Sucessão estratigráfica e paleoambientes dos microbialitos proterozóicos do membro sumidouro, formação lagamar, grupo Vazante, na fazenda Sumaré, em Lagamar - MG

Microbialites (irregular agglutinated grains, laterally continuous mats and stromatolites) occur in small, nearly continuous outcrops over a ~60 m-thick carbonate interval of the Sumidouro Member, Lagamar Formation, Vazante Group, Meso-Neoproterozoic, on the Sumaré Farm, in Lagamar (MG, Southeastern Brazil). Diversified stromatolites formed under shallow, high energy conditions predominate and exhibit frequent lateral and vertical changes, including probable bioherm borders. In the lower part of the interval, coniform columnar stromatolites (Conophyton), representative of the deepest and/or calmest settings, are common. Higher up, narrow subcylindrical unbranched forms become abundant and may grade to forms with subparallel dichotomous or multiple divergent branches. The microbialites are apparently organized in shallowing upward cycles

Análise teórica e experimental de uma ventaneira de alto forno, visando seu comportamento térmico e fluidodinâmico

In this work, it was studied the thermal and fluid dynamic behavior from theorical and experimental point of view of a blast furnace tuyere. The tuyere is responsible for the hot air insuflation into the blast furnace. The parameter used in the comparison was the difference between the cooling water inlet and outlet temperatures. There were used forced convection correlations inside circular sections with adequations for non circular sections. Based on operations dates of flux and thermal loads it was possible to model numerically the tuyere, and, since it was obtained the wall temperatures, estimate the conduction and convection resistances and the heat flux through the walls in contact with the water. The total heat fluxes from wall to water were applied to the energy conservation equation where could be estimated the theorical temperature variation. Compared to the real value, the theorical value presented a difference of 0,2 °C. Considering that the boundary conditions around the tuyere are transitories and that your channels have some rugosity irregularities we can consider the estimation method for cooling system coherent with the real operational parameters

Desenvolvimento de tijolos cerâmicos com escória de alto-forno

The construction industry is booming, and the federal government is heavily financially supporting public housing. This scenario is very favorable for the development of construction materials, especially low-cost construction. Thus, this study aims to develop a new class of unfired clay masonry bricks: GGBS stabilized bricks. Studies show that the ground granulated blast furnace slag, a material used as raw material in cement manufacture, can be used together with calcium oxide in soil stabilization for the manufacture of bricks. This study aims to test and identify the best parameters for the manufacture of unfired bricks, adapting its composition to the materials found in Brazil and identify the optimum curing conditions for our climate. So far preliminary studies were done to verify the technical feasibility of the material. Future studies should be done to ascertain the economic feasibility and environmental gains of such material

Sequenciamento de um fragmento de DNA mitocondrial de Camponotus textor (Forel, 1899) (Hymenoptera, Formicidae)

A grande diversidade das formigas implica na enorme variedade de hábitats de nidificação, preferências alimentares e comportamento social com divisão de trabalho, além da estruturação de seu ninho que por sua vez, podem revelar parte de sua história evolutiva. Camponotus textor é uma espécie tecelã, a qual constrói seu ninho a partir da seda produzida pelas suas próprias larvas, garantindo um dos mais notáveis exemplos de cooperação social. É uma formiga arborícola e de grande importância para a agricultura, já que pode nidificar no cafeeiro (Coffea arabica) e ser usada como agente de controle biológico impedindo o estabelecimento de outras pragas. Atualmente, existem poucos estudos abordando comportamento, fisiologia, genética, endossimbiontes e filogenia desse grupo. Segundo dados da literatura, o DNA mitocondrial tem sido utilizado em análises de filogenia devido ao ótimo número de cópias por célula, altas taxas mutacionais e pouca ou nenhuma recombinação. Sendo assim, o presente trabalho visa realizar o sequenciamento de um fragmento do DNA mitocondrial de populações distintas de Camponotus textor para ser utilizado como marcador molecular, tornandose uma ferramenta para diferenciação de populações e determinação das relações filogenéticas entre outras espécies de formigas relacionadas. Foi feita a extração do DNA em TNES (Tris, NaCl, EDTA, SDS), seguida da amplificação da região COI (citocromo oxidase I) do DNA mitocondrial utilizando-se os primers elaborados para este trabalho e o sequencimento foi realizado no 3130 Genetic Analyzer (Applied Biosystems). As seqüências obtidas foram editadas no BioEdit, e posteriormente comparadas com o banco de dados GenBank, utilizando-se a ferramenta BLAST, e assim a construção da análise filogenética através do programa MEGA. Foi possível a separação das cinco populações em duas linhagens distantes geograficamente

Discovery of a new antiviral protein isolated Lonomia obliqua analysed by bioinformatics and real-time approaches

This study presents a new recombinant protein that acts as a powerful antiviral (rAVLO—recombinant Antiviral protein of Lonomia obliqua). It was able to reduce the replication by 106 fold for herpes virus and by 104 fold for rubella virus. RT-PCR of viral RNA rAVLO treated infected cells also showed similar rate of inhibition in replication. The analysis of this protein by bioinformatics suggests that this protein is globular, secreted with a signal peptide and has the ability to bind to MHC class I. It was found that there are several protein binding sites with various HLA and a prevalence of α-helices in the N-terminal region (overall classified as a α/β protein type). BLAST similarity sequence search for corresponding cDNA did not reveal a similar sequence in Genbank, suggesting that it is from a novel protein family. In this study we have observed that this recombinant protein and hemolymph has a potent antiviral action. This protein was produced in a baculovirus/Sf-9 system. Therefore, these analyses suggest that this novel polypeptide is a candidate as a broad spectrum antiviral.

Analise das emissões de CO2 e de energia - simulação com novas tecnologias siderúrgicas

The process of steel production emits a large quantity of greenhouse gases, specifically carbon dioxide (CO2), and the reduction of such emissions is one of the main challenges for the industry in the 21st. Century. To quantify these emissions, the Worldsteel Association (association of the 170 large steel manufacturers of the world) published a methodology (CO2 Emission Data Collection) for calculation and comparison of CO2 emissions among its members. After that, in 2010, this methodology became an ISO (International Organization for Standardization) norm. Today, the calculation of the CO2 emissions in steel making companies follow the ISO 14404-1 for units with blast furnaces and the ISO 14404-2 for units with electric furnaces. In the last years, new technologies were and continue to be developed for the steel making sector aiming at energetic improvements and greenhouse gas reductions (mainly CO2) by the several processes involved in the production of steel. This work had the objective of producing a tool to calculate the CO2 emissions for the steel making sector. An Excel spreadsheet was developed to calculate the emission intensities of CO2 of a steel plant, the Usina Presidente Vargas, of the Companhia Siderúrgica Nacional (CSN). The spreadsheet furnishes results of CO2 emissions and energetic fluxes, and simulates the benefits that some of the new technologies can give to the company. The spreadsheet calculates the emissions in two ways: a) based on the carbon fluxes that enter the unit, and b) based on the emissions of each specific process within the unit (coking, sinterization, blast furnace, among others)

Resistência a fungicidas estrobilurinas em populações de Pyricularia oryzae de áreas de trigo no Brasil

Pós-graduação em Agronomia - FEIS

Effect of random/aligned nylon-6/MWCNT fibers on dental resin composite reinforcement

The aims of this study were (1) to synthesize and characterize random and aligned nanocomposite fibers of multi-walled carbon nanotubes (MWCNT)/nylon-6 and (2) to determine their reinforcing effects on the flexural strength of a dental resin composite.Nylon-6 was dissolved in hexafluoropropanol (10 wt%), followed by the addition of MWCNT (hereafter referred to as nanotubes) at two distinct concentrations (i.e., 0.5 or 1.5 wt%). Neat nylon-6 fibers (without nanotubes) were also prepared. The solutions were electrospun using parameters under low- (120 rpm) or high-speed (6000 rpm) mandrel rotation to collect random and aligned fibers, respectively. The processed fiber mats were characterized by scanning (SEM) and transmission (TEM) electron microscopies, as well as by uni-axial tensile testing. To determine the reinforcing effects on the flexural strength of a dental resin composite, bar-shaped (20 x 2 x 2 mm(3)) resin composite specimens were prepared by first placing one increment of the composite, followed by one strip of the mat, and one last increment of composite. Non-reinforced composite specimens were used as the control. The specimens were then evaluated using flexural strength testing. SEM was done on the fractured surfaces. The data were analyzed using ANOVA and the Tukey's test (alpha=5%).Nanotubes were successfully incorporated into the nylon-6 fibers. Aligned and random fibers were obtained using high- and low-speed electrospinning, respectively, where the former were significantly (p<0.001) stronger than the latter, regardless of the nanotubes'presence. Indeed, the dental resin composite tested was significantly reinforced when combined with nylon-6 fibrous mats composed of aligned fibers (with or without nanotubes) or random fibers incorporated with nanotubes at 0.5 wt%. (C) 2015 Elsevier Ltd. All rights reserved.

Nano- and macroscale structural and mechanical properties of in situ synthesized bacterial cellulose/PEO-b-PPO-b-PEO biocomposites

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Differential gene expression in drought-tolerant sugarcane roots

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Expression of receptors for ovarian steroids and prostaglandin E2 in the endometrium and myometrium of mares during estrus, diestrus and early pregnancy

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Molecular detection of hemotrophic mycoplasmas among domiciled and free-roaming cats in Campo Grande, state of Mato Grosso do Sul, Brazil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Ecological distribution of stream macroalgal communities from a drainage basin in the Serra da Canastra National Park, Minas Gerais, Southeastern Brazil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Molecular identification of food sources in triatomines in the Brazilian northeast: roles of goats and rodents in Chagas disease epidemiology

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relações filogenéticas e filogeográficas de populações de Phalloceros reisi Lucinda, 2008 (Cyprinodontiformes, Poeciliidae) da bacia do Alto Rio Paraná e Bacia costeira

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)