998 resultados para TETRAGONAL YBA2CU3O7-X
Resumo:
The objectives of this work were to evaluate the genotype x environment (GxE) interaction for popcorn and to compare two multivariate analyses methods. Nine popcorn cultivars were sown on four dates one month apart during each of the agricultural years 1998/1999 and 1999/2000. The experiments were carried out using randomized block designs, with four replicates. The cv. Zélia contributed the least to the GxE interaction. The cv. Viçosa performed similarly to cv. Rosa-claro. Optimization of GxE was obtained for cv. CMS 42 for a favorable mega-environment, and for cv. CMS 43 for an unfavorable environment. Multivariate analysis supported the results from the method of Eberhart & Russell. The graphic analysis of the Additive Main effects and Multiplicative Interaction (AMMI) model was simple, allowing conclusions to be made about stability, genotypic performance, genetic divergence between cultivars, and the environments that optimize cultivar performance. The graphic analysis of the Genotype main effects and Genotype x Environment interaction (GGE) method added to AMMI information on environmental stratification, defining mega-environments and the cultivars that optimized performance in those mega-environments. Both methods are adequate to explain the genotype x environment interactions.
Resumo:
A road safety audit was conducted for a 7.75 mile section of County Road X-37 in Louisa County, Iowa. In 2006, the average annual daily traffic on this roadway was found to be 680 vehicles per day. Using crash data from 2001 to 2007, the Iowa Department of Transportation (Iowa DOT) has identified this roadway as being in the highest 5% of local rural roads in Iowa for single-vehicle runoff- road crashes. Considering these safety data, the Louisa County Engineer requested that a road safety audit be conducted to identify areas of safety concerns and recommend low-cost mitigation to address those concerns. Staff and officials from the Iowa DOT, Governor’s Traffic Safety Bureau, Federal Highway Administration, Institute for Transportation, and local law enforcement and transportation agencies met to review crash data and discuss potential safety improvements to this segment of X-37. This report outlines the findings and recommendations of the road safety audit team to address the safety concerns on this X-37 corridor and explain several selected mitigation strategies.
Resumo:
Impressive developments in X-ray imaging are associated with X-ray phase contrast computed tomography based on grating interferometry, a technique that provides increased contrast compared with conventional absorption-based imaging. A new "single-step" method capable of separating phase information from other contributions has been recently proposed. This approach not only simplifies data-acquisition procedures, but, compared with the existing phase step approach, significantly reduces the dose delivered to a sample. However, the image reconstruction procedure is more demanding than for traditional methods and new algorithms have to be developed to take advantage of the "single-step" method. In the work discussed in this paper, a fast iterative image reconstruction method named OSEM (ordered subsets expectation maximization) was applied to experimental data to evaluate its performance and range of applicability. The OSEM algorithm with different subsets was also characterized by comparison of reconstruction image quality and convergence speed. Computer simulations and experimental results confirm the reliability of this new algorithm for phase-contrast computed tomography applications. Compared with the traditional filtered back projection algorithm, in particular in the presence of a noisy acquisition, it furnishes better images at a higher spatial resolution and with lower noise. We emphasize that the method is highly compatible with future X-ray phase contrast imaging clinical applications.
Resumo:
The objectives of this work were to identify parents resistant to Asian soybean rust using diallel crosses, obtain information on the genetic control of soybean resistance to the pathogen and verify whether the combining ability estimates interact with the environment (year or time of assessment). The F1 generation was obtained in a greenhouse from crosses between five contrasting parents for the trait resistance to soybean rust, in a complete diallel without reciprocals. Two rust-severity assessments were carried out on individual soybean plants of 25 treatments (parents and F2 and F3 populations) in 2006/2007 and 2007/2008, in an experimental field at Embrapa Soja, Londrina, PR, Brazil. Additive effects predominated in the genetic control of soybean resistance to Asian rust, and the interaction of the segregant populations with the environment, although significant, did not alter the genetic parameter's general combining ability (GCA) and specific combining ability estimates, indicating that estimates obtained in one year and one assessment can be extrapolated to others. BR01-18437 inbred line is resistant to Asian rust and showed high GCA effects. This line should be used as parent if the objective is the resistance to Phakopsora pachyrhizi.
Resumo:
On October 20–21, 2009, two road safety audits were conducted in Lee County, Iowa: one for a 6 mile section of County Road X-23 from IA 2 to the south corporate limits of West Point and one for a 9.7 mile section of County Road W-62 from US 218 to IA 27. Both roads have high severe crash histories for the years of 2001 through 2008. Using these crash data, the Iowa Department of Transportation (Iowa DOT) has identified County Road X-23 as being in the top 5 percent of similar roads for run-off-road crashes. The Iowa DOT lists County Road W-62 as a high-risk rural road that has above-average crash numbers and is eligible for funding under the Federal High-Risk Rural Road Program. Considering these issues, the Lee County Engineer and Iowa DOT requested that road safety audits be conducted to address the safety concerns and to suggest possible mitigation strategies.
Resumo:
O objetivo deste trabalho foi avaliar a conveniência de definir o número de componentes multiplicativos dos modelos de efeitos principais aditivos com interação multiplicativa (AMMI) em experimentos de interações genótipo x ambiente de algodão com dados imputados ou desbalanceados. Um estudo de simulação foi realizado com base em uma matriz de dados reais de produtividade de algodão em caroço, obtidos em ensaios de interação genótipo x ambiente, conduzidos com 15 cultivares em 27 locais no Brasil. A simulação foi feita com retiradas aleatórias de 10, 20 e 30% dos dados. O número ótimo de componentes multiplicativos para o modelo AMMI foi determinado usando o teste de Cornelius e o teste de razão de verossimilhança sobre as matrizes completadas por imputação. Para testar as hipóteses, quando a análise é feita a partir de médias e não são disponibilizadas as repetições, foi proposta uma correção com base nas observações ausentes no teste de Cornelius. Para a imputação de dados, foram considerados métodos usando submodelos robustos, mínimos quadrados alternados e imputação múltipla. Na análise de experimentos desbalanceados, é recomendável escolher o número de componentes multiplicativos do modelo AMMI somente a partir da informação observada e fazer a estimação clássica dos parâmetros com base nas matrizes completadas por imputação.
Resumo:
The U.S. Environmental Protection Agency (EPA) is completing a third five-year review of the E.I. du Pont de Nemours & Co., Inc., County Road X-23 Superfund site in Lee County, Iowa. The site is also known as the Baier and McCarl subsites. The EPA is inviting public comment on whether the current site remedy continues to be protective of public health and the environment. The Iowa Department of Public Health in cooperation with the Agency for Toxic Substances and Disease Registry (ATSDR) prepared this health consultation to review the current status of the Baier and McCarl subsites and to provide an evaluation of the public health status of these subsites. The information in this health consultation was current at the time of writing. Data that emerges later could alter this docum ent’s conclusions and recommendations.
Resumo:
Glucose metabolism is difficult to image with cellular resolution in mammalian brain tissue, particularly with (18) fluorodeoxy-D-glucose (FDG) positron emission tomography (PET). To this end, we explored the potential of synchrotron-based low-energy X-ray fluorescence (LEXRF) to image the stable isotope of fluorine (F) in phosphorylated FDG (DG-6P) at 1 μm(2) spatial resolution in 3-μm-thick brain slices. The excitation-dependent fluorescence F signal at 676 eV varied linearly with FDG concentration between 0.5 and 10 mM, whereas the endogenous background F signal was undetectable in brain. To validate LEXRF mapping of fluorine, FDG was administered in vitro and in vivo, and the fluorine LEXRF signal from intracellular trapped FDG-6P over selected brain areas rich in radial glia was spectrally quantitated at 1 μm(2) resolution. The subsequent generation of spatial LEXRF maps of F reproduced the expected localization and gradients of glucose metabolism in retinal Müller glia. In addition, FDG uptake was localized to periventricular hypothalamic tanycytes, whose morphological features were imaged simultaneously by X-ray absorption. We conclude that the high specificity of photon emission from F and its spatial mapping at ≤1 μm resolution demonstrates the ability to identify glucose uptake at subcellular resolution and holds remarkable potential for imaging glucose metabolism in biological tissue. © 2012 Wiley Periodicals, Inc.
Resumo:
We report on the growth of epitaxial YBa2Cu3O7 thin films on X-cut LiNbO3 single crystals. The use of double CeO2/YSZ buffer layers allows a single in-plane orientation of YBa2Cu3O7, and results in superior superconducting properties. In particular, surface resistance Rs values of 1.4 m¿ have been measured at 8 GHz and 65 K. The attainment of such low values of Rs constitutes a key step toward the incorporation of high Tc materials as electrodes in photonic and acoustic devices.
Resumo:
The objective of this work was to isolate and characterize tannin-tolerant ruminal bacteria from crossbred Holstein x Zebu cows fed a chopped mixture of elephant grass (Pennisetum purpureum), young stems of "angico-vermelho" (Parapiptadenia rigida), and banana tree (Musa sp.) leaves. A total of 117 bacteria strains were isolated from enrichment cultures of rumen microflora in medium containing tannin extracts. Of these, 11 isolates were able to tolerate up to 3 g L-1 of tannins. Classical characterization procedures indicated that different morphological and physiological groups were represented. Restriction fragments profiles using Alu1 and Taq1 of 1,450 bp PCR products from the 16S rRNA gene grouped the 11 isolates into types I to VI. Sequencing of 16S rRNA PCR products was used for identification. From the 11 strains studied, seven were not identifiable by the methods used in this work, two were strains of Butyrivibrio fibrisolvens, and two of Streptococcus bovis.
Resumo:
Purpose: Atheromatic plaque progression is affected, among others phenomena, by biomechanical, biochemical, and physiological factors. In this paper, the authors introduce a novel framework able to provide both morphological (vessel radius, plaque thickness, and type) and biomechanical (wall shear stress and Von Mises stress) indices of coronary arteries. Methods: First, the approach reconstructs the three-dimensional morphology of the vessel from intravascular ultrasound(IVUS) and Angiographic sequences, requiring minimal user interaction. Then, a computational pipeline allows to automatically assess fluid-dynamic and mechanical indices. Ten coronary arteries are analyzed illustrating the capabilities of the tool and confirming previous technical and clinical observations. Results: The relations between the arterial indices obtained by IVUS measurement and simulations have been quantitatively analyzed along the whole surface of the artery, extending the analysis of the coronary arteries shown in previous state of the art studies. Additionally, for the first time in the literature, the framework allows the computation of the membrane stresses using a simplified mechanical model of the arterial wall. Conclusions: Circumferentially (within a given frame), statistical analysis shows an inverse relation between the wall shear stress and the plaque thickness. At the global level (comparing a frame within the entire vessel), it is observed that heavy plaque accumulations are in general calcified and are located in the areas of the vessel having high wall shear stress. Finally, in their experiments the inverse proportionality between fluid and structural stresses is observed.
Resumo:
O objetivo deste trabalho foi avaliar o efeito da interação genótipo x ambiente (GxA), nas características peso à desmama e ganho de peso do nascimento à desmama, em machos e fêmeas da raça Simental, nascidos nas estações chuvosa e seca. Foram avaliados 20 mil animais, aos 210 dias de idade. Realizou-se uma análise multicaracterística, que considerou como distinta a mesma característica nos diferentes grupos ambientais, e uma análise unicaracterística, que considerou cada característica como a mesma em todos os grupos ambientais. Ainteração GxA foi avaliada por meio da correlação genética (r g). As interações foram consideradas importantes quando os valores de r g ficaram abaixo de 0,80. As distribuições posteriores das estimativas de herdabilidades mostraram ausência de heterogeneidade de variâncias entre os sexos, entretanto houve interação GxA entre os grupos ambientais. Observaram-se valores de correlação genética de 0,54 a 0,78 e 0,55 a 0,75 para peso à desmama e ganho de peso do nascimento à desmama, respectivamente. As seleções, baseadas tanto na análise unicaracterística quanto na multicaracterística, não mostraram diferenças significativas quanto ao ganho genético dos animais. Há efeito das estações de nascimento nas características avaliadas, em todos os grupos ambientais, e a interação GxA é mais evidente em fêmeas do que em machos.
Resumo:
O objetivo deste trabalho foi realizar a estratificação de ambientes de cultivo de milho nos Estados do Paraná, Minas Gerais e Bahia, por diferentes métodos, bem como determinar o grau de associação e divergência entre os métodos de estratificação. Foram avaliados quatro métodos: o tradicional de Lin; o de dissimilaridade ambiental; o de decomposição da interação genótipo x ambiente (GxA) em partes simples e complexa; e o de análise de fatores. Esses métodos foram aplicados a 48 híbridos experimentais de milho, avaliados em 11 ambientes de cultivo nos três Estados, divididos em dois conjuntos de experimentos. Além dos híbridos, foram avaliadas seis cultivares comerciais, utilizadas como testemunhas, comuns aos dois conjuntos. Verificou-se a predominância de interação GxA do tipo complexa. A decomposição da interação GxA em partes simples e complexa e a análise de fatores são métodos fortemente associados entre si, mas moderadamente associados aos demais. Além disso, esses métodos são mais rigorosos no processo de estratificação ambiental e ponderam de maneira mais eficiente a magnitude da interação GxA.