Evidence for divided automatic attention

A long-standing debate in the literature is whether attention can form two or more independent spatial foci in addition to the well-known unique spatial focus. There is evidence that voluntary visual attention divides in space. The possibility that this also occurs for automatic visual attention was investigated here. Thirty-six female volunteers were tested. In each trial, a prime stimulus was presented in the left or right visual hemifield. This stimulus was characterized by the blinking of a superior, middle or inferior ring, the blinking of all these rings, or the blinking of the superior and inferior rings. A target stimulus to which the volunteer should respond with the same side hand or a target stimulus to which she should not respond was presented 100 ms later in a primed location, a location between two primed locations or a location in the contralateral hemifield. Reaction time to the positive target stimulus in a primed location was consistently shorter than reaction time in the horizontally corresponding contralateral location. This attentional effect was significantly smaller or absent when the positive target stimulus appeared in the middle location after the double prime stimulus. These results suggest that automatic visual attention can focus on two separate locations simultaneously, to some extent sparing the region in between.

Method for automatic detection of wheezing in lung sounds

The present report describes the development of a technique for automatic wheezing recognition in digitally recorded lung sounds. This method is based on the extraction and processing of spectral information from the respiratory cycle and the use of these data for user feedback and automatic recognition. The respiratory cycle is first pre-processed, in order to normalize its spectral information, and its spectrogram is then computed. After this procedure, the spectrogram image is processed by a two-dimensional convolution filter and a half-threshold in order to increase the contrast and isolate its highest amplitude components, respectively. Thus, in order to generate more compressed data to automatic recognition, the spectral projection from the processed spectrogram is computed and stored as an array. The higher magnitude values of the array and its respective spectral values are then located and used as inputs to a multi-layer perceptron artificial neural network, which results an automatic indication about the presence of wheezes. For validation of the methodology, lung sounds recorded from three different repositories were used. The results show that the proposed technique achieves 84.82% accuracy in the detection of wheezing for an isolated respiratory cycle and 92.86% accuracy for the detection of wheezes when detection is carried out using groups of respiratory cycles obtained from the same person. Also, the system presents the original recorded sound and the post-processed spectrogram image for the user to draw his own conclusions from the data.

Manual and semi-automatic quantification of in vivo ¹H-MRS data for the classification of human primary brain tumors

In vivo proton magnetic resonance spectroscopy (¹H-MRS) is a technique capable of assessing biochemical content and pathways in normal and pathological tissue. In the brain, ¹H-MRS complements the information given by magnetic resonance images. The main goal of the present study was to assess the accuracy of ¹H-MRS for the classification of brain tumors in a pilot study comparing results obtained by manual and semi-automatic quantification of metabolites. In vivo single-voxel ¹H-MRS was performed in 24 control subjects and 26 patients with brain neoplasms that included meningiomas, high-grade neuroglial tumors and pilocytic astrocytomas. Seven metabolite groups (lactate, lipids, N-acetyl-aspartate, glutamate and glutamine group, total creatine, total choline, myo-inositol) were evaluated in all spectra by two methods: a manual one consisting of integration of manually defined peak areas, and the advanced method for accurate, robust and efficient spectral fitting (AMARES), a semi-automatic quantification method implemented in the jMRUI software. Statistical methods included discriminant analysis and the leave-one-out cross-validation method. Both manual and semi-automatic analyses detected differences in metabolite content between tumor groups and controls (P < 0.005). The classification accuracy obtained with the manual method was 75% for high-grade neuroglial tumors, 55% for meningiomas and 56% for pilocytic astrocytomas, while for the semi-automatic method it was 78, 70, and 98%, respectively. Both methods classified all control subjects correctly. The study demonstrated that ¹H-MRS accurately differentiated normal from tumoral brain tissue and confirmed the superiority of the semi-automatic quantification method.

Semi-automatic measurement of visual verticality perception in humans reveals a new category of visual field dependency

Previous assessment of verticality by means of rod and rod and frame tests indicated that human subjects can be more (field dependent) or less (field independent) influenced by a frame placed around a tilted rod. In the present study we propose a new approach to these tests. The judgment of visual verticality (rod test) was evaluated in 50 young subjects (28 males, ranging in age from 20 to 27 years) by randomly projecting a luminous rod tilted between -18 and +18° (negative values indicating left tilts) onto a tangent screen. In the rod and frame test the rod was displayed within a luminous fixed frame tilted at +18 or -18°. Subjects were instructed to verbally indicate the rod’s inclination direction (forced choice). Visual dependency was estimated by means of a Visual Index calculated from rod and rod and frame test values. Based on this index, volunteers were classified as field dependent, intermediate and field independent. A fourth category was created within the field-independent subjects for whom the amount of correct guesses in the rod and frame test exceeded that of the rod test, thus indicating improved performance when a surrounding frame was present. In conclusion, the combined use of subjective visual vertical and the rod and frame test provides a specific and reliable form of evaluation of verticality in healthy subjects and might be of use to probe changes in brain function after central or peripheral lesions.

Oculo-facio-cardio-dental syndrome in three succeeding generations: genotypic data and phenotypic features

Oculo-facio-cardio-dental (OFCD) syndrome is a rare X-linked disorder mainly manifesting in females. Patients show ocular, facial, cardiac, and dental abnormalities. OFCD syndrome is caused by heterozygous mutations in the BCOR gene, located in Xp11.4, encoding the BCL6 co-repressor. We report a Croatian family with four female members (grandmother, mother and monozygotic female twins) diagnosed with OFCD syndrome who carry the novel BCOR mutation c.4438C>T (p.R1480*). They present high intrafamilial phenotypic variability with special regard to cardiac defect and cataract that showed more severe disease expression in successive generations. Clinical and radiographic examination of the mother of the twins revealed a talon cusp involving the permanent maxillary right central incisor. This is the first known report of a talon cusp in OFCD syndrome with a novel mutation in the BCOR gene.

Design of automatic control system for the precipitation of bromelain from the extract of pineapple wastes

In this work, bromelain was recovered from ground pineapple stem and rind by means of precipitation with alcohol at low temperature. Bromelain is the name of a group of powerful protein-digesting, or proteolytic, enzymes that are particularly useful for reducing muscle and tissue inflammation and as a digestive aid. Temperature control is crucial to avoid irreversible protein denaturation and consequently to improve the quality of the enzyme recovered. The process was carried out alternatively in two fed-batch pilot tanks: a glass tank and a stainless steel tank. Aliquots containing 100 mL of pineapple aqueous extract were fed into the tank. Inside the jacketed tank, the protein was exposed to unsteady operating conditions during the addition of the precipitating agent (ethanol 99.5%) because the dilution ratio "aqueous extract to ethanol" and heat transfer area changed. The coolant flow rate was manipulated through a variable speed pump. Fine tuned conventional and adaptive PID controllers were on-line implemented using a fieldbus digital control system. The processing performance efficiency was enhanced and so was the quality (enzyme activity) of the product.

Brazil nut sorting for aflatoxin prevention: a comparison between automatic and manual shelling methods

The impact of automatic and manual shelling methods during manual/visual sorting of different batches of Brazil nuts from the 2010 and 2011 harvests was evaluated in order to investigate aflatoxin prevention.The samples were tested as follows: in-shell, shell, shelled, and pieces in order to evaluate the moisture content (mc), water activity (Aw), and total aflatoxin (LOD = 0.3 µg/kg and LOQ 0.85 µg/kg) at the Brazil nut processing plant. The results of aflatoxins obtained for the manually shelled nut samples ranged from 3.0 to 60.3 µg/g and from 2.0 to 31.0 µg/g for the automatically shelled samples. All samples showed levels of mc below the limit of 15%; on the other hand, shelled samples from both harvests showed levels of Aw above the limit. There were no significant differences concerning the manual or automatic shelling results during the sorting stages. On the other hand, the visual sorting was effective in decreasing the aflatoxin contamination in both methods.

Quadcopter assistant for a mobile assembly robot

Science has revolutionized the human life. The advance progress in science and research is making human life easier and more comfortable. The new and emerging technology of micro drone is penetrating and widening the scientific research. This thesis is a part of work in which a unique work is carried out, although related research paper and journal are available. Design and development of automatic charging station for a ready to fly quadcopter is rare and unusual work. The work is carried out as an standard engineering process that include requirements gathering, creating the required document (this thesis is a part of required document as well), selection of suitable hardware, configuring the hardware, generate the code for software, uploading code to the microcontroller, troubleshooting and rectification, finalized prototype and testing. Thesis describe how mechatronics engineering is useful in generating a customized and unique project. At the starting phase of this project (before purchasing a ready to fly quadcopter) every single aspect of this work was known. The only unknown alternatives was a battery and charger. Several task was achieved including design and development of automatic charging station, accurate landing and telecast a live video on additional screen. At starting it was decided that quadcopter should follow the mobile robot, during study it was concluded there is no such quadcopter available in market to auto follow a robot indoor. This works starts with a market survey and comparing the different brands of quadcopter that meets all the requirements and specifications of the mobile robot assembly. Selection of quadcopter is a result of discussion and meeting with the team members, supervisor, professor and project manage.

Replacing traditional ERP with EAI - the next generation’s ERP

Organizations often consider investing in a new Enterprise Resource Planning (ERP) system as a way to enhance their business processes, as it allows integrating information used by multiple different departments into a harmonized computing system. The hope of gaining significant business benefits, such as reducing operating costs, is the key reason why organizations have decided to invest in ERP systems since 1990’s. Still, all ERP projects do not end up in success, and deployment of ERP system does not necessarily guarantee the results people were waiting for. This research studies why organizations invest in ERP, but also what downsides ERP projects currently have. Additionally Enterprise Application Integrations (EAI) as next generation’s ERP solutions are studied to challenge and develop traditional ERP. The research questions are: What are the weaknesses in traditional ERP deployment in today’s business? How does the proposed next generation’s ERP answer to these weaknesses? At the beginning of the thesis, as an answer to the first research question, the basics of ERP implementation are introduced with both the pros and cons of investing in ERP. Key concepts such as IS integration and EAI are also studied. Empirical section of the thesis focuses on answering the second research question from the integration approach. A qualitative research is executed by interviewing five experienced IT professionals about EAI benefits, limitations, and problems. The thematic interview and questionnaire follow the presented ERP main elements from literature. The research shows that adopting traditional ERP includes multiple downsides, e.g. inflexibility and requiring big investments in terms of money. To avoid these critical issues, organizations could find a solution from integrations between their current IS. Based on the empirical study a new framework for the next generation’s ERP is created, consisting of a model and a framework that deal with various features regarding IS adoption. With this framework organizations can assess whether they should implement EAI or ERP. The model and framework suggest that there are multiple factors IT managers needs to consider when planning their IT investments, including their current IS, role of IT in the organization, as well as new system’s flexibility, investment level, and number of vendors. The framework created in the thesis encourages IT management to assess holistically their i) organization, ii) its IT, and iii) solution requirements in order to determine what kind of IS solution would suit their needs the best.

Replacing traditional ERP with EAI - the next generation’s ERP

Organizations often consider investing in a new Enterprise Resource Planning (ERP) system as a way to enhance their business processes, as it allows integrating information used by multiple different departments into a harmonized computing system. The hope of gaining significant business benefits, such as reducing operating costs, is the key reason why organizations have decided to invest in ERP systems since 1990’s. Still, all ERP projects do not end up in success, and deployment of ERP system does not necessarily guarantee the results people were waiting for. This research studies why organizations invest in ERP, but also what downsides ERP projects currently have. Additionally Enterprise Application Integrations (EAI) as next generation’s ERP solutions are studied to challenge and develop traditional ERP. The research questions are: What are the weaknesses in traditional ERP deployment in today’s business? How does the proposed next generation’s ERP answer to these weaknesses? At the beginning of the thesis, as an answer to the first research question, the basics of ERP implementation are introduced with both the pros and cons of investing in ERP. Key concepts such as IS integration and EAI are also studied. Empirical section of the thesis focuses on answering the second research question from the integration approach. A qualitative research is executed by interviewing five experienced IT professionals about EAI benefits, limitations, and problems. The thematic interview and questionnaire follow the presented ERP main elements from literature. The research shows that adopting traditional ERP includes multiple downsides, e.g. inflexibility and requiring big investments in terms of money. To avoid these critical issues, organizations could find a solution from integrations between their current IS. Based on the empirical study a new framework for the next generation’s ERP is created, consisting of a model and a framework that deal with various features regarding IS adoption. With this framework organizations can assess whether they should implement EAI or ERP. The model and framework suggest that there are multiple factors IT managers needs to consider when planning their IT investments, including their current IS, role of IT in the organization, as well as new system’s flexibility, investment level, and number of vendors. The framework created in the thesis encourages IT management to assess holistically their i) organization, ii) its IT, and iii) solution requirements in order to determine what kind of IS solution would suit their needs the best.