Modelling the input-output behaviour of piezoelectric structural health monitoring systems for composite plates

This paper investigates the input-output characteristics of structural health monitoring systems for composite plates based on permanently attached piezoelectric transmitter and sensor elements. Using dynamic piezoelectricity theory and a multiple integral transform method to describe the propagating and scattered flexural waves an electro-mechanical model for simulating the voltage input-output transfer function for circular piezoelectric transmitters and sensors adhesively attached to an orthotropic composite plate is developed. The method enables the characterization of all three physical processes, i.e. wave generation, wave propagation and wave reception. The influence of transducer, plate and attached electrical circuit characteristics on the voltage output behaviour of the system is examined through numerical calculations, both in frequency and the time domain. The results show that the input-output behaviour of the system is not properly predicted by the transducers' properties alone. Coupling effects between the transducers and the tested structure have to be taken into account, and adding backing materials to the piezoelectric elements can significantly improve the sensitivity of the system. It is shown that in order to achieve maximum sensitivity, particular piezoelectric transmitters and sensors need to be designed according to the structure to be monitored and the specific frequency regime of interest.

A liberation model for comminution based on probability theory

Mineral processing plants use two main processes; these are comminution and separation. The objective of the comminution process is to break complex particles consisting of numerous minerals into smaller simpler particles where individual particles consist primarily of only one mineral. The process in which the mineral composition distribution in particles changes due to breakage is called 'liberation'. The purpose of separation is to separate particles consisting of valuable mineral from those containing nonvaluable mineral. The energy required to break particles to fine sizes is expensive, and therefore the mineral processing engineer must design the circuit so that the breakage of liberated particles is reduced in favour of breaking composite particles. In order to effectively optimize a circuit through simulation it is necessary to predict how the mineral composition distributions change due to comminution. Such a model is called a 'liberation model for comminution'. It was generally considered that such a model should incorporate information about the ore, such as the texture. However, the relationship between the feed and product particles can be estimated using a probability method, with the probability being defined as the probability that a feed particle of a particular composition and size will form a particular product particle of a particular size and composition. The model is based on maximizing the entropy of the probability subject to mass constraints and composition constraint. Not only does this methodology allow a liberation model to be developed for binary particles, but also for particles consisting of many minerals. Results from applying the model to real plant ore are presented. A laboratory ball mill was used to break particles. The results from this experiment were used to estimate the kernel which represents the relationship between parent and progeny particles. A second feed, consisting primarily of heavy particles subsampled from the main ore was then ground through the same mill. The results from the first experiment were used to predict the product of the second experiment. The agreement between the predicted results and the actual results are very good. It is therefore recommended that more extensive validation is needed to fully evaluate the substance of the method. (C) 2003 Elsevier Ltd. All rights reserved.

Uncertainty during organizational change: Types, consequences, and management strategies

This research tested a model that classifies change uncertainty into three interrelated types: strategic, structural, and job-related. We predicted that control would mediate the effects of job-related uncertainty upon psychological strain, and that management communication and participation in decision-making (PDM) would reduce uncertainty and increase feelings of control. The model was tested in a public sector organization and the results supported it. Control was found to mediate the effects of job-related uncertainty upon psychological strain. Management communication was negatively related to strategic uncertainty, whereas PDM was negatively related to structural and job-related uncertainty, suggesting different mechanisms to deal with the types of uncertainty during change. Finally, PDM was positively associated with feelings of control and negatively associated with psychological strain. These results suggest that PDM can short-circuit the damaging effects of uncertainty by allowing employees to have a say in change related organizational affairs, thereby instilling a sense of control over their circumstances.

Glass transition behaviour of fructose

The glass transition temperature and the second transition (the endothermic change between the glass transition and melting temperatures) of fructose were studied. The thermal history strongly affected both transitions of fructose. Storage for 10 days at 22degreesC increased the dynamic glass transition temperature from 16 to 25degreesC and decreased the second transition of fructose from 110 to 98degreesC in the first differential scanning calorimetric (DSC) scan. The amplitude of the second transition increased slightly with storage time and reached 260% of the first transition for vacuum oven dried samples. The effect of thermal history on the glass transition temperature of fructose can be removed by scanning the sample in a DSC to 130degreesC. The effects of water content, glucose and sucrose on the two transitions were also investigated.

Adaptive stepsize based on control theory for stochastic differential equations

The numerical solution of stochastic differential equations (SDEs) has been focussed recently on the development of numerical methods with good stability and order properties. These numerical implementations have been made with fixed stepsize, but there are many situations when a fixed stepsize is not appropriate. In the numerical solution of ordinary differential equations, much work has been carried out on developing robust implementation techniques using variable stepsize. It has been necessary, in the deterministic case, to consider the best choice for an initial stepsize, as well as developing effective strategies for stepsize control-the same, of course, must be carried out in the stochastic case. In this paper, proportional integral (PI) control is applied to a variable stepsize implementation of an embedded pair of stochastic Runge-Kutta methods used to obtain numerical solutions of nonstiff SDEs. For stiff SDEs, the embedded pair of the balanced Milstein and balanced implicit method is implemented in variable stepsize mode using a predictive controller for the stepsize change. The extension of these stepsize controllers from a digital filter theory point of view via PI with derivative (PID) control will also be implemented. The implementations show the improvement in efficiency that can be attained when using these control theory approaches compared with the regular stepsize change strategy. (C) 2004 Elsevier B.V. All rights reserved.

High-pressure adsorption capacity and structure of CO2 in carbon slit pores: Theory and simulation

We present new simulation results for the packing of single-center and three-center models of carbon dioxide at high pressure in carbon slit pores. The former shows a series of packing transitions that are well described by our density functional theory model developed earlier. In contrast, these transitions are absent for the three-center model. Analysis of the simulation results shows that alternations of flat-lying molecules and rotated molecules can occur as the pore width is increased. The presence or absence of quadrupoles has negligible effect on these high-density structures.

Constraints to organizational learning during major change at a mental health services facility

This paper explains what happened during a three years long qualitative study at a mental health services organization. The study focuses on differences between espoused theory and theory in use during the implementation of a new service delivery model. This major organizational change occurred in a National policy environment of major health budget cutbacks. Primarily as a result of poor resourcing provided to bring about policy change and poor implementation of a series of termination plans, a number of constraints to learning contributed to the difficulties in implementing the new service delivery model. The study explores what occurred during the change process. Rather than blame participants of change for the poor outcomes, the study is set in a broader context of a policy environment—that of major health cutbacks.

Genetic resource impacts of habitat loss and degradation; reconciling empirical evidence and predicted theory for neotropical trees

The theoretical impacts of anthropogenic habitat degradation on genetic resources have been well articulated. Here we use a simulation approach to assess the magnitude of expected genetic change, and review 31 studies of 23 neotropical tree species to assess whether empirical case studies conform to theory. Major differences in the sensitivity of measures to detect the genetic health of degraded populations were obvious. Most studies employing genetic diversity (nine out of 13) found no significant consequences, yet most that assessed progeny inbreeding (six out of eight), reproductive output (seven out of 10) and fitness (all six) highlighted significant impacts. These observations are in line with theory, where inbreeding is observed immediately following impact, but genetic diversity is lost slowly over subsequent generations, which for trees may take decades. Studies also highlight the ecological, not just genetic, consequences of habitat degradation that can cause reduced seed set and progeny fitness. Unexpectedly, two studies examining pollen flow using paternity analysis highlight an extensive network of gene flow at smaller spatial scales (less than 10 km). Gene flow can thus mitigate against loss of genetic diversity and assist in long-term population viability, even in degraded landscapes. Unfortunately, the surveyed studies were too few and heterogeneous to examine concepts of population size thresholds and genetic resilience in relation to life history. Future suggested research priorities include undertaking integrated studies on a range of species in the same landscapes; better documentation of the extent and duration of impact; and most importantly, combining neutral marker, pollination dynamics, ecological consequences, and progeny fitness assessment within single studies.

The functions of societies and the evolution of group living: Spider societies as a test case

Many models have been advanced to suggest how different expressions of sociality have evolved and are maintained. However these models ignore the function of groups for the particular species in question. Here we present a new perspective on sociality where the function of the group takes a central role. We argue that sociality may have primarily a reproductive, protective, or foraging function, depending on whether it enhances the reproductive, protective or foraging aspect of the animal's life (sociality may serve a mixture of these functions). Different functions can potentially cause the development of the same social behaviour. By identifying which function influences a particular social behaviour we can determine how that social behaviour will change with changing conditions, and which models are most pertinent. To test our approach we examined spider sociality, which has often been seen as the poor cousin to insect sociality. By using our approach we found that the group characteristics of eusocial insects is largely governed by the reproductive function of their groups, while the group characteristics of social spiders is largely governed by the foraging function of the group. This means that models relevant to insects may not be relevant to spiders. It also explains why eusocial insects have developed a strict caste system while spider societies are more egalitarian. We also used our approach to explain the differences between different types of spider groups. For example, differences in the characteristics of colonial and kleptoparasitic groups can be explained by differences in foraging methods, while differences between colonial and cooperative spiders can be explained by the role of the reproductive function in the formation of cooperative spider groups. Although the interactions within cooperative spider colonies are largely those of a foraging society, demographic traits and colony dynamics are strongly influenced by the reproductive function. We argue that functional explanations help to understand the social structure of spider groups and therefore the evolutionary potential for speciation in social spiders.

Particle bed charge decay behaviour under high tension roll separation

A new theory of particle discharge in high tension roll (HTR) separation is presented. The discharge dynamics of an isolated charged particle resting on a conducting surface are studied first. The analysis is extended to particle discharge in a homogenous particle bed. Finally, the paper looks at the more realistic scenario of particle discharge in a non-homogenous particle bed. The consequences of the resulting theory on HTR separation are discussed. Predictions from the new theory are tested against experimental HTR separations at the pilot scale. (c) 2005 Elsevier Ltd. All rights reserved.

Change in physiotherapy management of children with cystic fibrosis in a large urban hospital

A retrospective audit was conducted in 1998 and 2000 to review the physiotherapy management of hospitalized children with cystic fibrosis (CF) at the Brisbane Royal Children's Hospital (RCH). The objective was to detect and explore possible changes in patient management in this time period and investigate whether these changes reflected changes in the current theory of CF management. All children over two years of age with CF admitted during 1998 and 2000 with pulmonary manifestation and who satisfied set criteria were included (n = 249). Relative frequency of each of six treatment modalities used were examined on two occasions, revealing some degree of change in practice reflecting the changes in current theory. There was a significant decrease in the frequency of usage of postural drainage with head-down tilt (p < 0.001), and autogenic drainage (p < 0.001) between 1998 and 2000. Modified postural drainage without head-down tilt (p < 0.001), and positive expiratory pressure devices (p < 0.001) were used more frequently in 2000 (p < 0.001). No significant changes were identified in the use of Flutter VRP1 (p = 0.145) and exercise (p = 0.763). No significant differences were found in population demographics or occurrence of concomitant factors that may influence patient management.

Behaviour of the energy gap in a model of Josephson coupled Bose-Einstein condensates

In this work we investigate the energy gap between the ground state and the first excited state in a model of two single-mode Bose-Einstein condensates coupled via Josephson tunnelling. The ene:rgy gap is never zero when the tunnelling interaction is non-zero. The gap exhibits no local minimum below a threshold coupling which separates a delocalized phase from a self-trapping phase that occurs in the absence of the external potential. Above this threshold point one minimum occurs close to the Josephson regime, and a set of minima and maxima appear in the Fock regime. Expressions for the position of these minima and maxima are obtained. The connection between these minima and maxima and the dynamics for the expectation value of the relative number of particles is analysed in detail. We find that the dynamics of the system changes as the coupling crosses these points.

Client fish ectoparasite loads and cleaner shrimp Urocaridella sp c hunger levels affect cleaning behaviour

Cleaning is a classic example of mutualism and determining the factors that maintain the balance between the costs and benefits for mutualist partners can assist our understanding of how cleaning relationships are maintained. Optimal foraging theory suggests two factors that might help to maintain the relationship between cleaners and their clients: client ectoparasite load and cleaner hunger levels. The ecological relevance and importance of foraging by cleaner fish in marine systems has been demonstrated repeatedly, yet there is little information available on this behaviour in cleaner shrimp. To determine whether cleaner shrimp base their choice of client fish on food patch quality (i.e. client fish ectoparasite load) we offered the yellow-beaked cleaner shrimp Urocaridella sp. c a choice of parasitized and unparasitized rock cods, Cephalopholis cyanostigma. To determine whether cleaner shrimp hunger levels influence cleaning time, we manipulated hunger levels in Urocaridella sp. c and examined their behaviour towards parasitized client fish. Cleaner shrimp preferred parasitized to unparasitized client fish and food-deprived cleaner shrimp cleaned parasitized rock cods more frequently than satiated cleaner shrimp did. Therefore, variations in client fish ectoparasite load and cleaner shrimp hunger level are two factors that affect the balance in this mutualism. Finally, our results meet some of the assumptions of biological market theory, a framework used to understand cooperative interactions, and thus this framework is suggested for future studies on this cleaning system.

Destination image, romance and place experience - an application of intimacy theory in tourism

In some forms of tourism, and perhaps particularly in the case of special interest tourism, it can be argued that tourism encounters are service relationships with emotional attachment through the special interest focus and a level of enduring involvement on the part of participants. This involvement is two-fold. First, an interest with the activity; second, a sharing with like-minded people in a social world that extends from home to tourist destination and return. Intimacies in tourism can thus be interpreted through the model of the relationship cycle that comprises the stages A. Aquaintance, B, Buildup, C, Continuation and D, Dissolution. The paper builds upon this concept by utilising ideas of other-centred and self-centredness in personal relationships, and extends the concept of other-centredness to host environments. It also suggests that, in the academic literature about place, location may be secondary in that the quality of experience is primarily determined by the intimacies that exist between people at that place, especially that existing between visitors. © 2004 Published by Elsevier Ltd.