Influence of oxygen flow on crystallization and morphology of PLZT thin films

PLZT thin films were prepared by a dip coating process using Pechini's method, also known as polymeric precursor method. The PLZT solution was obtained from a mixture of the individual cation solutions and the process to prepare each solution is based on metallic citrate polymerization. The viscosity of the PLZT solution was adjusted at 40 cP while the ionic concentration was adjusted at 0.1 M. PLZT solutions were deposited on silicon (100) and platinum coated silicon (100) substrates with withdrawal speed at 5 mm/min. The coated substrates were thermally treated with a heating rate of 1 degreesC/min up to 300 degreesC and 5 degreesC/min up to 650 degreesC in order to obtain homogeneous and cracks free films. The influence of oxygen flow on crystallization and morphology of PLZT (9/65/35) thin film is discussed. (C) 2002 Elsevier B.V. Ltd and Techna S.r.l. All rights reserved.

Influence of viscosity and ionic concentration on morphology of PLZT thin films

PLZT thin films were prepared by a dip-coating process using Pechini's method. The PLZT solution was obtained from the mixture of the cation solutions. The viscosity of the solution was adjusted in the range of 20-40 cP, while the ionic concentration was adjusted in the range of 0.1 and 0.2 M. PLZT solutions were deposited on Si (1 0 0) substrate with withdrawal speed at 5 mm/min. The coated substrates were thermally treated with heating rate of 1 degreesC/min up to 300 and 5 degreesC/ min up to 650 degreesC in order to obtain homogeneous and crack free films. The influence of viscosity and ionic concentration on crystallization and morphology of PLZT (9/65/35) thin film will be discussed. (C) 2001 Elsevier B.V. B.V. All rights reserved.

SAXS and UV-Vis combined to Quick-XAFS monitoring of ZnO nanoparticles formation and growth

Time-resolved X-ray absorption-fine structure (Quick-XAFS) and UV-Vis absorption spectroscopies were combined for monitoring simultaneously the time evolution of Zn-based species and ZnO quantum dot (Qdot) formation and growth during the sol-gel synthesis from zinc oxy-acetate precursor solution. The time evolution of the nanostructural features of colloidal suspension was independently monitored in situ by small angle X-ray scattering (SAXS). In both cases, the monitoring was initialized just after the addition of NaOH solution (B = [OH]/[Zn] = 0.5) to the precursor solution at 40 degrees C. Combined time-resolved Quick-XAFS and UV-Vis data showed that the formation of ZnO colloids from the zinc oxy-acetate consumption achieves a quasi-steady-state chemical equilibrium in less than 200s. Afterwards, the comparison of the ZnO Qdots size and Guinier gyration radius evidences a limited aggregation process coupled to the Qdots growth. The analysis of the experimental results demonstrates that the nanocrystal coalescence and Ostwald ripening control the kinetics of the Qdot growth.

Mechanical properties and dimensional effects of ZnO- and SnO(2)-based varistors

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Doping saturation in dye-sensitized solar cells based on ZnO:Ga nanostructured photoanodes

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Electron Transport in Dye-Sensitized Solar Cells Based on ZnO Nanotubes: Evidence for Highly Efficient Charge Collection and Exceptionally Rapid Dynamics

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Comparative electrical behavior at low and high current of SnO(2)- and ZnO-based varistors

The complete I-V characteristics of SnO(2)-based varistors, particularly of the Pianaro system SCNCr consisting in 98.9%SnO(2)+1%CoO+0.05%Nb(2)O(5)+0.05%Cr(2)O(3), all in mol%, have been seldom reported in the literature. A comparative study at low and high currents of the nonohmic behavior of SCNCr- and ZnO-based varistors (modified Matsuoka system) is proposed in this work. The SCNCr system showed higher nonlinearity coefficients in the whole range of measured current. The electrical breakdown field (E(b)) was twice as high for the SCNCr system (5400 V/cm) than for the ZnO varistor (2600 V/cm) due to a smaller average grain size of the former (4.5 mu m) with respect to the latter (8.5 mu m). Nevertheless, we consider that another important factor responsible for the high E(b) in the SCNCr system is the great number of electrically active interfaces (85%) as determined with electrostatic force microscopy (EFM). It was also established that the SCNCr system might be produced in disks of smaller dimensions than that of commercial ZnO-based product, with a 5.0 cm(-1) minimal area-volume (A/V) ratio. The SCNCr reached the saturation current in a short time because of the high resistivity of the grains, which is five times higher than that of the grains in ZnO-based varistors.

ZnO architectures synthesized by a microwave-assisted hydrothermal method and their photoluminescence properties

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Synthesis and characterization of ZnO and ZnO : Ga films and their application in dye-sensitized solar cells

Highly crystalline ZnO and Ga-modified zinc oxide (ZnO:Ga) nanoparticles containing 1, 3 and 5 atom% of Ga3+ were prepared by precipitation method at low temperature. The films were characterized by XRD, BET, XPS and SEM. No evidence of zinc gallate formation (ZnGa2O4), even in the samples containing 5 atom% of gallium, was detected by XRD. XPS data revealed that Ga is present into the ZnO matrix as Ga3+, according to the characteristic binding energies. The particle size decreased as the gallium level was increased as observed by SEM, which might be related to a faster hydrolysis reaction rate. The smaller particle size provided films with higher porosity and surface area, enabling a higher dye loading. When these films were applied to dye-sensitized solar cells (DSSCs) as photoelectrodes, the device based on ZnO: Ga 5 atom% presented an overall conversion efficiency of 6% (at 10 mW cm(-2)), a three-fold increase compared to the ZnO-based DSSCs under the same conditions. To our knowledge, this is one of the highest efficiencies reported so far for ZnO-based DSSCs. Transient absorption (TAS) study of the photoinduced dynamics of dye-sensitized ZnO:Ga films showed that the higher the gallium content, the higher the amount of dye cation formed, while no significant change on the recombination dynamics was observed. The study indicates that Ga-modification of nanocrystalline ZnO leads to an improvement of photocurrent and overall efficiency in the corresponding device.

Morphology and anatomy of the vegetative organs and scapes from Aphorocaulon (Paepalanthus, Eriocaulaceae)

Estudou-se a anatomia de raízes, caules, folhas e escapos de espécies de Paepalanthus subseção Aphorocaulon. Estas plantas apresentam caules reduzidos com folhas em roseta, de onde crescem os paracládios (sistemas de inflorescências). As espécies apresentam raízes com epiderme unisseriada e córtex com células isodiamétricas. Tanto os caules reduzidos como os paracládios apresentam espessamento resultante da atividade do periciclo, denominado Meristema de Espessamento Primário (MEP). Ambos apresentam estrutura anatômica semelhante. Os escapos apresentam endoderme descontínua, periciclo sinuoso, o córtex apresenta costelas salientes (5-6). As folhas apresentam células epidérmicas alongadas no sentido longitudinal com paredes levemente espessadas, estômatos somente na face abaxial, com câmara subestomática especializada, feixes vasculares colaterais com bainha dupla. Essas estruturas anatômicas são comuns para as espécies da subseção Aphorocaulon. Algumas características anatômicas observadas nestas espécies são típicas de plantas que crescem nos campos rupestres.

Seed morphology and post-seminal development of Tillandsia L. (Bromeliaceae) from the Campos Gerais, Paraná, Southern Brazil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Morphology of eggs of Dioctophyme renale Goeze, 1782 (Nematoda: Dioctophymatidae) and influences of temperature on development of first-stage larvae in the eggs

Este estudo teve a finalidade de fornecer dados morfológicos de ovos de D. renale e do desenvolvimento de larvas de primeiro estádio em ovos mantidos em diferentes temperaturas. Os ovos foram obtidos por centrífugação da urina de cães parasitados e colocados em placas de Petri em estufa BOD, durante 90 dias. O experimento consistiu de três tratamentos (GI - 15 ºC, GII - 20 ºC e GIII - 26 ºC) com cinco repetições cada. Os ovos apresentaram tamanho médio de 67,23 x 42,78 µm, e o tempo médio de incubação foi inversamente proporcional à temperatura de incubação e as larvas apresentaram motilidade por aproximadamente uma semana após sua formação.

Molecular phylogeny, morphology and their implications for the taxonomy of Eriocaulaceae

Eriocaulaceae é uma família pantropical com dez gêneros e cerca de 1.400 espécies, com centro de diversidade no Novo Mundo, especialmente no Brasil. A última revisão da família foi publicada há mais de 100 anos, e até recentemente, as relações genéricas e infra-genéricas ainda eram pouco resolvidas. Entretanto, tem havido nos últimos 30 anos, um grande esforço por parte de pesquisadores brasileiros para preencher as lacunas existentes, utilizando caracteres morfológicos e anatômicos, complementados por dados adicionais de diferentes fontes, como palinologia, química, embriologia, genética de populações, citologia e, mais recentemente, estudos de filogenia molecular. Tal conjunto de dados tem levado a uma re-avaliação do relacionamento filogenético dentro da familia. Neste trabalho são apresentados novos dados para as regiões de ITS e trnL-F, analisadas separadamente e em combinação, usando máxima parcimônia e inferência Bayesiana. Os dados obtidos confirmam resultados já publicados, e mostram que muitos caracteres tradicionalmente usados para diferenciação e circunscrição dos gêneros dentro da família são homoplásicos. Uma nova descrição e chave genérica para a família, utilizando caracteres de várias fontes são apresentadas, refletindo a taxonomia atual das Eriocaulaceae.

Cementum, apical morphology and hypercementosis: a probable adaptive response of the periodontal support tissues and potential orthodontic implications

Information about orthodontic movement of teeth with hypercementosis is scarce. As cementum deposition continues to occur, cementum is expected to change the shape of the root and apex over time, but this has not yet been demonstrated. Nor has it ever been established whether it increases or decreases the prevalence of root resorption during orthodontic treatment. The unique biological function of the interconnected network of cementocytes may play a role in orthodontic movement and its associated root resorptions, but no research has ever been conducted on the topic. Unlike cementum thickness and hypercementosis, root and apex shape has not yet been related to patient age. A study of the precise difference between increased cementum thickness and hypercementosis is warranted. Hypercementosis refers to excessive cementum formation above and beyond the extent necessary to fulfill its normal functions, resulting in abnormal thickening with macroscopic changes in the tooth root, which may require the delivery of forces that are different from conventional mechanics in their intensity, direction and distribution. What are the unique features and specificities involved in moving teeth that present with hypercementosis? Bodily movements would be expected to occur, since inclination might prove difficult to achieve, but would the root resorption index be higher or lower?

Análise teórica da interação de CO, CO2 e NH3 com ZnO

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)