Episodes of water deprivation enhance daily hypertonic NaCl intake in rats

Water and 1.8% NaCl intake was recorded daily in adult male rats (N = 6) submitted to four water deprivations plus four sodium appetite tests, each at the end of each 7-day interval, or in controls (non-deprived, N = 6). Water deprivation was achieved by removing water and 1.8% NaCl for 24 h. Water was then offered for 2 h. At the end of this period, 1.8% NaCl was also offered in addition to water (sodium appetite test). Average daily 1.8% NaCl intake was enhanced from 5.2 ± 1.0 to 15.7 ± 2.5 ml from the first to the fifth week in the experimental group and was unchanged in the control group. Daily water intake was not altered in either group. Thus, repeated episodes of water deprivation enhance daily NaCl intake.

Baclofen into the lateral parabrachial nucleus induces hypertonic sodium chloride and sucrose intake in rats

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Opioid activation in the lateral parabrachial nucleus induces hypertonic sodium intake

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Serotonergic receptor blockade in the lateral parabrachial nucleus: Different effects on hypertonic and isotonic NaCl intake

Hypertonic NaCl intake is produced by serotonin receptor antagonism in the lateral parabrachial nucleus (LPBN) of dehydrated rats or in rats pretreated with a mineralocorticoid, for example deoxycorticosterone (DOCA), that receive an intracerebroventricular injection (icv) of angiotensin II (ang II). The objective of the present work was to find out whether these two mechanisms are also involved with isotonic NaCl intake. Serotonin receptor blockade by methysergide in the LPBN (4 mu g/0.2 mu l bilaterally) had no effect on 0.15 M NaCl (methysergide: 19.3 +/- 5.2 ml/60 min; vehicle: 19.3 +/- 4.2 ml/60 min; n=7) or water (methysergide: 3.4 +/- 1.4 ml/ 60 min; vehicle 2.2 +/- 0.6 ml/60 min) intake induced by systemic diuretic furosemide combined with low dose of captopril (Furo/Cap). Methysergide treatment 4 days later in the same animals produced the expected enhancement in the 0.3 M NaCl intake induced by Furo/Cap (methysergide: 16.6 +/- 3.5 ml/60 min; vehicle: 6.6 +/- 1.5 ml/60 min). Similar result was obtained when another group was tested first with 0.3 M NaCl and later with 0.15 M NaCl. Isotonic NaCl intake induced by icv ang II was however enhanced by prior DOCA treatment. A de novo hypertonic NaCl intake was produced in another group by the same combined treatment. The results suggest that a facilitatory mechanism like the mineralocorticoid/ang II synergy may enhance NaCl solution intake at different levels of tonicity, while the action of an inhibitory mechanism, like the LPBN serotonergic system, is restricted to the ingestion at hypertonic levels. (c) 2007 Elsevier B.V. All rights reserved.

Changes in taste reactivity to intra-oral hypertonic NaCl after lateral parabrachial injections of an alpha(2)-adrenergic receptor agonist

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

The effect of disinfectant solutions on the hardness of acrylic resin denture teeth

This investigation studied the effects of disinfectant solutions on the hardness of acrylic resin denture teeth. The occlusal surfaces of 64 resin denture teeth were ground flat with abrasives up to 400-grit silicon carbide paper. Measurements were made after polishing and after the specimens were stored in water at 37 degreesC for 48 h. The specimens were then divided into four groups and immersed in chemical disinfectants (4% chlorhexidine; 1% sodium hypochlorite and sodium perborate) for 10 min. The disinfection methods were performed twice to simulate clinical conditions and hardness measurements were made. Specimens tested as controls were immersed in water during the same disinfection time. Eight specimens were produced for each group. After desinfection procedures, testing of hardness was also performed after the samples were stored at 37 degreesC for 7, 30, 60, 90 and 120 days. Data were analysed using two-way analysis of variance (anova) and Tukey's test at 95% confidence level. According to the results, no significant differences were found between materials and immersion solutions (P > 0.05). However, a continuous decrease in hardness was noticed after ageing (P < 0.05). It was conclude that the surfaces of both acrylic resin denture teeth softened upon immersion in water regardless the disinfecting solution.

Effect of Incorporation of Disinfectant Solutions on Setting Time, Linear Dimensional Stability, and Detail Reproduction in Dental Stone Casts

Purpose: The aim of this paper was to analyze the influence of incorporation of disinfectants during the cast die stone-setting time. Setting time, linear dimensional stability, and reproduction details on casts were measured.Materials and Methods: Die stone type IV specimens with disinfection solutions (sodium hypochlorite 1%, glutaraldehyde 2%, chlorhexidine 2%) were incorporated in two concentrations (50%, 100%). The detail reproduction, dimensional stability, and setting time were tested in accordance with ADA recommendations.Results: Disinfecting solutions promoted an increase in setting time compared to control; sodium hypochlorite was responsible for the highest setting time. The addition of undiluted sodium hypochlorite 1.0% led to contraction during setting, but the groups with 50% diluted sodium hypochlorite 1.0% and undiluted chlorhexidine 2.0% resulted in intermediate values compared to the other groups, thus matching the control. The others did not demonstrate any effect on expansion. For detail reproduction, it was observed that the control group presented results similar to the others, except those where sodium hypochlorite was added.Conclusions The addition of sodium hypochlorite in both dilutions significantly altered, negatively, all the evaluated properties. But the addition of glutaraldehyde and chlorhexidine did not promote any significant alterations in the evaluated properties.

Effectiveness of two disinfectant solutions and microwave irradiation in disinfecting complete dentures contaminated with methicillin-resistant Staphylococcus aureus

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Antibacterial effectiveness of several irrigating solutions and the Endox Plus system - an ex vivo study

Aim To compare the ex vivo antibacterial effectiveness of the Endox Plus system and sodium hypochlorite (NaOCl) in combination with BioPure MTAD (Tulsa Dental, Tulsa, OK, USA) or with EDTA in Enterococcus faecalis-contaminated root canals.Methodology After initial preparation, the root canals of 70 single-rooted human teeth were inoculated with E. faecalis (ATCC 29212) and incubated for 21 days. Specimens were divided into five groups: Endox Plus/saline; 2.5% NaOCl/MTAD; 2.5% NaOCl/EDTA; saline (positive control); negative control (root canals not prepared, nor irrigated). Samples were collected using paper points. Microbiological analysis evaluated the number of CFUs. Data were analysed by anova and Tukey tests at 0.05 significance.Results All specimens had bacterial growth after the incubation period, with similar CFU per mL counts (P > 0.05). After chemo-mechanical preparation, the number of bacteria in all groups reduced, except for the negative control. No significant differences were observed between 2.5% NaOCl/MTAD and 2.5% NaOCl/EDTA, but these groups had lower CFU counts than the other groups (P < 0.05). In the final samples, an increase in the bacterial counts was observed for Endox Plus/saline, 2.5% NaOCl/MTAD, 2.5% NaOCl/EDTA and saline (P < 0.05) with no significant differences between these groups.Conclusions This ex vivo study revealed that the Endox Plus system was associated with a reduced antibacterial effectiveness compared with conventional irrigation using 2.5% NaOCl/MTAD and 2.5% NaOCl/EDTA. All irrigation procedures allowed recovery of bacteria 7 days after treatment, demonstrating persistence of contamination within the root canal system.

In vitro antibacterial action of Tetraclean, MTAD and five experimental irrigation solutions

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Antibacterial efficacy of endodontic irrigating solutions and their combinations in root canals contaminated with Enterococcus faecalis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Penetration into dentin of sodium hypochlorite associated with acid solutions

Objective. The objective of this study was to evaluate the penetration of 2.5% NaOCl associated with 17.0% EDTA, 1.0% citric acid, and 1.0% peracetic acid into dentin tubules.Study design. The roots of 44 bovine incisors were cross-sectioned and 5-mm-long fragments were produced from their middle thirds. The specimens were instrumented with ProTaper hand files, stained in crystal violet, then sectioned mesiodistally. The buccal fragments were divided into 4 groups (n = 9) and subjected to 2 consecutive 10-minute immersion periods in one of the following acid solutions combined with 2.5% NaOCl: 17.0% EDTA (group 1), 1.0% citric acid (group 2), and 1.0% peracetic acid (group 3). Nine fragments were immersed in 2.5% NaOCl (group 4). The analysis of the penetration of NaOCl solutions into dentin was performed by measuring the depth of crystal violet stain that was bleached using a steromicroscope under x50 magnification. Statistical comparisons were carried out by Kruskal-Wallis and Dunn's tests at the 5% significance level.Results. Group 1 showed less penetration into dentin than group 4 (P < .05). No statistically significant differences were observed among groups 2, 3, and 4 (P > .05).Conclusions. Association of NaOCl with acid solutions did not increase its penetration depth into root dentin. (Oral Surg Oral Med Oral Pathol Oral Radiol Endod 2011;112:e155-e159)

Influence of 0.05% sodium fluoride solutions on microhardness of resin-modified glass ionomer cements

This study aimed to evaluate the influence of fluoride-containing mouthrinse solutions (Fluorgard and Oral B) on the superficial microhardness of two resin-modified glass ionomer cements (Vitremer and Fuji II LC). Fifteen discs-shaped specimens of each glass ionomer cement (0 10 mm; 2 mm thick) were prepared, thereby forming two groups. After 24-hour storage in artificial saliva, the microhardness was measure and the data were recorded. Next, each group was divided into three subgroups (n = 5), according to the solution to be immersed in. Control specimens were kept in artificial saliva along the whole experiment. The test specimens were kept in mouthrinse solution for 30 days. Vickers surface microhardness was analyzed at predetermined evaluation periods: 24 h, 48 h, 7, 14, 21 and 30 days after specimens' preparation. Data were subjected to three-way ANOVA and to Tukey test (p < 0.05). A better behavior of Fuji II LC was observed and Fluorgard affected most the characteristics of the tested materials. It may be concluded that fluoride-containing solutions influenced the tested characteristics of materials, mainly of Vitremer.