Three-phase three-level current-source converter for EVs fast battery charging systems

This paper presents a three-phase three-level fast battery charger for electric vehicles (EVs) based in a current-source converter (CSC). Compared with the traditional voltage-source converters used for fast battery chargers, the CSC can be seen as a natural buck-type converter, i.e., the output voltage can assume a wide range of values, which varies between zero and the maximum instantaneous value of the power grid phase-to-phase voltage. Moreover, using the CSC it is not necessary to use a dc-dc back-end converter in the battery side, and it is also possible to control the grid current in order to obtain a sinusoidal waveform, and in phase with the power grid voltage (unitary power factor). Along the paper is described in detail the proposed CSC for EVs fast battery charging systems: the circuit topology, the power control theory, the current control strategy and the grid synchronization algorithm. Several simulation results of the EV fast battery charger operating with a maximum power of 50 kW are presented.

Safest level of tricaine methanesulfonate (ms-222) to induce anesthesia in juveniles of Matrinxã, Brycon cephalus

The use of MS-222 as an anesthetic for matrinxã juveniles was investigated. At dosage of 100 mg/L or lower fish did not achieve a complete anesthesia state. At 150 mg/L, MS-222 induced anesthesia within 36 seconds and recovered from a 10 minutes period of anesthesia within 5.2 min. Higher concentrations (200, 250 and 300 mg/L) anesthetized fish in lesser times, with the offset of mortality (16.7 and 33.3%) at the 200 and 300 mg/L MS-222 doses, respectively. The only significant differences observed in the hematological parameters, was for the glucose values in fish anesthetized with 250 and 300 mg/L. From the results, the recommended dose of MS-222 for handling matrinxã juveniles is 150 mg/L.

Risk acceptance in the furniture sector: Analysis of acceptance level and relevant influence factors

Risk acceptance has been broadly discussed in relation to hazardous risk activities and/or technologies. A better understanding of risk acceptance in occupational settings is also important; however, studies on this topic are scarce. It seems important to understand the level of risk that stakeholders consider sufficiently low, how stakeholders form their opinion about risk, and why they adopt a certain attitude toward risk. Accordingly, the aim of this study is to examine risk acceptance in regard to occupational accidents in furniture industries. The safety climate analysis was conducted through the application of the Safety Climate in Wood Industries questionnaire. Judgments about risk acceptance, trust, risk perception, benefit perception, emotions, and moral values were measured. Several models were tested to explain occupational risk acceptance. The results showed that the level of risk acceptance decreased as the risk level increased. High-risk and death scenarios were assessed as unacceptable. Risk perception, emotions, and trust had an important influence on risk acceptance. Safety climate was correlated with risk acceptance and other variables that influence risk acceptance. These results are important for the risk assessment process in terms of defining risk acceptance criteria and strategies to reduce risks.

Desenvolvimento e caracterização tribológica de hidrogéis poliméricos de PVA reforçados com fosfato tricálcico para aplicação como cartilagem articular para implantes articulares

Dissertação de mestrado integrado em Engenharia de Materiais

A demonstration case on the derivation of process-level logical architectures for ambient assisted living ecosystems

When representing the requirements for an intended software solution during the development process, a logical architecture is a model that provides an organized vision of how functionalities behave regardless of the technologies to be implemented. If the logical architecture represents an ambient assisted living (AAL) ecosystem, such representation is a complex task due to the existence of interrelated multidomains, which, most of the time, results in incomplete and incoherent user requirements. In this chap- ter, we present the results obtained when applying process-level modeling techniques to the derivation of the logical architecture for a real industrial AAL project. We adopt a V-Model–based approach that expresses the AAL requirements in a process-level perspec- tive, instead of the traditional product-level view. Additionally, we ensure compliance of the derived logical architecture with the National Institute of Standards and Technology (NIST) reference architecture as nonfunctional requirements to support the implementa- tion of the AAL architecture in cloud contexts.

Simulation of OWES with five-Level converter linked to the grid: Harmonic assessment

This paper deals with a computing simulation for an offshore wind energy system taking into account the influence of the marine waves action throughout the floating platform. The wind energy system has a variable-speed turbine equipped with a permanent magnet synchronous generator and a full-power five level converter, injecting energy into the electric grid through a high voltage alternate current link. A reduction on the unbalance of the voltage in the DC-link capacitors of the five-level converter is proposed by a strategic selection of the output voltage vectors. The model for the drive train of the wind energy system is a two mass model, including the dynamics of the floating platform. A case study is presented and the assessment of the quality of the energy injected into the electric grid is discussed.

Testing Nelder-Mead based repulsion algorithms for multiple roots of nonlinear systems via a two-level factorial design of experiments

This paper addresses the challenging task of computing multiple roots of a system of nonlinear equations. A repulsion algorithm that invokes the Nelder-Mead (N-M) local search method and uses a penalty-type merit function based on the error function, known as 'erf', is presented. In the N-M algorithm context, different strategies are proposed to enhance the quality of the solutions and improve the overall efficiency. The main goal of this paper is to use a two-level factorial design of experiments to analyze the statistical significance of the observed differences in selected performance criteria produced when testing different strategies in the N-M based repulsion algorithm. The main goal of this paper is to use a two-level factorial design of experiments to analyze the statistical significance of the observed differences in selected performance criteria produced when testing different strategies in the N-M based repulsion algorithm.

Effect of fetal bovine serum on Candida glabrata cultures

Dissertação de mestrado integrado em Engenharia Biomédica (área de especialização em Engenharia Clínica)

Level of compliance in contact lens wearing medical doctors in Nepal

PURPOSES: To determine the level of compliance and major non-compliant behaviors in contact lens (CL) wearing medical doctors (MDs) and to compare it with age matched CL wearing normal subjects with no medical background (NS). METHODS: Thirty-nine current CL wearing MDs, who were prescribed CLs in Nepal Eye Hospital, Kathmandu, Nepal, between 2007 and 2011, were interviewed on ten modifiable compliant behaviors regarding lens care and maintenance. The level of compliance and the rate of non-compliance for each behavior were determined and compared with NS. RESULTS: Level of compliance was good, average and poor in 35.9%, 48.7% and 15.4% of MDs, respectively. There was no significant difference in compliance between MDs and NS (p=0.209). Level of compliance was not associated with age, gender and duration of lens wear (p>0.05). Compliance rate varied according to different behaviors, achieving a good compliance level of 95% for hand hygiene, avoidance of water contact and not sleeping with lenses. There was poor compliance for topping up solution (53.8%) and lens case replacement (15.4%). CONCLUSION: About one third of MDs had a good level of compliance. Level of compliance and compliance rate of different behaviors were similar in MDs and NS. Periodic lens case replacement was the most neglected behavior in CL wearers for this region.

High-level of viral genomic diversity in cervical cancers: a Brazilian study on human papillomavirus type 16

Invasive cervical cancer (ICC) is the third most frequent cancer among women worldwide and is associated with persistent infection by carcinogenic human papillomaviruses (HPVs). The combination of large populations of viral progeny and decades of sustained infection may allow for the generation of intra-patient diversity, in spite of the assumedly low mutation rates of PVs. While the natural history of chronic HPVs infections has been comprehensively described, within-host viral diversity remains largely unexplored. In this study we have applied next generation sequencing to the analysis of intra-host genetic diversity in ten ICC and one condyloma cases associated to single HPV16 infection. We retrieved from all cases near full-length genomic sequences. All samples analyzed contained polymorphic sites, ranging from 3 to 125 polymorphic positions per genome, and the median probability of a viral genome picked at random to be identical to the consensus sequence in the lesion was only 40%. We have also identified two independent putative duplication events in two samples, spanning the L2 and the L1 gene, respectively. Finally, we have identified with good support a chimera of human and viral DNA. We propose that viral diversity generated during HPVs chronic infection may be fueled by innate and adaptive immune pressures. Further research will be needed to understand the dynamics of viral DNA variability, differentially in benign and malignant lesions, as well as in tissues with differential intensity of immune surveillance. Finally, the impact of intralesion viral diversity on the long-term oncogenic potential may deserve closer attention.

Real-time monitoring of progression towards renal failure in primary care patients

First published online: December 16, 2014.

Effects of a novel fermented soy product on the serum lipids of hypercholesterolemic rabbits

OBJECTIVE: To assess the effect of a new feed soy product fermented by Enterococcus faecium and Lactobacillus jugurti on the serum lipid levels of rabbits with induced hypercholesterolemia. METHODS: Thirty-two rabbits were divided into 4 groups as follows: 1) control (C); 2) hypercholesterolemic (H); 3) hypercholesterolemic + fermented product (HPF); and 4) control + fermented product (CPF). The H and HPF groups were fed with a diet with 0.15% (p/p) cholesterol in the first 15 days. C and CPF groups received regular food preparation. The HPF and CPF groups received 10 mL daily of the fermented 30 days. Blood samples were drawn at the beginning of the study and at the 15th and 30th days. Concentrations of total cholesterol, HDL-cholesterol, and triglycerides were analyzed. RESULTS: After 15 days, the HPF group showed a total cholesterol concentration lower (18.4%) than that of the H group (p=0.05), but this difference disappeared after 30 days. No change was observed in total cholesterol levels of C and CPF groups. After 15 days, the HDL-cholesterol was higher (17.8%) in the HPF group, but the triglyceride levels remained unchanged in all groups during the same period of time. CONCLUSION: The soy fermented product caused an 18.4% reduction in total cholesterol and a 17.8% increase in the HDL-fraction. It may, therefore, be a possible coadjutor in the treatment of hypercholesterolemia.

Reliability of the information about the history of diagnosis and treatment of hypertension. Differences in regard to sex, age, and educational level. The pró-saúde study

OBJECTIVE: To assess the intraobserver reliability of the information about the history of diagnosis and treatment of hypertension. METHODS: A multidimensional health questionnaire, which was filled out by the interviewees, was applied twice with an interval of 2 weeks, in July '99, to 192 employees of the University of the State of Rio de Janeiro (UERJ), stratified by sex, age, and educational level. The intraobserver reliability of the answers provided was estimated by the kappa statistic and by the coefficient of intraclass correlation (CICC). RESULTS: The general kappa (k) statistic was 0.75 (95% CI=0.73-0.77). Reliability was higher among females (k=0.88, 95% CI=0.85-0.91) than among males (k=0.62, 95% CI=0.59-0.65).The reliability was higher among individuals 40 years of age or older (k=0.79; 95% CI=0.73-0.84) than those from 18 to 39 years (k=0.52; 95% CI=0.45-0.57). Finally, the kappa statistic was higher among individuals with a university educational level (k=0.86; 95% CI=0.81-0.91) than among those with high school educational level (k=0.61; 95% CI=0.53-0.70) or those with middle school educational level (k=0.68; 95% CI=0.64-0.72). The coefficient of intraclass correlation estimated by the intraobserver agreement in regard to age at the time of the diagnosis of hypertension was 0.74. A perfect agreement between the 2 answers (k=1.00) was observed for 22 interviewees who reported prior prescription of antihypertensive medication. CONCLUSION: In the population studied, estimates of the reliability of the history of medical diagnosis of hypertension and its treatment ranged from substantial to almost perfect reliability.

Experimental validation of a proposed single-phase five-level active rectifier operating with model predictive current control

This paper presents a model predictive current control applied to a proposed single-phase five-level active rectifier (FLAR). This current control strategy uses the discrete-time nature of the active rectifier to define its state in each sampling interval. Although the switching frequency is not constant, this current control strategy allows to follow the reference with low total harmonic distortion (THDF). The implementation of the active rectifier that was used to obtain the experimental results is described in detail along the paper, presenting the circuit topology, the principle of operation, the power theory, and the current control strategy. The experimental results confirm the robustness and good performance (with low current THDF and controlled output voltage) of the proposed single-phase FLAR operating with model predictive current control.

Impact of nutritional counseling in reducing serum cholesterol in public health service patients

OBJECTIVE: To assess the impact of nutritional attention on the lipid profile and nutritional status of hypercholesterolemic patients attended in health centers of Belo Horizonte. METHODS: Using nutritional attendance patient record cards from two health units, the evolution of the lipid profile and the nutritional state (BMI) was monitored of 96 hypercholesterolemic patients who received diet. The patients were appraised at the following moments: initial (1st consultation), after 3 months (2nd consultation) and last consultation (variable for each patient). RESULTS: On the first attendance, 44,4% of the patients presented not only high total cholesterol and LDL-c, but also hypertriglyceridemia and 70.3% were overweight or obese, but most patients (75.6%) presented adequate HDL-c levels. There was significant reduction in the BMI, total cholesterol, LDL-c values (p < 0.01) and also in the triglyceride levels (p < 0.05) in the first three months, without alteration in the HDL-c levels. A significant reduction (p < 0.01) was observed in the frequency of individuals with high cholesterol (from 89.6% down to 47.9%), high and very high LDL-c (from 82.6% down to 45.7%), as well as high and very high triglyceride (from 43.6% down to 16.7%). The observed reduction in frequency of the low HDL-c was statistically meaningless. CONCLUSION: This study evidences the effect of the nutritional attention on lipid profile in hypercholesterolemic patients, reinforcing the need for a multiprofessional team to attend them at the public health services.