981 resultados para CA-19.9
Resumo:
Analizar el rol de los 19 delegatarios de la Lista Nacional No.9, impulsada por la Alianza Democrática M-19, en la Asamblea Nacional Constituyente de 1991 y en la elaboración de la actual Constitución Política de Colombia
Resumo:
The produced water is a byproduct formed due to production of petroleum and carries with it a high amount of contaminants such as oil particles in suspension, organic compounds and metals. Thus, these latter pollutants are very difficult to treat because of its high solubility in water. The objective of this work is to use and evaluate a microemulsioned system to remove metals ( K , Mg , Ba , Ca , Cr , Mn , Li , Fe ) of synthetic produced water. For the extraction of metals, it was used a pseudoternary diagram containing the following phases: synthetic produced water as the aqueous phase (AP), hexane as organic phase (OP), and a cosurfactant/surfactant ratio equal to four (C/S = 4) as the third phase, where the OCS (saponified coconut oil) was used as surfactant and n-butanol as cosurfactant. The synthetic produced water was prepared in a bench scale and the region of interest in the diagram for the removal of metals was determined by experimental design called. Ten points located in the phase Winsor II were selected in an area with a large amount of water and small amounts of reagents. The samples were analyzed in atomic absorption spectrometer, and the results were evaluated through a statistical assesment, allowing the efficiency analysis of the effects and their interactions. The results showed percentages of extraction above 90% for the metals manganese, iron, chromium, calcium, barium and magnesium, and around 45% for metals lithium and potassium. The optimal point for the simultaneous removal of metals was calculated using statistical artifact multiple response function (MR). This calculation showed that the point of greatest extraction of metals occurs was the J point, with the composition [72% AP, 9% OP, 19% C/S], obtaining a global extraction percentage about 80%. Considering the aspects analyzed, the microemulsioned system has shown itself to be an effective alternative in the extraction of metals on synthetic produced water remediation
Resumo:
Quarenta e oito leitões híbridos comerciais, machos castrados e fêmeas, com 5,5 ± 0,21 kg foram distribuídos em blocos ao acaso, com quatro tratamentos e seis repetições, para determinar a melhor concentração de lisina até os 11,9 ± 0,35 kg (fase inicial-1) e os efeitos subseqüentes até os 19,0 kg (fase inicial-2). A composição química das frações corporais e a deposição de tecido muscular na carcaça e no corpo vazio foram determinadas. As concentrações de lisina total utilizadas na primeira fase pós-desmame foram 1,16 a 1,46%. Não foi observado efeito na composição química do sangue e das vísceras, caracterizando a independência das concentrações de lisina. As respostas para acúmulo protéico e água da carcaça e do corpo vazio foram ascendentes com o aumento de lisina, caracterizando a maior eficiência na utilização e direcionamento do nutriente para a síntese protéica da musculatura esquelética. Na segunda fase, não foram observados efeitos, mas os animais que, anteriormente, receberam menores níveis de lisina tenderam acumular mais proteína e água na carcaça e no corpo vazio. Possivelmente, encontrando-se em déficit de lisina, fisiologicamente tolerável, a nova dieta supriu parte da demanda anterior, porém pode não ter atendido à demanda para síntese protéica dos animais que se encontravam em maior ascensão de síntese e acúmulo protéico na fase inicial-1. As respostas favoráveis ao aumento da concentração de lisina na dieta de leitões entre 5,5 e 11,9 kg de peso vivo recomendam novos estudos utilizando níveis de lisina superiores aos empregados, combinados com maiores níveis de energia metabolizável, a fim de estabelecer a eficiência máxima de deposição protéica. Estudos nas fases subseqüentes devem complementar informações de melhor aporte nutricional para o suíno.
Resumo:
The fast sequential multi-element determination of Ca, Mg, K, Cu, Fe, Mn and Zn in plant tissues by high-resolution continuum source flame atomic absorption spectrometry is proposed. For this, the main lines for Cu (324.754 nm), Fe (248.327 nm), Mn (279.482 nm) and Zn (213.857 nm) were selected, and the secondary lines for Ca (239.856 nm), Mg (202.582 nm) and K (404.414 nm) were evaluated. The side pixel registration approach was studied to reduce sensitivity and extend the linear working range for Mg by measuring at wings (202.576 nm; 202.577 nm; 202.578 nm; 202.580 nm: 202.585 nm; 202.586 nm: 202.587 nm; 202.588 nm) of the secondary line. The interference caused by NO bands on Zn at 213.857 nm was removed using the least-squares background correction. Using the main lines for Cu, Fe, Mn and Zn, secondary lines for Ca and K, and line wing at 202.588 nm for Mg, and 5 mL min(-1) sample flow-rate, calibration curves in the 0.1-0.5 mg L-1 Cu, 0.5-4.0 mg L-1 Fe, 0.5-4.0 mg L-1 Mn, 0.2-1.0 mg L-1 Zn, 10.0-100.0 mg L-1 Ca, 5.0-40.0 mg L-1 Mg and 50.0-250.0 mg L-1 K ranges were consistently obtained. Accuracy and precision were evaluated after analysis of five plant standard reference materials. Results were in agreement at a 95% confidence level (paired t-test) with certified values. The proposed method was applied to digests of sugar-cane leaves and results were close to those obtained by line-source flame atomic absorption spectrometry. Recoveries of Ca, Mg, K, Cu, Fe, Mn and Zn in the 89-103%, 84-107%, 87-103%, 85-105%, 92-106%, 91-114%, 96-114% intervals, respectively, were obtained. The limits of detection were 0.6 mg L-1 Ca, 0.4 mg L-1 Mg, 0.4 mg L-1 K, 7.7 mu g L-1 Cu, 7.7 mu g L-1 Fe, 1.5 mu g L-1 Mn and 5.9 mu g L-1 Zn. (C) 2009 Elsevier B.V. All rights reserved.
Resumo:
Pós-graduação em Cirurgia Veterinária - FCAV
