Purification and biochemical characterization of an endoxylanase from Aspergillus versicolor

An endoxylanase (beta-1,4-xylan xylanohydrolase, EC 3.2.1.8) was purified from the culture filtrate of a strain of Aspergillus versicolor grown on oat wheat. The enzyme was purified to homogeneity by chromatography on DEAE-cellulose and Sephadex G-75. The purified enzyme was a monomer of molecular mass estimated to be 19 kDa by SDS-PAGE and gel filtration. The enzyme was glycoprotein with 71% carbohydrate content and exhibited a pI of 5.4. The purified xylanase was specific for xylan hydrolysis. The enzyme had a K-m of 6.5 mg ml(-1) and a V-max of 1440 U (mg protein)(-1). (C) 1998 Federation of European Microbiological Societies. Published by Elsevier B.V. B.V. All rights reserved.

PURIFICATION AND PROPERTIES OF SHIKIMATE DEHYDROGENASE FROM CUCUMBER (CUCUMIS-SATIVUS L)

Shikimate dehydrogenase (SDH, EC 1.1.1.25) extracted from cucumber pulp (Cucumis sativus L.) was purified 7-fold by precipitation with ammonium sulfate and elution from columns of Sephadex G-25, DEAE-cellulose, and hydroxyapatite. Two activity bands were detected on polyacrylamide gel electrophoresis at the last purification step. pH optimum was 8.7, and molecular weight of 45 000 was estimated on a Sephadex G-100 column. SDH was inhibited competitively by protocatechuic acid with a K(i) value of 2 x 10-4 M. K(m) values of 6 x 10-5 and 1 x 10-5 M were determined for shikimic acid and NADP+, respectively. The enzyme was completely inhibited by HgCl2 and p-(chloromercuri)benzoate (PCMB). NaCl and KCl showed partial protection against inhibition by PCMB. Heat inactivation between 50 and 55-degrees-C was biphasic, and the enzyme was completely inactivated after 10 min at 60-degrees-C. Incubation of SDH with either NADP+ or shikimic acid protected the enzyme against heat inactivation.

Identification of polycyclic aromatic hydrocarbons and methoxylated phenols in wood smoke emitted during production of charcoal

More than 130 organic substances in dichloromethane-methanol (4: 1) extracts of particulate matter and the gaseous phase from wood burning for the production of charcoal have been identified by capillary gas chromatography coupled with low-resolution mass spectrometry (GC-MS), use of GC retention indices, and comparison with authentic standards. Many of the substances identified are methoxyphenols (derivatives of syringol and guaiacol), polycyclic aromatic hydrocarbons (PAH), oxidized PAH (oxy-PAH), and levoglucosan, the last being a monosoccharide derivative from the thermal breakdown of cellulose. The amount of unsubstituted PAH was greater than that of methyl- and dimethyl-substituted homologs.

Influence of temperature on the properties of the xylanolytic enzymes of the thermotolerant fungus Aspergillus phoenicis

This study reports on the effects of growth temperature on the secretion and some properties of the xylanase and beta-xylosidase activities produced by a thermotolerant Aspergillus phoenicis. Marked differences were observed when the organism was grown on xylan-supplemented medium at 25 degreesC or 42 degreesC. Production of xylanolytic enzymes reached maximum levels after 72 h of growth at 42 degreesC; and levels were three- to five-fold higher than at 25 degreesC. Secretion of xylanase and beta-xylosidase was also strongly stimulated at the higher temperature. The optimal temperature was 85 degreesC for extracellular and 90 degreesC for intracellular beta-xylosidase activity, independent of the growth temperature. The optimum temperature for extracellular xylanase increased from 50 degreesC to 55 degreesC when the fungus was cultivated at 42 degreesC. At the higher temperature, the xylanolytic enzymes produced by A. phoenicis showed increased thermo stability, with changes in the profiles of pH optima. The chromatographic profiles were distinct when samples obtained from cultures grown at different temperatures were eluted from DEAE-cellulose and Biogel P-60 columns.

Measurements of ambient ozone using indigo blue-coated filters

Ozone monitoring techniques utilize expensive instruments that are often large and heavy. These instruments are not easy to handle in the field, and their size also limits some sampling schemes, principally for indoor ozone determination. We have developed a lightweight, inexpensive, and sensitive method that offers flexibility to undertake measurements of ambient ozone in many environments, both indoor and outdoor. The method is based on the reaction of ozone with indigo blue dye. The indigo molecule contains 1 carbon double bond (C = C) that reacts with ozone and results in nearly colorless reaction products. During sample collection, 2 cellulose filters coated with 40 mu L of 1.0 x 10(-3) M indigo blue were used. The determinations were done spectrophotometrically at 250 and 600 nm. The analytical parameters studied were sampling time and flow rate. Analytical curves were constructed with concentrations ranging from 37 to 123 parts per billion by volume (ppbv) of standard ozone, at 0.4 L/min and 15 min sampling time. The detection limits achieved were 6 and 9 ppbv, respectively, at 250 and 600 nm. Considering interferences, measurements made at 250 nm gave more reliable and specific values for ozone.

ISOLATION AND IN-VITRO HYDROLYSIS OF GLOBULIN G1 FROM LENTILS (LENS-CULINARIS, MEDIK)

The major globulin fraction from lentil seeds was investigated with respect td in vitro hydrolysis by trypsin and chymotrypsin. Globulin was isolated by a NaCl-ascorbate extraction procedure and purified by DEAE-cellulose chromatography and gelfiltration chromatography on Sepharose CL-6B. The purity and identification of the protein were performed by PAGE. The native globulin, with a molecular weight of 375 kD, was resolved by SDS-PAGE into twelve polypeptides with molecular weights ranging from 61 to 14.5 kD. Native and heated globulin GI was hydrolyzed with trypsin and chymotrypsin. SDS-PAGE indicated that native globulin was more resistant to digestion than heated protein. Amino acid analysis of the major globulin revealed that glutamic acid was present in the largest concentration, followed by aspartic acid, arginine and leucine. As is also the case for other legumin-like globulins, lentil GI was deficient in sulfur-containing amino acids.

Partial purification and some properties of a T2 ribonuclease from Aspergillus flavipes

A ribonuclease was partially purified from the culture medium of Aspergillus flavipes (IZ:1501), after 96 h of cultivation by chromatography on DEAE-cellulose and Sephadex G100 columns. The molecular weight of the RNase was estimated to be 40 kD by gel filtration using Sephadex G100, and the optimum pH and temperature were 4.0 and 50-55 degrees C, respectively. Catalytic activity was inhibited by Zn+2, Fe+3, Hg+2 and Ag+ ions. The enzyme did not show an exact base specificity and produced four kinds of 3'-nucleotides from yeast RNA.

Purification and characterization of beta-fructosidase with inulinase activity from Aspergillus niger-245

Aspergillus niger - 245 a strain isolated from soil samples showed good beta -fructosidase activity when inoculated in medium formulated with dahlia extract tubers. The enzyme was purified by precipitation in ammonium sulphate and percolated in DEAE-Sephadex A-50 and CM-cellulose columns, witch showed a single peack in all the purification steps, maintaining the I/S ratio between 0.32 to, 0.39. Optimum pH for inulinase activity (I) was between 4.0 - 4.5 and for invertase activity (S) between 2.5 and 50. The optimum temperature was 60 degrees .C for both activities and no loss in activity was observed when it was maintained at this temperature for 30 min. The K-m value was 1.44 and 5.0 respectively, for I and S and V-m value 10.48 and 30.55 respectively. The I activity was strongly inhibited by Hg2+ and Ag+ and 2 x 10(-3) M of glucose, but not by fructose at the same concentration. The enzyme showed an exo-action mechanism acting on the inulin of different origins. In assay conditions total hydrolysis of all the frutans was obtained although it has shown larger activity on the chicory inulin than that one from artichoke Jerusalem and dahlia, in the first 30 min. The obtained results suggested that the enzyme presented good potential for industrial application in the preparing the fructose syrups.

Effect of ammoniation and moisture-content on the quality of signal grass (Brachiaria-decumbens stapf) hay

The experiment was carried out to evaluate the effects of two moisture levels (18-20% and 13-15%) and three anhydrous ammonia levels (0.0; 1.5; 3.0% of NH3) on the quality of Brachiaria decumbens Stapf hay. The hay was bailed in April and weighed and treated under plastic cover during 30 days. The hay presented a similar chemical composition when bailed with high or low moisture. The percentages of NDF (80.59; 77.61; 76.10%); hemicellulose (32.56; 29.48; 28.76%) and lignin (9.53; 8.21; 7.54% decreased and the percentages of crude protein (4.04; 11.35; 13.22%) and IVDMD (36.78; 49.72; 54.33%) increased as the NH3 level increased. The fractions ADF, cellulose, and ADIN did not change due to the ammoniation. The incidence of fungi decreased with application of NH3 being the better results obtained with the 1.5% treatments.

Determination of oligoelements in parenteral formulations by planar chromatography and spectrophotometry

The authors have studied the chromatographic behavior of parenteral preparations for pediatric use containing inorganic cations. After separation and identification by thin-layer chromatography, Mn2+, Zn2+, and Cu2+ were analyzed by a method based on reaction with an appropriate reagent and extraction with an organic solvent which yielded elution and preconcentration, resulting in an appropriate solution for colorimetric quantitation. Cr3+ cation was determined by atomic absorption spectrophotometry after appropriate chromatographic separation, using microcrystalline cellulose (adsorbent) and an acetone:water:hydrochloric acid mixture (80:5:8) as the mobile phase.

Potentiometric determination of alendronate in pharmaceutical formulations

A simple, precise, fast and low-cost potentiometric method for alendronate determination in pharmaceutical formulations has been proposed. Alendronate present in tablets at the known concentration was potentiometrically titrated in an aqueous solution using a combined glass electrode coupled with an autotitrator. Determination limit of alendronate was 20.0 mug mL(-1). In the presence of common excipients, such as lactose, microcrystalline cellulose, glucose, croscarmellose sodium, starch, talc, magnesium stearate and titanium dioxide no interferences were observed. The method proposed was validated by determining alendronate in various dosage forms. The average RSD was 0.75%.

Rheological Characterization of Hydrophylic Gels

Rheological characteristics of gels were studied, with the focus on their use as a cosmetic base. Some ideal characteristics can be predicted by the rheological characterization, such as the performance, with easy application and without dripping or forming lumps and bubbles. Moreover, it is possible to detect signs of physical instability. The gels were prepared with sodium carboxymethyl cellulose 3% and 5%, with Carbopol 940 (INCI: Carbomer) and with Carbopol Ultrez (INCI: Acrylates/C10-30 alkyl acrylate crosspolymer). The tests performed were yield stress, stress sweep and creep and recovery. The gel with 3% of sodium carboxymethyl cellulose presented the most appropriated behavior and can be indicated as the most suitable cosmetic base.

Effects of histone hyperacetylation on the preimplantation development of male and female bovine embryos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Oxygen plasma treatment of sisal fibers and polypropylene: Effects on mechanical properties of composites

Polypropylene powder and sisal fibers were oxygen plasma treated, and the mechanical properties of their composites were tested. Two main effects were investigated: the incorporation of oxygen polar groups in the polypropylene surface and the surface degradation and chain scission of both polypropylene and sisal fibers. Prior to these treatments, three reactor configurations were tested to investigate the best condition for both effects to occur in PP film. Results showed that polypropylene-cellulose adhesion forces are about an order of magnitude higher for PP film treatments at 13.56 MHz than at 40 kHz owing to much higher chain scission at lower frequencies, although it probably also occurs at high frequency and high power. Polypropylene powder treated with oxygen plasma in optimum conditions for polar group incorporation did not result in improvement in any composite mechanical property, probably owing to the polymer melting. Sisal fibers and PP powder treated In conditions of surface degradation did not improve flexural or tensile properties but resulted in higher impact resistance, comparable to the improvement obtained with the addition of compatibilizer.

Self-supported bacterial cellulose/boehmite organic-inorganic hybrid films

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)