, and the shear stress distribution around the interface is sensitive to the interphase property. The results suggest that a th ree-phase model can describe the composites with surface-treated fillers.

The interlaminar fracture-behavior and toughening mechanisms of new carbon-fiber-reinforced bismaleimide composites

The interlaminar fracture behaviour of carbon fibre-reinforced bismaleimide (BMI) composites prepared by using a new modified BMI matrix has been investigated by various methods. Laminates of three typical stacking sequences were evaluated. Double cantilever beam, end-notch flexure and edge-delamination tension tests were conducted under conventional conditions and in a scanning electron microscope. The strain energy release rates in Mode I and Mode III G(lc) and G(llc), as well as the total strain energy release rate, G(mc), have been determined and found to be higher than those for laminates with an epoxy matrix. Dynamic delamination propagation was also studied. The toughening mechanisms are discussed.

Mixed-mode fracture mechanisms near the fatigue threshold of aisi-316 stainless-steel

Near threshold, mixed mode (I and II), fatigue crack growth occurs mainly by two mechanisms, coplanar (or shear) mode and branch (or tensile) mode. For a constant ratio of ΔK_I/ΔK_II the shear mode growth shows a self-arrest character and it would only start again when ΔK_I and ΔK_II are increased. Both shear crack growth and the early stages of tensile crack growth, are of a crystallographic nature; the fatigue crack proceeds along slip planes or grain boundaries. The appearance of the fracture surfaces suggest that the mechanism of crack extension is by developing slip band microcracks which join up to form a macrocrack. This process is thought to be assisted by the nature of the plastic deformation within the reversed plastic zone where high back stresses are set up by dislocation pile-ups against grain boundaries. The interaction of the crack tip stress field with that of the dislocation pile-ups leads to the formation of slip band microcracks and subsequent crack extension. The change from shear mode to tensile mode growth probably occurs when the maximum tensile stress and the microcrack density in the maximum tensile plane direction attain critical values.

How much efficiency gains and price reductions for an efficiency defense? 'Quanto Basta'

Potential efficiency gains due to a merger can be used by competition authorities to judge upon proposed mergers. In a world where agents’ efforts, observable or unobservable, affect the success of a production cost reducing project that may be conducted as a stand-alone firm or in a merger, we characterize the merger decision and the type of errors a competition authority may make when it relies on an efficiency defense. In addition, we show that the occurrence of either type of errors is always smaller under the unobservable efforts assumption, than under the observable efforts one.

Interim report on the progress of an inventory of artesian wells in Florida: leading to the enforcement of sections 370.051 - 370.54, Florida statues

One of the causes of lower artesian pressure, water waste and aquifer contamination is the misuse and insufficient care of artesian wells. In 1953, Senate Bill No. 57, entitled "An Act to Protect and Control the Artesian Waters of the State" (see Appendix) became a law. This law was passed through the efforts exerted by leading members of the Senate and the House of Representatives, who understood the need for a wise and controlled expenditure of our most valuable natural resource. The State Geologist and his authorized representatives were designated by this law to enforce this conservation measure; however, no financial provision was included for the 1953-55 biennium. The proposed program of the Florida Geological Survey for this biennium did not include the funds nor provide any full-time personnel for the enforcement of this statute. As a result, little actual work was accomplished during these two years, although much time was given to planning and discussion of the problem. Realizing that this program could provide additional basic data needed in the analysis of the water-supply problem, the State Geologist sought and was granted by the 1955 Legislature adequate funds with which to activate the first phase of the enforcement of Florida Statute No. 370.051-054. Enumerated below is a summary of the progress made on this investigation as outlined previously: 1. Data have been collected on 967 wildly flowing wells in 22 counties. 2. Chloride determinations have been run on 850 of the 967 wells. 3. Of the 967 wells, 554 have chlorides in excess of the 250 ppm, the upper limit assigned by the State Board of Health for public consumption. 4. Water escapes at the rate of 37, 762 gallons per minute from these 967 wells. This amounts to 54, 377, 280 gallons per day. The investigation is incomplete at this time; therefore, no final conclusions can be reached. However, from data already collected, the following recommendations are proposed: 1. That the present inventory of wildly flowing wells be completed for the entire State. 2. That the current inventory of wildly flowing wells be expanded at the conclusion of the present inventory to include all flowing wells. 3. That a complete statewide inventory program be established and conducted in cooperation with the Ground Water Branchof the U.S. Geological Survey. 4. That the enforcement functions as set down in Sections 370.051/.054, Florida Statutes, be separated from the program to collect water-resource data and that these functions be given to the Water Resources Department, if such is created (to be recommended by the Water Resources Study Commission in a water policy law presented to the 1957 Legislature). 5. That the research phase (well inventory) of the program remain under the direction of the Florida Geological Survey. (PDF contains 204 pages.)

Final report on an inventory of flowing artesian wells in Florida: leading to the enforcement of sections 373.021 - 373.061 Florida Statutes 1957

This report published as Information Circular No. 21, together with the interim report published in 1957 as Information Circular No. 10, Florida Geological Survey, illustrates as completely as possible the situation that now exists among the freely flowing wells of the State. (PDF contains 40 pages.)

Two-part tariff licensing mechanisms

Most of the patent licensing agreements that are observed include royalties, in particular per-unit or ad valorem royalties. This paper shows that in a differ entiated duopoly that competes á la Cournot the optimal contract for an internal patentee always includes a positive royalty. Moreover, we show that the patentee would prefer to use ad valorem royalties rather than per-unit royalties when goods are complements or when they are substitutes and the degree of differentiation is suffciently low. The reason is that by including an ad valorem royalty in the licensing contract the patentee can commit strategically to be more (less) aggressive when goods are complements (substitutes) since his licensing revenues become increasing with the price of output of his rival. As a result, licensing may hurt consumers although it always increases social welfare.