HORMONAL AND METABOLIC STUDY OF A CASE OF ADIPOSIS-DOLOROSA (DERCUMS DISEASE)

A case of a 43-year-old nonobese woman with adiposis dolorosa (Dercum's disease) is reported. Muscle glucose uptake and oxidation before and after ingestion of 75 g of glucose were similar to control group values, although a greater insulin release (16,578 vs 6,242 +/- 1,136 muU/3 h) occurred simultaneously. In vitro studies of abdominal normal and painful subcutaneous adipose tissue of the patient revealed lower responsiveness to norepinephrine and lack of response to the antilipolytic effect of insulin in the painful adipose tissue (0.98 vs 1.43 muM FFA/10(6) cells at 5.0 muM of norepinephrine). The disease was not correlated with the HLA system and there were no alterations in hormonal secretion at the pituitary, adrenal, gonadal, and thyroid levels. These findings indicate the presence of peripheral insulin resistance in this patient with adiposis dolorosa.

DIFFERENTIATION OF DROSOPHILA-SERIDO (ISOFEMALE LINE A95F3) AND D-KOEPFERAE (ISOFEMALE LINE B20D2) - REPRODUCTIVE ISOLATION, DEVELOPMENT TIME AND POLYTENE CHROMOSOME-BANDING PATTERNS

Drosophila serido is considered to be a superspecies consisting of two species: D. serido, from Brazil and D. koepferae from Argentina and Bolivia. However this probably does not express the entire evolutionary complexity of its populations. Isofemale lines A95F3 (from Brazil) and B20D2 (from Argentina), at present representing, respectively, the first and second species, were analyzed for fertility and fecundity in pair-mating intracrosses and intercrosses, as well as for development time, banding patterns and asynapsis of polytene chromosomes in the isofemale lines and their hybrids.Although variations in experimental conditions resulted in some variability in the results, in general A95F3 fertility and fecundity were lower than in B20D2. Intercrosses of A95F3 females and B20D2 males showed lower fertility and fecundity than the reciprocal crosses, following more closely characteristics of the mother strains. This is in contrast to the results obtained by Fontdevilla et al. (An. Entomol. Soc. Amer. 81: 380-385, 1988) and may be due to the different geographic origin of D. serido strains they used in crosses to B20D2. This difference and others cited in the literature relative to aedeagus morphology, karyotype characteristics, inversion polymorphisms and reproductive isolation strongly indicate that A95F3 and D. serido from the State of Bahia, Brazil are not a single evolutionary entity, reinforcing the idea of greater complexity of the superspecies D. serido than is known today.The reproductive isolation mechanisms found operating between A95F3 and B20D2 were prezygotic and postzygotic, the latter included mortality at the larvae stage in both directions of crosses and sterility of male hybrids in intercrosses involving B20D2 females and A95F3 males. The two isofemale lines differed in egg-adult development time, which was also differently affected by culture medium composition.A95F3 and B20D2 also showed differences in the banding patterns of proximal regions of polytene chromosomes 2, 3 and X, a fixed inversion in chromosome 3 (here named 3t), apparently not described previously, and a high degree of asynapsis in hybrids.These observations, especially those related to reproductive isolation and chromosomal differentiation (including the karyotype, previously described, and the differentiation of banding patterns, described in this paper), as well as the extensive asynapsis observed in hybrids reinforces the distinct species status of A95F3 and B20D2 isofemale lines.

Synthesis and thermal study of the prodrug of oxamniquine

Oxamniquine polymeric prodrug with potential antischistosomal activity was prepared using dextran T-70 as a carrier, which was analysed by (HNMR)-H-1, C-13 NMR and IR spectroscopy. The formation of the oxamniquine salt was confirmed by thermogravimetric analysis (TG) and differential scanning calorimetry (DSC) which showed a different thermal behaviour when compared to the physical mixture.

Bone healing in drill hole defects in spontaneously hypertensive male and female rats' femurs. A histological and histometric study

Objective: the aim of this study was to evaluate the bone healing in spontaneously hypertensive rats (SHR) and compare the results with normotensive rats, evaluating male and female animals.Methods: A bone drill defect was created in the left femur of 24 SHR (12 males and 12 females) and 24 normotensive rats (12 males and 12 females). The animals were divided into two groups and sacrificed 7 and 21 days after the surgical procedure. After the routine laboratory processing, histological and histometric analysis were carried out and data were submitted to ANOVA and Tukey's test (5%).Results: Males and females from the same group had similar histological characteristics. After seven days, all animals presented irregular bone trabeculae. The periosteal osteoblasts were flattened in SHR, and presented a cuboid shape in normotensive animals. After 21 days, the bone defects of all specimens showed a linear closure in all the superficial extension. In addition, SHR presented flattened osteoblasts surrounding the bone trabeculae, while normotensive ones showed cuboidal cells. Statistical analysis of the histometric data indicated similar means between the male and female groups, except for normotensive rats on day 7. In addition, a larger amount of new bone formation was observed in hypertensive when compared to normotensive rats on day 27, in males as well as females.Conclusion: We conclude that bone healing in SHR was more significant than in normotensive ones, as shown by the histological and histometric evaluation 21 days after surgery.

Synthesis and thermal study of magnesium complexes with 8-hydroxyquinolinate derivatives

Magnesium ion was reacted with 5,7-dibromo-, 5,7-dichloro-, 7-iodo- and 5-chloro-7-iodo-8-hydroxyquinoline, in acetone/ammonium hydroxide medium under constant stirring to obtain (I) Mg[(C9H4ONBr2)(2)].2H(2)O; (II) Mg[(C9H4ONCl2)(2)].3H(2)O; (III) Mg[(C9H5ONI)(2)].2H(2)O and (IV) Mg[(C9H4ONICl)(2)].2.5H(2)O complexes. The compounds were characterized by elemental analysis, IR spectra, ICP, TG-DTA and DSC.Through thermal decomposition residues were obtained and characterized, by X-ray diffractometry, as a mixture of hexagonal MgBr2 and cubic MgO to the (I) compound at 850degreesC; cubic MgO to the (II), (III) and (IV) compounds at 750, 800 and 700degreesC, respectively.

Laser weld: microstructure and corrosion study of Ag-Pd-Au-Cu alloy of the dental application

The laser Welding process was introduced into dentistry by the end of the 1980s, resulting on a great impulse to that area with the development of cheaper and smaller equipment, using simpler technique. This allowed greater use of that process on the confection of prostheses compared to the brazing process since the heat source for that process is a concentrated light beam of high power, which minimizes distortion problems on the prosthetic pieces. Ag-Pd-Au-Cu alloy used on the confection of dental implant prostheses was observed before and after subjection to the laser welding process. The microstructure was analyzed with the. use of optic microscopy and the corrosion resistance was studied by the traditional electrochemical techniques and by electrochemical impedance, under environmental conditions simulating the aggressiveness found in the mouth cavity. A structural change was detected on the weld area, which presented a refined microstructure deriving from the high-speed cooling. The base metal out of the weld area presented a fusion coarse microstructure. The electrochemical essays showed differences on the potentiodynamic polarization behavior in both weld and metal base areas, indicating superior corrosion resistance in the weld area. The impedance spectra were characterized by capacitive distorted components, presenting linear impedance in the low frequencies area. (C) 2002 Elsevier B.V. B.V. All rights reserved.

Thermal analysis and electrochemical study of Hg reactions on Pt-30% Ir alloy electrode

Thermogravimetry (TG), cyclic voltammetry (CV) and other analytical techniques were used to study the reactions of mercury with Pt-30% Ir alloy. The results allowed to suggest that an electrodeposited mercury film interacts with the substrate and when subjected to heat or electrochemical removal at least four mass loss steps or five peaks appeared during the mercury desorption process. The first two steps were attributed to Hg(0) removal probably from the bulk and from the adsorbed monolayer which wets the electrode surface. These two processes are responsible for peaks D and F in the cyclic voltammograms. The last two peaks (G, H) in CV were ascribed to the intermetallic compound decomposition. In TG curves, the last two steps were attributed to the PtHg4 (third step), and PtHg2 decomposition followed by Hg removal from the subsurface. The PtHg2 was formed by an eutectoide reaction: PtHg -> PtHg2+Hg(Pt-Ir). The Hg diffused to the subsurface was not detectable by cyclic voltammetry.

Room-temperature photoluminescence of BaTiO3: Joint experimental and theoretical study

Strong photoluminescent emission has been measured at room temperature for noncrystalline BaT'O-3 (BT) perovskite powders. A joint experimental and theoretical study has been carried out to rationalize this phenomenon. From the experimental side, BT powder samples have been synthesized following a soft chemical processing, their crystal structure has been confirmed by x-ray data and the corresponding photoluminescence (PL) properties have been measured. Only the structurally disordered samples present PL at room temperature. From the theoretical side, first-principles quantum-mechanical techniques, based on density-functional theory at the B3LYP level, have been employed to study the electronic structure of crystalline (BT-c) and asymmetric (BT-a) models. Theoretical and experimental results are found to be consistent and their confrontation leads to an interpretation of the PL apparition at room temperature in the structurally disordered powders.

Fungemia by yeasts in Brazil: occurrence and phenotypic study of strains isolated at the Public Hospital, Botucatu, São Paulo

Objective. - In this study strains of yeasts isolated from the blood of human patients were analyzed taxonomically, their virulence factors were determined and compared, and phenotypic markers were used to compare the samples with respect to phenotypic differences across the range of patients as well as between samples isotated from the same patient.Methods. - the study involved a total of 75 strains of yeast isolated from the blood of in-patients of the Public Hospital, Botucatu, S (a) over tildeo Paulo, Brazil, with a clinical profile of fungemia. The hospital wards with the largest number of fungemias were neonatal intensive care units (ICUs) (32%) followed by gastric surgery (13.4%) and pediatric wards (10.7%). After identification, the samples were analyzed for the production of phospholipase and proteinase enzymes, and biotyped according to their susceptibility to killer toxins.Results. - the most frequent species found was Candida albicans (38.7%) followed by C. parapsilosis (30.7%). In terms of enzyme production, 98.7% of the 75 samples of yeast presented a strongly positive activity for proteinase; however, 78.7% did not present any phospholipasic activity. Six different biotypes were identified, the most frequent being 511 and 888.Conclusion. In association with phenotypic methods, genetic analyses should also be made of the samples under study to help in the rational development of a wider range of preventive measures and better control of hospital-contracted infections. (c) 2005 Published by Elsevier SAS.

On the stabilizing behavior of zirconia: A combined experimental and theoretical study

Reactive zirconia powder was synthesized by the complexation of zirconium metal from zirconium hydroxide using a solution of 8-hydroxiquinoline. The kinetics of zirconia crystallization was followed by X-ray diffraction, scanning electron microscopy and surface area measured by the nitrogen adsorption/desorption technique. The results indicated that zirconia with a surface area as high as 100 m(2)/g can be obtained by this method after calcination at 500degreesC. Zirconia presents three polymorphic phases (monoclinic, tetragonal and cubic), which are reversibly interconversible. The cluster model Zr4O8 and Z(r)4O(7)(+2) was used for a theoretical study of the stabilization process. The ab initio RHF method was employed with the Gaussian94 program and the total energies and the energy gap of the different phases were calculated and compared with the experimental energy gap. The theoretical results show good reproducibility of the energy gap for zirconia. (C) 2004 Kluwer Academic Publishers.

Theoretical and experimental study of the relation between photoluminescence and structural disorder in barium and strontium titanate thin films

Thin films of barium and strontium titanate (BST), synthesized by the polymeric precursor solution and spin coated on [Pt (140nm)/Ti (10 nM)/SiO2(1000 nm)/Si] substrates were found to be photoluminescent at room temperature when heat treated below 973 K, i.e. before their crystallization. First principles quantum mechanical techniques, based on density functional theory (DFT) were employed to study the electronic structure of two periodic models: one is standing for the crystalline BST thin film and the other one for the structurally disordered thin film. The aim is to compare the photoluminescence (PL) spectra of the crystalline and disordered thin films with their UV-vis spectra and with their computed electronic structures. The calculations show that new localized states are created inside the band gap of the crystalline model, as predicted by the UV-vis spectra. The study of the charge repartition in the structure before and after deformation of the periodic model shows that a charge gradient appears among the titanate clusters. This charge gradient, together with the new localized levels, gives favorable conditions for the trapping of holes and electrons in the structure, and thus to a radiative recombination process. Our models are not only consistent with the experimental data, they also allow to explain the relations between structural disorder and photoluminescence at room temperature. (c) 2005 Elsevier Ltd. All rights reserved.