The measurement of ice velocity, mass balance and thinning-rate on Johnsons Glacier, Livingston Island, South Shetland Islands, Antarctica

A network of twenty stakes was set up on Johnsons Glacier in order to determine its dynamics. During the austral summers from 1994-95 to 1997-98, we estimated surface velocities, mass balances and ice thickness variations. Horizontal velocity increased dow nstream from 1 m a- 1 near the ice divides to 40 m a- 1 near the ice terminus. The accumulation zone showed low accumulation rates (maximum of 0,6 m a- 1 (ice)), whereas in the lower part of the glacier, ablation rates were 4,3 m a- 1 (ice). Over the 3-year study period, both in the accumulation and ablation zones, we detected a reduction in the ice surface level ranging from 2 to 10 m from the annual ve rt ical velocities and ice-thinning data, the mass balance was obtained and compared with the mass balance field values, resulting in similar estimates. Flux values were calculated using cross-section data and horizontal velocities, and compared with the results obtained by means of mass balance and ice thinning data using the continuity equation. The two methods gave similar results.

Positive Outcomes Influence the Rate and Time to Publication, but Not the Impact Factor of Publications of Clinical Trial Results

Objectives: Publication bias may affect the validity of evidence based medical decisions. The aim of this study is to assess whether research outcomes affect the dissemination of clinical trial findings, in terms of rate, time to publication, and impact factor of journal publications. Methods and Findings: All drug-evaluating clinical trials submitted to and approved by a general hospital ethics committee between 1997 and 2004 were prospectively followed to analyze their fate and publication. Published articles were identified by searching Pubmed and other electronic databases. Clinical study final reports submitted to the ethics committee, final reports synopses available online and meeting abstracts were also considered as sources of study results. Study outcomes were classified as positive (when statistical significance favoring experimental drug was achieved), negative (when no statistical significance was achieved or it favored control drug) and descriptive (for non-controlled studies). Time to publication was defined as time from study closure to publication. A survival analysis was performed using a Cox regression model to analyze time to publication. Journal impact factors of identified publications were recorded. Publication rate was 48·4% (380/785). Study results were identified for 68·9% of all completed clinical trials (541/785). Publication rate was 84·9% (180/212) for studies with results classified as positive and 68·9% (128/186) for studies with results classified as negative (p<0·001). Median time to publication was 2·09 years (IC95 1·61-2·56) for studies with results classified as positive and 3·21 years (IC95 2·69-3·70) for studies with results classified as negative (hazard ratio 1·99 (IC95 1·55-2·55). No differences were found in publication impact factor between positive (median 6·308, interquartile range: 3·141-28·409) and negative result studies (median 8·266, interquartile range: 4·135-17·157). Conclusions: Clinical trials with positive outcomes have significantly higher rates and shorter times to publication than those with negative results. However, no differences have been found in terms of impact factor.

Is high dose rate brachytherapy reliable and effective treatment for prostate cancer patients? A review of the literature.

The intrinsic physical and radiobiological characteristics of High Dose Rate Brachytherapy (HDR-BT) are well suited to the treatment of prostate cancer. HDR-BT was initially used as a boost to external beam brachytherapy, but has subsequently been employed as the sole treatment, which is termed HDR monotherapy. This review summarizes the clinical outcomes and toxicity results of the principal studies and discusses the radiobiological basis supporting its use.

Growth Models with Exogenous Saving Rates, Unemployment and Wage Inertia

[cat] El propòsit d'aquest article és introduir una mercat de treball no competitiu i atur en el model de creixement amb taxes d'estalvi exògenes que es pot trobar en els llibres de text de creixement (Sala‐i‐Martín, 2000; Barro and Sala‐i‐Martín, 2003; Romer, 2006). Primer, derivem un marc general amb una funció de producció neoclàssica per analitzar la relació entre creixement i ocupació. Utilitzem aquest marc per estudiar les dinàmiques conjuntes del creixement i l'ocupació sota diferents regles de fixació salarial.

Growth Models with Exogenous Saving Rates, Unemployment and Wage Inertia

[cat] El propòsit d'aquest article és introduir una mercat de treball no competitiu i atur en el model de creixement amb taxes d'estalvi exògenes que es pot trobar en els llibres de text de creixement (Sala‐i‐Martín, 2000; Barro and Sala‐i‐Martín, 2003; Romer, 2006). Primer, derivem un marc general amb una funció de producció neoclàssica per analitzar la relació entre creixement i ocupació. Utilitzem aquest marc per estudiar les dinàmiques conjuntes del creixement i l'ocupació sota diferents regles de fixació salarial.

Modelling the curing process in magneto-sensitive polymers: Rate-dependence and shrinkage

This paper deals with a phenomenologically motivated magneto-viscoelastic coupled finite strain framework for simulating the curing process of polymers under the application of a coupled magneto-mechanical road. Magneto-sensitive polymers are prepared by mixing micron-sized ferromagnetic particles in uncured polymers. Application of a magnetic field during the curing process causes the particles to align and form chain-like structures lending an overall anisotropy to the material. The polymer curing is a viscoelastic complex process where a transformation from fluid. to solid occurs in the course of time. During curing, volume shrinkage also occurs due to the packing of polymer chains by chemical reactions. Such reactions impart a continuous change of magneto-mechanical properties that can be modelled by an appropriate constitutive relation where the temporal evolution of material parameters is considered. To model the shrinkage during curing, a magnetic-induction-dependent approach is proposed which is based on a multiplicative decomposition of the deformation gradient into a mechanical and a magnetic-induction-dependent volume shrinkage part. The proposed model obeys the relevant laws of thermodynamics. Numerical examples, based on a generalised Mooney-Rivlin energy function, are presented to demonstrate the model capacity in the case of a magneto-viscoelastically coupled load.

Three-step pathway engineering results in more incidence rate and higher emission of nerolidol and improved attraction of Diadegma semiclausum

The concentration and ratio of terpenoids in the headspace volatile blend of plants have a fundamental role in the communication of plants and insects. The sesquiterpene (E)-nerolidol is one of the important volatiles with effect on beneficial carnivores for biologic pest management in the field. To optimize de novo biosynthesis and reliable and uniform emission of (E)-nerolidol, we engineered different steps of the (E)-nerolidol biosynthesis pathway in Arabidopsis thaliana. Introduction of a mitochondrial nerolidol synthase gene mediates de novo emission of (E)-nerolidol and linalool. Co-expression of the mitochondrial FPS1 and cytosolic HMGR1 increased the number of emitting transgenic plants (incidence rate) and the emission rate of both volatiles. No association between the emission rate of transgenic volatiles and their growth inhibitory effect could be established. (E)-Nerolidol was to a large extent metabolized to non-volatile conjugates.

Hot wire configuration for depositing device grade nano-crystalline silicon at high deposition rate

The University of Barcelona is developing a pilot-scale hot wire chemical vapor deposition (HW-CVD) set up for the deposition of nano-crystalline silicon (nc-Si:H) on 10 cm × 10 cm glass substrate at high deposition rate. The system manages 12 thin wires of 0.15-0.2 mm diameter in a very dense configuration. This permits depositing very uniform films, with inhomogeneities lower than 2.5%, at high deposition rate (1.5-3 nm/s), and maintaining the substrate temperature relatively low (250 °C). The wire configuration design, based on radicals' diffusion simulation, is exposed and the predicted homogeneity is validated with optical transmission scanning measurements of the deposited samples. Different deposition series were carried out by varying the substrate temperature, the silane to hydrogen dilution and the deposition pressure. By means of Fourier transform infrared spectroscopy (FTIR), the evolution in time of the nc-Si:H vibrational modes was monitored. Particular importance has been given to the study of the material stability against post-deposition oxidation.

Wage differentials between native and immigrant women in Spain: accounting for differences in support

Purpose: The objective of the study is to quantify the wage gap between native and immigrant women in Spain, taking into account differences in their characteristics and the need to control for common support. If immigrant women are segregated in occupations with few native women, it is important to take this into account to analyse wage differentials between both collectives. Methodology: We use microdata from the Continuous Sample of Working Histories (Muestra Continua de Vidas Laborales) on wages and other personal characteristics such as gender, country of origin, and age to apply the matching procedure and the decomposition of the wage gap along the lines of Ñopo (2008) for the analysis of wage differentials between native and immigrant women. The advantage of this procedure is that we can simultaneously estimate the common support and the mean counterfactual wage for the women on the common support (i.e., comparing native and immigrant women with similar observable characteristics). In addition, we can describe differences not only at the mean but also along the entire wage distribution. Findings: The results obtained indicate that, on average, immigrant women earn less than native women in the Spanish labour market. This wage gap is bigger when we consider immigrant women from developing countries, but our main finding is that an important part of this wage gap is related to differences in common support (i.e., immigrant women are segregated in certain jobs with low wages different from those occupied by native women). If the need to control for common support is neglected, estimates of the wage gap will be biased. Originality: Studying the case of Spain is particularly interesting because it is a country with abundant and recent immigration. Immigrant women account for more than half of the total immigrants in Spain, and unlike other host countries, they come from a highly varied range of countries, with origins as diverse as Latin America, the Maghreb and Eastern Europe. To our knowledge, no other study has explicitly focused on the analysis of the wage differential of immigrant women in the Spanish labour market by taking into account the need to control for common support. Moreover, published papers illustrating the potentiality of Ñopo"s (2008) methodology are also very scarce.

Quantitative TCR:pMHC Dissociation Rate Assessment by NTAmers Reveals Antimelanoma T Cell Repertoires Enriched for High Functional Competence.

Experimental models demonstrated that therapeutic induction of CD8 T cell responses may offer protection against tumors or infectious diseases providing that T cells have sufficiently high TCR/CD8:pMHC avidity for efficient Ag recognition and consequently strong immune functions. However, comprehensive characterization of TCR/CD8:pMHC avidity in clinically relevant situations has remained elusive. In this study, using the novel NTA-His tag-containing multimer technology, we quantified the TCR:pMHC dissociation rates (koff) of tumor-specific vaccine-induced CD8 T cell clones (n = 139) derived from seven melanoma patients vaccinated with IFA, CpG, and the native/EAA or analog/ELA Melan-A(MART-1)(26-35) peptide, binding with low or high affinity to MHC, respectively. We observed substantial correlations between koff and Ca(2+) mobilization (p = 0.016) and target cell recognition (p < 0.0001), with the latter independently of the T cell differentiation state. Our strategy was successful in demonstrating that the type of peptide impacted on TCR/CD8:pMHC avidity, as tumor-reactive T cell clones derived from patients vaccinated with the low-affinity (native) peptide expressed slower koff rates than those derived from patients vaccinated with the high-affinity (analog) peptide (p < 0.0001). Furthermore, we observed that the low-affinity peptide promoted the selective differentiation of tumor-specific T cells bearing TCRs with high TCR/CD8:pMHC avidity (p < 0.0001). Altogether, TCR:pMHC interaction kinetics correlated strongly with T cell functions. Our study demonstrates the feasibility and usefulness of TCR/CD8:pMHC avidity assessment by NTA-His tag-containing multimers of naturally occurring polyclonal T cell responses, which represents a strong asset for the development of immunotherapy.