Production of an axial piston: Impacts resulting from the substitution of steel by a polymer-based material

The substitution of steel as a raw material in the production of axial pistons for pressure washers by polyphthalamide, polytetrafluoroethylene and glass fiber-based composite was studied. The new production process with composite consists of only two steps, while the production of the steel piston is to comprise of thirteen steps. This replacement would result in an estimated reduction of 80% of water consumption, 83% of electricity consumption, 73% of the total cost and 88% of the final mass. With regard to the main mechanical properties required for the end product, the composite was found to withstand the critical axial loads and it shows acceptable wear resistance in an environment without lubrication, an additional advantage of this replacement. © 2012 Elsevier Ltd. All rights reserved.

Influence of ethanol, acidity and chloride concentration on the corrosion resistance of AISI 316L stainless steel

The influence of ethanol, sulfuric acid and chloride on the corrosion resistance of 316L stainless steel was investigated by means of polarization curves and electrochemical impedance spectroscopy measurements. Over the studied range, the steel corrosion potential was independent of H2SO 4 and NaCl concentrations in aqueous solution. On the other hand, in solution containing 65 wt.% ethanol and 35 wt.% water, the corrosion potentials were higher than those obtained in aqueous solution. Besides, the steel corrosion potential was affected by the addition of H2SO4 and NaCl in solution. In solutions with and without ethanol, plus 0.35 wt.% NaCl, the presence of 1 wt.% H2SO4 inhibited the appearance of pitting corrosion. © 2013 Sociedade Brasileira de Química.

Temperature and scarification on seeds germination of copernicia prunifera (Mill) H.E. Moore (Arecaceae)

Copernicia prunifera, known as carnauba, is native to Brazil and presents great potential to be used in gardens and cultivation in pot. Palms species, with relatively few exceptions, can only be propagated by seeds; even so, there are no reports in the literature about the germination of this palm seeds. Several species of the Arecaceae family present seed physical dormancy in varying degrees, demanding treatments to improve germination. The objective of this work was to study the effects of temperature and mechanical scarification on seed germination of C. prunifera. The experimental design was entirely randomized in a factorial arrangement 6 x 2 (six conditions of temperature with or without mechanical scarification) with 4 replications and 25 seeds each. In accordance with the treatment, lateral scarifications were made on the seeds until appearance of the endosperm. Seeds were sown in moist fine vermiculite. Germination (%) and germination rate (GR) were evaluated. Germination data were arcsine (x/100)1/2 transformed before analysis of variance and germination rate data were not transformed. The means of the resulting values were then compared by the Scott-Knott test at 1% confidence level. It was concluded that the biggest germination percentage were obtained at alternated temperature of 25-35°C (92%) and at constant temperature of 25°C (87%). Seeds germinated faster at alternated temperature of 25- 35°C. Germination percentage was similar for the scarified and non-scarified seeds; however, scarified seeds germinated faster.

Analysis of efficiency and rationality in a sugar-alcohol mill using hyperboloid a-load and potency

Brazil is the world's largest producer of sugar cane and which in the state of São Paulo concentrate the greatest amount of sugar cane field of the country. The sugar-alcohol sector has the capacity to produce sufficient thermal and electrical energy to be used in their process of production and commercialize of surplus in electricity distribution network. Therefore it is necessary to evaluate the energy efficiency and rationality within the mill. Accordingly this research proposed analyze the sugar-alcohol mill's sectors globally and individually, located in the west center of the São Paulo state, using the valuation methodology employed by the Agência Nacional de Energia Elétrica (ANEEL) in the industries that do not have systems of cogeneration. In this analysis, the hyperboloids of load and potency were applied based on the indexes of potency factor and load factor that allow estimate the efficiency and rationality. © 2013 IEEE.

Ion beam analysis of a-C:H films on alloy steel substrate

An a-C:H thin film deposited by plasma immersion ion implantation and deposition on alloy steel (16MnCr5) was analyzed using a self-consistent ion beam analysis technique.In the self-consistent analysis, the results of each individual technique are combined in a unique model, increasing confidence and reducing simulation errors.Self-consistent analysis, then, is able to improve the regular ion beam analysis since several analyses commonly used to process ion beam data still rely on handling each spectrum independently.The sample was analyzed by particle-induced x-ray emission (for trace elements), elastic backscattering spectrometry (for carbon), forward recoil spectrometry (for hydrogen) and Rutherford backscattering spectrometry (for film morphology).The self-consistent analysis provided reliable chemical information about the film, despite its heavy substrate.As a result, we could determine precisely the H/C ratio, contaminant concentration and some morphological characteristics of the film, such as roughness and discontinuities.© 2013 Elsevier B.V.All rights reserved.

Efeitos alelopáticos de microcistinas em rúcula (Eruca sativa Mill.)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Posibilidades de cooperación y complementación industrial entre América Latina y Japón para la producción y comercialización del hierro y el acero = Possibilities for co-operation and industrial complementation between Latin America and Japan in producing and marketing iron and steel

Incluye Bibliografía

Escurecimento enzimático em frutos: polifenoloxidase de atemóia (Annona cherimola Mill. X Annona squamosa L.)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Problemas de la industria siderúrgica y de transformación de hierro y acero en América Latina = Problems of the steel making and transforming industries in Latin America

Incluye Bibliografía