Distribution, feeding condition, and growth of Japanese Spanish mackerel (Scomberomorus niphonius) larvae in the Seto Inland Sea

Distribution of eggs and larvae and feeding and growth of larvae of Japanese Spanish mackerel (Scomberomorus niphonius) were investigated in relation to their prey in the Sea of Hiuchi, the Seto Inland Sea, Japan, in 1995 and 1996. The abundance of S. niphonius eggs and larvae peaked in late May, corresponding with that of clupeid larvae, the major prey organisms of S. niphonius larvae. The eggs were abundant in the northwestern waters and the larvae were abundant in the southern waters in late May in both years, indicating a southward drift during egg and yolksac stages by residual f low in the central part of the Sea of Hiuchi. Abundance of clupeid larvae in southern waters, where S. niphonius larvae were abundant, may indicate a spawning strategy on the part of first-feeding S. niphonius larvae to encounter the spatial and temporal peak in ichthyoplankton prey abundance in the Seto Inland Sea. Abundance of the clupeid larvae was higher in 1995 than in 1996. Feeding incidence (percentage of stomachs with food; 85.3% in 1995 and 67.7% in 1996) and mean growth rate estimated from otolith daily increments (1.05 mm/d in 1995 and 0.85 mm/d in 1996) of S. niphonius larvae in late May were significantly higher in 1995. Young-of-the-year S. niphonius abundance and catch per unit of fishing effort of 1-year-old S. niphonius in the Sea of Hiuchi was higher in 1995, indicating a more successful recruitment in this year. Spatial and temporal correspondence with high ichthyoplankton prey concentration was considered one of the important determinants for the feeding success, growth, and survival of S. niphonius larvae.

On the Distribution and Fishery Potential of the Japanese Red Crab Chaceon granulatus in the Palauan Archipelago, Western Caroline Islands

A deep-water trapping survey in the Palauan archipelago, Western Caroline Islands, has revealed an abundance of the Japanese red crab, Chaceon granulatus. The recorded depth range (250-900 m) is similar to that of other geryonids, but the large numbers of females caught below 700 m is atypical. Mean yields in excess of 5 kg crabs plus 1 kg shrimp, Heterocarpus laevigatus, by-catch per trap-night were attainable at optimum depths. Chaceon granulatus is apparently a very large geryonid, with maximum weights of 2.02 kg and 1.51 kg recorded for male and female specimens, respectively. A range of body colors was observed: Orange-red shades appear to dominate the deeper waters (below 500 m) while yellow-tan colors are more abundant in the upper reaches. Preliminary evidence suggests that Chaceon granulatus is highly marketable, and the infrastructure in Palau is such that crabs could either be marketed fresh locally or airfreighted to Japan as a quick-frozen product. The high post-trapping survival rates observed indicate that maintaining crabs in live-holding tanks may be a feasible option. The large catches and quality of deep-water crabs taken suggests that the Palauan population of Chaceon granulatus may be able to support a small-scale fishery. It is not yet known whether this population is unusually large or whether these findings typify the deep forereef fauna of the region.

Modelling the entrainment and motion of particles in a gap: Application to abrasive wear

The microscale abrasion or ball-cratering test is being increasingly applied to a wide range of bulk materials and coatings. The response of materials to this test depends critically on the nature of the motion of the abrasive particles in the contact zone: whether they roll and produce multiple indentations in the coating, or slide causing grooving abrasion. Similar phenomena also occur when hard contaminant particles enter a lubricated contact. This paper presents simple quantitative two-dimensional models which describe two aspects of the interaction between a hard abrasive particle and two sliding surfaces. The first model treats the conditions under which a spherical abrasive particle of size d can be entrained into the gap between a rotating sphere of radius R and a plane surface. These conditions are determined by the coefficients of friction between the particle and the sphere, and the particle and the plane, denoted by μs and μp respectively. This model predicts that the values of (μs + μp) and 2μs should both exceed √2d/R for the particles to be entrained into the contact. If either is less than this value, the particle will slide against the sphere and never enter the contact. The second model describes the mechanisms of abrasive wear in a contact when an idealized rhombus-sectioned prismatic particle is located between two parallel plane surfaces separated by a certain distance, which can represent either the thickness of a fluid film or the spacing due to the presence of other particles. It is shown that both the ratio of particle size to the separation of the surfaces and the ratio of the hardnesses of the two surfaces have important influences on the particle motion and hence on the mechanism of the resulting abrasive wear. Results from this model are compared with experimental observations, and the model is shown to lead to realistic predictions. © IMechE 2003.

A procedure for automatically estimating model parameters in optical motion capture

Model-based optical motion capture systems require knowledge of the position of the markers relative to the underlying skeleton, the lengths of the skeleton's limbs, and which limb each marker is attached to. These model parameters are typically assumed and entered into the system manually, although techniques exist for calculating some of them, such as the position of the markers relative to the skeleton's joints. We present a fully automatic procedure for determining these model parameters. It tracks the 2D positions of the markers on the cameras' image planes and determines which markers lie on each limb before calculating the position of the underlying skeleton. The only assumption is that the skeleton consists of rigid limbs connected with ball joints. The proposed system is demonstrated on a number of real data examples and is shown to calculate good estimates of the model parameters in each. © 2004 Elsevier B.V. All rights reserved.

Y chromosome evidence of earliest modern human settlement in East Asia and multiple origins of Tibetan and Japanese populations

Background: The phylogeography of the Y chromosome in Asia previously suggested that modern humans of African origin initially settled in mainland southern East Asia, and about 25,000 30,000 years ago, migrated northward, spreading throughout East Asia. H

Differential population structuring and demographic history of two closely related fish species, Japanese sea bass (Lateolabrax japonicus) and spotted sea bass (Lateolabrax maculatus) in Northwestern Pacific

The Quaternary cold periods in the Northwestern Pacific are thought to have heavily influenced the amount and distribution of intraspecific genetic variation in marine fishes. To estimate the demographic history and genetic structure of Lateolabrax macula