Achados timpanométricos em um grupo de escolares

PURPOSE: to characterize and compare the tympanometric findings in a group of preschoolers. METHOD: 112 preschoolers were evaluated, both genders, aged from four years old to five years and eleven months old who attended a Municipal School of Early Childhood Education in the suburbs of Marilia city- SP. Tympanometry was used as triage procedure. It was considered that the child PASSED in the triage when it presented an A type tympanometric curve, bilaterally, being reevaluated in case of failure. RESULTS: it was observed a high failure index (63.4%) in the studied population. The older female preschoolers presented a higher index of A type tympanograms, in both ears. There was a higher incidence of failure in male preschoolers aged from four years to four years and eleven months. CONCLUSION: in this sample, there was a high index of tympanometric alteration. There was a tendency among younger male students to present a higher index of tympanometric alteration when compared to older female preschoolers, this difference was not statistically significant.

Structural and optical properties of brominated plasma polymers

Novel brominated amorphous hydrogenated carbon (a-C:H:Br) films were produced by the plasma polymerization of acetylene-bromoform mixtures. The main parameter of interest was the degree of bromination, which depends on the partial pressure of bromoform in the plasma feed, expressed as a percentage of the total pressure, R-B. When bromoform is present in the feed, deposition rates of up to about 110 nm min(-1) may be obtained. The structure and composition of the films were characterized by Transmission Infrared Reflection Absorption Spectroscopy (IRRAS) and X-ray Photo-electron Spectroscopy (XPS). The latter revealed that films with atomic ratios Br:C of up to 0.58 may be produced. Surface contact angles, measured using goniometry, could be increased from similar to 63 degrees (for an unbrominated film) to similar to 90 degrees for R-B of 60 to 80%. Film surface roughness, measured using a profilometer, does not depend strongly on R-B. Optical properties the refractive index, n, absorption coefficient, alpha(E), where E is the photon energy, and the optical gap, E-g, were determined from film thicknesses and data obtained by Transmission Ultraviolet-Visible Near Infrared Spectroscopy (UVS). Control of n was possible via selection of R-B. The measured optical gap increases with increasing F-BC, the atomic ratio of Br to C in the film, and semi-empirical modeling accounts for this tendency. A typical hardness of the brominated films, determined via nano-indentation, was similar to 0.5 GPa. (C), 2013 Elsevier B.V. All rights reserved.

Anti-Trichophyton Activity of Protocatechuates and Their Synergism with Fluconazole

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

SeP hole injection layer for devices based on organic materials

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Cobalt(III) complexes with thiosemicarbazones as potential anti-Mycobacterium tuberculosis agents

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Writing saturated holograms in LiNbO3 crystals through phase control and double diffraction

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Picosecond nonlinearity of GeO2-Bi2O3-PbO-TiO2 glasses at 532 and 1,064 nm

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

UV laser photofabrication of waveguide couplers using self-patterning organic-inorganic hybrids

Planar waveguides with controlled refractive index were produced using thin films of sol-gel derived organic-inorganic hybrids, so called di-ureasils. Spectroscopic ellipsometry was used to characterize the films thickness and refractive index. UV-laser direct-writing method was used to produce Y-splitter structures with coupling ratio of 50% without the need of photoinitiators.

Composite Material Sensitive to Volatile Organic Compounds

This work evaluates fluorinated thin films and their composites for sensor development. Composites were produced using 5 µm starch particles and plasma films obtained from organic fluorinated and silicon compounds reactants. Silicon wafers and aluminum trenches were used as substrates. Film thickness, refractive index and chemical structure were also determined. Scanning electron microscopy shows conformal deposition on aluminum trenches. Films deposited on silicon were exposed to vapor of volatile organic compounds and CV curves were obtained. A qualitative model (FemLab 3.2® program) was proposed for the electronic behavior. These environmentally correct films can be used in electronic devices and preferentially reacted to polar compounds. Nonetheless, due to the difficulty in signal recovery, these films are more effective in one-way sensors, in sub-ppm range.

Analysis of autonomic modulation after an acute session of resistance exercise at different intensities in chronic obstructive pulmonary disease patients

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Lensometry by two-laser holography with photorefractive Bi12TiO20

Refractive and profilometric measurements of lenses were performed through holography with a photorefractive Bi12TiO20 crystal as the recording medium. Two properly aligned diode lasers emitting in the red region were employed as light sources. Both lasers were tuned in order to provide millimetric and sub-millimetric synthetic wavelengths. The surfaces of the test lens were covered by a 25-μm opaque plastic tape in order to allow the lens profilometry upon illuminating them with a collimated beam. The resulting holographic images appear covered by interference fringes corresponding to the wavefront geometry of the wave scattered by the lens. For refractive index measurement a diffusely scattering flat surface was positioned behind the uncovered lens which was also illuminated by a plane wave. The resulting contour interferogram describes the form of the wavefront after the beam traveled back and forth through the lens. The fringe quantitative evaluation was carried out through the four-stepping technique and the resulting phase map and the Branch-cut method was employed for phase unwrapping. The only non-optical procedure for lens characterization was the thickness measurement, made by a dial caliper. Exact ray tracing calculation was performed in order to establish a relation between the output wavefront geometry and the lens parameters like radii of curvature, thickness and refractive index. By quantitatively comparing the theoretical wavefront geometry with the experimental results relative uncertainties bellow 3% for refractive index and 1 % for focal length were obtained. © 2008 American Institute of Physics.

Avaliação do conhecimento sobre a infecção HIV de estudantes de odontologia antes e após palestra informativa

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Macronutrient intake is correlated with dyslipidemia and low-grade inflammation in childhood obesity but mostly in male obese

Condition of hypoxia caused by hypertrophy of adipose cells in obesity triggers macrophages recruitment and production of cytokines. Additionally, high consumption of saturated fatty acids (SFA) and high glycemic index meals may contribute to oxidative stress and chronic low-grade inflammation by increases NF-kB activation. Thus, the aim of the study was to analyze the contribution of the macronutrients intake in the metabolic and inflammatory profile, by levels of lipoproteins, insulin resistance, anti and pro inflammatory cytokines, in obese adolescents according the gender. sample was composed by 37 adolescents, both genders, identified as obese by body mass index (BMI). Body composition was assessed by Dual-energy X-ray absorptiometry (DEXA) and measures of intra-abdominal adiposity (IAAT) and subcutaneous adiposity tissue (SAT) were done by ultrasound. Biochemical analyses were done and the measurement of cytokines; fatty acids and insulin were performed by the technique of immunoassay ELISA. The estimation of macronutrients consumption was made by 3 day food register regarding food intake. Statistical significance was set at p-value < 5% and the statistical software SPSS version 17.0 (SPSS Inc, Chicago, IL) performed all analyses. BMI (p = 0.316), FM (p = 0.416), IAAT (p = 0.505) and SAT (p = 0.935) presented similarities between genders. Cytokines and metabolic variables values were similar between the groups. Only in the male group, metabolic variables and cytokines were significant correlated with the consumption of total lipids or its fractions. Was observed that insulin concentration had significant interaction with MUFA(g) (= -18.4; p = 0.004) and adiponectin with CHO(g) (= -58.2; p = 0.032) in the group male and female, respectively. macronutrients intake is associated with low-grade inflammation in obesity, by production of inflammatory cytokines and alteration of the lipid profile, especially male obese adolescents which seem to be more responsive of this consumption when compared with female obese adolescents.

Current advances in antitubercular drug discovery: potent prototypes and new targets

Tuberculosis (TB) is an infectious disease caused by bacterium of the Mycobacterium genus, mainly by Mycobacterium tuberculosis (MTB). The World Health Organization aims to substantially reduce the number of cases in the coming years; however, the increased number of multidrug-resistant (MDR) and extremely drug-resistant (XDR) forms of the bacterium and the lack of treatment for latent tuberculosis are challenges to be overcome. In this review, we have identified the most potent compounds described in the literature during recent years with MIC values < 7 µM, low toxicity and a high selective index. In addition, emerging targets in MTB are presented to provide new perspectives for the discovery of new antitubercular drugs. This review aims to summarize the current advances in and promote insights into antitubercular drug discovery.

Influence of Mg on the structural and optical properties of LiNbO3 thin films grown by polymeric precursor method

A polymeric precursor solution was used to deposit pure and Mg doped LiNbO3 thin films on sapphire substrates by spin-coating. The effects of magnesium addition on crystallinity, morphology and optical properties of the annealed films were investigated. X-ray diffraction patterns indicate the oriented growth of the films. Phi-scan diffraction evidenced the epitaxial growth with two in-plane variants. AFM studies show that the films are very homogeneous, dense and present smooth surfaces. The refractive index and optical losses obtained by the prism coupling method were influenced by the magnesium addition.