Biochemical and nutritional evaluation of patients with visceral leishmaniasis before and after treatment with leishmanicidal drugs

Introduction Visceral leishmaniasis (VL) is caused by the intracellular protozoan Leishmania donovani complex. VL may be asymptomatic or progressive and is characterized by fever, anemia, weight loss and the enlargement of the spleen and liver. The nutritional status of the patients with VL is a major determinant of the progression, severity and mortality of the disease, as it affects the clinical progression of the disease. Changes in lipoproteins and plasma proteins may have major impacts in the host during infection. Thus, our goal was evaluate the serum total cholesterol, high-density lipoprotein (HDL), low-density lipoprotein (LDL), triglycerides, glucose, albumin, globulin and total protein levels, as well as the body composition, of VL patients before and after treatment. Methods Nutritional evaluation was performed using the bioelectrical impedance analysis (BIA) to assess body composition. Biochemical data on the serum total cholesterol, HDL, LDL, triglycerides, glucose, albumin, globulin and total protein were collected from the medical charts of the patients. Results BIA indicated that both pre-treatment and post-treatment patients exhibited decreased phase angles compared to the controls, which is indicative of disease. Prior to treatment, the patients exhibited lower levels of total body water compared to the controls. Regarding the biochemical evaluation, patients with active VL exhibited lower levels of total cholesterol, HDL, LDL and albumin and higher triglyceride levels compared to patients after treatment and the controls. Treatment increased the levels of albumin and lipoproteins and decreased the triglyceride levels. Conclusions Our results suggest that patients with active VL present biochemical and nutritional changes that are reversed by treatment.

Genetic and biochemical markers of hydroxyurea therapeutic response in sickle cell anemia

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Cardiorespiratory and antinociceptive effects of two different doses of lidocaine administered to horses during a constant intravenous infusion of xylazine and ketamine

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Wolf presence in the ranch of origin: Impacts on temperament and physiological responses of beef cattle following a simulated wolf encounter

This experiment evaluated temperament, vaginal temperature, and plasma cortisol in beef cows from wolf-naive and wolf-experienced origins that were subjected to a simulated wolf encounter. Multiparous, pregnant, nonlactating Angus-crossbreed cows from the Eastern Oregon Agricultural Research Center located near Burns, OR (CON; n = 50), and from a commercial operation near Council, ID (WLF; n = 50), were used. To date, grey wolves are not present around Burns, OR, and thus CON were naive to wolves. Conversely, wolves are present around Council, ID, and WLF cows were selected from a herd that had experienced multiple confirmed wolf-predation episodes from 2008 to 2012. Following a 50-d commingling and adaptation period, CON and WLF cows were ranked by temperament, BW, and BCS and allocated to 5 groups (d 0; 10 CON and 10 WLF cows/group). Groups were individually subjected to the experimental procedures on d 2 (n = 3) and d 3 (n = 2). Before the simulated wolf encounter, cow temperament was assessed and blood samples and vaginal temperatures (using intravaginal data loggers) were collected (presimulation assessments). Cows were then sorted by origin, moved to 2 adjacent drylot pens (10 WLF and 10 CON cows/pen), and subjected to a simulated wolf encounter event for 20 min, which consisted of 1) cotton plugs saturated with wolf urine attached to the drylot fence, 2) continuous reproduction of wolf howls, and 3) 3 leashed dogs that were walked along the fence perimeter. Thereafter, WLF and CON cows were commingled and returned to the handling facility for postsimulation assessments, which were conducted immediately after exposure to wolf-urine-saturated cotton plugs, wolf howl reproduction, and 20-s exposure to the 3 dogs while being restrained in a squeeze chute. Chute score, temperament score, and plasma cortisol concentration increased (P <= 0.01) from pre- to postsimulation assessment in WLF but did not change in CON cows (P >= 0.19). Exit velocity decreased (P = 0.01) from pre-to postsimulation assessment in CON but did not change (P = 0.79) in WLF cows. In addition, WLF cows had a greater (P = 0.03) increase in temperature from pre-to postsimulation assessments compared with CON cows. In conclusion, the simulated wolf encounter increased excitability and fear-related physiological stress responses in cows that originated from a wolf-experienced herd but not in cows that originated from a wolf-naive herd.

The effect of chronic treatment with fluoride on salivary activity, tooth, and bone in spontaneously hypertensive rats (SHR)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Marginal adaptation of class II cavities restored with bulk-fill composites

Objectives: To determine the marginal adaptation of bulk-fill composites in class II MO cavities.Methods: Standardized class II MO cavities with bevelled enamel margins were prepared in 40 extracted human molars. The teeth were randomly assigned to one of the five experimental groups (n = 8). The teeth were restored with two horizontal increments of composite (4 mm and 2 mm thickness). The experimental groups were (1st/2nd increment): Gr. A - Venus Bulk-Fill/Venus Diamond; Gr. B - Tetric EvoCeram BulkFill/Tetric EvoCeram; Gr. C - Surefil SDR/Ceram-X; Gr. D - SonicFill; Gr. E - Ceram-X/Ceram-X (control). After finishing procedures, impressions were made using a polyvinyl siloxane and epoxy resin replicas were obtained. Thermo-mechanical stressing was carried out 24 h after the restorative procedure. All specimens were submitted to 240,000 occlusal loading and simultaneous 600 thermal cycles in water at 5 degrees C and 50 degrees C. After loading, a new set of epoxy resin replicas was obtained. Scanning electron microscopy was carried out at 200x magnification. Results for the marginal adaptation were expressed as percentages of continuity relative to the exposed interface and analyzed by ANOVA and Duncan post hoc test (p < 0.05).Results: In enamel, no significant differences were detected before and after thermo-mechanical loading between groups. In dentine, the worst results were observed in Gr. A.Conclusion: By applying simple layering techniques, bulk-fill materials do not allow better marginal adaptation than a standard composite. Clinical significance: A new class of resin-base composite (bulk-fill) was recently launched on the market. The bulk-fill composites exhibited adequate marginal adaptation and similar to the results of the standard composite. (C) 2014 Elsevier Ltd. All rights reserved.

Effect of Silver Nanoparticles in a Hydroxyapatite Coating applied by Atmospheric Plasma Spray

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

An innovative material based on natural rubber and leather tannery waste to be applied as antistatic flooring

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Evaluation of Decomposition Procedure to Determine Ba, Co, Cr, Cu, Ni, Mn, V, and Zn Total Content in Soil Samples

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Interfacial integrity of low-shrinkage composite restorations related to the filling technique and consistency

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Production and characterization of Tm3+/Yb3+ codoped pedestal-type PbO-GeO2 waveguides

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Exercise improves immune function, antidepressive response, and sleep quality in patients with chronic primary insomnia

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Composite Material Sensitive to Volatile Organic Compounds

This work evaluates fluorinated thin films and their composites for sensor development. Composites were produced using 5 µm starch particles and plasma films obtained from organic fluorinated and silicon compounds reactants. Silicon wafers and aluminum trenches were used as substrates. Film thickness, refractive index and chemical structure were also determined. Scanning electron microscopy shows conformal deposition on aluminum trenches. Films deposited on silicon were exposed to vapor of volatile organic compounds and CV curves were obtained. A qualitative model (FemLab 3.2® program) was proposed for the electronic behavior. These environmentally correct films can be used in electronic devices and preferentially reacted to polar compounds. Nonetheless, due to the difficulty in signal recovery, these films are more effective in one-way sensors, in sub-ppm range.

Avaliação de danos oxidativos no DNA de linfócitos e estresse oxidativo no plasma de pacientes a cirurgia sob anestesia balanceada com sevoflurano

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Fluorescence Level of Composites Assessed by Computer Processing of Digital Images - ScanWhite

The human dentition is naturally translucent, opalescent and fluorescent. Differences between the level of fluorescence of tooth structure and restorative materials may result in distinct metameric properties and consequently perceptible disparate esthetic behavior, which impairs the esthetic result of the restorations, frustrating both patients and staff. In this study, we evaluated the level of fluorescence of different composites (Durafill in tones A2 (Du), Charisma in tones A2 (Ch), Venus in tone A2 (Ve), Opallis enamel and dentin in tones A2 (OPD and OPE), Point 4 in tones A2 (P4), Z100 in tones A2 ( Z1), Z250 in tones A2 (Z2), Te-Econom in tones A2 (TE), Tetric Ceram in tones A2 (TC), Tetric Ceram N in tones A1, A2, A4 (TN1, TN2, TN4), Four seasons enamel and dentin in tones A2 (and 4SD 4SE), Empress Direct enamel and dentin in tones A2 (EDE and EDD) and Brilliant in tones A2 (Br)). Cylindrical specimens were prepared, coded and photographed in a standardized manner with a Canon EOS digital camera (400 ISO, 2.8 aperture and 1/ 30 speed), in a dark environment under the action of UV light (25 W). The images were analyzed with the software ScanWhite©-DMC/Darwin systems. The results showed statistical differences between the groups (p < 0.05), and between these same groups and the average fluorescence of the dentition of young (18 to 25 years) and adults (40 to 45 years) taken as control. It can be concluded that: Composites Z100, Z250 (3M ESPE) and Point 4 (Kerr) do not match with the fluorescence of human dentition and the fluorescence of the materials was found to be affected by their own tone.