Nutritional status of children, inmates of a small institution for homeless children in the capital of the State of S. Paulo, Brazil

Nutritional surveys (food consumption, clinical and biochemichal) were conducted in a small institution for homeless children. Results showed that only 30% of the children presented adequate calorie intake. Most of the children presented adequate protein intake, but almost half consumed less than 2/3 of the calcium RDA considered necessary. Food handling, processing, and distribution also proved inadequate and wastage, high. Skinfold measurement showed up one case of obesity. Furthermore, most of the children presented clinical signs of vitamin A deficiency, mostly skin lesions; while about half presented clinical signs of riboflavin deficiency. Biochemical data showed that 63.6% had deficient plasma levels of vitamin A, none showed abnormal results for riboflavin excretion, four showed packed blood cell volume below normal, and all had normal hemoglobin levels. Stool examinations revealed a high rate of pathogenic protozoa (Hymenolepis nana), in fact, one of the highest in Brazilian literature.

Ecological aspects of American cutaneous leishmaniasis: 4. Observations on the endophilic behavior of the sandfly and the vectorial role of Psychodopygus intermedius in the Ribeira Valley region of the S.Paulo State, Brazil

The invasive tendency of Psychodopygus intermedius in the home environment, observed initially by Forattini et al. (1976), has now been confirmed by the demonstration of its high endophilic ability and by the use of human residences for shelter. Populations such as Lutzomyia migonei and Pintomyia fischeri were also present in that environment, though their low densities registered during this investigation could be an indication of their poor ability to overcome the barriers raised by the artificial environment. An objective epidemiological analysis based on the variables here given showed that human infection takes place in the extraforest environment, and the principal vectorial function falls, without doubt, on P. intermedius.

Solid-state Marx based two-switch voltage modulator for the On-Line Isotope Mass Separator accelerator at the European Organization for Nuclear Research

A new circuit topology is proposed to replace the actual pulse transformer and thyratron based resonant modulator that supplies the 60 kV target potential for the ion acceleration of the On-Line Isotope Mass Separator accelerator, the stability of which is critical for the mass resolution downstream separator, at the European Organization for Nuclear Research. The improved modulator uses two solid-state switches working together, each one based on the Marx generator concept, operating as series and parallel switches, reducing the stress on the series stacked semiconductors, and also as auxiliary pulse generator in order to fulfill the target requirements. Preliminary results of a 10 kV prototype, using 1200 V insulated gate bipolar transistors and capacitors in the solid-state Marx circuits, ten stages each, with an electrical equivalent circuit of the target, are presented, demonstrating both the improved voltage stability and pulse flexibility potential wanted for this new modulator.

Repetitive Solid State Pulse Modulator Based on a DC Voltage Multiplier

A newly developed solid-state repetitive high-voltage (HV) pulse modulator topology created from the mature concept of the d.c. voltage multiplier (VM) is described. The proposed circuit is based in a voltage multiplier type circuit, where a number of d.c. capacitors share a common connection with different voltage rating in each one. Hence, besides the standard VM rectifier and coupling diodes, two solid-state on/off switches are used, in each stage, to switch from the typical charging VM mode to a pulse mode with the d.c. capacitors connected in series with the load. Due to the on/off semiconductor configuration, in half-bridge structures, the maximum voltage blocked by each one is the d.c. capacitor voltage in each stage. A 2 kV prototype is described and the results are compared with PSPICE simulations.

Mortality from asthma in the state of S. Paulo, Brazil (1970-1992)

Mortality from asthma has shown important variations over time in several countries. In Brazil, a mortality study performed in the 60s, covering the cities of S.Paulo and Ribeirão Preto, and other ten cities showed that S.Paulo presented the lowest death rate from asthma among of them all. It was decided to study the time trends of deaths from asthma and from the whole set of respiratory diseases from 1970 to 1992, in the population aged 15-34 yrs. old in the State of S.Paulo, as well as to compare them with those of other countries. Asthma mortality rates during the 23 years of observation since 1975, showed an oscillatory declining pattern with a peak of deaths in the initial years. The linearization of the curve allows the calculation of Pearson's correlation coefficient that was significantly negative, suggesting a decline in the mortality over this period, mainly in the 5-9 yrs. old and 30-34 yrs. old strata. The segmentation of data between the period of ICD-9, 1970 to 1978, and of ICD-9, 1979 and subsequent years, shows that there is stability within each period, in all age-groups, except for that of 5-9 yr. olds between 1970-1978. Comparing the rates of the population aged 15-34 yrs. old for the State of S. Paulo, Brazil, with trends observed in 14 other countries, an intermediate pattern for the first triennial period (1970-1972) as well as for the subsequent triennial periods, emerges. A prevalence study of asthma, a follow up program meant for using emergency rooms and a surveillance of deaths due to all respiratory diseases and specifically to asthma are strongly recommended.

Reliability of self-reported weight and height among State bank employees

INTRODUCTION: Self-reported weight and height were compared with direct measurements in order to evaluate the agreement between the two sources. METHOD: Data were obtained from a cross-sectional study on health status from a probabilistic sample of 1,183 employees of a bank, in Rio de Janeiro State, Brazil. Direct measurements were made of 322 employees. Differences between the two sources were evaluated using mean differences, limits of agreement and intraclass correlation coefficient (ICC). RESULTS AND CONCLUSIONS: Men and women tended to underestimate their weight while differences between self-reported and measured height were insignificant. Body mass index (BMI) mean differences were smaller than those observed for weight. ICC was over 0.98 for weight and 0.95 for BMI, expressing close agreement. Combining a graphical method with ICC may be useful in pilot studies to detect populational groups capable of providing reliable information on weight and height, thus minimizing resources needed for field work.

Cancer incidence in eighteen cities of the State of São Paulo, Brazil

OBJECTIVE: As in Brazil cancer registries are mostly based on large cities, there are no estimates per state or per region and information on the disease incidence in the vast in-land areas is very scarce. An incidence survey was conducted in 18 major cities of the state of São Paulo, excluding the capital, aiming to collect information about cancer incidence in the state of São Paulo. METHODS: Of the 18 cities in state of São Paulo included in the survey, all had available resources for cancer management. Data from the year of 1991 were collected by the personnel of the Instituto Brasileiro de Geografia e Estatística (Brazilian Institute of Statistics), who were especially trained by the study coordinators at the Fundação Oncocentro de São Paulo (Cancer Center of São Paulo). The collected data were processed and analyzed at the Oncocentro. Data collection, processing, and analyses were performed according to the recommendations of the International Agency for Research on Cancer. RESULTS: Although some discrepancies were observed in cancer incidence rates between the cities, results obtained for all 18 cities combined were remarkably close to those recently found for the city of São Paulo in the year 1993. One remarkable finding was the relatively high cancer incidence rates in both sexes in the city of Santos. CONCLUSIONS: The very similar all-sites cancer incidence rates found in the year 1991, when compared to those for the city of São Paulo in the year 1993, are suggestive that all regions have common cancer-related factors. Nevertheless, other explanations, such as the inclusion in the study of prevalent cases, as well as of non-residents, may have occurred in both studies, biasing the results. There is a need of further studies to confirm the high cancer incidence in Santos.

Intra-population plasticity of Anopheles darlingi's (Diptera, Culicidae) biting activity patterns in the state of Amapá, Brazil

OBJECTIVE: To assess the variation in Anopheles darlingi's biting activity compared to An. marajoara in the same locality and to biting activity data from other regions. METHODS: Using human bait, eight observations of the biting activity of An. darlingi and An. marajoara were carried out during 1999 and 2000 in the municipality of São Raimundo do Pirativa, state of Amapá, Brazil. Each observation consisted of three consecutive 13-hour collections, close to full moon. There were shifts of collectors in the observation points and nocturnal periods. RESULTS: An. darlingi revealed considerable plasticity of biting activity in contrast to An. marajoara, which showed well-defined crepuscular biting peaks. No significant correlation between density and biting activity was found, but a significant correlation existed between time and proportional crepuscular activity, indicating underlying ecological processes not yet understood. Two of the four available data sets having multiple observations at one locality showed considerable plasticity of this species' biting patterns as well. CONCLUSION: Intra-population variation of biting activity can be as significant as inter-population variation. Some implications in malaria vector control and specific studies are also discussed.

Solid-State Bipolar Marx Generator with Voltage Droop Compensation

This paper addresses the voltage droop compensation associated with long pulses generated by solid-stated based high-voltage Marx topologies. In particular a novel design scheme for voltage droop compensation in solid-state based bipolar Marx generators, using low-cost circuitry design and control, is described. The compensation consists of adding one auxiliary PWM stage to the existing Marx stages, without changing the modularity and topology of the circuit, which controls the output voltage and a LC filter that smoothes the voltage droop in both the positive and negative output pulses. Simulation results are presented for 5 stages Marx circuit using 1 kV per stage, with 1 kHz repetition rate and 10% duty cycle.

Solid-State Bipolar Marx Converter with Output Transformer and Energy Recovery

The purpose of this paper is to present and discuss a general HV topology of the solid-state Marx modulator, for unipolar or bipolar generation connected with a step-up transformer to increase the output voltage applied to a resistive load. Due to the use of an output transformer, discussion about the reset of the transformer is made to guarantee zero average voltage applied to the primary. It is also discussed the transformer magnetizing energy recovering back to the energy storage capacitors. Simulation results for a circuit that generates 100 kV pulses using 1000 V semiconductors are presented and discussed regarding the voltage and current stress on the semiconductors and result obtained.

Occupational accidents among middle and high school students of the state of São Paulo, Brazil

OBJECTIVES: To estimate the prevalence of occupational injuries and identify their risk factors among students in two municipalities. METHODS: A cross-sectional survey was conducted in public schools of the municipalities of Santo Antonio do Pinhal and Monteiro Lobato, Brazil. A stratified probabilistic sample was drawn from public middle and high schools of the study municipalities. A total of 781 students aged 11 to 19 years participated in the study. Students attending middle and high school answered a comprehensive questionnaire on living and working conditions, as well as aspects of work injuries, and health conditions. Multiple logistic regression models were fitted to estimate risk factors of previous and present occupational injuries. RESULTS: Of 781 students, 604 previously had or currently have jobs and 47% reported previous injuries. Among current workers (n=555), 38% reported injuries on their current job. Risk factors for work injuries with statistically significant odds ratio >2.0 included attending evening school, working as a housekeeper, waiter or brickmaker, and with potentially dangerous machines. CONCLUSIONS: The study results reinforce the need of restricting adolescent work and support communities to implement social promotion programs.

Dengue and the risk of urban yellow fever reintroduction in São Paulo State, Brazil

OBJECTIVE: To propose a mathematical method for the estimation of the Basic Reproduction Number, R0, of urban yellow fever in a dengue-infested area. METHODS: The method is based on the assumption that, as the same vector (Aedes aegypti) causes both infections, all the quantities related to the mosquito, estimated from the initial phase of dengue epidemic, could be applied to yellow fever dynamics. It is demonstrated that R0 for yellow fever is, on average, 43% lower than that for dengue. This difference is due to the longer dengue viremia and its shorter extrinsic incubation period. RESULTS: In this study the analysis was expanded to the epidemiological situation of dengue in São Paulo in the year 2001. The total number of dengue cases increased from 3,582 in 2000 to 51,348 in 2001. It was then calculated R0 for yellow fever for every city which have shown R0 of dengue greater than 1. It was also estimated the total number of unprotected people living in highly risky areas for urban yellow fever. CONCLUSIONS: Currently there is a great number of non-vaccinated people living in Aedes aegypti infested area in the state of São Paulo.

IOPT Petri Net State Space Generation Algorithm with Maximal-Step Execution Semantics

This paper presents an algorithm to efficiently generate the state-space of systems specified using the IOPT Petri-net modeling formalism. IOPT nets are a non-autonomous Petri-net class, based on Place-Transition nets with an extended set of features designed to allow the rapid prototyping and synthesis of system controllers through an existing hardware-software co-design framework. To obtain coherent and deterministic operation, IOPT nets use a maximal-step execution semantics where, in a single execution step, all enabled transitions will fire simultaneously. This fact increases the resulting state-space complexity and can cause an arc "explosion" effect. Real-world applications, with several million states, will reach a higher order of magnitude number of arcs, leading to the need for high performance state-space generator algorithms. The proposed algorithm applies a compilation approach to read a PNML file containing one IOPT model and automatically generate an optimized C program to calculate the corresponding state-space.

Magnetized color flavor locked state and compact stars

The stability of the color flavor locked phase in the presence of a strong magnetic field is investigated within the phenomenological MIT bag model, taking into account the variation of the strange quark mass, the baryon density, the magnetic field, as well as the bag and gap parameters. It is found that the minimum value of the energy per baryon in a color flavor locked state at vanishing pressure is lower than the corresponding one for unpaired magnetized strange quark matter and, as the magnetic field increases, the energy per baryon decreases. This implies that magnetized colorflavor locked matter is more stable and could become the ground state inside neutron stars. The mass-radius relation for such stars is also studied.

Solid State Marx Modulator with Blumlein Stack for Bipolar Pulse Generation

Sub-nanosecond bipolar high voltage pulses are a very important tool for food processing, medical treatment, waste water and exhaust gas processing. A Hybrid Modulator for sub-microsecond bipolar pulse generation, comprising an unipolar solid-state Marx generator connected to a load through a stack Blumlein system that produces bipolar pulses and further multiplies the pulse voltage amplitude, is presented. Experimental results from an assembled prototype show the generation of 1000 V amplitude bipolar pulses with 100 ns of pulse width and 1 kHz repetition rate.