Synthesis of isotope-labelled methoxypyrazine compounds as internal standards and quantitative determination of aroma methoxypyrazines in water and wines by solid-phase extraction with isotope dilution-GC-MS /

An efficient way of synthesizing the deuterium labelled analogues of three methoxypyrazine compounds: 2-d3-methoxy-3-isopropylpyrazine, 2-d3-methoxy-3- isobutylpyrazine, and 2-d3-methoxy-3-secbutylpyrazine, has been developed. To confirm that the deuterium labels had been incorporated into the expected positions in the molecules synthesized, the relevant characterization by NMR, HRMS and GC/MS analysis was conducted. Another part of this work involved quantitative determination of methoxypyrazines in water and wines. Solid-phase extraction (SPE) proved to be a suitable means for the sample separation and concentration prior to GC/MS analysis.Such factors as the presence of ethanol, salt, and acid have been investigated which can influence the recovery by SPE for the pyrazines from the water matrix. Significantly, in this work comparatively simple fractional distillation was attempted to replace the conventional steam distillation for pre-concentrating a sample with a relatively large volume prior to SPE. Finally, a real wine sample spiked with the relevant isotope-labelled methoxypyrazines was quantitatively analyzed, revealing that the wine with 10 beetles per litre contained 138 ppt of 2-methoxy-3-isopropylpyrazine. Interestingly, we have also found that 2-methoxy-3-secbutylpyrazine exhibits an extremely low detection limit in GC/MS analysis compared with the detection limit of the other two methoxypyrazines: 2- methoxy-3-isopropylpyrazine and 2-methoxy-3-isobutylpyrazine.

Investigations into the extraction and the determination of polycyclic aromatic hydrocarbons (PAHs) from water by solid-phase extraction and capillary gas chromatography/ mass spectrometry

Factors affecting the detennination of PAHs by capillary GC/MS were studied. The effect of the initial column temperature and the injection solvent on the peak areas and heights of sixteen PAHs, considered as priority pollutants, USillg crosslinked methyl silicone (DB!) and 5% diphenyl, 94% dimethyl, 1% vinyl polysiloxane (DBS) columns was examined. The possibility of using high boiling point alcohols especially butanol, pentanol, cyclopentanol, and hexanol as injection solvents was investigated. Studies were carried out to optimize the initial column temperature for each of the alcohols. It was found that the optimum initial column temperature is dependent on the solvent employed. The peak areas and heights of the PAHs are enhanced when the initial column temperature is 10-20 c above the boiling point of the solvent using DB5 column, and the same or 10 C above the boiling point of the solvent using DB1 column. Comparing the peak signals of the PAHs using the alcohols, p-xylene, n-octane, and nonane as injection solvents, hexanol gave the greatest peak areas and heights of the PAHs particularly the late-eluted peaks. The detection limits were at low pg levels, ranging from 6.0 pg for fluorene t9 83.6 pg for benzo(a)pyrene. The effect of the initial column temperature on the peak shape and the separation efficiency of the PARs was also studied using DB1 and DB5 columns. Fronting or splitting of the peaks was obseIVed at very low initial column temperature. When high initial column temperature was used, tailing of the peaks appeared. Great difference between DB! and.DB5 columns in the range of the initial column temperature in which symmetrical.peaks of PAHs can be obtained is observed. Wider ranges were shown using DB5 column. Resolution of the closely-eluted PAHs was also affected by the initial column temperature depending on the stationary phase employed. In the case of DB5, only the earlyeluted PAHs were affected; whereas, with DB1, all PAHs were affected. An analytical procedure utilizing solid phase extraction with bonded phase silica (C8) cartridges combined with GC/MS was developed to analyze PAHs in water as an alternative method to those based on the extraction with organic solvent. This simple procedure involved passing a 50 ml of spiked water sample through C8 bonded phase silica cartridges at 10 ml/min, dried by passing a gentle flow of nitrogen at 20 ml/min for 30 sec, and eluting the trapped PAHs with 500 Jll of p-xylene at 0.3 ml/min. The recoveries of PAHs were greater than 80%, with less than 10% relative standard deviations of nine determinations. No major contaminants were present that could interfere with the recognition of PAHs. It was also found that these bonded phase silica cartridges can be re-used for the extraction of PAHs from water.

Simultaneous extraction of order parameters and orientational distribution fuctions from 31[superscript]P NMR spectra of magnetically partially oriented phospholipid bilayers

Order parameter profiles extracted from the NMR spectra of model membranes are a valuable source of information about their structure and molecular motions. To al1alyze powder spectra the de-Pake-ing (numerical deconvolution) ~echnique can be used, but it assumes a random (spherical) dist.ribution of orientations in the sample. Multilamellar vesicles are known to deform and orient in the strong magnetic fields of NMR magnets, producing non-spherical orientation distributions. A recently developed technique for simultaneously extracting the anisotropies of the system as well as the orientation distributions is applied to the analysis of partially magnetically oriented 31p NMR spectra of phospholipids. A mixture of synthetic lipids, POPE and POPG, is analyzed to measure distortion of multilamellar vesicles in a magnetic field. In the analysis three models describing the shape of the distorted vesicles are examined. Ellipsoids of rotation with a semiaxis ratio of about 1.14 are found to provide a good approximation of the shape of the distorted vesicles. This is in reasonable agreement with published experimental work. All three models yield clearly non-spherical orientational distributions, as well as a precise measure of the anisotropy of the chemical shift. Noise in the experimental data prevented the analysis from concluding which of the three models is the best approximation. A discretization scheme for finding stability in the algorithm is outlined

Developing a numerical inverse-theory-based extraction of orientation-dependent relaxation rates from partially- relaxed spectra

Second-rank tensor interactions, such as quadrupolar interactions between the spin- 1 deuterium nuclei and the electric field gradients created by chemical bonds, are affected by rapid random molecular motions that modulate the orientation of the molecule with respect to the external magnetic field. In biological and model membrane systems, where a distribution of dynamically averaged anisotropies (quadrupolar splittings, chemical shift anisotropies, etc.) is present and where, in addition, various parts of the sample may undergo a partial magnetic alignment, the numerical analysis of the resulting Nuclear Magnetic Resonance (NMR) spectra is a mathematically ill-posed problem. However, numerical methods (de-Pakeing, Tikhonov regularization) exist that allow for a simultaneous determination of both the anisotropy and orientational distributions. An additional complication arises when relaxation is taken into account. This work presents a method of obtaining the orientation dependence of the relaxation rates that can be used for the analysis of the molecular motions on a broad range of time scales. An arbitrary set of exponential decay rates is described by a three-term truncated Legendre polynomial expansion in the orientation dependence, as appropriate for a second-rank tensor interaction, and a linear approximation to the individual decay rates is made. Thus a severe numerical instability caused by the presence of noise in the experimental data is avoided. At the same time, enough flexibility in the inversion algorithm is retained to achieve a meaningful mapping from raw experimental data to a set of intermediate, model-free

Towards reverse engineering of Photosystem II: Synergistic Computational and Experimental Approaches

ABSTRACT Photosystem II (PSII) of oxygenic photosynthesis has the unique ability to photochemically oxidize water, extracting electrons from water to result in the evolution of oxygen gas while depositing these electrons to the rest of the photosynthetic machinery which in turn reduces CO2 to carbohydrate molecules acting as fuel for the cell. Unfortunately, native PSII is unstable and not suitable to be used in industrial applications. Consequently, there is a need to reverse-engineer the water oxidation photochemical reactions of PSII using solution-stable proteins. But what does it take to reverse-engineer PSII’s reactions? PSII has the pigment with the highest oxidation potential in nature known as P680. The high oxidation of P680 is in fact the driving force for water oxidation. P680 is made up of a chlorophyll a dimer embedded inside the relatively hydrophobic transmembrane environment of PSII. In this thesis, the electrostatic factors contributing to the high oxidation potential of P680 are described. PSII oxidizes water in a specialized metal cluster known as the Oxygen Evolving Complex (OEC). The pathways that water can take to enter the relatively hydrophobic region of PSII are described as well. A previous attempt to reverse engineer PSII’s reactions using the protein scaffold of E. coli’s Bacterioferritin (BFR) existed. The oxidation potential of the pigment used for the BFR ‘reaction centre’ was measured and the protein effects calculated in a similar fashion to how P680 potentials were calculated in PSII. The BFR-RC’s pigment oxidation potential was found to be 0.57 V, too low to oxidize water or tyrosine like PSII. We suggest that the observed tyrosine oxidation in BRF-RC could be driven by the ZnCe6 di-cation. In order to increase the efficiency of iii tyrosine oxidation, and ultimately oxidize water, the first potential of ZnCe6 would have to attain a value in excess of 0.8 V. The results were used to develop a second generation of BFR-RC using a high oxidation pigment. The hypervalent phosphorous porphyrin forms a radical pair that can be observed using Transient Electron Paramagnetic Resonance (TR-EPR). Finally, the results from this thesis are discussed in light of the development of solar fuel producing systems.

QUANTIFICATION AND EXTRACTION OF SURFACE FEATURES FROM DIGITAL TERRAIN MODELS

Digital Terrain Models (DTMs) are important in geology and geomorphology, since elevation data contains a lot of information pertaining to geomorphological processes that influence the topography. The first derivative of topography is attitude; the second is curvature. GIS tools were developed for derivation of strike, dip, curvature and curvature orientation from Digital Elevation Models (DEMs). A method for displaying both strike and dip simultaneously as colour-coded visualization (AVA) was implemented. A plug-in for calculating strike and dip via Least Squares Regression was created first using VB.NET. Further research produced a more computationally efficient solution, convolution filtering, which was implemented as Python scripts. These scripts were also used for calculation of curvature and curvature orientation. The application of these tools was demonstrated by performing morphometric studies on datasets from Earth and Mars. The tools show promise, however more work is needed to explore their full potential and possible uses.

Capital Income Taxation, Depletion, Allowances and Non-Renewable Resource Extraction

Dans Cet Article, Nous Etudions les Distorsions Que Cause L'impot Sur le Revenu des Societes Dans le Profil de Production des Firmes Extractives et Dans L'allocation des Ressources Entre les Secteurs D'extraction et les Autres Secteurs Soumis a L'impot Sur les Societes. Nous Etudions En Particulier L'allocation D'epuisement, Dont Nous Montrons Qu'elle Peut Trouver Sa Justification, Non Pas a Assurer la Neutralite de L'impot, Mais En Permettant L'etablissement de Taux Effectifs D'imposition Identiques Dans les Secteurs D'extraction et Dans les Autres Secteurs.

Partager le savoir du lexicographe: extraction et modélisation ontologique des savoirs lexicographiques

Cette recherche porte sur la lexicologie, la lexicographie et l’enseignement/apprentissage du lexique. Elle s’inscrit dans le cadre du projet Modélisation ontologique des savoirs lexicographiques en vue de leur application en linguistique appliquée, surnommé Lexitation, qui est, à notre connaissance, la première tentative d’extraction des savoirs lexicographiques — i.e. connaissances déclaratives et procédurales utilisées par des lexicographes — utilisant une méthode expérimentale. Le projet repose sur le constat que les savoirs lexicographiques ont un rôle crucial à jouer en lexicologie, mais aussi en enseignement/apprentissage du lexique. Dans ce mémoire, nous décrirons les méthodes et les résultats de nos premières expérimentations, effectuées à l’aide du Think Aloud Protocol (Ericsson et Simon, 1993). Nous expliquerons l’organisation générale des expérimentations et comment les savoirs lexicographiques extraits sont modélisés pour former une ontologie. Finalement, nous discuterons des applications possibles de nos travaux en enseignement du lexique, plus particulièrement pour la formation des maîtres.

Extraction, purification et caractérisation d’isoformes d’hexokinase du tubercule de pomme de terre (Solanum tuberosum)

L’hexokinase (HK) est la première enzyme du métabolisme des hexoses et catalyse la réaction qui permet aux hexoses d’entrer dans le pool des hexoses phosphates et donc par le fait même la glycolyse. Bien que le glucose soit son principal substrat, cette enzyme peut aussi phosphoryler le mannose et le fructose. Malgré son importance dans le métabolisme primaire, l’HK n’a jamais été purifiée à homogénéité sous forme native. Le but de ce travail était donc de purifier une isoforme d’HK à partir de tubercule de Solanum tuberosum et par la suite de caractériser ses propriétés cinétiques. Bien avant que je commence mon travail, un groupe de recherche avait déjà séparé et partiellement purifié trois isoformes d’HK de S. tuberosum. Un protocole d’extraction était donc disponible, mais l’HK ainsi extraite était peu stable d’où le besoin d’y apporter certaines modifications. En y ajoutant certains inhibiteurs de protéases ainsi qu’en modifiant les concentrations de certains éléments, le tampon d’extraction ainsi modifié a permis d’obtenir un extrait dont l’activité HK était stable pendant au moins 72h après l’extraction, en empêchant la dégradation. À l’aide du tampon d’extraction optimisé et d’une chromatographie sur colonne de butyl sépharose, il a été possible de séparer 4 isoformes d’HKs. Par la suite, une isoforme d’HK (HK1) a été purifiée à l’homogénéité à l’aide de 5 étapes de chromatographie supplémentaires. En plus de caractériser les propriétés cinétiques de cette enzyme, l’analyse de séquençage par MS/MS a permis de l’associer au produit du gène StHK1 de Solanum tuberosum. Avec une activité spécifique de 10.2 U/mg de protéine, il s’agit de l’HK purifiée avec l’activité spécifique la plus élevée jamais rapportée d’un tissu végétal.L’ensemble des informations recueillies lors de la purification de HK1 a ensuite été utilisée pour commencer la purification d’une deuxième isoforme (HK3). Ce travail a permis de donner des lignes directrices pour la purification de cette isoforme et certains résultats préliminaires sur sa caractérisation enzymatique.