973 resultados para Nitrate concentration
Resumo:
A novel poly-l-arginine microcapsule was prepared due to its nutritional function and pharmacological efficacy. A high-voltage electrostatic droplet generator was used to make uniform microcapsules. The results show that the membrane strength and permeating property are both remarkably affected with the changes of sodium alginate concentration. With the sodium alginate concentration increasing, gel beads sizes increase from 233 mum to 350 mum, release ratio is also higher at the same time, but the membrane strength decreases.
Resumo:
The power-time curves of growth of three strains of petroleum bacteria at different NaCl concentrations at 40.0 and 50.0 degreesC have been determined by using a 2277 Thermometric Thermal Activity Analyser. An equation of a power-time curve, ln[alphaP(K)/P(t) - 1] = ln[(alphaK - N-0)/N-0] - alphakt, was established based on the generalized logistic equation, where P(t) is the thermal power at time t, K the carrying capacity, P-K = P0K, P-0 the thermal power of one cell, N-0 the bacterial population at time zero, alpha = (k - D)/k. The method of four observed points with the same time interval was used to calculate the value of P-K. The growth rate constant k and the death rate constant D were calculated. The NaCl concentration of optimum growth rate of petroleum bacteria at 40.0 and 50.0 degreesC, respectively, have been obtained according to the curves k - D versus NaCl concentration, which are 0.26, 0.54 and 0.57 mol l(-1) for B-1, B-2 and B-3, respectively, at 50.0 degreesC, 0.26, 0.55 and 0.56 mol l(-1) for B-1, B-2 and B-3, respectively, at 40.0 degreesC. The results indicated that the effect of temperature on NaCl concentration of optimum growth rate was small. (C) 2002 Elsevier Science B.V. All rights reserved.
Resumo:
Germination of non-dormant upper cocklebur (Xanthium pinsylvanicum Wallr.) seeds was stimulated by not only CS(NH2)2 but also NH2OH, KCN and NaN3. This stimulation was not via the enhancement of aerobic C2H4 production. NH2OH, KCN and NaN3 in certain concentrations promoted the initial growth of axial and/or cotyledonary parts, but the degree of growth promotion by NH2OH, NaN3 and KCN was slight compared with that by CS(NH2)2. As in the case of CS(NH2)2, however, the germinationstimulating effect of NH2OH disappeared rapidly as the preceding imbibition period was prolonged. In contrast, KCN and NaN3 were still effective in stimulating the germination of aged seeds maintained on a water substratum, as previously seen with anaerobiosis. Anaerobic induction was enhanced not only by NaN3 and KCN but also by NH2OH, KNO3, KNO2 CO(NH2)2 and CS(NH2)2 applied during the anaerobic treatment, but without causing an increase in anaerobic production of C2H4. Furthermore, KCN and NaN3, given prior to the anaerobic treatment acted additively with anaerobic induction. The germination-stimulating actions of nitrogenous compounds are discussed in comparison with those of C2H4 and anaerobiosis.
Resumo:
A method is presented for determining production and consumption rates of .OH radicals produced photochemically in natural surface waters. It is based on the determination of the kinetics by which the concentration of a specified trace compound decreases during irradiation. In samples from Lake Greifensee (Switzerland) low production rates for .OH limit its possible effects. In addition, fast consumptions by the natural dissolved organic solutes and by the bicarbonate protect organic micropollutants from oxidation by .OH. Neither direct nor indirect H2O2 photolysis was a significant source of .OH in the lakewater studied lacking iron, whereas nitrate photolysis could have been a source. Comparison with reaction kinetic formulations allows generalizations for other types of waters.
Resumo:
The study on the response of a mutant and a wild type of Arabidopsis to 660 μl·L -1 CO 2 and ambient CO 2 showed that under elevated CO 2,the stomatal numbers of the mutant increased,while those of the wild type decreased. The chlorophyll content and NR (nitrate reductase) activity of the mutant increased,but those of the wild type had no obvious response. The mutant was not reproductively mature after the continuous exposure to increased CO 2 for five months. The results provided evidence of plant response to the changes of atmospheric CO 2 concentration,and the clues to related studies on other plants.
Resumo:
Birefringent ring-banded spherulites with radial periodic variation of thicknesses were grown from poly(epsilon-caprolactone) (PCL) solutions under conditions for which the Solution concentration was held constant during the whole development of the morphology. The as-grown ring-banded spherulites were investigated by optical (OM) and atomic force (AFM) microscopies, by transmission electron microscopy (TEM) of samples sectioned parallel to the plane of film, and also by electron diffraction (ED) and grazing incidence X-ray diffraction (GIXD) techniques.
Resumo:
Extraction kinetics of thorium(IV) with primary amine N1923 in sulfate media has been investigated by a constant interfacial cell with laminar flow. Studies of interfacial tension and effects of the stirring rate, temperature, and specific interfacial area on mass transfer rate show that the most probable reaction zone takes place at the liquid-liquid interface. According to the experimental data correlated as a function of the concentration of the relevant species involved in the extraction reaction, the rate equation of extracting thorium has been obtained as follows: -d[Th(IV)]((o))/dt = 10(-3.10)center dot[Th(IV)](0.89)center dot[(RNH3)(2)SO4](0.74).
Resumo:
Microstructures and mechanical properties of the Mg-7Y-4Gd-xZn-0.4Zr (x = 0.5, 1.5, 3, and 5 wt.%) alloys in the as-cast, as-extruded, and peak-aged conditions have been investigated by using optical microscopy, scanning electron microscope, X-ray diffraction, and transmission electron microscopy. It is found that the peak-aged Mg-7Y-4Gd-1.5Zn-0.4Zr alloys have the highest strength after aging at 220 A degrees C. The highest ultimate tensile strength and yield tensile strength are 418 and 320 MPa, respectively. The addition of 1.5 wt.% Zn to the based alloys results in a greater aging effect and better mechanical properties at both room and elevated temperatures. The improved mechanical properties are mainly ascribed to both a fine beta' phase and a long periodic stacking-ordered structure, which coexist together in the peak-aged alloys.