Effects of seawater acidification on early development of the intertidal sea urchin Paracentrotus lividus, seawater carbonate chemistry and biological processes

The effect of pH ranging from 8.0 to 6.8 (total scale - pHT) on fertilization, cleavage and larval development until pluteus stage was assessed in an intertidal temperate sea urchin. Gametes were obtained from adults collected in two contrasting tide pools, one showing a significant nocturnal pH decrease (lowest pHT = 7.4) and another where pH was more stable (lowest pHT = 7.8). The highest pHT at which significant effects on fertilization and cleavage were recorded was 7.6. On the contrary, larval development was only affected below pHT 7.4, a value equal or lower than that reported for several subtidal species. This suggests that sea urchins inhabiting stressful intertidal environments produce offspring that may better resist future ocean acidification. Moreover, at pHT 7.4, the fertilization rate of gametes whose progenitors came from the tide pool with higher pH decrease was significantly higher, indicating a possible acclimatization or adaptation of gametes to pH stress.

(Table 1) Stable carbon and oxygen isotopes of planktonic and benthic foraminifera in ODP Hole 1006A

During ODP Leg 166, the recovery of cores from a transect of drill sites across the Bahamas margin from marginal to deep basin environments was an essential requirement for the study of the response of the sedimentary systems to sea-level changes. A detailed biostratigraphy based on planktonic foraminifera was performed on ODP Hole 1006A for an accurate stratigraphic control. The investigated late middle Miocene-early Pliocene sequence spans the interval from about 12.5 Ma (Biozone N12) to approximately 4.5 Ma (Biozone N19). Several bioevents calibrated with the time scale of Berggren et al. (1995a,b) were identified. The ODP Site 1006 benthic oxygen isotope stratigraphy can be correlated to the corresponding deep-water benthic oxygen isotope curve from ODP Site 846 in the Eastern Equatorial Pacific (Shackleton et al., 1995. Proc. ODP Sci. Res. 138, 337-356), which was orbitally tuned for the entire Pliocene into the latest Miocene at 6.0 Ma. The approximate stratigraphic match of the isotopic signals from both records between 4.5 and 6.0 Ma implies that the paleoceanographic signal from the Bahamas is not simply a record of regional variations but, indeed, represents glacio-eustatic fluctuations. The ODP Site 1006 oxygen and carbon isotope record, based on benthic and planktonic foraminifera, was used to define paleoceanographic changes on the margin, which could be tied to lithostratigraphic events on the Bahamas carbonate platform using seismic sequence stratigraphy. The oxygen isotope values show a general cooling trend from the middle to late Miocene, which was interrupted by a significant trend towards warmer sea-surface temperatures (SST) and associated sea-level rise with decreased ice volume during the latest Miocene. This trend reached a maximum coincident with the Miocene/Pliocene boundary. An abrupt cooling in the early Pliocene then followed the warming which continued into the earliest Pliocene. The late Miocene paleoceanographic evolution along the Bahamas margin can be observed in the ODP Site 1006 delta13C values, which support other evidence for the beginning of the closure of the Panama gateway at 8 Ma followed by a reduced intermediate water supply of water from the Pacific into the Caribbean at about 5 Ma. A general correlation of lower sedimentation rates with the major seismic sequence boundaries (SSBs) was observed. Additionally, the SSBs are associated with transitions towards more positive oxygen isotope excursions. This observed correspondence implies that the presence of a SSB, representing a density impedance contrast in the sedimentary sequence, may reflect changes in the character of the deposited sediment during highstands versus those during lowstands. However, not all of the recorded oxygen isotope excursions correspond to SSBs. The absence of a SSB in association with an oxygen isotope excursion indicates that not all oxygen isotope sea-level events impact the carbonate margin to the same extent, or maybe even represent equivalent sea-level fluctuations. Thus, it can be tentatively concluded that SSBs produced on carbonate margins do record sea-level fluctuations but not every sea-level fluctuation is represented by a SSB in the sequence stratigraphic record.

Legal Aspects which Implement Good Practice Measures in the Management of Construction and Demolition Waste

The construction industry, one of the most important ones in the development of a country, generates unavoidable impacts on the environment. The social demand towards greater respect for the environment is a high and general outcry. Therefore, the construction industry needs to reduce the impact it produces. Proper waste management is not enough; we must take a further step in environmental management, where new measures need to be introduced for the prevention at source, such as good practices to promote recycling. Following the amendment of the legal frame applicable to Construction and Demolition Waste (C&D waste), important developments have been incorporated in European and International laws, aiming to promote the culture of reusing and recycling. This change of mindset, that is progressively taking place in society, is allowing for the consideration of C&D waste no longer as an unusable waste, but as a reusable material. The main objective of the work presented in this paper is to enhance C&D waste management systems through the development of preventive measures during the construction process. These measures concern all the agents intervening in the construction process as only the personal implication of all of them can ensure an efficient management of the C&D waste generated. Finally, a model based on preventive measures achieves organizational cohesion between the different stages of the construction process, as well as promoting the conservation of raw materials through the use and waste minimization. All of these in order to achieve a C&D waste management system, whose primary goal is zero waste generation

Combining statistical and semantic approaches to the translation of ontologies and taxonomies

Ontologies and taxonomies are widely used to organize concepts providing the basis for activities such as indexing, and as background knowledge for NLP tasks. As such, translation of these resources would prove useful to adapt these systems to new languages. However, we show that the nature of these resources is significantly different from the "free-text" paradigm used to train most statistical machine translation systems. In particular, we see significant differences in the linguistic nature of these resources and such resources have rich additional semantics. We demonstrate that as a result of these linguistic differences, standard SMT methods, in particular evaluation metrics, can produce poor performance. We then look to the task of leveraging these semantics for translation, which we approach in three ways: by adapting the translation system to the domain of the resource; by examining if semantics can help to predict the syntactic structure used in translation; and by evaluating if we can use existing translated taxonomies to disambiguate translations. We present some early results from these experiments, which shed light on the degree of success we may have with each approach

On the specification and testing of inverters for stand-alone PV systems

Inverter features are reviewed from a PV systems perspective, with a view to contributing to possible codes, procurement specifications and testing procedures, in order to assure the technical quality of these systems. A laboratory testing campaign has been carried out on a representative set of sixteen currently available inverters and a set of the most common AC appliances. The results of the tests are discussed with the aim of divulging the particular features of operating AC appliances in PV systems and the provisions to be taken into account in PV system design. The development of testing procedures has followed the motto ?keep it as simple as possible?, in order to make their application easier in conventional laboratories in developing countries.

On the uses of attributed variables in parallel and concurrent logic programming systems

Incorporating the possibility of attaching attributes to variables in a logic programming system has been shown to allow the addition of general constraint solving capabilities to it. This approach is very attractive in that by adding a few primitives any logic programming system can be turned into a generic constraint logic programming system in which constraint solving can be user defined, and at source level - an extreme example of the "glass box" approach. In this paper we propose a different and novel use for the concept of attributed variables: developing a generic parallel/concurrent (constraint) logic programming system, using the same "glass box" flavor. We argüe that a system which implements attributed variables and a few additional primitives can be easily customized at source level to implement many of the languages and execution models of parallelism and concurrency currently proposed, in both shared memory and distributed systems. We illustrate this through examples.