Energy Efficiency through Thermal Energy Storage : Possibilities for the Swedish Building Stock

The need for heating and cooling in buildings constitutes a considerable part of the total energy use in a country and reducing this need is of outmost importance in order to reach national and international goals for reducing energy use and emissions. One important way of reaching these goals is to increase the proportion of renewable energy used for heating and cooling of buildings. Perhaps the largest obstacle with this is the often occurring mismatch between the availability of renewable energy and the need for heating or cooling, hindering this energy to be used directly. This is one of the problems that can be solved by using thermal energy storage (TES) in order to save the heat or cold from when it is available to when it is needed. This thesis is focusing on the combination of TES techniques and buildings to achieve increased energy efficiency for heating and cooling. Various techniques used for TES as well as the combination of TES in buildings have been investigated and summarized through an extensive literature review. A survey of the Swedish building stock was also performed in order to define building types common in Sweden. Within the scope of this thesis, the survey resulted in the selection of three building types, two single family houses and one office building, out of which the two residential buildings were used in a simulation case study of passive TES with increased thermal mass (both sensible and latent). The second case study presented in the thesis is an evaluation of an existing seasonal borehole storage of solar heat for a residential community. In this case, real measurement data was used in the evaluation and in comparisons with earlier evaluations. The literature reviews showed that using TES opens up potential for reduced energy demand and reduced peak heating and cooling loads as well as possibilities for an increased share of renewable energy to cover the energy demand. By using passive storage through increased thermal mass of a building it is also possible to reduce variations in the indoor temperature and especially reduce excess temperatures during warm periods, which could result in avoiding active cooling in a building that would otherwise need it. The analysis of the combination of TES and building types confirmed that TES has a significant potential for increased energy efficiency in buildings but also highlighted the fact that there is still much research required before some of the technologies can become commercially available. In the simulation case study it was concluded that only a small reduction in heating demand is possible with increased thermal mass, but that the time with indoor temperatures above 24 °C can be reduced by up to 20%. The case study of the borehole storage system showed that although the storage system worked as planned, heat losses in the rest of the system as well as some problems with the system operation resulted in a lower solar fraction than projected. The work presented within this thesis has shown that TES is already used successfully for many building applications (e.g. domestic hot water stores and water tanks for storing solar heat) but that there still is much potential in further use of TES. There are, however, barriers such as a need for more research for some storage technologies as well as storage materials, especially phase change material storage and thermochemical storage.

Energy Efficiency through Thermal Energy Storage - Evaluation of the Possibilities for the Swedish Building Stock, Phase 1

As a first step in assessing the potential of thermal energy storage in Swedish buildings, the current situation of the Swedish building stock and different storage methods are discussed in this paper. Overall, many buildings are from the 1960’s or earlier having a relatively high energy demand, creating opportunities for large energy savings. The major means of heating are electricity for detached houses and district heating for multi dwelling houses and premises. Cooling needs are relatively low but steadily increasing, emphasizing the need to consider energy storage for both heat and cold. The thermal mass of a building is important for passive storage of thermal energy but this has not been considered much when constructing buildings in Sweden. Instead, common ways of storing thermal energy in Swedish buildings today is in water storage tanks or in the ground using boreholes, while latent thermal energy storage is still very uncommon.

Environmental Objectives, Cost Efficiency, and Multivariate Stochastic Control

This paper is concerned with the cost efficiency in achieving the Swedish national air quality objectives under uncertainty. To realize an ecologically sustainable society, the parliament has approved a set of interim and long-term pollution reduction targets. However, there are considerable quantification uncertainties on the effectiveness of the proposed pollution reduction measures. In this paper, we develop a multivariate stochastic control framework to deal with the cost efficiency problem with multiple pollutants. Based on the cost and technological data collected by several national authorities, we explore the implications of alternative probabilistic constraints. It is found that a composite probabilistic constraint induces considerably lower abatement cost than separable probabilistic restrictions. The trend is reinforced by the presence of positive correlations between reductions in the multiple pollutants.

Policy instruments to improve energy efficiency in buildings

The newly adopted energy efficiency directive (2012/27/EU) highlights the importance of energy efficiency in reaching the Union’s 2020 targets. The directive commits member states to defining national energy efficiency targets (art. 3), achieving yearly energy savings of 1.5% of the annual energy sales through the energy efficiency obligation scheme (art. 7), and providing a long-term strategy for the building sector that aims at a 3% refurbishment rate for public buildings (art. 4+5). Buildings currently account for 40% of energy use in most countries, putting them among the largest end-use sectors. This report takes a closer look at the best practices for implementing increasing energy efficiency in different regions and countries in Europe. The final aim is to identify some policy tools to be suggested to the region of Dalarna (Dalarna having been chosen as the pilot county in Sweden) as a means of implementing energy efficiency in the building sector. The final objective is to give analysts and decision-makers a better analytical foundation to explore future policy development in the area of buildings to be proposed and tested at the regional level in Dalarna and later at the national level in Sweden.

AN APPROACH TO ILLUSTRATE STRATEGIES FOR IMPROVED ENERGY EFFICIENCY AT THE MUNICIPAL LEVEL

REESBE

Equity and Efficiency in Education: motivations and targets

The recently released "Educational PAC" attempts to place basic education at the center of the social debate. We have subsidized this debate, offering a diagnosis of how different education levels can impact individuals' lives through broad and easily interpreted indicators. Initially, we analyze how much each educational level reaches the poorest population. For example, how are those in the bottom strata of income distribution benefited by childcare centers, private secondary education, public university or adult education. The next step is to quantify the return of educational actions, such as their effects on employability and an individual's wages, and even health as perceived by the individual, be that individual poor, middle class or elite. The next part of the research presents evidence of how the main characters in education, aka mothers, fathers and children, regard education. The site available with the research presents a broad, user-friendly database, which will allow interested parties to answer their own questions relative to why people do not attend school, the time spent in the educational system and returns to education, which can all be cross-sectioned with a wide array of socio-demographic attributes (gender, income, etc.) and school characteristics (is it public, are school meals offered, etc.) to find answers to: why do young adults of a certain age not attend school? Why do they miss classes? How long is the school day? Aside from the whys and hows of teaching, the research calculates the amount of time spent in school, resulting from a combination between absence rates, evasion raters and length of the school day. The study presents ranks of indicators referring to objective and subjective aspects of education, such as the discussion of the advantages and care in establishing performance based incentives that aim at guiding the states in the race for better educational indicators.

Interim efficiency with MEU-preferences

Recently Kajii and (2008) proposed to characterize interim efficient allocations in an exchange economy under asymmetric information when uncertainty is represented by multiple posteriors. When agents have Bewley's incomplete preferences, Kajii and Ui (2008) proposed a necessary and sufficient condition on the set of posteriors. However, when agents have Gilboa--Schmeidler's MaxMin expected utility preferences, they only propose a sufficient condition. The objective of this paper is to complete Kajii and Ui's work by proposing a necessary and sufficient condition for interim efficiency for various models of ambiguity aversion and in particular MaxMin expected utility. Our proof is based on a direct application of some results proposed by Rigotti, Shannon and Stralecki (2008).

Sacrifice and efficiency of the income tax schedule

We investigate the efficiency of equal sacrifice tax schedules in an economy which primitives are exactly those in Mirrlees (1971): a continuum of individuals with identical preferences defined over consumption and leisure who differ with respect to their labor market productivity. Using a separable specification for preferences we derive the minimum equal sacrifice allocation and recover the tax schedule that implements it. The separable specification allows us to use the methodology developed by Werning (2007b) to check whether the schedule is efficient, that is, whether there is no alternative tax schedule that raises more revenue while delivering less utility to no one. We find that inefficiency does not arise for most parametrizations we use to approximate the US economy. For the few cases for which inefficiency does arise, it does so only for very high levels of income and marginal tax rates.